Long-term nitrogen and phosphorus removal,shifts of functional bacteria and fate of resistance genes in bioretention systems under sulfamethoxazole stress

To understand the long-term performance of bioretention systems under sulfamethoxazole (SMX) stress, an unplanted bioretention system (BRS) and two modified BRSs with coconut-shell activated carbon (CAC) and CAC/zero-valent-iron (Fe0) granules (CAC-BRS and Fe/CAC-BRS) were established. Both CAC-BRS and Fe/CAC-BRS significantly outperformed BRS in removing total nitrogen (TN)(CAC-BRS:82.48%; Fe/CAC-BRS:78.08%; BRS:47.51%), total phosphorous (TP)(CAC-BRS:79.36%; Fe/CAC-BRS:98.26%; BRS:41.99%),and...     

焦化黄血盐吸收塔填料自燃原因分析

焦化黄血盐系统内的吸收塔在停产检修补充填料——铁刨花期间，经常发生铁刨花自燃现象，这是严重的事故隐患。结合武钢焦化公司黄血盐工艺特点，对其自燃原因作了详细分析，提出了避免此类事故发生的措施。     

变压器火灾及预防

本文通过详细分析变压器火灾原因，提出预防变压器火灾的技术措施，供生产厂家、使用单位和消防监督管理部门有关技术人员、生产者、监管人员参考。     

散射光下铁(III)-丙酮酸盐配合物还原铬(VI)的研究

研究了在散射光下铁(III)-丙酮酸盐配合物对铬(V I)的光还原反应;考察了溶液pH、铁(III)、丙酮酸钠、铬(V I)浓度对反应的影响;分析了铬(V I)光还原反应的动力学。实验结果表明:铁(III)-丙酮酸盐配合物体系能在较弱的散射光下还原铬(V I)。在铬(V I)浓度为19.2μm o l/L、铁(III)浓度为10.0μm o l/L、丙酮酸钠浓度为240μm o l/L、pH为3.0、光照240m in的条件下,铬(V I)的还原率达到99.7%。从表观动力学方程的反应级数看,铁(III)的级数(0.83)最高,铁(III)浓度是影响铬(V I)光还原反应速率的主要因素,铁(II)是铬(V I)光还原的主要还原剂。     

ARE RURAL RESIDENTS WILLING TO PAY ENOUGH TO IMPROVE DRINKING WATER QUALITY?1

ABSTRACT: The concentrations of iron and sulfate in community water supplies are a concern for a number of areas in southwestern Minnesota. This study used the contingent valuation method to determine how much consumers would be willing to pay to improve their drinking water quality. On average, individuals were willing to pay US$5.25 per month (in 1995 U.S. dollars) to reduce the level of iron and US$4.33 per month to reduce the level of sulfate in their water to the USEPA's secondary standards for drinking water quality. Respondents with negative perceptions of their drinking water quality were willing to pay more to improve water quality. The aggregate annual willingness to pay (WTP) for all consumers in community water systems in southwestern Minnesota that were out of compliance with water quality standards were estimated to be US$2.4 million and US$2.0 million (in 1995 dollars) for reducing the levels of iron and sulfate, respectively. Yet the total WTP of consumers who use small community water systems may not be enough to pay the full cost of providing improved water in those systems. Economies of scale in water treatment and difficulties in financing improvements mean that technical innovation, government assistance, or institutional changes may be needed to improve water quality in these areas.     

