Assessment of groundwater quality in a region of endemic fluorosis in the northeast of Brazil

The aim of this study was to estimate the risk for caries and fluorosis in a desertification area, applying the calcium/fluoride concentration ratio of underground water and the quality of water in a selected geographical region. This study was performed in the municipality of São João do Rio do Peixe, located in the tropical semiarid lands of Brazil. A total of 111 groundwater samples were collected. Fluoride concentration varied from 0.11 to 9.33 mg/L. Thirty percent of all samples analyzed showed values above 1.5 mg/L, while 64 % were above the ideal limit of 0.7 mg/L. Mean calcium concentration was 47.6 mg/L, and 14.4 % of all samples presented values above the WHO acceptable limits. The proportional value of calcium/fluoride in water showed that only 12 % of the samples were suitable for dental caries prevention with minimal risk for dental fluorosis. Mapping of the fluoride distribution indicated that approximately 2,465 people could be affected by dental fluorosis and 1,057 people might be affected by skeletal fluorosis. It can be concluded that, in addition to fluoride, many water parameters were not suitable for the drinking water. Mapping out calcium/fluoride ratio may indicate areas of water suitability for caries control, whereas the fluoride concentration solely can indicate the areas with the risk for fluorosis. This approach can be relevant for health authorities for identifying communities where dental caries or dental fluorosis is prevalent.     

Pulp and paper plant wastes valorisation in bituminous mixes

Nowadays, the increasing amount of wastes is a concerning reality and the environmental aspects has become a major priority. Following this worry, the purpose of this experimental study was to investigate the possibility of using pulp and paper inorganic wastes, named dregs and grits, in bituminous mixtures as aggregate replacement to reduce environmental effects of these wastes disposal.First, the wastes were chemically and physically characterized and also tested primarily taking into account the requirements for aggregates in bituminous mixtures. Then, formulations were prepared replacing aggregates with wastes in different amounts. The mechanical properties of these mixtures containing wastes were compared with reference samples based on standard methods.According to the results it was possible to verify that grits had a good performance and it might be directly tested industrially as an aggregate in road construction. On the other hand, dregs need to be treated before incorporation to guarantee stable mixes in terms of water sensitivity.     

Critical analysis of the potential of Ipomoea nil'Scarlet O'Hara' for ozone biomonitoring in the sub-tropics

This study aimed to analyze critically the potential of Ipomoea nil'Scarlet O'Hara' for O(3) biomonitoring in the sub-tropics. Four field experiments (one in each season of 2006) were carried out in a location of the city of S?o Paulo mainly polluted by O(3). Each experiment started with 50 plants, and lasted 28 days. Sub-lots of five plants were taken at intervals between three or four days long. Groups of four plants were also exposed in closed chambers to filtered air or to 40, 50 or 80 ppb of O(3) for three consecutive hours a day for six days. The percentage of leaf injury (interveinal chloroses and necroses), the concentrations of ascorbic acid (AA) and the activity of superoxide dismutase (SOD) and peroxidases (POD) were determined in the 5th, 6th and 7th oldest leaves on the main stem of the plants taken in all experiments. Visible injury occurred in the plants from all experiments. Seasonality in the antioxidant responses observed in plants grown under field conditions was associated with meteorological variables and ozone concentrations five days before leaf analyses. The highest levels of antioxidants occurred during the spring. The percentage of leaf injury was explained (R(2) = 0.97, p < 0.01) by the reduction in the levels of AA and activity of POD five days before the leaf analyses and by the reduction in the levels of particulate matter, and enhancement of temperature and global radiation 10 days before this same day. Although I. nil may be employed for qualitative O(3) biomonitoring, its efficiency for quantitative biomonitoring in the sub-tropics may be compromised, depending on how intense the oxidative power of the environment is.     

Geostatistics under preferential sampling in the presence of local repulsion effects

Environmental and Ecological Statistics - This paper presents an extension of the Geostatistical model under preferential sampling in order to accommodate possible local repulsion effects. This...     

Host community attitudes towards solid waste landfill infrastructure: comprehension before compensation

One of the most controversial planning issues internationally is the siting of waste disposal infrastructure in local communities. Compensation is viewed as a possible solution to siting difficulties in many countries. However, existing empirical evidence is conflicting as to whether or not compensation-based siting has reduced opposition to such developments. Thus, before compensation policy can be considered as the solution for recognising social costs and introducing equity into the waste planning system, it is important to understand why people reject waste disposal infrastructure developments and if this rejection continues over the lifetime of facility operations. This paper utilises information gathered through surveys to examine the effects of distance, local authority consultation efforts, experience and other factors, on attitudes towards non-hazardous solid waste landfill developments in two examples of a potential and actual host communities. Our findings suggest distance proxies expectations of environmental risk in communities with no experience of living with landfill infrastructure. Community consultations by authorities are consistently important, even after a landfill has been in operation for a number of years. This suggests to policy makers to consult thoroughly and adequately before pursuing compensation policies.     

