中空纤维膜家用净水器工艺改良设计的探讨

针对家用净水器的市场情况,介绍了中空纤维膜超滤技术的工作原理和特点;提出用串联活性炭(或RO)过滤单元的组合模式可弥补该技术存在的不足;依据消费者对该类产品在净化功能等方面的需求,提出了改进建议。     

安徽铜陵铜尾矿硫形态及硫同位素分布特征

分析讨论了安徽铜陵水木冲S和SP剖面尾矿砂的理化指标、硫形态变化和硫酸根硫同位素组成与分布特征.结果显示：S和SP剖面整体呈酸性,pH值为2.59~6.12和3.50~6.27,由下而上有明显的降低趋势;Eh随剖面由下至上明显升高,范围为66~457和-37~307mV;酸可挥发性硫（AVS）含量为0~62.36和0~3.44mg/g,黄铁矿硫（CRS）含量为0.70~32.30mg/g和0.17~5.39mg/g;AVS与CRS的变化趋势基本一致,随剖面自下而上减少,且AVS先于CRS被氧化.2个剖面元素硫（ES）含量为0~8.83和0~3.62mg/g,随深度变化无明显规律.硫酸根硫（SO₄^2--S）含量为8.44~66.34和8.48~29.87mg/g,自下而上呈降低趋势,且分别在剖面的氢氧化物薄膜层（11.5~16.5cm和18~54cm）出现高值区.2个剖面总硫（TS）含量为9.18~109.69和12.38~37.72mg/g,表层由于淋滤含量较低,底层变化则不大.位于斜坡上的SP剖面TS及各形态硫含量均低于S剖面,表明淋滤对硫含量影响更明显.硫酸根硫同位素δ³⁴S为-3.32‰~13.43‰和-3.08‰~1.80‰,S-9硫酸根δ³⁴S为13.43‰,指示其来自于伴生硬石膏,其余层位δ³⁴S偏负且变幅较小,指示其硫酸根主要来源于硫化物的氧化.     

外秦淮河底泥污染及疏浚效果

外秦淮河是南京市一条重要的城市景观行洪河道,多年来受工业及生活污水影响,内源污染严重.为充分了解外秦淮河底泥污染特征,为疏浚提供决策依据,对河道上、中和下游典型断面底泥界面微环境以及营养物含量进行调查,采用有机指数法和污染指数法对底泥污染状况进行评估,同时根据污染物垂向分布特征模拟清淤对底泥内源释放削减的影响.结果表明,上中下游底泥界面以上DO均值分别为4.62、 3.25和3.41mg·L^-1,且分别在4.4、 3.5和5.5 mm处消耗殆尽,是典型的城市河道污染特征体现.调查河段表层底泥的ω(TN)、ω(TP)和ω(OM)均值分别为1 734mg·kg^-1、 1 337 mg·kg^-1和4.82%,底泥TN和OM的有机污染指数均值为0.48,处于尚清洁水平,TP的单项污染指数均值为3.18,处于重度污染水平.模拟30 cm清淤深度结果表明,底泥SRP和Fe²⁺的释放速率较清淤前分别削减42%～82%和88%～96%,而NH⁺₄-N的释放速率却较清淤前有...     

酸性土壤条件下纳米氧化锌长期暴露对蕹菜生长和叶绿素荧光参数的影响

为了探明酸性土壤条件下纳米氧化锌（nano-ZnO）长期暴露对蕹菜的生理生态效应，通过盆栽实验，设置7个浓度系列的nano-ZnO，70 d后测定相对叶绿素含量、生长参数和叶绿素荧光参数。结果显示，随nano-ZnO浓度升高，蕹菜相对叶绿素含量和生长参数先缓慢增加后显著下降。nano-ZnO对蕹菜生物量在根部和冠部间的分配无显著影响。相对叶绿素含量与nano-ZnO浓度呈显著负相关（r=-0.879,p<0.001）。在nano-ZnO质量比为160 mg/kg时，光合有效辐射190μmol/(m²·s)诱导的激发能过剩，但过剩激发能可通过热耗散保护机制消耗，以避免发生光损伤。酸性土壤条件下，弱光诱导的蕹菜叶绿素荧光参数对nano-ZnO长期暴露不敏感，但蕹菜的生物量累积易受nano-ZnO长期暴露的影响。     

Characterizing the generation and spatial patterns of carbon emissions from urban express delivery service in China

Express delivery services, as an indispensable part of our daily life, have grown rapidly because of the booming e-commerce and logistics industries. Accordingly, there is increasing concern about the environmental load from delivering letters and parcels, such as road freight transportation emissions and packaging waste, which have not been seriously considered in previous work. In this study, a spatially based dynamic model has been created to quantify the impacts (measured in carbon emissions, CO₂eq.) from the express delivery sector in China. Specifically, intracity (urban) express delivery services—delivery and pick-up services located within the same city—was chosen for analysis. The results indicated that the carbon emissions from the transportation phase of the express delivery sector in Chinese cities varied from 20 t to 4000 t in 2017, of which 18% was attributable to the weight of extra packaging materials. Carbon emission intensities for all cities showed a close relationship with their socioeconomic status. For example, the spatial pattern of intracity express delivery volumes and associated carbon emissions showed a significant clustering property: high-value cities were clustered in eastern China and low-value cities in western China. Furthermore, the carbon hotspots were mainly located in the Yangtze River Delta and Pearl River Delta urban agglomerations. Overall, our research method and preliminary findings could be helpful for the green development of the booming express delivery sector in China and beyond.     

