生物活性炭去除水中挥发性苯系物的基础研究

采用连续流生物活性炭(BAC)工艺处理水中挥发性苯系物(BTEX,包括苯、甲苯、乙苯、二甲苯),评价进水负荷、活性炭炭型等因素对于BAC处理性能的影响.研究表明,在40d的处理时间内,除苯之外,其余BTEX的BAC出水中均未检出苯系物(进水为6mg/L).为了检验BAC在高BTEX负荷情况时的处理效果,将进水浓度设定为19~32mg/L左右,在EBCT为1.2min条件下同样只有苯的出水浓度上升至10mg/L(C/Cin为0.45),然后略有下降,最终保持在5~10mg/L(C/Cin为0.3以下),其余苯系物出水浓度均一直保持小于5mg/L.这表明BAC可以有效地处理高负荷BTEX(8.68~12.9kgTOC/(m3·d))的进水.生物活性炭对于活性炭吸附容量的恢复有比较明显的作用,煤质炭和椰壳炭的生物再生效率分别为53.6%和26.6%,煤质炭再生效率高的原因可能是其具备更多的大型中孔和大孔.     

曝气调节-水解酸化-生物接触氧化工艺处理城镇生活污水

介绍了采用曝气调节-水解酸化-两级生物接触氧化为主的工艺处理城镇生活污水的工程实例。经过调试运行,污水处理系统运行稳定,工艺运行成本低,污染物处理效果好。其中COD、BOD5、SS与氨氮去除率均在85%以上,出水水质优于GB 8978-1996《污水综合排放标准》一级排放标准。     

垃圾渗滤液的膜生物反应器与传统生物工艺述评

采用文献调研法比较评价了膜生物反应器与传统生物工艺对垃圾渗滤液的处理效果。结果表明,渗滤液的水质特征(主要指COD)主要由渗滤液年龄决定,B/C值和渗滤液年龄对COD去除有重要影响。传统生物处理常采用多级组合工艺,渗滤液特性、工艺单元数、水力停留时间和有机负荷率等是影响COD去除的重要参数。近年来,MBR工艺的应用日益广泛,对于B/C值较低的老龄渗滤液,MBR工艺可获得更好的COD去除效果,也有利于废水的膜深度处理。     

焦化废水处理工程调试运行研究

针对焦化废水处理调试运行存在的问题,以实际运行中的焦化废水处理工程为例,介绍了其调试运行过程.指出焦化废水调试及稳定运行的控制要点,并提出调试运行过程中可能出现的问题及解决措施,为同类废水的调试和运行提供参考.     

Removal of phosphate by Fe-coordinated amino-functionalized 3D mesoporous silicates hybrid materials

Phosphate removal from aqueous waste streams is an important approach to control the eutrophication downstream bodies of water. A Fe(III) coordinated amino-functionalized silicate adsorbent for phosphate adsorption was synthesized by a post-grafting and metal cation incorporation process. The surface structure of the adsorbent was characterized by X-ray di raction, N2 adsoropion/desoprotion technique, and Fourier transform infrared spectroscopy. The experimental results showed that the adsorption equilibrium data were well fitted to the Langmuir equation. The maximum adsorption capacity of the modified silicate material was 51.8 mg/g. The kinetic data from the adsorption of phosphate were fitted to pseudo second-order model. The phosphate adsorption was highly pH dependent and the relatively high removal of phosphate fell within the pH range 3.0–6.0. The coexistence of other anions in solutions has an adverse e ect on phosphate adsorption; a decrease in adsorption capacity followed the order of exogenous anions: F?? > SO2?? 4 > NO??3 > Cl??. In addition, the adsorbed phosphate could be desorbed by NaOH solutions. This silicate adsorbent with a large adsorption capacity and relatively high selectivity could be utilized for the removal of phosphate from aqueous waste streams or in aquatic environment.     

Remediation of copper polluted red soils with clay materials

Attapulgite and montmorillonite were utilized to remediate heavy metal polluted red soils in Guixi City, Jiangxi Province, China. The e ects of clay minerals on availability, chemical distribution, and biotoxicity of Cu and Zn were evaluated. The results provided a reference for the rational application of clay materials to remediate heavy metal contaminated soils. From the sorption experiment, the maximum adsorbed Cu2+ by attapulgite and montmorillonite was 1501 and 3741 mg/kg, respectively. After polluted red soil was amended with attapulgite or montmorillonite and cultured at 30 and 60 days, soil pH increased significantly compared to the control. An 8% increase in the amount of montmorillonite in soil and 30 days incubation decreased acid exchangeable Cu by 24.7% compared to the control red soil. Acid exchangeable Cu decreased with increasing amounts of attapulgite and montmorillonite, with best remediation e ect reached at a dose of 8%. Results also showed that the Cu poisoning e ect on earthworms was reduced with the addition of attapulgite and montmorillonite. Montmorillonite showed the best e ect, with the addition of a 2% dose the mortality of earthworms decreased from 60% to zero compared to the control. Our results indicated that the bioavailability of Cu in soils was reduced more e ectively with the application of montmorillonite than attapulgite.     

