气浮--厌氧--生物接触氧化工艺处理屠宰废水

介绍了采用气浮-厌氧-生物接触氧化工艺处理屠宰废水的工程实例。当进水CODcr≤4500mg／L时，出水可达到国家《肉类加工工业污染物排放标准》(GB13457—1992)一级标准。     

序批式活性污泥法在炼油化工废水处理中的应用

炼油化工废水处理的传统处理工艺中存在一定的弊端。为此,玉门炼油化工总厂对其废水处理设施进行了改建和扩建,其生物处理系统采用了序批式活性污泥法处理工艺。经过 3年运行的结果表明:该系统运行效果良好,处理后的水质可达到《GB8978-1996》(石化)一级排放标准的要求;化学需氧量(COD)和生化需氧量(BOD)分别降低78.6%和91.2%,硫化物去除率为98.2%,挥发酚去除率为99.6%。而且该反应器具有较强的耐冲击负荷能力,进水中COD在600 mg/L以下且有大幅度波动时,该系统仍可稳定地运行,处理后的水可达标排放。     

移动床生物膜反应器充氧能力的试验研究

对移动床生物膜反应器的充氧能力进行了试验研究，结果表明：反应器充氧能力在添加填料比无填料时大；在悬浮载体能够均匀流化的填充率范围内，反应器充氧能力随着填充率的增大而增大；当填充率大于可以均匀流化的最大填充率时，反应器的充氧能力略有下降。     

Effect of Cross-Linking Waste Protein with Dialdehydes on Its Biodegradation Under Anaerobic Conditions

Most native polymers used in processing and application technologies are admittedly disposable from the environment in a biologic manner, but products possess low mechanical strength. One of the paths to increasing this attribute (if feasible) is their cross-linking, which may, however, affect their readiness to biodegradation. In the presented work this condition was observed on the example of waste protein (Hykol B) cross-linking by means of glutardialdehyde and glyoxal. Degree and course of cross-linking were determined through impedance spectroscopy. The objective of this work also was to obtain data for constructing a sensor capable of following the cross-linking course in real time, for potential industrial application of Hykol in continuous production. Impedance spectroscopy proved to be applicable even to this kind of material marked by considerable water content and exhibiting relatively high electric conductivity; so far it had been used only for materials of low conductivity. An aqueous environment inoculated with digested anaerobic sludge from a municipal wastewater treatment plant was selected for modeling anaerobic conditions. The relation was studied between cross-linking degree given by content of cross-linking agent (determined by impedance spectroscopy) and biodegradation degree under anaerobic conditions. It was confirmed that network density as given by quantity of added agent not only reduced breakdown degree but also slowed the course of the process. This fact is particularly obvious with cross-linking by means of glyoxal; network density is thus dependent on type of employed substance, which affect type and structure of created network. That not merely forms an obstacle during polymer swelling and dissolution but also prevents access of bacteria to source of metabolized organic carbon.     

SBR法处理垃圾渗滤液及其同时硝化反硝化生物脱氮研究

采用SBR系统处理城市垃圾渗滤液，研究了不同C／N、130和MLSS对同时硝化反硝化脱氮效率的影响。结果表明：总氮去除率随着C／N、MLSS升高而上升；DO越低，总氮去除率越高；当进水CODCr与NH3-N浓度分别为420mg／L和112mg／L,DO和MLSS分别为1．5mg／L和5016mg／L时，CODCr、NH3-N及TN去除率分别为81．54％、96．57％和46．66％。根据试验结果，对同时硝化反硝化一个代表周期作了分析。     

螺旋升流反应器氧传递性能的试验研究

本文主要针对螺旋升流反应器技术特性，对工艺的好氧反应器进行了氧传递性能的试验研究，考察了反应器水深、曝气量等对螺旋升流反应器氧转移过程的影响；并对试验数据进行回归，得到了氧传质总系数与螺旋升流反应器内表现气速的数学关系。试验结果表明，螺旋升流反应器具有良好的氧传递特性，是一种新型的高效、节能的污水处理反应技术。     

新型生物转筒处理食品生产废水的试验研究

生物转盘（筒）是处理中、小流量废水的一种较经济有效的方法，本试验采用新型填料式生物转筒作为关键设备处理食品加工废水，结果表明：系统对COD、BOD5、SS和LAS有显著的去除效果，当进水COD为1200～1700mg/L，BOD5为600～1200mg/L时，出水水质可以达到广东省地方标准《水污染物排放限值》（DB44／26-2001）中的二级标准。     

厌氧-好氧一体化反应器处理高浓度有机废水的运行特性研究

本实验采用新型厌氧—好氧一体化反应器处理高浓度有机废水,主要研究了系统的启动与运行性能,并对系统的NH3 N去除效果作了初步考察。实验结果表明:在16℃～24℃的自然温度下,采用递增负荷、厌氧和好氧分期启动的方式,系统可在38天内达到较好的启动效果;在系统负荷运行期内,当系统总进水COD浓度平均值为3601 8mg/L,总出水COD浓度平均值为384 0mg/L,系统容积负荷平均值为2 54kgCOD/(m3·d),系统总HRT平均值为35 1h时,系统总COD去除率平均值达90 6%。实验还发现:当进水NH3 N浓度为280 3～350 7mg/L,整个系统的NH3 N去除率在68 5%～91 7%,平均为81 0%。由此说明,本反应器具有很好的COD去除性能和NH3 N去除效果,适合于处理COD浓度高且含有中等NH3 N浓度的有机废水。     

稠油污水生化性处理技术研究

为了探讨稠油污水能否使用生物法处理,以生活污水和农药厂生化池原菌种经过诱导驯化,分别培养了可以在稠油污水中生长的好氧菌种革兰氏阴性菌G-1和厌氧菌种革兰氏阴性菌G-2.以G-2和G-1对稠油污水进行顺序处理,可使其BOD5/CODCr达到0.26;采用SBR法对新疆稠油污水放大处理试验的结果：COD降至150 mg/L以下,各项指标达到GB8978-1998二级排放标准.