An isolated AC module for photovoltaic energy conversion

In this paper, an isolated ac module with pseudo dc-link and galvanic isolation is proposed for photovoltaic energy conversion. The studied grid-tie ac module can individually extract the maximum solar power from each photovoltaic panel and transfer to ac utility system. It consists of an interleaved active-clamping single-ended primary-inductive circuit (SEPIC) with a secondary voltage doubler, a full-bridge polarity selector operating under line frequency to achieve high efficiency. For the studied topology, key features such as reduced input current ripple, zero-voltage switching (ZVS) of primary switches, low reverse-recovery current of the output diodes, and lower switch voltage stress are obtained. Also, to reduce input current ripple, an interleaved control strategy is adopted. A simple control strategy is proposed to generate a rectified sinusoidal waveform voltage at the pseudo dc-link capacitors and achieve the high maximum power point tracking (MPPT) accuracy. The operation principles and design considerations of the studied ac module are analyzed and discussed. A prototype with 25–60 V dc input, 110 V/60 Hz ac output and 150 W power rating has been constructed for verifying the feasibility of the proposed ac module.     

一体式膜生物反应器污水处理工艺研究

在一体式膜生物反应器研制开发实验及反应器各参数运行协调理论分析的基础上,提出了一体式膜生物反应器工艺各参数间的设计原则、方法、步骤及设计实例,对该工艺的运行能耗作了评价.     

A signal-amplified whole-cell biosensor for sensitive detection of Hg2+ based on Hg2+-enhanced reporter module

A signal-amplified mercury sensing biosensor with desired sensitivity was developed through firstly using the GFP mutant with fluorescence increasing response towards Hg²⁺ as the reporter module. The developed biosensor showed response for Hg²⁺ in a relatively wide range of 1–10,000 nmol/L, and the detection limit was improved one or two orders of magnitude in comparison with most metal-sensing biosensors in similar constructs. In addition, the biosensor could distinguish Hg²⁺ easily from multiple metal ions and displayed strong adaptability to extensive pH conditions (pH 4.0–10.0). More importantly, the developed biosensor was able to provide an initial assessment of Hg²⁺ spiked in the environmental water with the recoveries between 85.70% and 112.50%. The signal-amplified strategy performed by the modified reporter module will be widely applicable to many other whole-cell biosensors, meeting the practical requirements with sufficient sensing performance.     

系统电磁脉冲效应摸底试验初探

目的研究武器装备系统的电磁脉冲效应。方法采用系统理论计算和部件摸底试验相结合的方法,以某装备的信息处理模块为测试对象,开展电磁脉冲近场辐照和电流注入试验,通过改变场强、注入电流等试验条件,探讨电磁脉冲对该模块的电磁效应。结果得出了工作状态下该模块的电磁脉冲干扰效应试验数据,该模块在310 V/m的辐照场强或电缆耦合电流为4.3~6.4 A时会出现敏感状态,多次测试时百分之百敏感阈值略高。结论对部件开展近场辐照和电流注入的电磁脉冲摸底试验方法可行,为进一步研究系统装备电子部件的电子脉冲效应提供了借鉴。     

污水厂污泥处置方法评价模型及应用研究

总结目前污泥处置现状,讨论各污泥处置方法的优缺点,对污水厂污泥处置方法影响因素进行分析,并提出评价指标,建立污水污泥处置方法综合评价决策模型,确立目标层和评价指标层影响因素权重值。运用层次分析法对污泥处置方法进行评价分析,得出处置方法的综合排序。     

基于GaN技术的大功率T/R组件可靠性设计与分析

结合T/R组件的工作原理,对影响大功率T/R组件可靠性的关键技术进行了设计与分析。通过与现有的基于GaAs技术的T/R组件设计电路对比分析,阐述了基于Ga N技术的大功率、高可靠性T/R组件的电路设计方法。     

Feasibility and simulation model of a pilot scale membrane bioreactor for wastewater treatment and reuse from Chinese traditional medicine

The lack and pollution of water resource make wastewater reuse necessary. The pilot scale long-term tests for submerged membrane bioreactor were conducted to treat the effluents of anaerobic or aerobic treatment process for the high-strength Chinese traditional medicine wastewater. This article was focused on the feasibility of the wastewater treatment and reuse at shorter hydraulic retention time （HRT） of 5.0, 3.2 and 2.13 h. MLSS growth, membrane flux, vacuum values and chemical cleaning periods were also investigated. The experimental results of treating two-phase anaerobic treatment effluent demonstrated that the CODfilt was less than 100 mg/L when the influent COD was between 500-10000 mg/L at HRT of 5.0 h, which could satisfy the normal discharged standard in China. The experimental results to treat cross flow aerobic reactor effluent demonstrated that the average value of CODfilt was 17.28 mg/L when the average value of influent COD was 192.84 mg/L at HRT of 2.13 h during 106 d, which could completely meet the normal standard for water reuse. The maximum MLSS and MLVSS reached 24000 and 14500 mg/L at HRT of 3.2 h respectively. Membrane flux had maximal resume degrees of 94.7% at vacuum value of 0.02 MPa after cleaning. Chemical cleaning periods of membrane module were 150 d. A simulation model of operational parameters was also established based on the theory of back propagation neural network and linear regression of traditional mathematical model. The simulation model showed that the optimum operational parameters were suggested as follows： HRT was 5.0 h, SRT was 100 d, the range of COD loading rate was between 10.664-20.451 kg/（m3.d）, the range of MLSS was between 7543-13694 mg/L.     

矿井通风网络的社团结构及灾害控制研究

为研究矿井通风网络的社团结构特征和有效控制灾害在通风网络中的传播范围,根据通风网络的连接特点对传统的GN算法进行改进,以淮南某矿井的通风网络结构为例进行说明,发现矿井通风网络具有较强的社团结构特征;引入强弱社团结构和外内连接边数比后,社团结构的划分更符合实际。根据矿井通风网络社团间的连接关系,就会找到灾害传播的关键分支与节点并加以控制,降低灾害对相邻社团危害程度,控制灾害的蔓延范围。     

膜萃取处理水溶液中镉、锌离子的传质模型

通过测量中空纤维膜器管程和壳程RTD曲线,发现对于中低装填密度的膜器,管程的实际流动与理想层流有较大差异,而壳程的流动与理想层流符合较好,膜器管程和壳程流动RTD曲线的平均停留时间的实验值与理论值相差很小,停留时间相对偏差小于±5%.通过计算,得出与实际RTD曲线符合较好的速度分布公式,依据镉离子传质数据,提出了较为准确的低流速下的传质系数预测关联式,并用此关联式预测锌离子的出口浓度,预测值与实验值符合较好,相对偏差在±25% 以内.     

桩体材料弹性模量对桩基负摩阻力特性的影响

分析了桩体材料弹性模量对于桩基负摩阻力特性的影响,指出不同的桩体材料弹性模量会使得桩身压缩值不同,对于复合地基中常用的低弹性模量桩应当考虑桩身压缩对于桩基性状的影响。有限元分析结果表明,影响桩基负摩阻力特性的桩体材料弹性模量存在一个临界值。当桩体材料模量大于此值时,可以忽略桩身材料模量的影响;桩体材料模量小于此值时,桩身压缩变形增大,桩顶位移和桩端位移会有很明显的差异,会造成中性点位置上移,桩身中最大附加应力降低。这对复合地基中桩体负摩阻力特性的研究是有益的。