Methyl mercury in fish—a case study on various samples collected from Ganges river at West Bengal

This study investigated the presence of total mercury (Hg) and organic mercury levels in the muscle of 19 common fresh water fish species captured from river Ganges, West Bengal, India. The total mercury level found in our study may not cause any toxic effect, but the methyl mercury (MeHg) level in some freshwater fish species was surprisingly very high and toxically unacceptable. The results of mercury analysis in various specimens indicated that some fish muscles tended to accumulate high levels of Hg, and approximately 50–84% of Hg was organic mercury. A strong positive correlation between mercury levels in muscle with food habit and fish length (age) was found. Wallago attu possessed the highest amount of organic mercury in their muscle tissues, and it was 0.93 ± 0.61 μg Hg/g of wet weight. Whereas in small-sized fishes Eutropiichthys murius, Puntius sarana, Cirrhinus mrigala, Mystus vittatus or Mystus gulio, and Tilapia mossambicus, it was below the detection limit. Contamination in Catla catla (0.32 ± 0.11), Anguilla bengalensis bengalensis (0.26 ± 0.07 μg Hg/g), Chitala chitala (0.25 ± 0.18), Rita rita (0.34 ± 0.14), and Ompok pabda (0.26 ± 0.04) was also above the 0.25 μg Hg/g of wet weight, the limit set by the PFA for the maximum level for consumption of fish exposed to MeHg. Though in Labeo rohita (0.12 ± 0.03), Mastacembelus armatus (0.17 ± 0.02), Pangasius pangasius (0.12 ± 0.16), Bagarius bagarius (0.12 ± 0.01), and Clupisoma garua (0.1 ± 0.01), concentration was below the recommended level, in Lates calcarifer (0.23 ± 0.0) and Mystus aor (0.23 ± 0.1), it was threatening. Interestingly, a low concentration of Hg was found in post-monsoon samples.     

Optimal stabilization of the copper market: The problem of information

This paper investigates the scope for stabilizing commodity prices by buffer stock interventions. Optimal control is used, rather than simulation, to evaluate the scope for intervention at best. Applications to a world copper market model show that substantial but extensive gains to stabilization are possible. These gains cannot be realised by traditional bandwidth decision rules. An important difficulty is setting the level at which prices should be stabilized. The lack of this information severely reduces the achievable gains.     

Characterization of aerosols from biomass burning--a case study from Mizoram (Northeast), India

Physical and optical properties of biomass burning aerosols in Northeastern region, India analyzed based on measurements made during February 2002. Large spatial extent of Northeastern Region moist tropical to moist sub-tropical forests in India have high frequency of burning in annual dry seasons. Characterization of resultant trace gases and aerosols from biomass burning is important for the atmospheric radiative process. Aerosol optical depth (AOD) observed to be high during burning period compared to pre- and post-burning days. Peak period of biomass burning is highly correlated with measured AOD and total columnar water vapor. Size distribution of aerosols showed bimodal size distribution during burning day and unimodal size distribution during pre- and post-burning days. Size distribution retrievals from biomass burning aerosols show dominance of accumulation mode particles. Weighted mean radius is high (0.22 microm) during burning period. Columnar content of aerosols observed to be high during burning period in addition to the drastic reduction of visibility. During the burning day Anderson sampler measurements showed dominance of accumulation mode particles. The diurnal averaged values of surface shortwave aerosol radiative forcing af biomass burning aerosols varies from -59 to -87 Wm(-2) on different days. Measured and modeled solar irradiances are also discussed in the paper.     

