空气相对湿度对煤自燃特性的影响研究

为研究空气相对湿度对煤自燃特性的影响,运用自制空气湿度控制装置和程序升温试验台,通入湿度不同的空气,对砚石台矿煤样进行程序升温,测定不同温度下所产生气体的浓度,分析耗氧速率、CO和CO2产生率、放热强度以及自燃极限参数的变化规律。试验结果表明:低温氧化前期,煤体的耗氧速率、放热强度和CO产生率与空气相对湿度成正比。随着反应的进行,85%或32%的湿度均会对耗氧速率、放热强度和CO产生率产生一定的抑制作用;CO2产生率随空气相对湿度的增大先升高后降低,最小浮煤厚度和下限氧浓度随空气相对湿度的增大先减小后增大,上限漏风强度先增大后减小。增大空气相对湿度对煤低温氧化前期有促进作用,其自燃环境条件更易被满足,自燃危险性升高。     

石灰石-石膏湿法脱硫装置中影响脱硫效率的关键设计参数

本文针对石灰石-石膏湿法脱硫装置阐述了关键参数对工艺性能的影响,介绍了影响脱硫效率的液气比、浆液pH值、钙硫比、固体物停留时间等关键设计参数,并给出这些变量的典型设计范围,为同类型脱硫工程设计提供借鉴和参考。     

基于事故树分析的脚手架作业安全评价

为实现脚手架作业安全的系统性分析与评价,系统分析脚手架作业事故诱发机制,层层深入细化各影响因素,直至难以再细分的基本事件,确定相互之间的逻辑关系,建立脚手架事故树。在分析最小割集的基础上,采用专家调查法,给出各基本事件发生概率的经验估计,进而确定顶事件概率。在此基础上,通过敏感性分析,揭示基本事件对于顶事件的贡献程度。研究结果表明,脚手架作业事故发生的主要原因包括脚手架上有人、设计不合理、架设错误、材料不合格等,为保障作业安全,尤其需要加强作业人员在脚手架作业中的警惕性,注重脚手架设计理论计算,同时规范脚手架架设程序,选择合乎规格的脚手架材料。     

气象参数对基于BP神经网络的PM2.5日均值预报模型的影响

建立了基于BP神经网络的PM2.5质量浓度预报模型,对广州市5个监测点2012年6月-2013年5月的PM2.5质量浓度日均值进行预报,分析了总体预报误差、不同风速和降雨量下的预报误差,以及天气预报误差对PM2.5质量浓度预报误差的影响.结果表明,BP神经网络模型对5个站点的PM2.5预报结果稳定,平均相对误差为29.71％.在有利于PM2.5扩散的气象条件下预报误差较大,风速较大时与风速较小时预报误差的差异高达15％,而不同降雨量情况下的预报误差较相近.修正天气预报后,各站点的预报误差平均降低了4.67％.这表明可从空气质量数据质量等方面人手改进模型.     

微囊藻毒素对水稻幼苗生长与叶绿素荧光的影响

为明确被微囊藻毒素(MCs)污染的灌溉水对农业生产的潜在危害,采用水培法研究了不同浓度(1、100、1000、3000μg·L-1)MCs处理对胁迫期和恢复期内水稻叶片MCs积累量、叶绿素含量和叶绿素荧光参数的影响.结果表明,胁迫处理7 d后,MCs在叶片中的积累量随MCs处理浓度的增大而升高.与CK相比,1μg·L-1MCs处理组水稻叶片的各生长指标和叶绿素含量上升,F0下降,Fv/Fm、ETR、q P和q N均未发生显著变化;高浓度(≥100μg·L-1)处理下,水稻叶片的生长受抑制,叶绿素含量下降,F0上升,Fv/Fm、ETR、q P和q N显著下降.恢复7 d后各处理组水稻叶片MCs的积累量均低于胁迫期,100μg·L-1MCs处理组的F0、q N均接近CK,Fv/Fm、ETR和q P虽低于CK却高于胁迫期,表明MCs对光合系统的伤害有一定程度的恢复.1000和3000μg·L-1MCs处理组的F0依然高于CK,且Fv/Fm、ETR、q P和q N不仅低于CK也低于胁迫期,表明高浓度MCs(≥1000μg·L-1)降低了水稻叶片PSⅡ原初光能转换效率和PSⅡ潜在活性,对叶片光合功能造成不可逆的伤害.     

