Influence of osmotic distillation on membrane absorption for the treatment of high strength ammonia wastewater

Osmotic distillation (OD) was found to be a coupled process in membrane absorption (MA) for the treatment of high strength ammonia wastewater. As a result, ammonia could not be concentrated in absorption solution(AS) as expected. The inhibition of the coupled OD in MA process was investigated as well as various factors affecting the inhibition. The results indicated that the coupled OD can be effectively inhibited by heating concentrated solution and cooling dilute solution. It was also found that experimental minimum inhibition temperature difference(MITD) between concentrated and dilute solutions was different when using polyvinylidene fluoride(PVDF) and polypropylene(PP) membranes respectively, which could be ascribed to material properties, such as OD and membrane distillation (MD) coefficients of the membranes. Experimental MITDs were found to be higher than theoretical MITDs which were calculated using a simplified method.     

用水解酸化池-膜生物反应器处理活性艳红X-3B废水

采用水解酸化池-膜生物反应器处理含活性艳红X-3B的模拟废水，研究了水力停留时间（HRT）对水解酸化池废水处理效果的影响，考察了水解酸化池-膜生物反应器对废水的处理效果及膜生物反应器中污泥沉降性能对膜污染的影响。实验结果表明：水解酸化池HRT为16h时，废水的可生化性最好，挥发性脂肪酸质量浓度与COD比值为0．5；HRT为17h时，废水脱色率达69％，而COD的去除率受HRT影响较小；膜生物反应器主要起去除废水中COD的作用；水解酸化池-膜生物反应器处理后废水的脱色率和COD去除率分别为83％和97％；膜生物反应器中活性污泥沉降性能的变化直接影响膜污染的速率。     

铁阳极电凝聚处理活性黑KN-B染料废水

对铁阳极电凝聚处理活性黑KN-B染料废水过程进行了实验研究.考察了电流密度、染料溶液初始pH值、电介质浓度及种类、温度、染料浓度等因素对脱色效率的影响.结果表明,在一定实验条件下,活性黑KN-B模拟废水的脱色效率达93%;电流强度、染料浓度、电解液初始pH值及电解质的种类对染料溶液脱色效率影响显著,电解液温度、电解质的浓度对脱色效率的影响不明显;以铁为阳极的原位电凝聚处理活性黑KN-B模拟废水混凝过程中主要作用机理以吸附电性中和为主;电凝聚过程中活性黑KN-B在阴极上发生了还原反应.     

腐殖酸与典型碳纳米材料协同光致产生活性氧物种的研究

采用电子自旋共振光谱(EPR)技术,分析腐殖酸在光照下对4种典型碳纳米材料诱导产生单线态氧(~1O_2)和羟基自由基(·OH)的影响。基于密度泛函理论计算4种典型碳纳米材料的前线轨道能,比较了它们分别经能量转移诱导产生~1O_2的能力以及经电子传递诱导产生·OH的能力。结果显示,4种不同形状的碳纳米材料(富勒烯、单壁碳纳米管、多壁碳纳米管以及石墨烯)悬浮液在紫外光照下均无~1O_2和·OH产生。与腐殖酸共同存在下,4种碳纳米材料均显著诱导~1O_2的产生,且富勒烯和石墨烯还能光致生成·OH。协同产生~1_O2的能力大小为:单壁碳纳米管富勒烯多壁碳纳米管石墨烯,协同产生·OH的能力大小为:石墨烯富勒烯。~1O_2的产生能力与碳纳米材料的能隙大小和颗粒聚集程度有关,而诱导产生·OH的能力主要取决于化学硬度。总之,我们的研究表明腐殖酸与碳纳米颗粒可协同产生活性氧物种。     

Fe-Mn-sepiolite as an effective heterogeneous Fenton-like catalyst for the decolorization of reactive brilliant blue

