气固两相流90°弯管抗冲蚀结构优化

为了提高天然气输送管道90°弯管的耐磨性能,提出了1种三段弯曲式弯管,通过对弯管弯曲段进行三段式改进来减小弯管中二次流的大小,优化弯管内的流场,改善弯管的冲蚀磨损状况。利用COMSOL仿真软件建立三段式弯管模型,并以弯管弯曲段和出口段二次流平均值之和最小为优化目标,在约束条件下凭借COMSOL中的COBYLA优化算法得到了最优管形;用Fluent对优化后的三段式弯管进行冲蚀数值模拟并与一段式弯管的模拟结果进行对比分析。研究结果表明:与一段式90°弯管相比,优化后的三段式弯管流场更加平稳,其弯曲段的二次流强度大幅降低,弯管壁面的冲蚀磨损程度得到较大的改善。     

River water quality management model using genetic algorithm

Conventional mathematical programming methods, such as linear programming, non linear programming, dynamic programming and integer programming have been used to solve the cost optimization problem for regional wastewater treatment systems. In this study, a river water quality management model was developed through the integration of a genetic algorithm (GA). This model was applied to a river system contaminated by three determined discharge sources to achieve the water quality goals and wastewater treatment cost optimization in the river basin. The genetic algorithm solution, described the treatment plant efficiency, such that the cost of wastewater treatment for the entire river basin is minimized while the water quality constraints in each reach are satisfied. This study showed that genetic algorithm can be applied for river water quality modeling studies as an alternative to the present methods.     

米曲霉产氨基酰化酶条件及部分酶学性质研究

通过单因子和多因子摇瓶正交优化试验,确定了米曲霉液态发酵产氨基酰化酶的最佳发酵条件.优化发酵培养基组成(ρ/gL-1):葡萄糖40,蔗糖10,可溶性淀粉20,蛋白胨2.5,马铃薯液1000mL,pH自然.培养基装量50mL/250mL三角瓶,接种量4%.培养温度30℃,转速100r/min,发酵时间42h.每50mL培养物的总酶活由优化前的2627u提高到7338u,是优化前的2.79倍.研究了米曲霉氨基酰化酶的部分酶学性质.该酶催化反应的最适pH为7.0,最适温度为40℃,低浓度的Co2 (5×10-4mol/L)对酶活激活作用显著.图5表2参8     

Incorporating the Effects of Socioeconomic Uncertainty into Priority Setting for Conservation Investment

Abstract:  Uncertainty in the implementation and outcomes of conservation actions that is not accounted for leaves conservation plans vulnerable to potential changes in future conditions. We used a decision-theoretic approach to investigate the effects of two types of investment uncertainty on the optimal allocation of global conservation resources for land acquisition in the Mediterranean Basin. We considered uncertainty about (1) whether investment will continue and (2) whether the acquired biodiversity assets are secure, which we termed transaction uncertainty and performance uncertainty, respectively. We also developed and tested the robustness of different rules of thumb for guiding the allocation of conservation resources when these sources of uncertainty exist. In the presence of uncertainty in future investment ability (transaction uncertainty), the optimal strategy was opportunistic, meaning the investment priority should be to act where uncertainty is highest while investment remains possible. When there was a probability that investments would fail (performance uncertainty), the optimal solution became a complex trade-off between the immediate biodiversity benefits of acting in a region and the perceived longevity of the investment. In general, regions were prioritized for investment when they had the greatest performance certainty, even if an alternative region was highly threatened or had higher biodiversity value. The improved performance of rules of thumb when accounting for uncertainty highlights the importance of explicitly incorporating sources of investment uncertainty and evaluating potential conservation investments in the context of their likely long-term success.     

Metropolitan Open-Space Protection with Uncertain Site Availability

Abstract:  Urban planners acquire open space to protect natural areas and provide public access to recreation opportunities. Because of limited budgets and dynamic land markets, acquisitions take place sequentially depending on available funds and sites. To address these planning features, we formulated a two-period site selection model with two objectives: maximize the expected number of species represented in protected sites and maximize the expected number of people with access to protected sites. These objectives were both maximized subject to an upper bound on area protected over two periods. The trade-off between species representation and public access was generated by the weighting method of multiobjective programming. Uncertainty was represented with a set of probabilistic scenarios of site availability in a linear-integer formulation. We used data for 27 rare species in 31 candidate sites in western Lake County, near the city of Chicago, to illustrate the model. Each trade-off curve had a concave shape in which species representation dropped at an increasing rate as public accessibility increased, with the trade-off being smaller at higher levels of the area budget. Several sites were included in optimal solutions regardless of objective function weights, and these core sites had high species richness and public access per unit area. The area protected in period one depended on current site availability and on the probabilities of sites being undeveloped and available in the second period. Although the numerical results are specific for our study, the methodology is general and applicable elsewhere.     

