高速公路路面沉积物的污染特性

对湖南省长潭西高速公路不同采样点的路面沉积物进行取样分析,并检测了样品的颗粒级配、COD、重金属(Cu、Zn、Pb和Cd)和有机质。结果表明,路面沉积物主要以粒径<0.15 mm的颗粒为主;较小颗粒物中的COD含量高于较大颗粒中的COD含量;粒径在0.15 mm以下的颗粒物所含重金属Cu、Zn、Pb和Cd的浓度普遍高于所选的土壤标准值,降雨一旦形成径流将会产生严重的污染危害;沉积物中的有机质含量对重金属的吸附有一定的影响,有机质含量越高,沉积物中重金属含量相对也高。     

响应面法优化聚丙烯酸/腐殖酸/累托石吸附剂的制备条件

以累托石、丙烯酸及腐殖酸为原料制备出能同时吸附重金属和多环芳烃的吸附剂聚丙烯酸/腐殖酸/累托石,采用响应面试验设计法优化吸附剂的制备条件。利用Design Expert软件,建立了预测吸附剂对Cd2+、菲吸附量的二次回归模型,对回归模型进行了方差分析,并确定了吸附剂的最佳制备条件。结果表明,二次回归模型能较好地模拟Cd2+、菲的吸附量与影响因子丙烯酸中和度、引发剂量和交联剂量之间的关系。各因子对Cd2+吸附量的影响次序为:交联剂量>引发剂量>丙烯酸中和度;对菲吸附量的影响次序为引发剂量>交联剂量>丙烯酸中和度。吸附剂的最佳制备条件为:累托石、丙烯酸和腐殖酸三者的质量比为65∶30∶5,丙烯酸中和度、引发剂量和交联剂量分别为75.16%、2.57%和0.44%。在此优化条件下制备的吸附剂对Cd2+和菲的吸附量分别为170.19 mg/g和7.36 mg/g。     

堇青石负载Pd和过渡金属氧化物催化剂的表征及其对CO的催化氧化活性

以堇青石蜂窝陶瓷(CC)为载体,采用浸渍法制备了堇青石负载Pd和过渡金属混合氧化物催化剂,记作Pd-M-Mn(M=Cu,Co,Fe,Ni)/CC。实验结果表明:Pd-Co-Mn/CC催化剂的催化活性最高;随着Pd负载量的增加,CO转化率提高;当Pd负载量为1.00%时,反应温度为150℃时CO转化率达到98%,200℃时CO转化率达到100%;在反应温度150℃条件下,Pd-Co-Mn/CC催化剂(Pd负载量1.00%)的CO转化率在前30h内小幅度下降,随后稳定在90%以上,反应100h后,催化剂表面颜色由黑色变为棕褐色。     

Industrial wastewater pre-treatment for heavy metal reduction by employing a sorbent-assisted ultrafiltration system

This work examined the adoption of a sorbent-assisted ultrafiltration (UF) system for the reduction of Pb(II), Cu(II), Zn(II) and Ni(II) from industrial wastewater. In such a system metals were removed via several processes which included precipitation through the formation of hydroxides, formation of precipitates/complexes among the metal ions and the wastewater compounds, adsorption of metals onto minerals (bentonite, zeolite, vermiculite) and retention of insoluble metal species by the UF membranes. At pH = 6 the metal removal sequence obtained by the UF system was Pb(II) > Cu(II) > Zn(II) > Ni(II) in mg g⁻¹ with significant amount of lead and copper being removed due to chemical precipitation and formation of precipitates/complexes with wastewater compounds. At this pH, zinc and nickel adsorption onto minerals was significant, particularly when bentonite and vermiculite were employed as adsorbents. Metal adsorption onto zeolite and bentonite followed the sequence Zn(II) > Ni(II) > Cu(II) > Pb(II), while for vermiculite the sequence was Ni(II) > Zn(II) > Cu(II) > Pb(II) in mg g⁻¹. The low amount of Pb(II) and Cu(II) adsorbed by minerals was attributed to the low available lead and copper concentration. At pH = 9 the adoption of UF could effectively reduce heavy metals to very low levels. The same was observed at pH = 8, provided that minerals were added. The prevailing metal removal process was the formation of precipitates/complexes with wastewater compounds.     

Risks of using membrane filtration for trace metal analysis and assessing the dissolved metal fraction of aqueous media--a study on zinc, copper and nickel

Membrane filtration is commonly performed for solid-liquid separation of aqueous solutions prior to trace metal analysis and when assessing “dissolved” metal fractions. Potential artifacts induced by filtration such as contamination and/or adsorption of metals within the membrane have been investigated for different membrane materials, metals, applied pressures and pre-cleaning steps. Measurements have been conducted on aqueous solutions including well-defined metal standards, ultrapure water, and on runoff water from corroded samples.Filtration using both non-cleaned and pre-cleaned filters revealed contamination and adsorption effects, in particular pronounced for zinc, evident for copper but non-significant for nickel. The results clearly show these artifacts to be non-systematic both for non-cleaned and pre-cleaned membranes. The applied pressure was of minor importance.Measurements of the labile fraction by means of stripping voltammetry clearly elucidate that membrane filtration followed by total metal analysis cannot accurately assess the labile or the dissolved metal fraction.     

