流动注射分光光度法测定水中铝的含量

以桑色素作显色剂，采用流动注射分光光度法测定水中铝的含量。在桑色素质量浓度为0．8g／L、聚氧乙烯辛基苯基醚体积分数为1．0％、进样环体积为400μL、检测波长420nm的条件下，采用流动注射分光光度法对水中铝的含量进行测定，本方法的线性范围为2～300μg／L，检出限（信噪比为3）为0．124μg／L，相对标准偏差为2．9％，加标回收率为96．4％～101．8％。     

轨道交通运行引起的场地振动试验研究

轨道交通运行引起的环境振动问题,已成为土木工程界关注的一个新的课题。对南京市栖霞镇某场地进行了列车振动现场试验,得到了不同列车车型与车速下的地面振动速度时程曲线,给出了地面振动速度的频谱特性和衰减规律,分析了列车运行引起的环境振动的传递路径,为进一步研究轨道交通振动控制提供了参考。     

交通事故再现技术研究现状与发展趋势

道路交通事故再现不仅是交通事故责任鉴定和原因分析的重要方法,也是交通事故防治的重要内容。在详细介绍国内外事故再现计算机仿真技术的基础上,分析目前事故再现系统开发中事故现场数据采集技术、碰撞前后速度估算的技术、碰撞过程进行模拟的虚拟现实技术的研究现状与存在的问题,提出进一步优化的方向,进而达到完善交通事故模拟再现的目的。最后指出我国交通事故再现技术进一步研究的内容和发展趋势。     

Determination of turbulent burning velocities of dust air mixtures with the open tube method

Correlating turbulent burning velocity to turbulence intensity and basic flame parameters-like laminar burning velocity for dust air mixtures is not only a scientific challenge but also of practical importance for the modelling of dust flame propagation in industrial facilities and choice of adequate safety strategy. The open tube method has been implemented to measure laminar and turbulent burning velocities at laboratory scale for turbulence intensities in the range of a few m/s. Special care has been given to the experimental technique so that a direct access to the desired parameters was possible minimising interpretation difficulties. In particular, the flame is propagating freely, the flame velocity is directly accessible by visualisation and the turbulence intensity is measured at the flame front during flame propagation with special aerodynamic probes. In the present paper, those achievements are briefly recalled. In addition, a complete set of experiments for diametrically opposed dusts, starch and aluminium, has been performed and is presented hereafter. The experimental data, measured for potato dust air mixtures seem to be in accordance with the Bray Gülder model in the range of 1.5 m/s<u′<3.5 m/s. For a further confirmation, the measurement range has been extended to lower levels of turbulence of u′<1.5 m/s. This could be achieved by changing the mode of preparation of the dust air mixture. In former tests, the particles have been injected into the tube from a pressurised dust reservoir; for the lower turbulence range, the particles have been inserted into the tube from above by means of a sieve–riddler system, and the turbulence generated from the pressurised gas reservoir as before. For higher levels of turbulence, aluminium air mixtures have been investigated using the particle injection mode with pressurised dust reservoir. Due to high burning rates much higher flame speeds than for potato dusts of up to 23 m/s have been obtained.     

新疆油田抽汲排液污染控制研究

抽汲排液存在抽汲设备和工具密封性差,对井场环境污染比较严重的问题,为解决抽汲排液对井场造成的污染,分别对抽汲钢丝绳的选择、试油井口防喷盒的密封以及试油抽汲作业规程及其它方面作了研究和应用,使抽汲排液对井场造成的污染得到了较好控制,符合新疆油田创建"绿色油气田"的要求。     

集中排烟公路隧道入口段火灾下诱导风速研究

为研究集中排烟模式下公路隧道入口段发生火灾时的合理诱导风速,以某公路隧道为背景,运用火灾动力学模拟软件FDS对隧道人口段火灾时不同坡度、不同诱导风速的16组火灾工况进行模拟研究,通过对各工况下隧道内的温度场分布及烟气控制效果模拟结果的分析,得到了各工况下的合理诱导风速,研究结果可为公路隧道集中排烟系统关键设计参数提供参考.     

