The Loch Fleet Project in the Context of Acidification Reduction Measures

At Loch Fleet, and in other liming studies in similar environments, catchment liming is successful if an adequate amount of lime is added to hydrological source areas. Geochemical modelling demonstrates that the relatively late acidification of L. Fleet is consistent with the ameliorating effect of an alkaline groundwater input: the presence of this input implies that had the Loch not been limed in 1985 it would have recovered to conditions suitable for fish in about 20 years, given current commitments to sulphur emission reductions. Lakes without similar alkaline groundwater are not likely to recover as quickly. the different consequences of liming and emission reduction as methods of restoring acid waters are reviewed and contrasted. Restoration of waters by liming may result in some undesirable effects on the terrestrial catchment: these are discussed but it is concluded that catchment liming, used with discrimination, can be an acceptable management tool.     

F/M对活性污泥微生物生态网络的影响

为深入理解有机负荷率(F/M)对活性污泥(AS)微生物群落的影响,以F/M(以BOD/MLVSS计,下同)设计建议范围0.2～0.5 kg·(kg·d)-1为依据,将采集的AS样品分为3组,运用基于随机矩阵理论(RMT)的网络分析方法,解析了不同F/M条件下的AS微生物生态网络拓扑性质及结构特征.结果表明,较低的F/M...     

Effect of humic substances on the precipitation of calcium phosphate

For phosphorus （P） recovery from wastewater, the effect of humic substances （HS） on the precipitation of calcium phosphate was studied. Batch experiments of calcium phosphate precipitation were undertaken with synthetic water that contained 20 mg/L phosphate （as P） and 20 mg/L HS （as dissolved organic carbon, DOC） at a constant pH value in the range of 8.0-10.0. The concentration variations of phosphate, calcium （Ca） and HS were measured in the precipitation process; the crystalline state and compositions of the precipitates were analysed by powder X-ray diffraction （XRD） and chemical methods, respectively. It showed that at solution pH 8.0, the precipitation rate and removal efficiency of phosphate were greatly reduced by HS, but at solution pH ≥9.0, the effect of HS was very small. The Ca consumption for the precipitation of phosphate increased when HS was added; HS was also removed from solution with the precipitation of calcium phosphate. At solution pH 8.0 and HS concentrations ≤3.5 mg/L, and at pH ≥ 9.0 and HS concentrations ≤ 10 mg/L, the final precipitates were proved to be hydroxyapatite （HAP） by XRD. The increases of solution pH value and initial Ca/P ratio helped reduce the influence of HS on the precipitation of phosphate.     

土地利用/覆盖变化对长江上游非点源污染影响研究

在国内外相关研究的基础上,利用输出系数模型,结合RS和GIS技术,对长江上游的非点源污染负荷进行了空间模拟和负荷估算.模拟结果表明,在不考虑流域损失的前提下,由于土地利用造成的非点源污染负荷TN总量从20世纪70年代的123万t下降至2000年的116万t,基本呈逐年减少的趋势,由土地利用造成的TP的变化趋势与TN基本相同,从70年代的3.7万t下降到2000年的3.5万t左右.就省份、土地利用类型和水系而言,四川省、种植用地和草地以及金沙江水系和嘉陵江水系对长江上游的非点源污染贡献较大.在非点源污染负荷强度上,重庆市和嘉陵江水系单位面积负荷最高,是今后应重点治理的地区.结果表明,该模型可以对长江上游这样的超大尺度空间的非点源污染进行较好的空间模拟.     

Occurrences of pharmaceutical and personal care products as micropollutants in rivers from Romania

The occurrence of pharmaceutical and personal care products (PPCPs) was investigated in the Somes River. The aim of this study was to obtain a first overview about the contamination of Somes River (Transylvania) with PPCPs. The samples were preconcentrated by Solid Phase Extraction (SPE) procedures and analysed by GC/MS. A number of 15 compounds including pharmaceutics, metabolites, intermediates and musk fragrances were detected in concentration ranging from 30 ng/l to 10 μg/l. The detected pharmaceuticals are included in following therapeutic groups: analgesics, antiepileptics, psychiatric, stimulants, anticoagulants, antineoplastic and disinfectants.     