Resistance and biosorption mechanism of silver ions by Bacillus cereus biomass

Biosorption of silver ions onto Bacillus cereus biomass was investigated. Overall kinetic experiments were performed for the determination of the necessary contact time for the attainment of equilibrium. It was found that the overall biosorption process was best described by pseudo second-order kinetic model. The crystals detected by scanning electron microscope and X-ray photoelectron spectroscopy suggested the precipitation was a possible mechanism of biosorption. The molecular genetics of silver resistance of B. cereus biomass was also detected and illustrated by a whole cell sensor tool.     

Effect of chromium on accumulation and antioxidants in Cucumis utillissimus L.: Response under enhanced bioavailability condition

This study compares the accumulation of Cr(VI) and biochemical changes (total chlorophyll, carotenoid, protein, malondialdehyde (MDA) and cysteine contents) and roles of antioxidant enzymes (superoxide dismutase (SOD), guaiacol peroxidase (GPX), ascorbate peroxidase (APX)) in tolerance to metal induced stress in Cucumis utillissimus L. grown in Cr contaminated soil (CS) with garden soil (GS). Furthermore, Cr bioavailability was enhanced by ethylene diamine tetra-acetic acid (EDTA) addition to the soil to forecast the plant’s accumulation pattern at elevated Cr environment. Accumulation of Cr in the leaves of the plant increased with increase in substrate metals concentration. It further increased with the addition of EDTA by 1437% and 487% in GS and CS, respectively at the highest treatment level. The lipid peroxidation increased proportionately with increase in Cr accumulation in the leaves. All the activity of antioxidant enzymes (SOD, GPX and APX) and the level of cysteine increased with dose dependant manner. SOD and cysteine were observed to be higher in the GS than in CS, but APX and GPX were found to be higher in CS than in GS. The increase in GPX and APX activities with the increase in Cr concentration could be assumed that these two enzymes have a major role in the defense mechanism towards stress induced by Cr in C. utillissimus.     

Methanotrophic community structure of aged refuse and its capability for methane bio-oxidation

Aged refuse from waste landfills closed for eight years was examined and found to contain rich methanotrophs capable of biooxidation for methane. Specially, community structure and methane oxidation capability of methanotrophs in the aged refuse were studied. The amount of methanotrophs ranged 61.97 103–632.91 103 cells/g (in dry basis) in aged refuse from Shanghai Laogang Landfill. Type I and II methanotrophs were found in the aged refuse in the presence of sterilized sewage sludge and only Type I methanotrophs were detected in the presence of nitrate minimal salt medium (NMS). The clone sequences of the pmoA gene obtained from the aged refuse were similar to the pmoA gene of Methylobacter, Methylocaldum, and Methylocystis, and two clones were distinct with known genera of Type I methanotrophs according to phylogenetic analysis. Aged refuse enriched with NMS was used for methane biological oxidation and over 93% conversions were obtained.     

Evaluation of adsorption capacities of humic acids extracted from Algerian soil on polyaniline for application to remove pollutants such as Cd(Ⅱ), Zn(Ⅱ) and Ni(Ⅱ) and characterization with cavity microelectrode

The adsorption capacities of new humic acids isolated from Yakouren forest (YHA) and Sahara (Tamenrasset: THA) soils (Algeria) and commercial humic acid (PFHA) on polyaniline emeraldine base (PEB) were studied at pH 6.6. Also the adsorption of heavy metals such as Cd2+, Zn2+ and Ni2+ on humic acid-polyaniline systems (HA-PEB) was investigated at the same conditions. HA-PEB compounds were characterized by scanning electron microscopy (SEM), infrared spectrometry and cavity microelectrode. In addition, batch adsorption and cavity microelectrode were used in the adsorption study of Cd2+, Zn2+ and Ni2+ on HA-PEB. To develop biocaptors of polluting metals using a cavity microelectrode modified by HA-PEB systems, the adsorption kinetic and adsorption capacity were investigated. The SEM analysis showed that the presence of humic acid affected the PEB surface and caused the formation of a granular morphology. The maximum adsorption capacities (qmax) of PFHA, THA and YHA determined by adsorption isotherms were 91.31, 132.1 and 151.0 mg/g, respectively. Batch adsorption results showed that qmax of Cd2+, Zn2+ and Ni2+ on HA-PEB followed the order: THA-PEB > YHA-PEB > PFHA-PEB. The voltammograms obtained with HA-PEB modified cavity microelectrode showed the appearance of new redox couples reflecting the adsorption of HA on PEB. Metal-humic acid-polyaniline voltammograms were characterized by appearance of oxidation-reduction couples or reduction wave corresponding to metal. Finally, the result may be exploited to develop a biocaptor based on the cavity microelectrode amended by THA-PEB and YHA-PEB.