典型铅锌矿化区不同土地利用类型土壤重金属污染特征与评价

选取云南者海典型铅锌矿区周边冶炼区（A）、粮食主产区（B）、保护区（C）三个区域土壤为研究对象,分析三个区域内林地（LD）和耕地（GD）土壤pH、总碳（TC）、总氮（TN）、总磷（TP）和5种重金属（Hg、Cd、Pb、Zn、Cu）含量,利用典范对应分析（CCA）研究不同土地利用类型下它们之间的关系,基于系统熵值与重金属生物毒性改进灰色聚类评价法对研究区重金属污染程度进行评价。结果表明,A、B、C三区土壤的5种重金属均超过云南省土壤背景值,且含量A区 > B区 > C区,所有土壤样品Hg、Cd、Pb、Zn、Cu平均含量分别为7.24、1.53、1 794、2 892、210 mg/kg;LD土壤重金属含量普遍高于GD。研究区土壤pH总体呈弱酸性,但A区土壤受矿业活动影响呈弱碱性。TC、TN含量和C/N值均表现出LD大于GD,但TP含量表现为GD显著大于LD （P<0.05）。CCA分析表明LD和GD土壤pH与Cd和Cu呈负相关,与Zn和Pb呈正相关,且pH对重金属含量的影响最大;TC、TP与重金属Cd和Cu在LD土壤中呈正相关,在GD土壤中呈负相关。改进灰色聚类评价结果表明重金属污染程度均表现为LD大于GD;A区污染最严重且均呈重度污染,B区次之,C区污染程度最轻。经比较本文改进的灰色聚类评价法在准确性和灵敏度方面优于传统方法。     

固相微萃取-毛细管气相色谱法快速同步分析水中有机氯及有机磷农药

固相微萃取是一种快速、简便,集萃取浓缩进样于一体的样品前处理技术,具有分析时间短、灵敏度高、无需有机溶剂的优点.用固相微萃取富集水中8种有机氯及7种有机磷农药,毛细管气相色谱ECD检测器分离分析,整个分析过程只需26min,检出限可达0.002～1μg/L,已用于地表水中有机氯及有机磷农药含量的测定.     

Desert Water Harvesting to Benefit Wildlife: A Simple, Cheap, And Durable Sub-Surface Water Harvester for Remote Locations

A sub-surface desert water harvester was constructed in the sagebrush steppe habitat of south-central Idaho, U.S.A. The desert water harvester utilizes a buried micro-catchment and three buried storage tanks to augment water for wildlife during the dry season. In this region, mean annual precipitation (MAP) ranges between about 150–250 mm (6″–10″), 70% of which falls during the cold season, November to May. Mid-summer through early autumn, June through October, is the dry portion of the year. During this period, the sub-surface water harvester provides supplemental water for wildlife for 30–90 days, depending upon the precipitation that year. The desert water harvester is constructed with commonly available, “over the counter” materials. The micro-catchment is made of a square-shaped, 20 mL. “PERMALON” polyethylene pond liner (approximately 22.9 m × 22.9 m = 523 m²) buried at a depth of about 60 cm. A PVC pipe connects the harvester with two storage tanks and a drinking trough. The total capacity of the water harvester is about 4777 L (1262 U.S. gallons) which includes three underground storage tanks, a trough and pipes. The drinking trough is refined with an access ramp for birds and small animals. The technology is simple, cheap, and durable and can be adapted to other uses, e.g. drip irrigation, short-term water for small livestock, poultry farming etc. The desert water harvester can be used to concentrate and collect water from precipitation and run-off in semi-arid and arid regions. Water harvested in such a relatively small area will not impact the ground water table but it should help to grow small areas of crops or vegetables to aid villagers in self-sufficiency.     

CTL-12型化学需氧量速测仪与标准法测定CODCr之比较

使用CTL—12型化学需氧量速测仪分析废水化学需氧量，简便、快速，且方法可行，完全能满足环境监测技术要求。     

膜、柱串联固相萃取-高效液相色谱法测定水中多环芳烃(PAHs)的研究

建立了用膜-柱串联固相萃取(SPE)技术,甲醇和水作为流动相进行梯度洗脱,紫外和荧光检测器串联的高效液相色谱法(HPLC)分析水中EPA优先监控的16种PAHs的方法.     

