焦化废水对蚕豆和大麦毒性的影响

以COD作为主要参照指标,研究了焦化废水在符合GB 13456-92<钢铁工业水污染物排放标准>焦化一级、二级排放标准限值要求时,对蚕豆和大麦幼根生长、根尖细胞遗传毒性的影响.结果表明:在实验周期内,焦化废水对蚕豆幼根根长、根重和有丝分裂指数的影响不大;对大麦幼根根重无明显影响,而对大麦根长和有丝分裂指数有促进作用.焦...     

Effect of chromium on accumulation and antioxidants in Cucumis utillissimus L.: Response under enhanced bioavailability condition

This study compares the accumulation of Cr(VI) and biochemical changes (total chlorophyll, carotenoid, protein, malondialdehyde (MDA) and cysteine contents) and roles of antioxidant enzymes (superoxide dismutase (SOD), guaiacol peroxidase (GPX), ascorbate peroxidase (APX)) in tolerance to metal induced stress in Cucumis utillissimus L. grown in Cr contaminated soil (CS) with garden soil (GS). Furthermore, Cr bioavailability was enhanced by ethylene diamine tetra-acetic acid (EDTA) addition to the soil to forecast the plant’s accumulation pattern at elevated Cr environment. Accumulation of Cr in the leaves of the plant increased with increase in substrate metals concentration. It further increased with the addition of EDTA by 1437% and 487% in GS and CS, respectively at the highest treatment level. The lipid peroxidation increased proportionately with increase in Cr accumulation in the leaves. All the activity of antioxidant enzymes (SOD, GPX and APX) and the level of cysteine increased with dose dependant manner. SOD and cysteine were observed to be higher in the GS than in CS, but APX and GPX were found to be higher in CS than in GS. The increase in GPX and APX activities with the increase in Cr concentration could be assumed that these two enzymes have a major role in the defense mechanism towards stress induced by Cr in C. utillissimus.     

产表面活性剂根际菌协同龙葵修复镉污染土壤

从某矿区重金属污染的土壤中分离筛选出一株能产生物表面活性剂的根际细菌LKS06,经生理生化特征及16S rDNA序列分析,将其鉴定为假单孢菌属(Pseudomonas sp.LKS06).生物学特性的测定表明,菌株LKS06对多种重金属有很高的耐受性,且具有分泌吲哚乙酸、产铁载体和ACC脱氨酶活性的能力,并对土壤重金属...     

模拟水体硝态氮对黄菖蒲生长及其氮吸收的影响

为了对挺水植物在水环境与水生态修复中的应用提供参考依据,选取黄菖蒲(Iris pseudacorus L.)为对象,通过模拟水培实验,对比研究了6种水体硝态氮质量浓度(10.68、23.88、42.22、63.33、82.92、97.13 mg·L~(-1))下,黄菖蒲地上和地下生物量、根冠比、叶绿素含量、氮累计吸收量以及对硝态氮去除效果的差异,以期明确模拟水体硝态氮质量浓度对黄菖蒲生长及其氮吸收能力的影响.结果显示,首先,不同硝态氮质量浓度对黄菖蒲地上部分(茎叶)生长的影响大于地下部分(根);当硝态氮质量浓度为10.68 mg·L~(-1)时,黄菖蒲的根冠比增加;当硝态氮质量浓度为42.22~97.13 mg·L~(-1)时,黄菖蒲的根冠比减少.其次,黄菖蒲适宜生长的硝态氮质量浓度为23.88~63.33 mg·L~(-1);硝态氮质量浓度低于10.68 mg·L-1或高于82.92mg·L-1时,均会对黄菖蒲的叶绿素合成产生抑制作用.再次,黄菖蒲对氮的累积量随硝态氮质量浓度增加而增加,且地下部分对氮的累积能力优于地上部分;6种浓度下,单株黄菖蒲的氮累计吸收量为10.56~75.43 mg,其地下部分依次为地上部分的7.2、2.3、2.5、2.1、1.6以及1.5倍.此外,黄菖蒲对氮的利用效率与硝态氮质量浓度之间成显著的幂函数关系,且地上部分的氮利用效率高于地下部分.最后,黄菖蒲对硝态氮的去除率随硝态氮质量浓度增加而增加,6种浓度下黄菖蒲对硝态氮的去除率介于94.9%和99.3%之间,且水体中硝态氮质量浓度随时间延续呈指数函数降低.结果表明,黄菖蒲对硝态氮有很好的去除效果,但黄菖蒲的生长及其对氮的吸收与去除效率受水体硝态氮质量浓度影响显著,且地上部分较地下部分更为敏感.     

