In situ push-pull method to determine ground water denitrification in riparian zones

To quantify ground water denitrification in discrete locations of riparian aquifers, we modified and evaluated an in situ method based on conservative tracers and 15N-enriched nitrate. Ground water was "pushed" (i.e., injected) into a mini-piezometer and then "pulled" (i.e., extracted) from the same mini-piezometer after an incubation period. This push-pull method was applied in replicate mini-piezometers at two Rhode Island riparian sites, one fresh water and one brackish water. Conservative tracer pretests were conducted to determine incubation periods, ranging from 5 to 120 h, to optimize recovery of introduced plumes. For nitrate push-pull tests, we used two conservative tracers, sulfur hexafluoride and bromide, to provide insight into plume recovery. The two conservative tracers behaved similarly. The dosing solutions were amended with 15N-enriched nitrate that enabled us to quantify the mass of denitrification gases generated during the incubation period. The in situ push-pull method detected substantial denitrification rates at a site where we had previously observed high denitrification rates. At our brackish site, we found high rates of ground water denitrification in marsh locations and minimal denitrification in soils fringing the marsh. The push-pull method can provide useful insights into spatial and temporal patterns of denitrification in riparian zones. The method is robust and results are not seriously affected by dilution or degassing from ground water to soil air. In conjunction with measurements of ground water flow-paths, this method holds promise for evaluating the influence of site and management factors on the ground water nitrate removal capacity of riparian zones.     

A NEW METHOD FOR ESTIMATING PRODUCTIVITY IN STANDING WATERS USING FREE OXYGEN MEASUREMENTS1

ABSTRACT: Continuous measures of net productivity at discrete depths in standing waters may be obtained using diurnal free oxygen measurements and estimates of the vertical mixing. If oxygen concentration and vertical mixing are known in a laterally homogeneous water body, the only unknown term in the oxygen mass-balance equation is net productivity. If this is represented by a Fourier series, the equation may be solved and Fourier coefficients selected so that the sum of square errors between the oxygen measurements and predictions of the equation is minimized; the Fourier series then describes the diurnal variation of net productivity.     

Improved protection for children in forward-facing restraints during side impacts

OBJECTIVE: This study aims to determine the potential for improved child occupant protection in side impacts that can be obtained using rigid and semi-rigid anchorage systems and the addition of energy-absorbing padding in the side structures of child restraints. METHODS: This study uses a comprehensive set of simulated side impacts to evaluate the potential for improved side impact protection in forward-facing child restraints. Factors investigated included methods of anchoring the restraint to the vehicle, energy-absorbing materials in the side structure of restraints, and design features of the restraints such as side wing geometry and seat belt routing. RESULTS: The results show clearly that completely rigid lower attachment of restraints offers the potential for great reductions in head injury risk, which anchorage systems employing a combination of a rigid anchorage bar and webbing attached to a child restraint cannot match. The addition of energy absorbing material in the side structure of restraint systems is effective when the head is fully contained within an adequately designed side wing structure. For restraints anchored by seat belts and loop style semi rigid anchorage straps, belt routing has the potential to significantly affect occupant head excursion. CONCLUSIONS: The results suggest that current child restraint standards and consumer testing protocols do not adequately encourage best practice design of child restraints for side impact protection.     

Application of capillary electrophoresis combined with a modified BCR sequential extraction for estimating of distribution of selected trace metals in PM2.5 fractions of urban airborne particulate matter

The capillary electrophoresis (CE) method combined with a sequential extraction was applied to determine the distribution of Fe, Zn, Cu, Mn and Cd in urban ambient air PM2.5 samples. PM2.5 was collected on Teflon filters with dichotomous sampler, and the modified extraction procedure following the BCR leaching procedure was used to chemically fractionate metals into "easily exchangeable" with water, "acid extractable" with 0.11 mol/l acetic acid, "reducible" with 0.1 mol/l hydroxylamine hydrochloride acidified to pH 2.0 with nitric acid, and "oxidisable" with oxidation by 8.8 mol/l hydrogen peroxide (H2O2) followed by extraction with 1.0 mol/l ammonium acetate. Based on the obtained results it was concluded that the application of the studied methodology provides chemical fractionation data that reflect the general sources and potential health hazards of the studied metals.     

