Flame regime estimations of gasoline explosion in a tube

Flame regime of gasoline-air mixture explosion is related to chemical reaction, turbulent flow and heat and mass transfer. Experimental data of gas velocity, pressure and flame temperature of gasoline-air mixture explosion in a tube at the equivalence ratio of 0.72, 1.00 and 1.28 were preliminarily acquired. Then, fluctuating velocities, overpressures, and burned and unburned gas temperatures at early stage (50 ms), intermediate stage (150 ms) and last stage (250 ms) in three explosions were determined through the analysis of the experimental data. Finally, the Damköhler number and Reynolds number of the early, intermediate and late stage were calculated respectively, and the flame regimes for each stage were estimated through the Damköhler number vs. Reynolds number diagram. Results show that all the flames at early, intermediate and late stage of the three explosions have the same regime of flamelets-in-eddies. The conclusions can provide some useful references for further study of the flame regime and the numerical analysis model selection of gasoline-air mixture explosion.     

压缩空气泡沫在长距离管路输送中压降的数值模拟

基于Fluent对压缩空气泡沫在长距离管道中的流动特性进行了数值模拟研究,将压缩空气泡沫近似为弥散流,采用Saplart-Allmaras模型模拟了不同管径下压缩空气泡沫以及不同泡沫原液浓度的AFFF泡沫在长距离管道内的流动及压降变化。模拟结果表明,随着距离变化,各管径管道内压降均呈现线性变化,且随着压缩空气泡沫的流动,压降线性增大。管道管径对管内压降变化具有显著影响,管道直径越小,管道内压降越大;泡沫原液浓度对压降的影响较小,且压缩空气泡沫在长距离输送中的压力随距离线性衰减。将模拟结果与长距离输送的试验结果进行了对比,误差在10%以内。     

几种压力容器在役监控技术及应用

介绍了若干压力容器在役监控技术的实例。声发射技术和超声检测是比较可行的监控技术。     

Flame propagation in lycopodium/air mixtures below atmospheric pressure

Industrial processes are often operated at conditions deviating from atmospheric conditions. Safety relevant parameters normally used for hazard evaluation and classification of combustible dusts are only valid within a very narrow range of pressure, temperature and gas composition. The development of dust explosions and flame propagation under reduced pressure conditions is poorly investigated. Standard laboratory equipment like the 20 l Siwek chamber does not allow investigations at very low pressures. Therefore an experimental device was developed for the investigations on flame propagation and ignition under reduced pressure conditions. Flame propagation was analysed by a video analysis system the actual flame speed was measured by optical sensors. Experiments were carried out with lycopodium at dust concentrations of 100 g/m³, 200 g/m³ and 300 g/m³. It was found that both flame shapes and flame speeds were quite different from those obtained at atmospheric pressure. Effects like buoyancy of hot gases during ignition and flame propagation are less strong than at atmospheric conditions. For the investigated dust concentrations the flame reaches speeds that are nearly an order of a magnitude higher than at ambient conditions.     

在用压力管道若干常见缺陷的分析与检验

对在用压力管道的磨蚀、结构不合理及焊接缺陷等几种常见缺陷进行了分析,提出了防范措施及检验中应注意的问题。     

Experimental study on the competing effect of ceramic pellets on premixed methane-air flame propagation in a duct

It is urgent to explore effective suppression methods for gas fires and explosions to ensure the safe utilizations of combustible gases in industrial processes. In this work, experiments are performed to study the effect of spherical ceramic pellets on premixed methane-air flame propagation in a closed duct. High-speed schlieren photography and pressure transducers are used to record the flame propagation and pressure transient, respectively. Behaviors of the flame propagating through a section of the duct filled with ceramic pellets in mixtures at different equivalence ratios are scrutinized. Three different diameters of pellets are considered in the experiments. The result shows that the flame can be quenched in the case with a smaller pellet diameter (3 mm) for a wide range of equivalence ratios from fuel-lean to fuel-rich mixture. For larger pellet diameter (5 or 10 mm), flame extinction occurs in fuel-rich mixtures (e.g. Φ = 1.1, 1.2). For the cases of flame surviving through the pellets bed, the pellets show a significant influence on the flame structure and behavior. The flame propagation depends on the porosity and the mean void diameter of the porous media in the pellets bed. Small void diameter is beneficial to flame quenching, while large porosity can accelerate the flame propagation. The pressure dynamics evolution is closely related to the interaction of flame with the pellets, and it depends on whether the flame quenches in the pellets bed. Overall, d = 3 mm ceramic pellets display the best suppression effect on flame propagation and pressure buildup in this study. The results of this study are of great significance to guide the safety design of spherical suppression materials in engineering applications for process safety researchers and engineers.     

压力容器定期检验体积缺陷高度的简易检测

利用曝光曲线和胶片特性曲线,推导了焊缝内部体积缺陷高度的计算公式,缺陷高度计算公式适应于焊缝表面比较平滑的体积型缺陷计算。通过测量缺陷处底片黑度、缺陷附近焊缝处底片黑度、缺陷附近母材处底片黑度、缺陷附近焊缝高度,可以用公式计算焊缝内部体积缺陷高度,该公式能够应用于未焊透和条状夹渣的高度测定,并在压力容器定期检验时对未焊透和条状夹渣缺陷安全状况进行定级。     

我国的劳动安全监察制度与压力容器事故预防

分析了压力容器事故的主要原因 ,介绍了劳动安全监察制度 ,研究了该制度对减少压力容器事故所起的作用 ,为预防压力容器事故 ,对劳动安全监察制度的发展 ,提出了自己的见解与看法。     

氨制冷压力容器定期检验相关问题分析

随着大量制冷装置的建成和使用,氨制冷企业安全问题日益突出,定期检验作为保证在役氨制冷压力容器安全使用的一个重要环节,目前仍存检验依据不清、检验项目不明、检验针对性不足等问题.文中对氨制冷压力容器定期检验现状进行了介绍,对氨制冷压力容器损伤机理进行了分析和讨论,从损伤模式判别的角度提出了相应的检验策略,给相关人员提供一些...