二维与三维电解法处理含铜废水的试验研究

以含铜废水为处理对象,考察了二维电解法的电解电压、电解时间、pH值、极间距对铜去除率的影响。在此基础上为提高处理效率,两极间填充活性炭和玻璃珠形成三维电解,确定了三维电解的最佳运行条件是极间距4cm,pH值3～4,电解电压22 V,电解135min,铜离子的去除率为80.6%。     

复合纳米微粒修饰碳糊电极方波伏安法检测水中甲基对硫磷

采用溶胶-凝胶法合成纳米ZrO2,将其混合在石墨粉和碳纳米管（CNTs）中,利用硅油做粘合剂,制得一次性有机磷农药（OPs）检测碳糊电极（CNTs/ZrO2│CPE）,并对水中甲基对硫磷（MP）进行了检测.采用扫描电镜（SEM）、X射线荧光光谱（XRFS）表征电极的制备过程,采用循环伏安（CV）法和方波伏安（SWV）法...     

An antibiotic composite electrode for improving the sensitivity of electrochemically active biofilm biosensor

• Antibiotic azithromycin employed in graphite electrode for EAB biosensor. • Azithromycin at 0.5% dosage increased the sensitivity for toxic formaldehyde. • Azithromycin increased the relative abundance of Geobacter. • Azithromycin regulated thickness of electroactive biofilm. Extensive research has been carried out for improved sensitivity of electroactive biofilm-based sensor (EAB-sensor), which is recognized as a useful tool in water quality early-warning. Antibiotic that is employed widely to treat infection has been proved feasible in this study to regulate the EAB and to increase the EAB-biosensor’s sensitivity. A novel composite electrode was prepared using azithromycin (AZM) and graphite powder (GP), namely AZM@GP electrode, and was employed as the anode in EAB-biosensor. Different dosages of AZM, i.e., 2 mg, 4 mg, and 8 mg, referred to as 0.25%, 0.5% and 1% AZM@GP were under examination. Results showed that EAB-biosensor was greatly benefited from appropriate dosage of AZM (0.5% AZM@GP) with reduced start-up time period, comparatively higher voltage output, more readable electrical signal and increased inhibition rate (30%-65% higher than control sensor with GP electrode) when exposing to toxic formaldehyde. This may be attributed to the fact that AZM inhibited the growth of non-EAM without much influence on the physiologic or metabolism activities of EAM under proper dosage. Further investigation of the biofilm morphology and microbial community analysis suggested that the biofilm formation was optimized with reduced thickness and enriched Geobacter with 0.5% AZM@GP dosage. This novel electrode is easily fabricated and equipped, and therefore would be a promising way to facilitate the practical application of EAB-sensors.     

钛基IrO2-RuO2阳极电解处理亚甲基蓝溶液

采用钛基IrO2-RuO2为阳极材料,不锈钢为阴极材料,NaCl质量浓度为10 g/L的溶液为电解液,对亚甲基蓝溶液进行电化学处理。实验结果表明:处理初始质量浓度为25 mg/L的亚甲基蓝溶液,电解电流0.050 A,电解20 min后亚甲基蓝去除率达95%;处理初始质量浓度为100 mg/L的亚甲基蓝溶液,电解电流0.100 A,电解30 min后亚甲基蓝去除率达98%。随着电解时间和电解电流的增加,亚甲基蓝去除率均增大。     

硝基苯在碳纳米管修饰电极上的电化学行为及其分析应用

硝基苯在碳纳米管修饰电极上的电化学行为表明,硝基苯在-0.50V有一灵敏的还原峰,为硝基苯得到四个电子还原为苯胲所形成,电位继续负移,苯胲能继续还原为苯胺.在扫描速度为100mV·s-1,pH=5.0和富集时间为2min的条件下,-0.50V处的还原峰电流与硝基苯在1.5—150mg·l-1范围内线性关系良好,线性系数为0.99992,检测限为0.3mg·l-1.应用于实际废水中硝基苯的测定,相对标准偏差小于5%(n=10),相对误差为-5%— 5%.     

检测水中有机磷农药的酶传感器

采用丝网印刷技术制作厚膜型电极,通过交联法将乙酰胆碱酯酶固定在电极上,开发快速检测水中有机磷农药的酶传感器.采用循环伏安法对电极所做的检测结果表明电极彼此间的差异在10%以内,具有较好的一致性.通过在交联剂、酶和底物等方面优化传感器的工作参数,确定了戊二醛、酶和底物的浓度分别为0.2%、0.5 mg/mL和10 mmol/L时,传感器响应最好.在交联固定酶的情况下,根据酶活受到有机磷抑制的原理,采用时间-电流法对特丁硫磷和对硫磷进行了检测.结果表明:这2种有机磷的检测限都可以达到1 ng/mL,线性区间1～10 000ng/mL.在物理吸附固定酶的情况下,采用循环伏安法对特丁硫磷进行了检测.结果表明:采用循环伏安法检测的灵敏度比采用时间-电流法的灵敏度要高.     

光电催化降解壬基酚影响因素研究

采用sol-gel法制备TiO2薄膜光电极,以该电极为工作电极,铂丝作对电极,饱和甘汞电极为参比电极,对壬基酚的光电催化降解进行了研究。结果表明:该电极具有n型半导体的特征行为。在外加偏压为+0.8V、pH=5、、30mg/L的H2O2中对初始浓度为20mg/L的壬基酚溶液光照180min降解率达62.22%。讨论了氧的存在、外加偏压、pH等因素对光电催化反应的影响。     

ACF电极电解处理含NaCl结晶紫染料废水的研究

以吸附结晶紫达到饱和的活性炭纤维为阳极,在NaCl介质中对初始浓度为100 mg/L的结晶紫染料废水进行了电解脱色处理。实验考察了NaCl浓度、pH值和电流密度等对溶液脱色率的影响,测定了电解时溶液中生成的游离氯浓度及不同电解时间后溶液的紫外-可见吸收光谱曲线,并对不同电解时间后溶液的归一化吸光度比值进行了计算。结果发现,溶液中所产生的游离氯的浓度随电解时间的增加快速上升,20 min时就几乎达到了最大值;在活性氯的作用下,结晶紫分子中的大π共轭体系被破坏,溶液迅速脱色;电解液中所含的NaCl浓度、电解液的pH值和电流密度等都对脱色率有影响;在一定实验条件下,初始浓度为100 mg/L的结晶紫染料废水在电解60 min后脱色率可高达99.3%。     

旋转电极式电除尘器技术研究

简要阐述了旋转电极式电除尘器的原理、结构、应用及特点,并总结出其除尘效率计算公式。研究结果表明：该技术能最大限度的减少二次扬尘,显著降低电除尘器出口排放浓度,对高比电阻粉尘有很好的收尘效果。与其他除尘器比较,旋转电极式电除尘器节省场地、空间和能源,性价比高,具有较广阔的应用前景。     

接地极的土壤腐蚀

接地极是接地装置的主要组成部分,接地极埋设在土壤中,用于泄流,保障电网和电气设备的安全运行。近年来,接地极的腐蚀损坏造成的事故屡有发生,接地极的土壤腐蚀引起了普遍的重视,防止接地极腐蚀已成为一个重要的研究课题。本文介绍了目前我国电网和电气设备接地极的选材,接地极土壤腐蚀的特点,并对接地极防腐蚀方法做了简单总结。