Vapour pressures, aqueous solubility, Henry's law constants and air/water partition coefficients of 1,8-dichlorooctane and 1,8-dibromooctane

New data on the vapour pressures and aqueous solubility of 1,8-dichlorooctane and 1,8-dibromooctane are reported as a function of temperature between 20 °C and 80 °C and 1 °C and 40 °C, respectively. For the vapour pressures, a static method was used during the measurements which have an estimated uncertainty between 3% and 5%. The aqueous solubilities were determined using a dynamic saturation column method and the values are accurate to within ±10%. 1,8-Dichlorooctane is more volatile than 1,8-dibromooctane in the temperature range covered (p_sat varies from 3 to 250 Pa and from 0.53 to 62 Pa, respectively) and is also approximately three times more soluble in water (mole fraction solubilities at 25 °C of 5.95 × 10⁻⁷ and 1.92 × 10⁻⁷, respectively). A combination of the two sets of data allowed the calculation of the Henry’s law constants and the air water partition coefficients. A simple group contribution concept was used to rationalize the data obtained.     

Formation of dioxins from combustion of polyvinylidene chloride in a well-controlled incinerator

Polyvinylidene chloride (PVDC; polymer of 1,1-dichloroethylene) was combusted with paper in a well-controlled, small-scale incinerator at an average grate temperature of 700 °C, and then dioxins (PCDDs, PCDFs, and coplanar-PCBs) formed in the exhaust gases were analyzed by gas chromatography/mass spectrometry. PVDC lowered the combustion temperature due to its less flammable character. The amount of total dioxins (PCDDs + PCDFs + coplanar-PCBs) formed in the exhaust gas was 58.0 ng/g of a combustion sample and its toxicity equivalency quantity (TEQ) value was 0.64 ng-TEQ/g. The amount of PCDDs formed in the sample ranged from 2.33 ng/g (Cl₈-isomer) to 0.048 ng/g (Cl₁-isomer). The lower the number of chloride, the less production of PCDDs. On the other hand, there was no relation between the number of chloride and PCDF formation. The amount of PCDFs formed in the sample ranged from 8.02 ng/g (Cl₂-isomer) to 4.46 ng/g (Cl₈-isomer). A polyvinylchloride (PVC) sample produced 207 ng/g of total dioxins and a PVDC sample produced 57.4 ng/g of total dioxins when they were combusted under the same conditions. An approximately equal composition of dioxin isomers was formed from PVDC and PVC samples. Paper was found to contribute to PCDF formation when it was combusted with plastics.     

Evaluation of the emission characteristics of PCDD/Fs from electric arc furnaces

Distribution of PCDD/F (polychlorinated dibenzo-p-dioxin and polychlorinated dibenzofuran) congeners at two electric arc furnaces (EAFs) in Taiwan is evaluated via intensive stack sampling and analysis. Two kinds of exhaust system in EAFs including stack system and shutter system are selected for measuring dioxin emissions. In addition, dioxin emissions during oxidation and reduction stages at EAF-A were characterized. Results indicate that the PCDD/F concentration of stack gas in EAF-A was 4.39 ng/N m³ while total Toxic Equivalent Quantity (TEQ) concentration was 0.35 ng I-TEQ/N m³. The PCDD/F concentration of stack gas in EAF-B was 2.20 ng/N m³ and the TEQ concentration was 0.14 ng I-TEQ/N m³. 1,2,3,4,6,7,8-H_pCDF, OCDD and OCDF are the major contributors of the dioxin concentrations for two EAFs investigated and the percentage of PCDD/F in particulate phase increases as the chlorination level of the PCDD/F congener increases. The results obtained on gas/particulate partitioning of PCDD/Fs in flue gases prior to the APCD in EAFs indicate that more than 90% exists in particulate phase. In EAF-A, the PCDD/F concentration during oxidation stage is slightly higher than that measured during reduction stage, including the sampling points of CO converter outlet, prior to bag filter and stack. Majority of PCDD/Fs emitted from steel-making processes exists in particulate-phase (about 60–70%) at both EAFs investigated.     

Broad range analysis of endocrine disruptors and pharmaceuticals using gas chromatography and liquid chromatography tandem mass spectrometry

Endocrine disrupting compounds (EDCs) and pharmaceuticals and personal care products (PPCPs) have been globally detected in impacted natural waters. The detection of trace quantities of EDCs and PPCPs in the environment is of great concern since some of these compounds have known physiological responses at low concentrations. EDCs can have a wide range of polarities, acidic and basic moieties, and exist in trace quantities, which often requires numerous complex extractions, large sample collection volumes, and multiple instrumental analyses. A comprehensive method has been developed allowing for the analysis of 58 potential EDCs in various water matrices using a single solid-phase extraction (SPE) of a 1 L sample with subsequent analyses using both gas chromatography and liquid chromatography, each coupled with tandem mass spectrometry (GC–MS/MS and LC–MS/MS). Instrument detection limits ranged between 0.12–7.5 pg with corresponding method reporting limits of 1–10 ng l⁻¹ in water. Recoveries for most compounds were between 50% and 112% with good reproducibility (RSD 6–22%).