二维平流扩散模型下的集合卡尔曼滤波模拟同化研究

为提高环境数值预报水平,构建了一个针对污染物扩散的模拟数据同化系统。采用集合卡尔曼滤波方法对二维平流扩散模型的状态变量进行了实时校正,实现污染物浓度的实时模拟预报,完成了敏感性实验中集合数目变化、观测方差变化和同化窗口长度变化研究。比较考察观测点位置与污染源距离不同时的预报效果,探讨了优化条件下的同化策略,提出一种根据距离远近动态调节卡尔曼增益权重的方法。在集合数目较小时,可降低计算代价,得到优化的同化效果。     

Metabolic uncoupler, 3,3′,4′,5-tetrachlorosalicylanilide addition for sludge reduction and fouling control in a gravity-driven membrane bioreactor

• Effects of metabolic uncoupler TCS on the performances of GDMBR were evaluated. • Sludge EPS reduced and transformed into dissolved SMP when TCS was added. • Appropriate TCS increased the permeability and reduced cake layer fouling. • High dosage aggravated fouling due to compact cake layer with low bio-activity. The gravity-driven membrane bioreactor (MBR)system is promising for decentralized sewage treatment because of its low energy consumption and maintenance requirements. However, the growing sludge not only increases membrane fouling, but also augments operational complexities (sludge discharge). We added the metabolic uncoupler 3,3′,4′,5-tetrachlorosalicylanilide (TCS) to the system to deal with the mentioned issues. Based on the results, TCS addition effectively decreased sludge ATP and sludge yield (reduced by 50%). Extracellular polymeric substances (EPS; proteins and polysaccharides) decreased with the addition of TCS and were transformed into dissolved soluble microbial products (SMPs) in the bulk solution, leading to the break of sludge flocs into small fragments. Permeability was increased by more than two times, reaching 60–70 L/m²/h bar when 10–30 mg/L TCS were added, because of the reduced suspended sludge and the formation of a thin cake layer with low EPS levels. Resistance analyses confirmed that appropriate dosages of TCS primarily decreased the cake layer and hydraulically reversible resistances. Permeability decreased at high dosage (50 mg/L) due to the release of excess sludge fragments and SMP into the supernatant, with a thin but more compact fouling layer with low bioactivity developing on the membrane surface, causing higher cake layer and pore blocking resistances. Our study provides a fundamental understanding of how a metabolic uncoupler affects the sludge and bio-fouling layers at different dosages, with practical relevance for in situ sludge reduction and membrane fouling alleviation in MBR systems.     

游泳池中隐孢子虫卵囊替代物的去除

隐孢子虫是常见的球状寄生虫。接触含有隐孢子虫卵囊的水体可致隐孢子虫病,主要的临床表现为腹泻,严重者可致死。游泳池是主要的传播场所。采用容积为5 500 L的游泳池,进行隐孢子虫卵囊替代物的修复模拟实验,研究在游泳池条件下絮凝沙滤技术对直径为4.5μm隐孢子虫卵囊替代物的去除效果。实验结果表明,氯化铝剂量为0.1 mg/L,沙滤料高度为30 cm,内循环流速为11.5 L/min,对隐孢子虫卵囊替代物去除率在90%以上。该技术对浊度具有较好的处理效果,当进水浊度降低且接近于出水浊度时,系统进入稳定运行阶段,对虫卵囊替代物去除率可以达到96%。     

膜电解技术处理含氯及重金属的废酸

采用离子交换膜电解技术处理铜冶炼过程产生的含氯及重金属的废酸。考察了废酸处理工艺、电解温度、电解时间、电流密度和催化剂的添加等条件对处理效果的影响。实验结果表明：采用先沉淀重金属后脱氯的废酸处理工艺，氯离子和铜离子的去除效果均较好;当以钛盐为催化剂时，在电解温度为40 ℃、电解时间为2.0 h、电流密度为825 A/m²的最佳工艺条件下，处理后废酸中的氯离子质量浓度为0.22 g/L，氯离子去除率为98.59%，铜离子质量浓度为0.45 g/L，铜离子去除率为95.08%，其他重金属大部分也得到有效去除。净化后的废酸可回用至铜冶炼的生产过程中。     

膜电解法退镀废ABS电镀件及回收铜和镍

采用膜电解法对废丙烯腈-丁二烯-苯乙烯（ABS）电镀件进行退镀处理。以退镀废液作为阴极液和阳极液，在阳极室退镀ABS电镀件，在阴极室电解退镀废液，进行铜镍分离，回收铜粉和NiCl₂。实验结果表明：在阴极电流密度为500 A/m²、初始铜离子质量浓度为24.00 g/L的条件下电解160 min，阴极铜回收率可达97.65%，电流效率达86.60%，得到的铜粉纯度为97%~99%，处理1 L退镀废液可回收铜粉20.0 g，2 mol/L盐酸0.87 L，NiCl₂晶体43.8 g;在阳极电流密度为500 A/m²、液固比为6的条件下电解60 min， ABS电镀件的退镀率为77.22%。     

