Identification of soil heavy metal sources from anthropogenic activities and pollution assessment of Fuyang County, China

Understanding regional variations of soil heavy metals and their anthropogenic influence are very important for environmental planning. In this study, 286 surface soil samples were collected in Fuyang county, and the 'total' metals for copper (Cu), zinc (Zn), lead (Pb), cadmium (Cd) and nickel (Ni) were measured in 2005. Statistic analysis showed that Cu, Zn, Pb and Cd had been added by exterior factors, and Ni was mainly controlled by natural factors. The combination of multivariate statistical and geostatistical analysis successfully grouped three groups (Cu, Zn and Pb; Cd; and Ni) of heavy metals from different sources. Through pollution evaluation, it was found that 15.76% of the study area for Cu, Zn and Pb, and 46.14% for Cd suffered from moderate or severe pollution. Further spatial analysis identified the limestone mining activities, paper mills, cement factory and metallurgic activities were the main sources for the concentration of Cu, Zn, Pb and Cd in soils, and soil Ni was mainly determined by the parent materials.     

脉冲电晕反应器结构对乙硫醇消除效果的影响

研究了脉冲电晕等离子体反应器结构的变化对乙硫醇消除效果的影响规律。结果表明，在反应器内设置折流板，可以增加气流的湍动程度，有利于活性粒子与污染物的充分接触，从而提高消除率。高压电极间距对电晕区范围及消毒效果有较大影响，间距较小将导致各电极产生的电场相互干扰明显，消除率减小；而电极间距过大，虽然电极间电场分布相互干扰小，但是反应器内可排布的电极数减少，总电晕区减少，消除率也减小。根据实验结果，电极间距设置为50 mm比较合理。另外，在相同的电场强度和脉冲频率下，毛刺形高压电极比线电极结构能耗低，能量利用率高。     

A comparison of techniques to sample salamander assemblages along highland streams of Maryland

Amphibians may be useful indicators of biological condition in small streams so determining which sampling technique maximizes encounters at the least cost and at the optimal time of year is important. Area constrained surveys (ACS), used by the Maryland Biological Stream Survey, were tested against cover board surveys, drift fences with pitfall and funnel traps, quadrat leaf litter searches, and leaf litter bags. Sixteen, 100 m-long sites were established in headwater streams in the Savage River State Forest in Garrett County, Maryland. Each technique was randomly assigned to a 25 m stream section within each overall sampling site, and sites were sampled once each month from May to October (2005) with additional sampling in March and April (2006). Area constrained surveys yielded means of 2.7 taxa and 14.9 total individuals per sampling visit, which was significantly higher than the yield of all other methods in all months except October and March, when yields were low for all techniques. Area constrained surveys were also significantly more cost-effective per taxon and per individual compared to all other methods. September produced the most taxa and individuals, October and March produced the least, and yields for April through August were similar to September. We employed removal sampling at four sites in April 2006, but abundance could not be estimated because a significant linear decrease in the accumulated catch versus catch per unit effort did not occur for three of the sites.     

Cooling Towers and the Environment

Measurements of natural draft cooling tower plume behavior, as well as meteorological variables, were obtained from aircraft flights near major power plants of the American Electric Power System. Persistence of the visible plume to great distances depends essentially on ambient humidity. Atmospheric stability at plume elevation was also important. Cooling tower-induced fog at ground-level was never observed in any of the tests, and aerodynamic downwash of the visible plume was absent also. The cooling towers did cause modification of natural clouds and they occasionally shadowed some local areas from the sun. Merging of the stack and cooling tower plumes was a common occurrence.     

Estimates of Particle Hygroscopicity during the Southeastern Aerosol and Visibility Study

ABSTRACT

Aerosol water content was determined from relative humidity controlled optical particle counter (ASASP-X) size distribution measurements made during the Southeastern Aerosol and Visibility Study (SEAVS) in the Great Smoky Mountains National Park during summer 1995. Since the scattering response function of the ASASP-X is sensitive to particle refractive index, a technique for calibrating the ASASP-X for any real refractive index was developed. A new iterative process was employed to calculate water mass concentration and wet refractive index as functions of relative humidity. Experimental water mass concentrations were compared to theoretically predicted values assuming only ammonium sulfate compounds were hygroscopic. These comparisons agreed within experimental uncertainty. Estimates of particle hygroscopicity using a rural aerosol model of refractive index as a function of relative humidity demonstrated no significant differences from those made with daily varying refractive index estimates. Although aerosol size parameters were affected by the assumed chemical composition, forming ratios of these parameters nearly canceled these effects.     

