芳纶1313纤维的特点及其在个体防护服装领域的应用

对芳纶1313纤维的发展历程、性能特点、生产加工、产品应用等各个方面进行了详细的阐述。芳纶1313纤维是一种性能优异的阻燃耐热纤维,在安全生产领域有着广阔的应用前景。自问世以来历经半个多世纪的发展,其在安全生产领域的应用价值已经得到广泛的认可。由于芳纶1313纤维具备一系列的突出优点,同时也存在某些缺陷,因此建议扬长避短,充分发挥这种纤维的种种优点,同时通过纤维改性、改进和优化生产工艺等方法,充分发挥其在安全生产领域的应用,使之产生应有的社会效益和经济效益。     

超高效液相色谱-串联质谱法测定污水中14种有机磷酸酯阻燃剂

建立了超高效液相色谱-串联质谱(UPLC-MS/MS)联用法同时测定污水中14种有机磷酸酯阻燃剂(OPEs)的分析方法.样品采集后,经GF/C膜过滤,HLB固相萃取小柱净化后进样分析.以BEH C18色谱柱为分离柱,乙腈和水混合液为流动相(0.2 mL min-1)梯度洗脱,15 min内可完成14种OPEs的分离.在电喷雾正离子模式下,采用多反应监测模式(MRM)进行质谱测定.在加标浓度为1.0μg·L-1时,14种OPEs在污水处理厂进水和出水中的回收率分别为52.1%—119%、43.6%—114%,相对标准偏差(RSD)分别为1.2%—16.2%、0.4%—9.2%,方法的检出限(LOD)在0.3—6.0 ng·L-1间.方法精密度好,准确度高,可满足同时对污水样品中的14种OPEs进行定性及定量分析的要求.     

Oxidized multiwalled carbon nanotubes modified with 2-(2-hydroxy-5-nitrophenyl)-4,5-diphenyl imidazole for solid phase extraction and preconcentration of some metal ions

In this work, a new procedure for the enrichment of the trace amount of Cu²⁺, Ni²⁺, Co²⁺, Pb²⁺, Fe²⁺, and Zn²⁺ ions based on the utilization of multiwalled carbon nanotubes (MWCNT) modified with 2-(2-hydroxy-5-nitrophenyl)-4,5-diphenyl imidazole as chelating agent prior to their determination by flame atomic absorption spectrometry has been described. The influence of effective parameters including pH, amount of ligand and MWCNT, composition of eluent, and coexisting ions on recoveries of understudy metal ions was examined. At the optimum pH of 5.0, all metal ions were quantitatively sorbed onto the proposed solid phase and completely desorbed with 8?mL of 5.0?mol?L^?1 HNO₃. The detection limit of Cu²⁺, Co²⁺, Ni²⁺, Pb²⁺, Fe²⁺, and Zn²⁺ ions was 1.7, 2.4, 2.3, 2.9, 2.8, and 1.4?µg?L^?1, while the preconcentration factor was 63 for Cu²⁺ and 94 for the other metal ions and relative standard deviations between 1.8 less than 3.0%. The proposed procedure was applied for the analysis of various samples.     

Determination of cobalt by air-assisted liquid–liquid microextraction

Abstract

A rapid and selective technique for extraction, preconcentration and determination of trace amounts of cobalt in water and pharmaceutical samples by air-assisted liquid–liquid microextraction combined with flame atomic absorption spectrometry is proposed. 1-Nitroso-2-naphthol is used as a complexing agent and 1-octanol as an extraction solvent. Parameters relevant for analytical effectivity, i.e. pH of sample solution, concentration of complexing agent, volume of extraction solvent, and number of extraction cycles are optimized using a Box–Behnken design. At optimum conditions, a dynamic linear range of 5–600?µg L^?1 is obtained, with a limit of detection of 1.2?µg L^?1. The method is used for determination of Co(II) in environmental water and pharmaceutical samples.     

Hazardous halogenated substances formed during combustion processes

The results of the emissions from combustion processes and/or from fire accidents show the risk to man and his environment and thus the need for strict legislation and critical analysis of unwanted compounds. These substances or their thermolysis products are often due to incomplete combustion or may result from the interaction of various substances.

In the following we report the formation of octachlorostyrene (OCS) and of high‐toxic substances such as polybrominated dioxins (PBrDD's), dibenzofurans (PBrDF's) by the combustion.

In order to determine a possible source of the non‐manufactured compound OCS, we conducted several model experiments in a combustion chamber at various temperatures from 400 °C to 800 °C. The thermolysis of chlorinated solvents like chloroform or of chlorinated aromatice like pentachlorobenzene produced—among other chlorinated substances—OCS as one of the major products.

Analogous combustion experiments with polyester plastics containing decabromodiphenylether as flame retardant and antimony trioxide as Synergist led to PBrDD's and PBrDF's. Here antimony trioxide seems to play an important role because in absence of this oxide, PBrDD's and PBrDF's were not found in our experimental conditions.     