Large eddy simulation and experimental study of the effect of wire mesh on flame behaviours of methane/air explosions in a semi-confined pipe

Preventing the propagation of flames in a pipeline is an effective measure for avoiding gas explosion accidents and reducing losses. To evaluate the effect of wire mesh, acting as a porous media, experimental and simulation studies are conducted to determine the influence of the wire mesh on the dynamics of premixed methane/air flame propagation in a semi-closed pipe. Four different kinds of wire mesh with different numbers of layers are chosen in the experiments and simulation, and the mechanism of wire mesh quenching of the flame is investigated. The experimental and simulation results are consistent. Flames are quenched when 4 layers of 40-mesh or 3 layers of 60-mesh wire mesh are used; however, once the flame propagates through the wire mesh, the risk of methane combustion may increase. The wire mesh becomes the key factor causing flame folds and acceleration, and the greater the number of layers or the larger the mesh size is, the more obvious the folds after the flame passes through the wire mesh. Moreover, the combination of heat absorption and disruption of the continuous flame surface by the mesh causes flame quenching. Wire mesh can effectively attenuate the flame temperature during premixed flame propagation in a pipe, and the attenuated maximum rate reaches approximately 79% in the case of adding 3 layers of 60-mesh wire mesh.     

侧向风速作用下聚氨酯泡沫双火源火蔓延研究

为探究环境风作用下逆向双点火源聚氨酯泡沫火蔓延及融合行为，开展多组对照实验并从材料传热机理角度分析侧向风速对火蔓延行为中火羽流形态、质量损失和辐射热流场等特征参数的影响。结果表明:风速与上述参数之间存在非线性关系。环境风效应使火焰被拉长且敷贴于预热区表面，增大预热区面积和热反馈；侧向风速的增加对FPU板材质量损失的影响逐渐弱化，且板材的熔滴率与风速呈正相关；无论侧向风是否存在，两侧逆向火焰融合后均达到整个蔓延过程中的峰值温度；风速的存在限制了火焰温度与辐射热通量峰值，也缩短了温度和辐射峰值出现的时间。     

Theoretical pressure prediction of confined hydrogen explosion considering flame instabilities

In order to ensure the safe utilization of hydrogen energy, the explosion pressure behavior is extremely important to design chemical equipment and evaluate explosion accident consequence. This paper is aimed at establishing a theoretical method of predicting explosion pressure behavior in the confined chamber by considering flame instabilities. The tendency of flame wrinkling factor in the pressure-buildup stage is firstly evaluated using large eddy simulation and the compensation theory. The limiting value of flame wrinkling factor during entire explosion process is calculated using the fractal theory. Finally, the dynamic model of flame wrinkling factor is implemented into the smooth flame model. The results demonstrated that the flame wrinkling factor in the pressure-buildup stage almost increases linearly with time. The limiting value of flame wrinkling factor is 2.4649. The explosion pressure will be underestimated using the smooth flame model, and the calculated explosion pressure in the isothermal condition is smaller than that in the adiabatic condition. When the fully turbulent flame is considered, the explosion pressure will be overpredicted significantly. By changing the confined chamber size, the explosion pressure could be reproduced relatively satisfactorily when the flame wrinkling factor is assumed to increase exponentially. The explosion pressure prediction must consider the effect of adiabatic compression and flame instabilities on burning rate.     

京津冀地区雾霾污染生态补偿标准研究

以京津冀地区雾霾污染作为研究对象,采用京津冀地区2006—2015年雾霾污染的空间面板数据,引入大气污染物减排成本模型,比较了京津冀各地区雾霾污染治理成本高低;继而基于机会成本法,核算了京津冀地区雾霾污染生态补偿标准.结果表明:河北省雾霾治理成本显著低于北京市和天津市,由河北省承担更多的雾霾污染治理任务,能使京津冀地区雾霾污染治理成本达到最小化;在京津冀地区联合治理雾霾污染过程中,河北省因限制工业增长对其经济发展带来负面影响,因此,北京市和天津市应给予河北省相应的生态补偿.最后依据研究结论提出完善区域联防联控机制的政策建议,如成立跨区域联合治理机构,健全雾霾污染生态补偿立法,设立雾霾污染生态补偿专项基金等,以此来促进京津冀地区雾霾污染生态补偿方案顺利实施.     

Effect of the vent burst pressure on explosion venting of rich methane-air mixtures in a cylindrical vessel

The effect of the vent burst pressure on explosion venting of a rich methane-air mixture was experimentally investigated in a small cylindrical vessel. The experimental results show that Helmholtz oscillation of the internal flame bubble of the methane-air mixture can occur in a vessel with a vent area much smaller than that reported by previous researchers, and the period of Helmholtz oscillation decreases slightly when the vent burst pressure increases. The maximum overpressure in the vessel increases approximately linearly with the increase in the vent burst pressure; however, the pressure peaks induced by Helmholtz oscillation always remain approximately several kilopascals. The external flame reaches its maximum length in a few milliseconds after vent failure and then oscillates in accordance with the pressure oscillation in the vessel. The maximum length of the external flame increases, but its duration time decreases with the increase in the vent burst pressure.