Explosion characteristics of micron- and nano-size magnesium powders

Explosion characteristics of micron- and nano-size magnesium powders were determined using CSIR-CBRI 20-L Sphere, Hartmann apparatus and Godbert-Greenwald furnace to study influence of particle size reduction to nano-range on these. The explosion parameters investigated are: maximum explosion pressure (P_max), maximum rate of pressure-rise (dP/dt)_max, dust explosibility index (K_St), minimum explosible concentration (MEC), minimum ignition energy (MIE), minimum ignition temperature (MIT), limiting oxygen concentration (LOC) and effect of reduced oxygen level on explosion severity. Magnesium particle sizes are: 125, 74, 38, 22, 10 and 1 μm; and 400, 200, 150, 100, 50 and 30 nm. Experimental results indicate significant increase in explosion severity (P_max: 7–14 bar, K_St: 98–510 bar·m/s) as particle size decreases from 125 to 1 μm, it is maximum for 400 nm (P_max: 14.6 bar, K_St: 528 bar·m/s) and decreases with further decrease of particle size to nano-range 200–30 nm (P_max: 12.4–9.4 bar, K_St: 460–262 bar·m/s) as it is affected by agglomeration of nano-particles. MEC decreases from 160 to 30 g/m³ on decreasing particle size from 125 to 1 μm, its value is 30 g/m³ for 400 and 200 nm and 20 g/m³ for further decrease in nano-range (150–30 nm). MIE reduces from 120 to 2 mJ on decreasing the particle size from 125 to 1 μm, its value is 1 mJ for 400, 200, 150 nm size and <1 mJ for 50 and 30 nm. Minimum ignition temperature is 600 °C for 125 μm magnesium, it varies between 570 and 450 °C for sizes 38–1 μm and 400–350 °C for size range 400–30 nm. Magnesium powders in nano-range (30–200 nm) explode less violently than micron-range powder. However, likelihood of explosion increases significantly for nano-range magnesium. LOC is 5% for magnesium size range 125–38 μm, 4% for 22–1 μm, 3% for 400 nm, 4% for 200, 150 and 100 nm, and 5% for 50 and 30 nm. Reduction in oxygen levels to 9% results in decrease in P_max and K_St by a factor of 2–3 and 4–5, respectively, for micron as well as nano-sizes. The experimental data presented will be useful for industries producing or handling similar size range micron- and nano-magnesium in order to evaluate explosibility of their magnesium powders and propose/design adequate safety measures.     

供水管网铁释放的影响因素相对重要性分析

供水管网的铁释放问题近年来日益受到关注.影响供水管网铁释放的因素众多,本研究选取了pH、溶解氧(DO)、碱度(Alk)、硬度、氯离子(Cl~-)、硫酸根(SO_4~(2-))、温度(T)和水力停留时间(HRT)这8个影响因素,利用逐步回归和偏相关分析,建立了铁释放的非线性幂指数模型,并用标准化回归系数和偏相关系数比较了这些因素的相对重要性.结果表明,铁释放模型拟合效果良好;用标准化回归系数衡量影响因素相对重要性时,SO_4~(2-)、HRT、Cl~-和T是相对重要的因素,相对重要性排序为SO_4~(2-)≈HRTCl~-T;用偏相关系数衡量时,HRT、SO_4~(2-)、Alk、Cl~-和T是相对重要的因素,排序为HRTSO_4~(2-)AlkCl~-T.综合两种系数的分析结果,HRT、SO_4~(2-)和Cl~-是本研究条件下相对重要的因素,T和Alk的相对重要性视实际情况变动.     

水环境中碳纳米管对沙丁胺醇光降解的影响

选取沙丁胺醇(salbutamol,SAL)为目标污染物,研究了3种碳纳米管(CNTs,单壁碳纳米管SCNT、羟基衍生化多壁碳纳米管MWNT-OH和羧基衍生化多壁碳纳米管MWNT-COOH)对有机污染物在模拟太阳光照下降解的影响;并且研究了CNTs与天然水体中光活性物质三价铁离子(Fe3+)的相互作用.结果表明,3种CNTs能够通过竞争吸收光子,即光屏蔽作用抑制SAL光解;同时又能通过光致激发产生单线态氧(1O2)促进光解反应,两种作用机制同时存在,在绝大多数情况下,抑制作用占主导地位.此外,CNTs还能通过静电吸附作用使水体中的光活性物质Fe3+失活,从而影响有机污染物在天然水体中的光化学行为.     

我国工业危险废物的来源、处理及监管对策与建议

通过大量环境统计数据的分析,对我国工业危险废物的产生、综合利用、处置和贮存,从行业来源、区域分布进行了分析和总结。结合我国工业危险废物企业自建设施和政府集中处理设施处理情况,对我国工业危险废物的处理和环保监管对策提出了若干建议。     

Ti/SnO_2-Sb阳极-空气阴极电催化降解染料废水

为解决电化学法处理高盐染料废水存在的能耗大、成本高等问题,分别采用溶胶-凝胶法和辊压法制备Ti/SnO_2-Sb阳极和空气阴极,构建了Ti/SnO_2-Sb阳极-空气阴极双极体系(TSSA-ADC)。甲基橙(MO)作为高盐染料废水的典型污染物,考察了电流强度、MO浓度、电解液浓度和初始p H对TSSA-ADC体系和TSSA单阳极体系降解MO的影响。结果表明:与TSSA单阳极体系相比,TSSA-ADC体系具有更好的抗有机负荷冲击、抗盐分冲击、抗酸碱波动能力,能够维护酸碱平衡防止硬度离子结垢。最佳反应条件为电流强度为0.030 A,电解液浓度为3%,MO浓度为100 mg/L,初始pH=6。以MO去除率达到98%为基准,TSSA-ADC体系比TSSA体系可节能74.26%。