城市污水回用于农业的技术经济分析——以以色列农业灌溉为例

城市污水回用于农业是污水资源化的有效途径。论述了污水灌溉对农业和环境的影响 ,并以以色列为例对污水回用于农业进行了经济效益分析 ,同时介绍了决定用水组成、回用水质以及农作物的组成等的优化模型     

我国中小城市大气污染总量控制研究

本文提出了一套适合于我国中小城市大气污染总量控制研究的技术路线和模型。通过环境容量规划和污染综合治理规划的有机结合，从而达到以优化的方式协调经济发展与环境保护的矛盾。对镇江市的应用结果表明，本文提出的技术路线和模型是合理可行的。所给出的总量控制方案既能符合经济发展的需要，又能经济有效地控制并改善区域的大气环境质量。     

多循环CCRs法在分离燃煤锅炉尾部烟气中CO2方面的应用

随着温室效应和全球变暖的加剧,煤燃烧所排出的CO2作为引起温室效应的主要气体而引起人们的密切关注.由于燃煤锅炉所排放的尾气中所含的CO2的体积份额低、排放量大,而且处于微负压状态,因此目前控制和分离吸收CO2的方法,包括各类吸收法、吸附法、膜分离法和O2/CO2燃烧技术等,能够经济可行地适用于电力工业燃煤锅炉尾部烟气中CO2分离的方法非常少.与上述各类方法相比,钙基吸收剂CCRs(calcination/carbonation reactions)法是一种新兴的经济可行的分离燃煤锅炉尾部烟气中CO2的方法.对采用该法时,吸收剂的选择、吸收剂在多次CCRs过程中结构特点的变化、提高吸收剂对CO2的吸收容量以及防止吸收剂反应性的衰减等方面进行了详细的阐述.     

中国电子废物循环利用空间优化

基于2014年和2015年环保部发布的省级回收数据,分析了现有传统回收体系下,各省的电子废物回收率变化,发现省级尺度电子废物的回收率呈现较大波动,这与电子废物的跨省流动有密切关系.为此,本文基于现有回收渠道的省际流动网络格局,采用网络分析中的层次聚类方法,揭示全国电子废物流动的区域化特征.结果显示根据区域化特征重新划分市场区,可以使主要市场区的整体回收率波动明显降低,从而为制定合理的回收目标提供参考.针对这一研究结果,提出基于市场区域化特征,建立全国一体化的回收利用市场和差异化的区域性回收目标,有助于充分利用市场机制优化中国电子废物循环利用的空间格局.最后,讨论了生产者主导和处理企业主导两种治理机制对空间优化的潜在影响.     

高温高含二氧化碳条件下五种含Cr钢适用性评价

目的 预测某高温高含二氧化碳油井中管柱的腐蚀情况,为该油井推荐安全经济的材质。方法 采用高温高压反应釜模拟现场工况进行腐蚀试验,通过失重法、扫描电子显微镜(SEM)和X射线能谱分析(EDS)对五种含Cr钢的适用性进行评价。结果 在40~160 ℃温度范围内,五种钢材随温度的升高,其均匀腐蚀速率先升高后降低,且均在80 ℃时达到最大值。3Cr钢的腐蚀速率最高,在整个温度范围内,均远高于0.076 mm/a。在温度为120 ℃时,9Cr钢开始出现局部腐蚀。在温度为160 ℃时,13Cr钢有一定的局部腐蚀倾向。S13Cr、22Cr钢在整个温度范围内的腐蚀速率都较低,试验后试样表面平整连续,耐蚀性能好。结论 建议在采出井井筒中上部40~80 ℃较低温度井段选用9Cr钢,中部80~120 ℃中高温井段选用13Cr钢,底部120~160 ℃高温井段选用S13Cr钢。