Bidens pilosa L. hyperaccumulating Cd with different species in soil and the role of EDTA on the hyperaccumulation

Environmental Science and Pollution Research - Investigating whether the same hyperaccumulator shows a high accumulation potential for different species of the same heavy metal in the soil has...     

Improving dialogue among researchers,local and indigenous peoples and decision-makers to address issues of climate change in the North

Ambio - The Circumpolar North has been changing rapidly within the last decades, and the socioeconomic systems of the Eurasian Arctic and Siberia in particular have displayed the most dramatic...     

Development of a composite line source emission model for traffic interrupted microenvironments and its application in particle number emissions at a bus station

A composite line source emission (CLSE) model was developed to specifically quantify exposure levels and describe the spatial variability of vehicle emissions in traffic interrupted microenvironments. This model took into account the complexity of vehicle movements in the queue, as well as different emission rates relevant to various driving conditions (cruise, decelerate, idle and accelerate), and it utilised multi-representative segments to capture the accurate emission distribution for real vehicle flow. Hence, this model was able to quickly quantify the time spent in each segment within the considered zone, as well as the composition and position of the requisite segments based on the vehicle fleet information, which not only helped to quantify the enhanced emissions at critical locations, but it also helped to define the emission source distribution of the disrupted steady flow for further dispersion modelling. The model then was applied to estimate particle number emissions at a bi-directional bus station used by diesel and compressed natural gas fuelled buses. It was found that the acceleration distance was of critical importance when estimating particle number emission, since the highest emissions occurred in sections where most of the buses were accelerating and no significant increases were observed at locations where they idled. It was also shown that emissions at the front end of the platform were 43 times greater than at the rear of the platform. Although the CLSE model is intended to be applied in traffic management and transport analysis systems for the evaluation of exposure, as well as the simulation of vehicle emissions in traffic interrupted microenvironments, the bus station model can also be used for the input of initial source definitions in future dispersion models.     

Air ion concentrations in various urban outdoor environments

Atmospheric ions are produced by many natural and anthropogenic sources and their concentrations vary widely between different environments. There is very little information on their concentrations in different types of urban environments, how they compare across these environments and their dominant sources. In this study, we measured airborne concentrations of small ions, particles and net particle charge at 32 different outdoor sites in and around a major city in Australia and identified the main ion sources. Sites were classified into seven groups as follows: park, woodland, city centre, residential, freeway, power lines and power substation. Generally, parks were situated away from ion sources and represented the urban background value of about 270 ions cm^?3. Median concentrations at all other groups were significantly higher than in the parks. We show that motor vehicles and power transmission systems are two major ion sources in urban areas. Power lines and substations constituted strong unipolar sources, while motor vehicle exhaust constituted strong bipolar sources. The small ion concentration in urban residential areas was about 960 cm^?3. At sites where ion sources were co-located with particle sources, ion concentrations were inhibited due to the ion-particle attachment process. These results improved our understanding on air ion distribution and its interaction with particles in the urban outdoor environment.     

Remobilization of polychlorinated biphenyls from sediment and its consequences for their transport in river waters

A laboratory experiment was performed to examine the remobilization of indicator polychlorinated biphenyls (iPCBs) from sediments and its results were applied to the real-world data for explaining the transport of PCBs in river. Seven PCB concentrations were determined in three series of model water–sediment systems (3 g of river sediment, three different volumes of distilled water (0.5, 0.25, and 0.15 ml), and 5 mg of biocide) after 11 days of incubation. Solid-phase extraction was used for separation of analytes from the aqueous phase and solvent extraction for isolation of analytes from the sediments, respectively. The extracts were analyzed for individual iPCB congeners using gas chromatography–mass spectrometry method. For each series of the experiment, the concentrations of PCBs in aqueous phase were similar. The average sediment/water partition coefficient value was 10⁴?l/kg. The solubility of individual PCB congeners in water did not influence the desorption of PCBs from the sediment. Although the dominant form of PCBs in a water–sediment system occurs as suspended and colloidal fractions, these compounds are transported mostly in a dissolved form. Suspended and colloidal matter is a major sink for PCBs in low-energy aquatic environments. In contrast, the dissolved PCBs are readily transported in running waters. The mobilization of PCBs from sediments to aqueous phase, with respect to their solubility in water, seems to be limited, thus reducing the risk of secondary pollution.     