Effect of oxide-based fluxes on mechanical and metallurgical properties of Dissimilar Activating Flux Assisted-Tungsten Inert Gas Welds

Present investigation is to study the “Effect of Activating Fluxes on Mechanical and Metallurgical Properties of Dissimilar Activated Flux-Tungsten Inert Gas Welds”. Effect of current, welding speed, joint gap and electrode diameter on weld bead dimensions on 6 mm thick dissimilar weld between carbon steel to stainless steel, was studied under Activated Flux-Tungsten Inert Gas Welding process. During this investigation three different types of oxide powders were used-TiO₂, ZnO and MnO₂. After welding samples were subject to mechanical testing, in addition to characterization via micro hardness and microstructures of Normal Tungsten Inert Gas Welds and Activated Flux-Tungsten Inert Gas Welds. Activating fluxes TiO₂ and ZnO are effective fluxes for Activated Flux-Tungsten Inert Gas Welding of dissimilar weld between CS to SS. Highest depth/width (D/W) ratio reported under TiO₂ and ZnO fluxes compare to Normal-Tungsten Inert Gas Welds. Lowest angular distortion was observed under TiO₂ flux compare to Normal-Tungsten Inert Gas Welds. Mechanical properties, Joint Efficiency of Activated Flux-Tungsten Inert Gas Welds are higher than normal-Normal Tungsten Inert Gas Welds. Tensile Test specimens of both the processes failed from the parent metal (carbon steel side). Carbon migration from CS to SS, had occurred which led to failure of weld joints from CS side.     

Microstructure of 2205 duplex stainless steel joint in submerged arc welding by post weld heat treatment

The 2205 duplex stainless steel (DSS) is of both good properties austenitic steel and ferritic steel, which applies to the shipbuilding industry usually. In this paper, the OM, XRD and microhardness test methods are used to analyze the variation of submerged arc welded (SAW) joints with and without post weld heat treatment (PWHT). The research results show that the σ phase disappear in the fusion edge zone near heat affect zone (HAZ) and an increase in the welded center zone during the follow-up PWHT, while the amount of γ phase is decreased in the welded center zone with PWHT. A segregation distribution of some second phases is also found in the welded center zone after PWHT. There have two pick values of microhardness arise in the fusion edge zone and the welded center zone separately without PWHT. However, a maximum value of microhardness at the fusion edge zone near HAZ is disappeared and the other is still held at the welded center zone during PWHT. It can be attributed to the changes of second phases, element diffusions and particle segregation during PWHT. A developing mechanism is issued to demonstrate the second phases transferring of the 2205 DSS SAW joints by PWHT.     

45~#钢在西双版纳大气环境下的腐蚀研究

目的研究西双版纳热带雨林地区大气环境下材料的初期腐蚀行为。方法使用45#碳钢在西双版纳大气环境下进行1年的大气暴露腐蚀试验,并利用质量损失分析、SEM、XRD和FTIR等技术,分析45#碳钢在西双版纳大气环境下暴露1年的腐蚀行为。结果 45#碳钢的腐蚀产物以γ-FeOOH,Fe(OH)3和Fe3O4为主,并有少量的α-FeOOH。结论西双版纳大气环境腐蚀性为C2级。在暴露1年的时间内,锈层化学稳定性随试验时间的延长逐渐增强,对基体的保护性逐渐加大。     

某大型钢结构项目喷涂废气污染防治措施可行性分析研究

钢结构建筑是一种新型的节能环保的建筑体系,大多数大型钢结构产品在生产过程中均需要进行抛丸除锈、喷涂处理,使用油漆进行喷涂过程中将不可避免地产生含TVOC(主要为甲苯、二甲苯和非甲烷总烃)的有机废气。大型钢构类生产项目喷涂废气的收集和处理尤为困难。文章结合某大型钢结构生产企业实际采取的喷涂废气治理方法进行喷涂废气污染防治可行性分析,旨在为同类项目喷涂废气污染治理及进一步改良涂装废气治理工艺和技术提供参考依据。     

双层板桁钢梁应力分析

以跨度最大的双层斜拉桥闵浦大桥为背景,研究了双层板桁钢梁桥面板的受力特性,阐述了精细壳单元与梁单元结合的整体有限元模型,并分析了上、下桥面间腹杆的受力特性与桥面板的应力分布特性;采用桥面纵横梁间带U肋精细桥面模型,分析了桥面板和U肋在车辆荷载作用下的应力分布.研究表明,上、下层桥面横桥向应力小于纵桥向应力,并且横桥向应...     

设置限位器双向隔震铁路桥梁车桥耦合动力响应研究

对铅芯橡胶双向隔震铁路桥梁在列车荷载作用下的力学性能进行了研究,针对双向隔震铁路桥梁中存在的问题,提出了设置限位器的解决方案,并对设置限位器的双向隔震铁路桥梁进行了车桥耦合动力响应分析.研究结果表明,采用常规隔震设计方法的铅芯橡胶支座在横桥向的初始刚度和屈服强度均不能满足规范要求,设置限位器后,双向隔震铁路桥梁的力学性...