共代谢膜生物反应器法处理二甲基亚砜废水

采用蔗糖作为共代谢基质与一体式好氧膜生物反应器（MBR）工艺相结合处理二甲基亚砜（DMSO）废水。考察了装置的污泥驯化效果、DMSO去除率、污泥的性能、HRT和冲击负荷对DMSO去除率的影响。试验结果表明：驯化第29天，DMSO去除率达98.5%，表明MBR内的污泥已驯化成功；在MBR运行的正式期，当DMSO处于高负荷状态时，DMSO去除率较低；随蔗糖加入量的增加，DMSO去除率逐渐提高，最终恢复到DMSO高负荷冲击前的DMSO去除效果；正常运行时，装置进水ρ（DMSO）=257~1 448 mg/L（平均值为718 mg/L）、出水ρ（DMSO）=6~22 mg/L（平均值为7 mg/L），DMSO去除率为96.4%~99.6%（平均值为98.9%）；在MBR运行的正式期，污泥体积指数小于100 mL/g，表明污泥的沉降性能较好，MLVSS/MLSS较高，表明污泥的活性高，MBR内MLSS的平均值为5.52 g/L，MLVSS的平均值为4.78 g/L；MBR适宜的HRT为12 h。     

烟气同时脱硫脱氮生物膜填料塔的适用外加碳源

实验分别考察了外加乙酸钠、葡萄糖、酒石酸钾钠、甲醇等4种低分子有机碳源对生物膜填料塔烟气同时脱硫脱氮效率的影响。结果表明,外加乙酸钠的脱氮效果最佳,对NOx的平均去除率为62.05%;外加葡萄糖、酒石酸钾钠、甲醇时的NOx平均去除率分别为51.03%、46.98%、58.71%。乙酸钠、酒石酸钾钠、甲醇均能使SO2的去除率达到100%,葡萄糖显著降低了SO2的去除率。乙酸钠是在生物膜填料塔烟气同时脱硫脱氮技术中适宜的外加碳源。     

好氧颗粒污泥自生动态膜生物反应器处理碱减量印染废水

自生动态膜生物反应器(SFDMBR)接种颗粒污泥启动,研究溶解氧浓度和水力停留时间对该反应器处理碱减量印染废水的影响。自生动态膜生物反应器形成稳定的动态膜后,出水浊度小于10 NTU,系统对浊度的去除率在90%以上,溶解氧和水力停留时间对反应器出水浊度基本无影响。系统对废水色度的去除率随着溶解氧浓度的提高和水力停留时间的延长而增加,但是系统对色度的去除效率一般不超过40%。溶解氧浓度由0.3 mg/L逐渐增大至2.4 mg/L,COD的去除率由40%提升至80%,而当溶解氧浓度大于1.0 mg/L后,UV254的去除率达到95%。水力停留时间在8~48 h时,COD去除效率由65%逐渐上升至85%左右;水力停留时间在8~32 h,UV254去除效率为68%~93%,超过32 h后水力停留时间对UV254去除效率的影响已不明显。     

MBR在橡胶废水处理中的应用

橡胶废水具有含盐量高、色度高、有机污染成分含量高且难于生化降解等特点。膜生物反应器(MBR)技术的核心是生化处理加微滤膜过滤,通过将MBR技术应用于橡胶废水处理的实践表明,该技术对COD、氨氮、磷酸盐的平均去除率都达到了85%以上,再辅之以药剂处理后,降低了色度和难降解有机物含量,出水水质完全符合排放标准的要求,是一种解决橡胶污水处理难题的有效途径。     

Review of Pesticide Retention Processes Occurring in Buffer Strips Receiving Agricultural Runoff1

Arora, Kapil, Steven K. Mickelson, Matthew J. Helmers, and James L. Baker, 2010. Review of Pesticide Retention Processes Occurring in Buffer Strips Receiving Agricultural Runoff. Journal of the American Water Resources Association (JAWRA) 46(3):618-647. DOI: 10.1111/j.1752-1688.2010.00438.x Abstract: Review of the published results shows that the retention of the two pesticide carrier phases (runoff volume and sediment mass) influences pesticide mass transport through buffer strips. Data averaged across different studies showed that the buffer strips retained 45% of runoff volume (ranging between 0 and 100%) and 76% of sediment mass (ranging between 2 and 100%). Sorption (soil sorption coefficient, K_oc) is one key pesticide property affecting its transport with the two carrier phases through buffer strips. Data from different studies for pesticide mass retention for weakly (K_oc < 100), moderately (100 < K_oc < 1,000), and strongly sorbed pesticides (K_oc > 1,000) averaged (with ranges) 61 (0-100), 63 (0-100), and 76 (53-100) %, respectively. Because there are more data for runoff volume and sediment mass retention, the average retentions of both carrier phases were used to calculate that the buffer strips would retain 45% of weakly to moderately sorbed and 70% of strongly sorbed pesticides on an average basis. As pesticide mass retention presented is only an average across several studies with different experimental setups, the application of these results to actual field conditions should be carefully examined.