A study of the decolorization of reactive brilliant blue in an aqueous solution using Fe-Mn-sepiolite as a heterogeneous Fenton-like catalyst has been performed. The Fourier transform infrared (FTIR) spectra of the catalyst showed bending vibrations of the Fe-O. The X-ray diffraction (XRD) patterns of the catalyst showed characteristic diffraction peaks of α-Fe₂O₃, γ-Fe₂O₃ and MnO. A four factor central composite design (CCD) coupled with response surface methodology (RSM) was applied to evaluate and optimize the important variables (catalyst addition, hydrogen peroxide dosage, initial pH value and initial dye concentration). When the reaction conditions were catalyst dosage= 0.4 g, [H₂O₂]= 0.3 mL, pH= 2.5, [reactive brilliant blue]_o = 50 mg·L⁻¹, and volume of solution= 500 mL at room temperature, the decolorization efficiency of reactive brilliant blue was 91.98% within 60 min. Moreover, the Fe-Mn-sepiolite catalyst had good stability for the degradation of reactive brilliant blue even after six cycles. Leaching of iron ions (<0.4 mg·L⁻¹) was observed. The decoloring process was reactive brilliant blue specific via a redox reaction. The benzene ring and naphthalene ring were first oxidized to open ring; these were then oxidized to the alcohol and carboxylic acid. The reactive brilliant blue was decomposed mainly by the attack of ·OH radicals including surface-bound ·OH radicals generated on the catalyst surface.     

Validation of the UN test method N.5

Many substances react with water in such a way that flammable gases are formed. For transport issues this reaction may possess a considerable hazard especially if the cargo is wetted by rain or by water from other sources. In the UN Recommendations on the Transport of Dangerous Goods these kinds of problems are addressed. The UN test N.5 “Test method for substances which in contact with water emit flammable gases” corresponds to this hazard. Classification according to the test method is done by measurement of the gas evolution rate of the flammable gas by any suitable procedure. At BAM a gravimetric approach is used to measure the gas evolution rate. In this paper we present the evaluation of the apparatus by means of an absolute calibration routine utilizing a reaction where a known amount of gas is produced as well as the evaluation of important parameters influencing the gas evolution rate using different substances. It can be shown that the apparatus is capable of measuring absolute gas volumes as low as 6 mL with an acceptable error of about 17% as determined from the reaction of Mg with demineralized water.     

采用TSF技术改善电力变压器运行的安全性

分析了无功功率和高次谐波对电力变压器的危害,介绍了晶闸管投切滤波器(TSF)装置的特点、结构原理．提出了TSF装置在工厂实际应用中的主电路结构,操作及控制方案。实践证明,TSF晶闸管投切滤波器装置起到了高效节能、优化电能质量的作用,保证了电网的安全运行。     

轧钢污泥综合利用的技术研究

阐述了一种轧钢污泥的回收处理技术,该技术可把轧钢污泥有效地分离成氧化铁粉和混合油,实现综合利用,减少铁素资源浪费,有良好的经济效益和环境效益.     

零价铁PRB技术在地下水原位修复中的研究进展

PRB(可渗透反应墙)是地下水治理中新型的原位修复技术,具有成本低、处理效果好、对环境干扰小等优点,已逐渐应用到实际. 原位修复技术中PRB根据结构的不同可分为单处理系统PRB和多单元处理系统PRB,单处理系统PRB适用于单一污染物、污染浓度较低、污染羽规模较小的场地,多单元系统用于污染场地较复杂、污染种类较多的场地. 零价铁PRB去除地下水中无机污染物及有机组分的反应机理主要是氧化还原反应和还原性脱卤反应. 实际场地PRB的运行中存在的主要问题是零价铁钝化及PRB堵塞,现阶段的解决方法主要包括超声、电化学等,但为了提高PRB技术的实用性,铁材料的解钝化技术、实际场地PRB的设计与安装、PRB体系的长期运行及服务期满后的处置均需进一步的研究探索.      

四氨基钴酞菁催化产生活性氧的性能

四氨基钴酞菁作为一种有前途的可见光催化剂,可光敏化为三线态,与溶液中的O2反应产生活性氧.实验考察了反应过程中的光照时间、光敏剂质量、光照强度和pH等4个因素对活性氧产生的影响,同时确定了一种简单可行的检测方法:活性氧与卡巴肼(DPCI)反应,生成卡巴腙(DPCO),以苯-四氯化碳萃取,在563 nm处测其吸光度,从而表示出活性氧的相对产量.实验优化了四氨基钴酞菁催化产生活性氧的条件:于50 mL的溶液中,光照时间为25 min,光敏剂质量为5 mg,光照强度为60 W,pH值为4.同时证明了在反应体系中生成了自由基和单线态氧等活性氧,并且对光催化产生活性氧的机理进行了探讨.