Nitrous oxide and methane emission from a flooded rice field as influenced by separate and combined application of herbicides bensulfuron methyl and pretilachlor

Combination of divergent active principles to achieve broad-spectrum control is gaining popularity to manage the weed menace in intensive agriculture. However, such application could have non-target impacts on the soil processes affecting soil ecology and environmental interactions. A field experiment was conducted to investigate the impact of separate and combined applications of herbicides bensulfuron methyl and pretilachlor on the emission of N₂O and CH₄, and related soil and microbial parameters in a flooded alluvial field planted to rice cv Lalat. Single application of the herbicide bensulfuron methyl or pretilachlor resulted in a significant reduction of N₂O and CH₄ emissions while the combination of these two herbicides distinctly increased N₂O and CH₄ emissions. Cumulative N₂O emissions (kg N₂O-N) followed the order of bensulfuron methyl (0.35 kg ha⁻¹) < pretilachlor (0.36 kg ha⁻¹) < control (0.45 kg ha⁻¹) < bensulfuron methyl 0.6% + pretilachlor 6.0% single dose (0.49 kg ha⁻¹) < bensulfuron methyl 0.6% + pretilachlor 6.0% double dose (0.54 kg ha⁻¹). Cumulative CH₄ emissions (kg CH₄), on the other hand, followed the order of bensulfuron methyl (47.89 kg ha⁻¹) < pretilachlor (73.17 kg ha⁻¹) < bensulfuron methyl 0.6% + pretilachlor 6.0% single dose (93.50 kg ha⁻¹) < control (106.54 kg ha⁻¹) < bensulfuron methyl 0.6% + pretilachlor 6.0% double dose (124.67 kg ha⁻¹). The inhibitory effect of separate application of herbicides bensulfuron methyl 0.6% and pretilachlor 6.0% on N₂O emission was linked to lower mineral N, lower denitrifying and nitrifying activity and low denitrifier and nitrifier populations. Inhibitory effect on CH₄ emission, on the contrary, was linked to prevention in the drop of redox potential, lower readily mineralizable carbon (RMC) and microbial biomass carbon (MBC) contents as well as lower methanogenic and higher methanotrophic bacterial population. Admittedly, stimulatory effect of combined application of herbicides bensulfuron methyl 0.6% and pretilachlor 6.0% at double dose on N₂O and CH₄ emission was related to reversal of the identified indicators of inhibition. Results indicate that while individual application of herbicides bensulfuron methyl 0.6% or pretilachlor 6.0% can reduce N₂O and CH₄ emission from flooded soil planted to rice, their combined application at normal dose can keep the emission at a comparatively lower level with significantly higher grain yield as compared to the herbicides applied alone.     

Anaerobic treatment of atrazine bearing wastewater.

Performance of mixed microbial anaerobic culture in treating synthetic waste-water with high Chemical Oxygen Demand (COD) and varying atrazine concentration was studied. Performance of hybrid reactors with wood charcoal as adsorbent, with a dose of 10 g/l and 40 g/l, along with the microbial mass was also studied. All the reactors were operated in sequential mode with Hydraulic Retention Time (HRT) of 5 days. In all the cases, COD removal after 5 days was found to be above 81%. Initial COD was above 1,000 mg/l. From a hybrid reactor COD removal after 2 days was observed to be 90%. Atrazine reduction after 5 days by microbial mass alone was 43.8%, 40% and 33.2% with an initial concentration of 0.5, 1.0 and 2.0 mg/l respectively. MLSS on all the cases were almost same. Increasing MLSS concentration by about 2 fold did not increase the atrazine removal efficiency significantly. Maximum atrazine removal was observed to be 64% from the hybrid reactor with 10 g/l of wood charcoal and 69.4% from the reactor with 40 g/l of wood charcoal. Atrazine removal from the hybrid reactors after 15 days were observed to be 35.7% and 38.7%, which showed that the higher dose of wood charcoal in hybrid reactor did not improve the atrazine removal efficiency significantly. Specific methanogenic activity test showed no inhibitory effect of atrazine on methane producing bacteria. The performance of anaerobic microorganisms in removing atrazine with no external carbon source and inorganic nitrogen source was studied in batch mode. With an initial concentration of 1.0 mg/l, reduction of atrazine by the anaerobic microorganisms in absence of external carbon source after 35 days was observed to be 61.8% where as in absence of external carbon and inorganic nitrogen source the reduction was only 44.2% after 150 days. Volatilization loss of atrazine was observed to be insignificant.     