Zebrafish as a possible bioindicator of organic pollutants with effects on reproduction in drinking waters

Organic contaminants can be detected at low concentrations in drinking water, raising concerns for human health, particularly in reproduction. In this respect, we attempted to use the zebrafish as a bioindicator to detect the possible presence of these substances in drinking water, aiming to define the most relevant parameters to detect these substances, which particularly affect the development and reproduction of zebrafish. To this end, batches of 30 embryos with the chorion intact were cultured in drinking waters from different sources, throughout their full life-cycle up to 5 months, in 20 L tanks. Six replicates were performed in all water groups, with a total of 24 aquariums. Two generations (F0 and F1) were studied and the following parameters were tested: in the F0 generation, survival and abnormality rates evaluated at 5 dpf (days post-fertilization) and at 5 mpf (months post-fertilization), the onset of spawning and the fertility rate from 3 mpf to 5 mpf, and the sex ratio and underdeveloped specimens at 5 mpf. Furthermore, in the F0 offspring (F1), survival and abnormality rates were evaluated at 5 dpf and the hatching rate at 72 hpf. These results revealed that the hatching rate is the most sensitive parameter to distinguish different levels of effects between waters during the early life stages, whereas the rate of underdeveloped specimens is more suitable at later life stages. Regarding adult reproduction, fertility rate was the most sensitive parameter. The possible reversibility or accumulative nature of such effects will be studied in future work.     

Safety and kinetic parameters analysis for 1,1,-Di(tert-butylperoxy) cyclohexane mixed with monoammonium phosphate

Runaway reactions by organic peroxides have occurred throughout the world. In this study, we used 1,1,-Di(tert-butylperoxy) cyclohexane (CH) 70 mass% as the main material, which was extensively employed as initiator for styrene in polymerization. Fire extinguishers are the first fire-fighting apparatus when fires occur. If a fire extinguisher has sat idle for a long time, which would cause the extinguishing agent to damp, it cannot achieve the desired effect and be properly handled at the start of the accident, thereby causing more casualties and property losses. CH 70 mass% was employed to mixed with monoammonium phosphate (MAP) for understanding the phenomenon by applying differential scanning calorimetry (DSC). Safety parameters also were carried out for more deeply understanding the basic characteristics for preventing an accident from occurring, in terms of applying CH 70 mass% as the initiator in the manufacturing process.     

Study of the explosion parameters of vapor–liquid diethyl ether/air mixtures

The knowledge of the vapor–liquid two-phase diethyl ether (DEE)/air mixtures (mist) on the explosion parameters was an important basis of accident prevention. Two sets of vapor–liquid two-phase DEE/air mixtures of various concentrations were obtained with Sauter mean diameters of 12.89 and 22.90 μm. Experiments were conducted on vapor–liquid two-phase DEE/air mixtures of various concentrations at an ignition energy of 40.32 J and at an initial room temperature and pressure of 21 °C and 0.10 MPa, respectively. The effects of the concentration and particle size of DEE on the explosion pressure, the explosion temperature, and the lower and upper flammability limits were analyzed. Finally, a series of experiments was conducted on vapor–liquid two-phase DEE/air mixtures of various concentrations at various ignition energies. The minimum ignition energies were determined, and the results were discussed. The results were also compared against our previous work on the explosion characteristics of vapor–liquid two-phase n-hexane/air mixtures.     

基于空间故障树理论的系统可靠性评估方法研究

为了研究可靠性对工作环境变化敏感的一类系统,利用空间故障树SFT的思想和方法,并结合T-S模糊故障树和贝叶斯网络,建立了一种系统可靠性评估方法。总结了T-S模糊故障树和BN网络评价系统可靠性时存在的问题,并在所提出的方法中予以解决。方法中将事件的故障状态划分为:无故障a、轻度故障b、严重故障c、完全故障d四种状态,分别用a,b,c,d表示。故障率为[0~30%)、[30%~60%)、[60%~85%)、[85%~100%),并得到了划分的规则。研究了该系统在不同故障状态下的有效范围。得到了系统在不同状态之间过渡时的特征,并分析了过渡期间的可靠性对因素敏感度问题。