Trace Metal Concentration in Roadside Surface Soil and Tree Back: A Measurement of Local Atmospheric Pollution in Abuja, Nigeria

Cadmium, copper, lead, nickel and zinc concentrations were analysed by atomic absorption spectrophotometry in surface soil and tree bark from different districts of Abuja, Nigeria, in order to determine the atmospheric trace metal input in the area.Elevated concentrations of some of the studied metals were observed in the soil and tree bark samples from the commercial/high traffic areas of the city compared to backgroundvalues. In soil samples, the average concentration of the metals were 0.6±0.4, 18.0±4.0, 281±39, 16±4 and66±23 g g^-1 dry weight for Cd, Cu, Pb, Ni and Zn, respectively, whilst the average concentrations in tree bark were 0.3±0.2, 12±4, 133±32, 13±3 and 61±10 g g^-1 dry weight for Cd, Cu, Pb, Ni and Zn, respectively. The trend in trace metal levels suggested that automobile emissions are a major source of these metals as the highest concentrations of Pb and Zn were recorded in the commercial areas of the city known for their high traffic densities. The levels of metal in the study area were relativelylow compared to levels found in some larger and older cities in various countries worldwide.     

Comparison of Two Manual Methods of Nitrogen Dioxide Determination in Ambient Air

Sodium arsenite (modified Jacobs and Hochheiser method; hereafter referred as SA), the most widely used manual monitoring method for determination of nitrogen dioxide (NO₂) in ambient air, particularly in developing countries has been evaluated and compared with US EPA recommended equivalent method of TGS-ANSA (hereafter referred as ANSA). NO₂ concentrations generated from laboratory test atmosphere were analyzed by these two methods and were compared statistically. Laboratory evaluations showed that SA method has high sensitivity to different sampling conditions, which normally vary during actual field monitoring. Hence, correction factors for absorption efficiency were estimated for SA and ANSA methods. Absorption efficiency of NO₂ in SA method was found to be much lower (64%) as against the reported value of 82% at the method recommended sampling conditions, whereas for ANSA method, it was found 1.0 as against the reported value of 0.93. After applying derived correction factors, both the methods produced almost similar concentration values of NO₂.     

Monitoring of Butter and Ghee (Clarified Butter Fat) for Pesticidal Contamination from Cotton Belt of Haryana, India

Butter (45) and ghee (55) samples were collected from rural and urban areas of cotton growing belt of Haryana and analysed for detecting the residues of organochlorine, synthetic pyrethroid and organophosphate insecticides. The estimation was carried out by using multi residue analytical technique employing GC-ECD and GC-NPD systems equipped with capillary columns. Butter samples were comparatively more contaminated (97%) than ghee (94%), showing more contamination with organochlorine insecticides from urban samples. About 11% samples of butter showed endosulfan residues above MRL value and 2% samples had residues of synthetic pyrethroids and organophosphates each above their respective MRL values. In ghee, residues of HCH & DDT both and of endosulfan exceeded the MRL values in 5 and 20% samples, respectively. Among organophosphates, only chlorpyriphos was detected with 9% samples showing its residue above MRL value. Irrespective of contamination levels, residues above the MRL values were more in ghee. More extensive study covering other agricultural regions/zones of Haryana has been suggested to know the overall scenario of contamination of milk products.     

Linking Land Cover and Water Quality in New York City’S Water Supply Watersheds

The Catskill/Delaware reservoirs supply 90% of New York City’s drinking water. The City has implemented a series of watershed protection measures, including land acquisition, aimed at preserving water quality in the Catskill/Delaware watersheds. The objective of this study was to examine how relationships between landscape and surface water measurements change between years. Thirty-two drainage areas delineated from surface water sample points (total nitrogen, total phosphorus, and fecal coliform bacteria concentrations) were used in step-wise regression analyses to test landscape and surface-water quality relationships. Two measurements of land use, percent agriculture and percent urban development, were positively related to water quality and consistently present in all regression models. Together these two land uses explained 25 to 75% of the regression model variation. However, the contribution of agriculture to water quality condition showed a decreasing trend with time as overall agricultural land cover decreased. Results from this study demonstrate that relationships between land cover and surface water concentrations of total nitrogen, total phosphorus, and fecal coliform bacteria counts over a large area can be evaluated using a relatively simple geographic information system method. Land managers may find this method useful for targeting resources in relation to a particular water quality concern, focusing best management efforts, and maximizing benefits to water quality with minimal costs.The United States Environmental Protection Agency through its Office of Research and Development funded and managed the research described here. It has been subjected to Agency’s administrative review and approved for publication as an EPA document.     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.