Microbiological and physical–chemical water quality of the rice fields in Sinos River’s basin, Southern Brazil

In this study, we evaluate spatial and temporal variations of the water’s quality used in rice fields. Every 15 days during the different phases of cultivation of the rice—vegetative, reproductive, and maturity—samples were collected from the main irrigation channel, from the surface water in the field, and from the excess-water drainage channel. The differences in the values of 13 variables were analyzed by the analysis of variance system and by the Principal Component Analysis (PCA) technique. The results demonstrate that the values observed for the presence of total coliforms, heat-tolerant coliforms, and pH were higher in the irrigation water and that the calcium and magnesium components were greater in the drainage water. The PCA results indicate that three groups of variance exist and that these three account for 77 % of the observed variances. The first principal component, (39 % of the variances), includes the variables pH, phosphorus, potassium, carbon, and turbidity; the second (28.1 %), calcium, magnesium, and conductivity; while the third accounts for only 9.9 % of the variation and incorporates the variable biological thermotolerant coliforms. The spatial pattern resulting from the distribution of the sampling locations as regards the first two principal components indicates a difference between the irrigation and drainage waters. The variables of the first and third items (except for the turbidity in the second component) reach higher values in the irrigation water, while the variables associated with the second component have higher values in the drainage water. The information provided is important for the analysis of the influence exercised by plantation management decisions on the microbiological, physical, and chemical quality of the water. The results confirm the ability of paddy rice field to filter out some of the chemicals and coliforms from the irrigation water as it passes through the agro ecosystem.     

Efficacy of supplementation of selected medicinal mushrooms with inorganic selenium salts

The aim of the study was to evaluate the possibility of supplementation with inorganic forms of selenium (Na₂SeO₄ and Na₂SeO₃) in concentrations of 0, 0.1, 0.2, 0.4, 0.6, 0.8, 1.0 and 1.5 mM of three medicinal mushroom species: Agrocybe aegerita, Hericium erinaceus and Ganoderma lucidum. Tested mushroom species grew in Se additions of 0–0.6 mM (A. aegerita and H. erinaceus), while growth of G. lucidum bodies was observed for 0–0.8 mM. For the latter mushroom species, the total Se content was the highest. Content of Se_org was diverse; for control bodies it was the highest for G. lucidum (only organic forms were present), lower for A. aegerita (84% organic forms) and the lowest for H. erinaceus (56% organic forms). Accumulation of Se(IV) was generally significantly higher than Se(VI) for all tested mushroom species. There was no significant decrease of A. aegerita or G. lucidum biomass with the exception of G. lucidum bodies growing under 0.8 mM of Se species addition (15.51 ± 6.53 g). Biomass of H. erinaceus bodies was the highest under 0.2 (197.04 ± 8.73 g), control (191.80 ± 6.06 g) and 0.1 mM (185.04 ± 8.73 g) of both inorganic salts. The addition to the medium of Se salts brought about macroscopic changes in the fruiting bodies of the examined mushrooms. Concentrations exceeding 0.4 mM caused diminution of carpophores or even their total absence. In addition, colour changes of fruiting bodies were also recorded. At Se concentrations of 0.4 and 0.6 mM, A. aegerita fruiting bodies were distinctly lighter and those of H. erinaceus changed colour from purely white to white-pink.     

The evolution of December 2004 tsunami deposits: Temporal and spatial distribution of potentially toxic metalloids

The article presents the results of research into the content of metalloid fractions in the tsunami deposits from southern Thailand. The following fractions, which are potentially most easily released from deposits to the environment, have been distinguished: the water soluble fraction, the exchangeable fraction extracted with the phosphate buffer and the fraction eluted with the solution of hydrochloric acid. The analytical technique atomic absorption spectrometry with hydride generation was applied. Spatial variability of the metalloid fractions in deposits and changes occurring in deposits over a period of several years of observation were determined. Based on the statistical analysis of the results, an attempt was made to determine the post-depositional release of deposits components to the environment. Based on the conducted research, the 4 years forming process of the arsenic, antimony and selenium occurrence after the deposition of sediments on land were described, as well as the balance in the amount of deposit components released to the environment.     

A direct observation study of nighttime safety belt use in Indiana

INTRODUCTION: Nearly all direct observation studies of safety belt use are conducted exclusively during daylight hours. Recent work has suggested that safety belt use at night may differ from daytime belt use. METHODS: An observational study of nighttime safety belt use, utilizing specialized night vision equipment, was conducted in Indiana surrounding the Click It or Ticket 2006 safety belt mobilization activities. A pre- and a post-mobilization statewide direct observation survey was conducted at night coinciding with daytime safety belt use data collection conducted by the state of Indiana. Daytime and nighttime belt use rates were compared. RESULTS: The comparisons across the mobilization period revealed a significant increase during the day, but a significant decrease at night. Comparisons between daytime and nighttime belt use revealed no overall difference during the pre wave, but a significant difference during the post wave. Finally, many common daytime trends in belt use were also found at night, with the exception of the typical age and seating position effects. DISCUSSION: The mobilization activities had a positive effect on daytime belt use, but no effect on nighttime belt use, likely resulting in the differences between daytime and nighttime belt use observed during the post wave. IMPACT ON INDUSTRY: The findings of this study suggest that safety belt mobilizations implemented only during the day do not influence nighttime safety belt use. Changes to how these programs are implemented or additional programs specifically targeting belt use at night should be considered, along with continued monitoring of nighttime belt use.