五氟苯甲酰氯衍生色谱法分析水体中痕量羟基多溴联苯醚

以五氟苯甲酰氯(PFBCl)作为衍生化试剂,气相色谱-电子捕获检测器(Gas chromatography-electron capture detector,GC-ECD)为检测手段,建立了水体中痕量羟基多溴联苯醚(Hydroxylated polybrominated diphenyl ethers,简称OH-PBDEs)的酰基化衍生-GC/ECD检测方法.通过实验讨论了衍生化缓冲溶液、衍生化时间以及衍生后萃取溶液异辛烷的用量对检测结果的影响,确定了最佳的衍生化条件.在最佳的衍生化条件下,4-OH-BDE 42、4’-OH-BDE 49、6-OH-BDE 47、2’-OH-BDE 68和6’-OH-BDE 99的衍生化产物均获得了良好的分离度和色谱响应值.本方法的仪器检出限为0.02—0.14 pg,方法检出限为0.61—4.67 pg.L-1,标准曲线线性相关系数的范围为0.9973—0.9996,相对标准偏差均小于10%.3种采自大连市不同地区环境水样的加标回收率检测结果表明,所建立的分析方法适于水体中痕量OH-PBDEs的检测.     

水体和甘蓝及土壤中毒死蜱残留检测方法

研究运用不同的样品前处理方式,在装配火焰光度检测器的气相色谱(GC-FPD)上检测,建立了有机磷杀虫剂毒死蜱在水样、土壤和甘蓝中的残留测定方法.研究表明,不同样品中的毒死蜱残留采用本文中介绍的前处理方法是可行的,用石油醚盐析提取和净化水样中毒死蜱,采用丙酮振荡提取甘蓝中毒死蜱,选用索氏提取法提取土壤中毒死蜱,并经液液分配净化后,采用OV-101大口径毛细管柱(30 m×0.53 mm×1.0μm),在装配火焰光度检测器(FPD和磷滤光片)的气相色谱上测定.该分析方法下,毒死蜱的保留时间为1.74 min,线性范围在1.0×10-11—1.0×10-8g之间,其线性相关系数为0.9998,最小检出量为2.0×10-12g.在设定的较低添加浓度的条件下,毒死蜱在水样、土壤与甘蓝上的添加回收率为80%—120%,变异系数均小于5%.该分析方法灵敏、准确、操作简便,适合水样、甘蓝和土壤中低浓度毒死蜱的残留检测.     

Determination of persistent organic pollutants by gas chromatography/laser multiphoton ionization/time-of-flight mass spectrometry

An authentic mixture of polychlorinated biphenyls was measured using a short wide-bore capillary column for the group separation of major components present in an actual sample of Kanechlor. The limits of detection were improved by ca. 2 fold in comparison with those obtained using a conventional capillary column, since the retention time was reduced and the amount of analytes introduced into the mass spectrometer per unit time could be increased. On the other hand, surface-water and sediment samples containing polycyclic aromatic hydrocarbons (PAHs) were collected from the river located in the vicinity of a waste water treatment plant. Even acenaphthylene, a minor component of the mixture could be measured for the sediment sample, and the concentrations were determined for several heavy PAHs. As demonstrated, a technique involving laser multiphoton ionization/time-of-flight mass spectrometry was useful as a sensitive and selective analytical tool for the trace analysis of persistent organic pollutants in an environmental sample.     

基于3D激光扫描技术的绕腰法采空区资源回收方法研究

针对大多数矿山采空区残留资源回收探测中存在人员、设备进入难,精度低、危险高等问题,我们通过采用三维激光扫描技术恰恰克服了以上困难。应用三维激光自动扫描新技术对采空区进行精密探测,能够安全准确地获取采空区的三维形态和矿石空间分布位置,再通过三维建模软件 Surpac 建立三维可视化实体模型,为回收残留矿石资源提供重要依据;最后通过应用绕腰法综合回收残留矿石,不仅能够减少采准工程量,并把采准与采矿工作很好地结合起来,而且达到了能够高效安全地回采采空区残留矿石目的。工程实例的成功应用,表明此方法在给矿山和国家带来良好的经济社会效益的同时,能够在同类矿山中推广应用。     

溴代阻燃剂在土壤中的迁移转化研究进展

BFRs（溴代阻燃剂）是一种重要的持久性有机污染物,各种传统和新型的BFRs（PBDEs、TBBPA、DBDPE、BTBPE等）在全球环境中被广泛检出,其持久性、生物蓄积性以及对环境和人类健康的潜在毒性引起了人们的极大关注.在归纳和总结国内外关于BFRs在土壤中的迁移转化行为规律研究动态的基础上,重点讨论了吸附/解吸、光降解的机理和影响因素以及厌氧、好氧微生物降解和植物代谢的特点和降解途径.结果表明:吸附/解吸是BFRs在土壤中迁移转化的关键过程,土壤有机质含量和pH是影响其在土壤中迁移的主要影响因素.光解、微生物降解是BFRs在土壤中的主要转化途径,光解是表层土壤中BFRs的主要转化过程,逐步脱溴产生低溴化产物,溴化程度、土壤有机质和矿物质会直接影响其光解速率;厌氧脱溴和好氧微生物降解是BFRs在深层土壤中的主要降解过程,溴化程度与微生物降解密切相关.土壤中BFRs被植物吸收的过程中可能被代谢为低溴化产物,在食物链中积累,危害人体健康.尽管多年来在BFRs方面的研究取得了进展,但对这类污染物的环境行为和归趋的全面了解仍然很难,随着越来越多的新型BFRs被作为传统BFRs的替代品推向市场,建议对这些新兴替代化学品在土壤介质中的迁移转化过程,特别是生物降解进行更多的调查.