A Comparative Analysis of Emissions Deterioration for In-Use Alternative Fuel Vehicles

Abstract

Although there have been several studies examining emissions from in–use alternative fuel vehicles (AFVs), little is known about the deterioration of these emissions over vehicle lifetimes and how this deterioration compares with deterioration from conventional vehicles (CVs). This paper analyzes emissions data from 70 AFVs and 70 CVs operating in the federal government fleet to determine whether AFV emissions deterioration differs significantly from CV emissions deterioration. An analysis is conducted on three alternative fuel types (natural gas, methanol, and ethanol) and on four pollutants (carbon monoxide, total hydrocarbons, non-methane hydrocarbons, and nitrogen oxides). The results indicate that for most cases studied, deterioration differences are not statistically significant; however, several exceptions (most notably with natural gas vehicles) suggest that air quality planners and regulators must further analyze AFV emissions deterioration to properly include these technologies in broader air quality management schemes.     

Mathematical models for accurate prediction of atmospheric visibility with particular reference to the seasonal and environmental patterns in Hong Kong

Atmospheric visibility impairment has gained increasing concern as it is associated with the existence of a number of aerosols as well as common air pollutants and produces unfavorable conditions for observation, dispersion, and transportation. This study analyzed the atmospheric visibility data measured in urban and suburban Hong Kong (two selected stations) with respect to time-matched mass concentrations of common air pollutants including nitrogen dioxide (NO(2)), nitrogen monoxide (NO), respirable suspended particulates (PM(10)), sulfur dioxide (SO(2)), carbon monoxide (CO), and meteorological parameters including air temperature, relative humidity, and wind speed. No significant difference in atmospheric visibility was reported between the two measurement locations (p > or = 0.6, t test); and good atmospheric visibility was observed more frequently in summer and autumn than in winter and spring (p < 0.01, t test). It was also found that atmospheric visibility increased with temperature but decreased with the concentrations of SO(2), CO, PM(10), NO, and NO(2). The results showed that atmospheric visibility was season dependent and would have significant correlations with temperature, the mass concentrations of PM(10) and NO(2), and the air pollution index API (correlation coefficients mid R: R mid R: > or = 0.7, p < or = 0.0001, t test). Mathematical expressions catering to the seasonal variations of atmospheric visibility were thus proposed. By comparison, the proposed visibility prediction models were more accurate than some existing regional models. In addition to improving visibility prediction accuracy, this study would be useful for understanding the context of low atmospheric visibility, exploring possible remedial measures, and evaluating the impact of air pollution and atmospheric visibility impairment in this region.     

A Field Intercomparison and Fundamental Characterization of Various Dust Samplers with a Reference Sampler

The European Economic Community Council Directive 80/779/EEC¹ describes air quality limit values and guide values for sulfur dioxide and suspended particulates. However, article 10, paragraph 1 does not define well enough the reference method required, amongst others, for the gravimetric measurement of suspended particulates. It is explicity stated in article 10, paragraph 5 of the directive, that “the commission shall, in selected locations in the member states and in cooperation with the latter, carry out studies on the sampling…of suspended particulates. These studies shall be designed in particular to promote the harmonization of methods of sampling and analysis of these pollutants.” Therefore, in a joint research program the Umweltbundesamt (grant #104 02263), the commission of European Communities (grant #84-B-6642-11-017-11-N) and the U.S. EPA (grant #2-43211-3580) funded the development of a reference dust sampler by the Fraunhofer-lnstitute of Toxicology and Aerosol Research (FhITA, in Hannover, Federal Republic of Germany) in order: ? to study the particle size distribution of ambient air aerosol at a number of selected sites;

? to compare the results obtained with the reference dust sampler with those of particle samplers operated in Europe and the United States;

? to verify the applicability of wind tunnel results to sampling behaviour in the free atmosphere.

     

Radionuclide transfer to animal products: revised recommended transfer coefficient values

A compilation has been undertaken of data which can be used to derive animal product transfer coefficients for radionuclides, including an extensive review of Russian language information. The resultant database has been used to provide recommended transfer coefficient values for a range of radionuclides to (i) cow, sheep and goat milk, (ii) meat (muscle) of cattle, sheep, goats, pigs and poultry and (iii) eggs. The values are used in a new IAEA handbook on transfer parameters which replaces that referred to as ‘TRS 364’. The paper outlines the approaches and procedures used to identify and collate data, and assumptions used. There are notable differences between the TRS 364 ‘expected’ values and the recommended values in the revised Handbook from the new database. Of the recommended values, three milk values are at least an order of magnitude higher than the TRS 364 values (Cr, Pu (cow) Pu (sheep)) and one milk value is lower (Ni (cow)). For meat, four values (Am, Cd, Sb (beef) I (pork)) are at least an order of magnitude higher than the TRS 364 values and eight values are at least an order of magnitude lower (Ru, Pu (beef), Ru, Sr, Zn (sheep), Ru, Sr (pork), Mn (poultry)). Many data gaps remain.