大宝山矿区水体和沉积物中重金属的污染评价

分别于丰水期和枯水期对广东省大宝山矿区铁龙拦泥坝至凉桥河段水体中溶解态的重金属进行了调查,应用EPA推荐的健康风险评价模型发现,水体中非致癌物通过饮水途径所导致平均个人年风险排列顺序是Cu〉Pb〉Zn,最大值的平均个人年风险在丰水期和枯水期的平均值分别是2.14×10-7 a-1和4.13×10-7 a-1,小于国际防辐射委员会（ICRP）推荐的最大可接受平均个人年风险5.0×10-5a-1。致癌物Cd的平均个人年风险在丰水期和枯水期的平均值分别是3.52×10-4 a-1和4.53×10-4 a-1,大于ICRP推荐的最大可接受值,同时也大于非致癌物3～4个数量级。另外,通过对枯水期沉积物的重金属总量分析,发现凉桥槽对坑支流受水体pH的影响,导致其沉积物重金属的浓度最高。根据Long和Macdonald利用生物效应数据库法建立的沉积物质量基准,发现除冷水泾外,其他采样点的平均效应中值指数（mERMQ）值都大于1.5,可见沉积物中的重金属会对当地底栖生物产生毒害作用。     

PVA降解混合菌系生长和产酶的营养条件分析

研究碳源、氮源以及不同金属离子对PVA降解混合菌系生长和产酶的影响。结果表明,混合菌系生长过程中无机氮源优于有机氮源;补充碳源可促进混合菌系的生长,但酶活比不添加时稍有降低。金属离子对酶活影响的正交实验表明Mg2＋浓度影响最大,其次是Fe2＋和K＋浓度,Ca2＋、Mn2＋、Zn2＋和Cu2＋浓度影响较小;最佳浓度分别为Mg2＋0.05 g/L、Fe2＋0.04 g/L、K＋2 g/L和Ca2＋0.05 g/L。     

表面铜螯合磁性二氧化硅固定化漆酶及其催化降解水中2，4-二氯酚

利用磁性二氧化硅表面接枝的聚丙烯酰胺络合Cu2＋离子,制备了表面铜螯合磁性SiO：材料,采用傅立叶红外光谱（FT．IR）,X射线衍射（XRD）对该磁性材料进行了表征,并通过配位作用固定化漆酶,考察了其对水中2,4-二氯酚（2,4-DCP）的催化降解效能及主要影响因素。结果表明,表面铜螯合磁性SiO：固定化漆酶对2,4-DCP具有较好的催化降解效能,利用8g／L固定化漆酶催化降解50mL初始浓度为24．25mg／L的2,4-DCP,反应12h2,4-DCP去除率达91％;当pH值在3．0～6．0范围内时,2,4-DCP的去除率随反应pH值的增加而升高;2,4-DCP初始浓度在14．39～257．6mg／L范围内时,反应12h,2,4-DCP的去除率均达85％以上;给酶量增加促进2,4-DCP的去除,但过多的给酶量导致单位质量固定化漆酶催化降解2,4-DCP的速率下降;水中硫酸根离子对固定化漆酶催化降解2,4-DCP具有明显的促进作用,而碳酸氢根离子明显抑制反应的进行。     

餐厨垃圾厌氧消化中硬脂酸钙的形成及作用

在稳定运行的餐厨垃圾单相厌氧消化体系中,出现白色颗粒状物质,且随着负荷的提高,其数量和粒径不断增加。利用能谱技术分析白色颗粒的元素组成,结合傅里叶红外光谱和13C核磁共振技术分析白色颗粒中的官能基团。经过研究分析认为,该白色颗粒的主要成分为长链羧酸钙盐,具体为硬脂酸钙。同时,对其形成过程进行了分析。该物质的形成对餐厨垃圾中油脂的去除提供了新的思路和途径。     

Comparison of EDTA-enhanced phytoextraction and phytostabilisation strategies with Lolium perenne on a heavy metal contaminated soil

Phytoremediation is a promising and cost-effective strategy to manage heavy metal polluted sites. In this experiment, we compared simultaneously phytoextraction and phytostabilisation techniques on a Cd and Zn contaminated soil, through monitoring of plant accumulation and leaching. Lolium perenne plants were cultivated for 2 months under controlled environmental conditions in a 27.6 dm³-pot experiment allowing the collect of leachates. The heavy metal phytoextraction was promoted by adding Na-EDTA (0.5 g kg⁻¹ of soil) in watering solution. Phytostabilisation was assessed by mixing soil with steel shots (1%) before L. perenne sowing. Presence of plants exacerbated heavy metal leaching, by improving soil hydraulic conductivity. Use of EDTA for phytoextraction led to higher concentration of heavy metal in shoots. However, this higher heavy metal extraction was insufficient to satisfactory reduce the heavy metal content in soil, and led to important heavy metal leaching induced by EDTA. On the other hand, addition of steel shots efficiently decreased both Cd and Zn mobility, according to 0.01 M CaCl₂ extraction, and leaching. However, improvement of growth conditions by steel shots led to higher heavy metal mass in shoot tissues. Therefore, soil heavy metal mobility and plant metal uptake are not systematically positively correlated.