Solubilization of manganese and trace metals in soils affected by acid mine runoff

Manganese solubility has become a primary concern in the soils and water supplies in the Alamosa River basin, Colorado due to both crop toxicity problems and concentrations that exceed water quality standards. Some of the land in this region has received inputs of acid and trace metals as a result of irrigation with water affected by acid mine drainage and naturally occurring acid mineral seeps. The release of Mn, Zn, Ni, and Cu following saturation with water was studied in four soils from the Alamosa River basin. Redox potentials decreased to values adequate for dissolution of Mn oxides within 24 h following saturation. Soluble Mn concentrations were increased to levels exceeding water quality standards within 84 h. Soluble concentrations of Zn and Ni correlated positively with Mn following reduction for all four soils studied. The correlation between Cu and Mn was significant for only one of the soils studied. The soluble concentrations of Zn and Ni were greater than predicted based on the content of each of these metals in the Mn oxide fraction only. Increases in total electrolyte concentration during reduction indicate that this may be the result of displacement of exchangeable metals by Mn following reductive dissolution of Mn oxides.     

Trace elements and organochlorines in surf scoters from San Francisco Bay, 1985

Surf scoters (Melanitta perspicillata) were collected from 6 locations in San Francisco Bay during January and March 1985. Overall, mean concentrations of cadmium and zinc were higher in livers of scoters from the southern region of the Bay, whereas mean iron and lead were higher in those from the northern Bay region. Mean concentrations of arsenic, copper, lead, zinc, aluminum (January only) and iron (January) also differed among individual locations. Mean concentrations of copper and zinc increased, arsenic decreased, and cadmium remained the same between January and March. Selenium and mercury concentrations in scoter livers were not significantly correlated (P>0.05), but cadmium concentrations in livers and kidneys were positively correlated (P<0.0001), and body weight was negatively related to mercury concentration in the liver (P<0.05). Body weight differed among locations but not between January and March. Body weight was correlated with lipid content (P<0.0001). DDE and PCBs were each detected in 34 of 36 scoter carcasses. DDE increased significantly between January and March at Richmond Harbor, but BCBs did not differ between January and March at the 3 locations that could be tested.     

Emission factor estimation for oil and gas facilities

Fugitive emission rate quantification in an oil and gas facility is an important step of risk management. There are several studies conducted by the United States Environmental Protection Agency (USEPA) and American Petroleum Institute (API) proposing methods of estimating emission rates and factors. Four major approaches of estimating these emissions, in the order of their accuracy, are: average emission factor approach, screening ranges emission factor approach, USEPA correlation equation approach, and unit-specific correlation equation approach. The focus of this study is to optimize the USEPA correlation equations to estimate the emission rate of different units in an oil and gas facility. In the developed methodology, the data available from USEPA (1995) is used to develop new sets of equations. A comparison between USEPA correlation equations and the proposed equations is performed to define the optimum sets of equations. It is observed that for pumps, flanges, open-ended lines, and others, the proposed developed equations provide a better estimation of emission rate, whereas for other sources, USEPA equations supply the better estimate of emission rate.     

The potential use of Atlantic silverside (Menidia menidia) for monitoring estuarine pollution

Monitoring chronic impacts of nearshore pollution on fish in Atlantic marine systems is challenging due to the mobility and seasonal nature of most habitat use. We evaluated Atlantic silverside (Menidia menidia) as a potential indicator of pollution across a gradient of contaminated sites in the Saint John River Estuary, New Brunswick, Canada. Fish returning from offshore in the spring showed no differences in length, weight, or condition factor between sites, but a graded response in condition factor appeared gradually, consistent with levels of contamination. Gonad size peaked in early June, however no differences in GSI were found among sites. By September, most fish collected were young of the year, with a significant bias towards female juveniles at the exposed site. These results indicate that Atlantic silverside are locally resident during their onshore period, and demonstrates their potential as a sentinel species. Sampling should focus on early June prior to the full moon to ensure maximal exposure periods before spawning, or in late October to evaluate growth as fish grow rapidly prior to offshore movement.     

Use of Hygiene Protocols to Control the Spread of Viruses in a Hotel

The goals of this study were to observe the spread of viruses in a hotel setting and to assess the effectiveness of a hygiene intervention in reducing their spread. Selected fomites in one hotel room were inoculated with bacteriophage ?x-174, and fomites in a conference center within the same hotel were inoculated using bacteriophage MS2. Cleaning of the contaminated room resulted in the spread of viruses to other rooms by the housekeeping staff. Furthermore, viruses were transferred by hotel guests to the conference center and a communal kitchen area. Additionally, conference attendees transferred viruses from the conference center to their hotel rooms and a communal kitchen area. This study demonstrated how viruses can be spread throughout a hotel setting by both housekeepers and guests. A hygiene intervention, which included providing hand hygiene products and facial tissues to the guests and disinfecting solutions with disposable wipes to the housekeeping staff, was successful in reducing the spread of viruses between the hotel guest rooms and conference center. The hygiene intervention resulted in significantly reduced transfer of the ?x-174 between the contaminated hotel room and other hotel rooms, communal areas, and the conference center (p = 0.02).