卧式电除尘器电晕极优化实验研究

运用粉尘粒子荷电原理,对四种电晕极的主要技术性能进行了试验研究,探讨了卧式电除尘器的最佳极配形式。     

Description and evaluation of a model of deposition velocities for routine estimates of dry deposition over North America. Part II: review of past measurements and model results

Numerical sensitivity tests and four months of complete model runs have been conducted for the Routine Deposition Model (RDM). The influence of individual model inputs on dry deposition velocity as a function of land-use category (LUC) and pollutant (SO₂, O₃, SO²⁻₄ and HNO₃) were examined over a realistic range of values for solar radiation, stability and wind speed. Spatial and temporal variations in RDM deposition velocity (V_d) during June – September 1996 time period generated using meteorological input from a mesoscale model run at 35 km resolution over north-eastern North America were also examined. Comparison of RDM V_d values to a variety of measurements of dry deposition velocities of SO₂, O₃, SO²⁻₄ and NHO₃ that have been reported in the literature demonstrated that RDM produces realistic results. Over northeastern NA RDM monthly averaged dry deposition velocities for SO₂ vary from 0.2 to 3.0 cm s⁻¹ with the highest deposition velocities over water surfaces. For O₃, the monthly averaged dry deposition velocities are from 0.05 to 1.0 cm s⁻¹ with the lowest values over water surfaces and the highest over forested areas. For HNO₃, the monthly averaged dry deposition velocities have the range of 0.5 to 6 cm s⁻¹, with the highest values for forested areas. For SO²⁻₄, they range from 0.05–1.5 cm s⁻¹, with the lowest values over water and the highest over forest. The monthly averaged dry deposition velocities for SO₂ and O₃ are higher in the growing season compared to the fall, but this behaviour is not apparent for HNO₃ and sulphate. In the daytime, the hourly averaged dry deposition velocities for SO₂, O₃, SO²⁻₄ and HNO₃ are higher than that in the nighttime over most of the vegetated area. The diurnal variation is most evident for surfaces with large values for leaf area index (LAI), such as forests. Based on the results presented in this paper, it is concluded that RDM V_d values can be combined with measured air concentrations over hourly, daily or weekly periods to determine dry deposition amounts and with wet deposition measurements to provide seasonal estimates of total deposition and estimates of the relative importance of dry deposition.     

Fractionation of plutonium in environmental and bio-shielding concrete samples using dynamic sequential extraction

Fractionation of plutonium isotopes (²³⁸Pu, ^239,240Pu) in environmental samples (i.e. soil and sediment) and bio-shielding concrete from decommissioning of nuclear reactor were carried out by dynamic sequential extraction using an on-line sequential injection (SI) system combined with a specially designed extraction column. Plutonium in the fractions from the sequential extraction was separated by ion exchange chromatography and measured using alpha spectrometry. The analytical results show a higher mobility of plutonium in bio-shielding concrete, which means attention should be paid to the treatment and disposal of nuclear waste from decommissioning.     

水动力条件下蓝藻水华生消的模拟实验研究与探讨

蓝藻水华是当今世界共同面临的重大水污染问题之一。通过室内模拟实验,在温度、光照、初始pH值和营养盐等基本条件相同的前提下模拟水流流速分别为10cm/s、20cm/s、30cm/s、40cm/s时铜绿微囊藻(Microcystis aeruginosa)水华的产生与消亡过程,在10～40cm/s流速区间里藻类生长周期随流速增大而变长,藻类最大现存量在40cm/s流速下最大,在10cm/s流速下最小,流速为30cm/s时藻类比增率最大,较适合藻类生存,在整个水华暴发过程中水体氮磷营养浓度呈下降趋势,水体的pH、DO和Ec变化不大。