The role of transboundary air pollution over Galicia and North Portugal area

In summer, high levels of ozone (O₃) are frequently measured at both Galicia and Northern Portugal air quality monitoring stations, even exceeding the limit values imposed by legislation. This work aims to investigate the origin of these high O₃ concentrations by the application of a chemical transport modelling system over the northwestern area of the Iberian Peninsula. The WRF–CHIMERE modelling system was applied with high resolution to simulate the selected air pollution episodes that occurred simultaneously in Galicia and North Portugal and in order to study both the contribution of local emission sources and the influence of transboundary pollution. Emission inputs have been prepared based on the development of the Portuguese and Galician emission inventories. The obtained results for O₃ have been evaluated and validated against observations. Modelling results show possible contribution of the transboundary transport over the border of two neighbour regions/countries, indicating that the O₃ episode starts over the urban and industrialised area of North coast of Portugal, reaching the maximum peaks over this region; at the same time, O₃ levels increased over Galicia region, where lower concentrations, but still high, were observed. These results pointed out that air quality management should not be driven by political boundaries and highlight the importance of joining efforts between neighbouring countries.     

Ensemble Techniques to Improve Air Quality Assessment: Focus on O3 and PM

Five air quality models were applied over Portugal for July 2006 with an ensemble purpose. These models were used, with their own meteorology, parameterizations, boundary conditions and chemical mechanisms, but with the same emission data. The validation of the individual models and its ensemble for ozone (O₃) and particulate matter was performed using monitoring data from 22 background stations over Portugal. After removing the bias from each model, different ensemble techniques were applied and compared. Besides the median, several weighted ensemble approaches were tested and intercompared: static (SLR) and dynamic (DLR) multiple linear regressions (using less-square optimization method) and the Bayesian Model Averaging (BMA) methodology. The goal of the comparison is to estimate to what extent the ensemble analysis is an improvement with respect to the single model results. The obtained results revealed that no one of the 4 tested ensembles clearly outperforms the others on the basis of statistical parameters and probabilistic analysis (reliability and resolution properties). Nevertheless, statistical results have shown that the application of the weights slightly improves ensemble performance when compared to those obtained from the median ensemble. The same statistical analysis together with the probabilistic measures demonstrates that the SLR and BMA methods are the best performers amongst the assessed methodologies.     

Derivation of motor vehicle tailpipe particle emission factors suitable for modelling urban fleet emissions and air quality assessments

Background, aim and scope  

Urban motor vehicle fleets are a major source of particulate matter pollution, especially of ultrafine particles (diameters < 0.1 μm), and exposure to particulate matter has known serious health effects. A considerable body of literature is available on vehicle particle emission factors derived using a wide range of different measurement methods for different particle sizes, conducted in different parts of the world. Therefore, the choice as to which are the most suitable particle emission factors to use in transport modelling and health impact assessments presented as a very difficult task. The aim of this study was to derive a comprehensive set of tailpipe particle emission factors for different vehicle and road type combinations, covering the full size range of particles emitted, which are suitable for modelling urban fleet emissions.     

Construction materials as a waste management solution for cellulose sludge

Sustainable waste management system for effluents treatment sludge has been a pressing issue for pulp and paper sector. Recycling is always recommended in terms of environmental sustainability. Following an approach of waste valorisation, this work aims to demonstrate the technical viability of producing fiber-cement roof sheets incorporating cellulose primary sludge generated on paper and pulp mills.From the results obtained with preliminary studies it was possible to verify the possibility of producing fiber-cement sheets by replacing 25% of the conventional used virgin long fiber by primary effluent treatment cellulose sludge. This amount of incorporation was tested on an industrial scale. Environmental parameters related to water and waste, as well as tests for checking the quality of the final product was performed. These control parameters involved total solids in suspension, dissolved salts, chlorides, sulphates, COD, metals content. In the product, parameters like moisture, density and strength were controlled.The results showed that it is possible to replace the virgin long fibers pulp by primary sludge without impacts in final product characteristics and on the environment.This work ensures the elimination of significant waste amounts, which are nowadays sent to landfill, as well as reduces costs associated with the standard raw materials use in the fiber-cement industrial sector.     

The Brazilian National Intercomparison Program (PNI/IRD/CNEN): evaluation of 15 years of data

The Instituto de Radioprote??o e Dosimetria has been coordinating the National Intercomparison Program (PNI) for 15 years, from 1991 to 2005. The objective is to evaluate the analytical performance of the laboratories in low-level activity concentration radionuclide assays in environmental samples. This work presents an evaluation of PNI data from 42 intercomparison runs, which distributed to 22 Brazilian laboratories 2511 samples evaluating 5768 radionuclide assays involving 32 radionuclides in the period from 1991 to 2004. The laboratory performance was evaluated using the Normalized Standard Deviation used by the U.S. EPA. For comparison aims, the Normalized Deviation, used by BIPM was also applied. Laboratory performance were grouped and evaluated in three periods of 5 years each. The first period shows, an average value of good performance of 71.2%, the second shows an average of 78.6% and the last an average of 82.3%. Performance for each kind of radionuclide is also presented.