Determination and discussion hydraulic retention time in membrane bioreactor system

Based on the microorganism kinetic model, the formula for computing hydraulic retention time in a membrane bioreactor system (MBR) is derived. With considering HRT as an evaluation index a combinational approach was used to discuss factors which have an effect on MBR. As a result, the influencing factors were listed in order from strength to weakness as: maximum specific removal rate K, saturation constant Ks, maintenance coefficient m, maximum specific growth rate ,ua and observed yield coefficient Yobs. Moreover, the formula was simplified, whose parameters were experimentally determined in petrochemical wastewater treatment. The simplified formula is θ= 1.1( 1/β -1)(Kｓ S)/KXo , for oetroehemical wastewater treatment K and Ko eaualed 0.185 and 154.2, resoectively.     

铅芯橡胶支座等效线性分析模型参数的研究

针对目前铅芯橡胶支座等效线性分析模型动力参数选取不够合理的现状 ,笔者通过对铅芯橡胶支座水平动态试验分析 ,系统研究了铅芯橡胶支座等效线性分析模型参数与其几何结构及外加动力荷载特性的关系。研究结果表明 :铅芯橡胶支座等效线性分析模型参数 (水平耗能、等效刚度及等效阻尼比 )主要由其本身的几何构造及组成材料决定 ,且在往复加、卸载循环过程中具有较好的稳定性。笔者对试验数据进行数学统计分析 ,归纳出一些经验公式 ,为其等效线性化动力分析模型参数的合理选取提供了计算方法 ,从而提高其动力分析结果的安全性。     

钙类化合物固硫作用动力学分析

通过钙类化合物对动力用煤固硫作用的模拟试验 ,对不同钙化合物固硫率 (J)与Ca/S及助剂关系的研究 ,得到了钙类化合物固硫率的次序 ,即 :JNaOH +CaO>JCaCO3>JCaO>JCa(OH) 2 ,结果说明固硫率与钙类化合物的存在形式有关 ,并解释了其固硫作用机理     

METHODOLOGIES FOR CALIBRATION AND PREDICTIVE ANALYSIS OF A WATERSHED MODEL1

ABSTRACT: The use of a fitted parameter watershed model to address water quantity and quality management issues requires that it be calibrated under a wide range of hydrologic conditions. However, rarely does model calibration result in a unique parameter set. Parameter nonuniqueness can lead to predictive nonuniqueness. The extent of model predictive uncertainty should be investigated if management decisions are to be based on model projections. Using models built for four neighboring watersheds in the Neuse River Basin of North Carolina, the application of the automated parameter optimization software PEST in conjunction with the Hydrologic Simulation Program Fortran (HSPF) is demonstrated. Parameter nonuniqueness is illustrated, and a method is presented for calculating many different sets of parameters, all of which acceptably calibrate a watershed model. A regularization methodology is discussed in which models for similar watersheds can be calibrated simultaneously. Using this method, parameter differences between watershed models can be minimized while maintaining fit between model outputs and field observations. In recognition of the fact that parameter nonuniqueness and predictive uncertainty are inherent to the modeling process, PEST's nonlinear predictive analysis functionality is then used to explore the extent of model predictive uncertainty.     

正交化方法在水质模型参数确定中的应用

本文根据常微分方程参数反问题的数学理论，将正交化方法同有限差分法结合用于确定水质模型参数，并与正则化方法、最速下降法和共轭梯度法作了比较。其计算结果对比表明，正交化方法具有快速、简便、可靠的特点。更适合于水质模型参数的确定。     

臭氧-生物活性炭深度处理黄浦江水源水中试研究

以黄浦江水源水厂的滤后水为试验对象，进行饮用水O3-BAC深度处理工艺影响因素的中试研完。针对进水水质的试验结果表明，最优臭氧投加量为3mg／L左右，空床停留时间为15min左右。试验结果可为工程设计提供有益的参考。     

熵法估参在环境监测数据频率分析中的应用

以最大信息熵原理为理论基础的熵法估参方法，是一种具有严格物理和数学意义的新型参数估计方法，本文针对珠江广州河段主要污染物含量长年监测数据，对比熵法与传统方法矩法对四参数Г分布的估参结果，并以频率绝对离盖和最小为准则进行判定，结果表明，熵法估参结果与矩法总体上相当接近，且大部分样本的熵法估计参数优于矩法，在环境监测数据频率分析中具有实用性和推广价值。     

Lyapounov理论在矿井通风系统稳定性分析中的应用

当矿井通风系统的特征参数发生变化时,矿井通风系统的风流状态也会发生变化,这些变化是否会影响矿井通风系统的稳定工作,对这个问题进行研究有利于确保安全生产.本文根据Lyapounov稳定性理论对矿井通风系统的稳定性进行分析,得到矿井通风系统在其正常的工作区段,系统特征参数发生一定的变化时,其状态是稳定的;当变化超过一定的界限后,系统变得不稳定,不利于系统正常功能的实现.     

船舶塑料垃圾热解特性及动力学分析

利用热重分析(TGA)研究船舶塑料垃圾在不同升温速率和不同气氛下的热解特性,并得到了热解动力学参数。结果表明,船舶塑料垃圾的热解过程主要有3个阶段,比一般塑料热解复杂;随着升温速率增大,最大热解速率和最大热解速率温度等热解特性参数也增大,反应变得更剧烈;N2/CO2比为4∶1时,热解反应进行得最完全,固体残留率最少。动力学分析表明,采用3个连续一级反应模型能很好地拟合实验数据;不同的升温速率和气氛比对反应各阶段活化能均有不同程度的影响。