Residual fate and persistence of endosulfan (50 WDG) in Bengal gram (Cicer arietinum)

A detailed study has been presented on heavy metal content of the Iture Estuary. Waters of the Sorowie and Kakum rivers that supply water into the Estuary were investigated to ascertain heavy metal pollution levels due to anthropogenic activities. Concentration s of Cd, Zn, Se and Pb were measured. The study shows pre-occupying pollution levels that constitute a threat to both terrestrial and aquatic ecosystems. The abundance of metals in the Estuary is in the order Zn > Pb > Cd > Se. The level of Cd in the Iture Estuary ranged between 0.011 mg/l and 0.041 mg/l while Se was in the range 0.018 mg/l to 0.029 mg/l, Pb 0.020 mg/l to 0.075 mg/l and Zn 0.040 to 2.45 mg/l. The impact of contaminated water from the Sorowie River on the Iture Estuary was outstanding and the study points out the importance of the Sorowie River as a primary pollution source to the Iture Estuary. The pollution of the Iture Estuary was found to be connected to human activities in its catchments.     

Respiratory problems of workers in the zarda industry in Kolkata, India.

This study was undertaken to assess the pulmonary and respiratory problems of workers in a zarda factory. A total of 70 permanent zarda workers (50 manufacturing workers and 20 office ones) were studied in a factory in Baguihati, Kolkata, India. The study included (a) completion of a questionnaire (on pulmonary and respiratory problems), (b) measurement of physical parameters, (c) spirometry and (d) measurement of peak expiratory flow rate. At the same time, the worksite was analyzed with an OSHA-recommended ergonomics checklist. Many zarda manufacturing workers complained of respiratory symptoms. Continuous exposure to the tobacco processing environment reduced the workers' lung volume and peak expiratory flow rates. Our study indicates that zarda manufacturing workers may have respiratory and pulmonary disorders related to exposure to tobacco dust in their work environment.     

Modified titanium oxide (TiO2) nanocomposites and its array of applications: a review

Titania (TiO₂) has been the focus of attention of researchers since the first demonstration of its capability to generate the photocatalytic splitting of water into hydrogen and oxygen. However, there seems to be a recent surge in the research activity, involving modified TiO₂ nanoparticles (NP), which are considered to be more effective due to different physicochemical properties in comparison to unmodified fine particle analogs. Several strategies have been employed to modify TiO₂ to reduce recombination rates of photogenerated charge carriers to enhance the optimal functioning of TiO₂. Doping with cations and anions and coupling it with another semiconductor are the most well-known modification methods used. Titania nanocomposites are known to have a plethora of applications. Photoexcitation of these particles are seen to be extraordinarily effective in eliciting microbial death which makes it an attractive candidate for the manufacturing of antimicrobial coatings. On the other hand, TiO₂ induces the oxidation of various organic refractory compounds like tetracycline, sulfamethazine, and bisphenol. The photo-electrocatalytic oxidation technique which amalgamates the principle of photocatalysis and electrolysis serves as a newer, unswerving, and cost effective water treatment process. In the biomedical arena, use is now acknowledged for the photodynamic therapy of cancer, cell imaging, biological sensors, drug delivery system, and as endonucleases. In the commercial front, it is utilized in creams owing to its small particle size, which facilitates absorption through skin. It is also employed as ultraviolet blocking agents in sunscreen and commonly encountered as a brilliant white pigment in paint due to its brightness, high refractive index and resistance to discoloration. Its use in solar cells has also been reported. This review aims to encompass the new progress of modified TiO2 nanocomposites for efficient applications, emphasizing the future trends of TiO2 in arenas like healthcare, environment, biomedical, food, personal care, and pharmacy and also highlights the commercial implications of this promising nanomaterial.