淀粉/凹凸棒粘土复合吸附絮凝材料的研究

采用接枝聚合法在硅烷化凹凸棒粘土(OATP)表面接枝淀粉,制备淀粉/凹凸棒粘土(ATP)复合吸附絮凝材料.采用傅里叶变换红外光谱(FT-IR)、扫描电子显微镜(SEM)对淀粉/ATP进行了表征,并对其制备条件进行了优化.结果表明,当淀粉质量分数(相对OATP质量)为100%,聚合反应时间为3 h,引发剂质量分数为0.003%,反应温度为60℃时,制备的淀粉/ATP对镉离子的最大吸附容量可达到36.78 mg/g.与ATP、OATP相比,淀粉/ATP对镉离子的吸附容量增大了2倍以上.复合材料具有比OATP更强的捕获能力,所形成的絮凝体大而密实,比淀粉絮凝剂具有更好的沉降性能.     

厌氧氨氧化菌与其他细菌之间的协同竞争关系

随着污水脱氮行业的蓬勃发展,各种新工艺、新理论层出不穷.厌氧氨氧化(Anammox)工艺以其独特的优点脱颖而出,成为最具应用前景的新工艺.厌氧氨氧化菌作为该过程的执行者目前已发现5属17种,本文主要对5属17种的厌氧氨氧化菌进行总结,并对厌氧氨氧化菌种内关系中的群体感应系统进行详细介绍,此外还介绍了厌氧氨氧化菌与硝化菌、反硝化菌以及厌氧甲烷氧化菌之间的协同与竞争关系.最后给出常见竞争因素对厌氧氨氧化种群结构的影响,通过控制竞争因素来实现对厌氧氨氧化种群结构的调节.本文将厌氧氨氧化菌微生物生态学与厌氧氨氧化污水处理工艺相结合,为厌氧氨氧化工艺在污水生物处理中的应用提供理论依据.     

限量曝气进水时间对硝化颗粒污泥的影响特性研究

缺氧-好氧环境的交替循环对氨氧化细菌和亚硝酸盐氧化细菌具有重要影响.本研究通过逐渐增加限量曝气进水时间(从10 min至120 min)延长缺氧时段,考察柱形SBR中硝化颗粒污泥对不同缺氧-好氧环境交替循环的响应特性.整个研究过程中,硝化颗粒污泥保持着稳定的颗粒特征,粒径大于0.8 mm的颗粒污泥占总污泥量的质量分数始终在95%以上,颗粒平均沉降速率维持在125～130 m·h-1之间.尽管缺氧时段不断延长,但NH+4-N去除率和NO-2-N累积率分别稳定在(60±5)%、(85±5)%;此外,在每个周期的曝气反应时段,NH+4-N的去除速率以及NO-2-N和NO-3-N的累积速率分别保持在90mg·(L·h)-1、70 mg·(L·h)-1和15 mg·(L·h)-1左右.以上结果表明,限量进水时间的延长及其所造成的不同时间跨度的缺氧环境对硝化颗粒污泥没有较为显著的影响.     

ITFB强化除氨及醌指纹生物群落结构分析

通过改变内循环生物流化床(internal-circulation three-phase bio-fluidized bed,ITFB)的启动水质,提高N/C组成以强化流化床后期的硝化作用.结果表明,高N/C和低进水COD是强化除氨的必要启动条件;强化启动后以模拟生活污水为研究对象,在HRT为2h时,可以实现COD和氨氮的同时高效去除,氨氮的平均去除率为74%,出水氨氮浓度小于10 m g/L.研究利用醌指纹技术对反应系统中微生物群落结构变化进行了跟踪分析,结果表明经过强化除氨启动后,内循环生物流化床生物膜中以Nitrosomonas europaea为代表的硝化细菌数量有所增加;而以Acinetobacter sp.和Pseudomonas sp.为代表的变形细菌的γ亚类数量减少.EQ值始终在0.5左右变化表明生物膜中微生物种群的分布均匀性变化较小.所有测试样品中UQ/MK的比值均大于1,说明生物膜系统中以革兰氏阴性菌为主.     

兼性厌氧苯胺降解菌的分离鉴定及其特性

从处理印染废水的厌氧折流板反应器(ABR)系统中分离、纯化并筛选出1株能以苯胺为唯一碳氮源进行代谢的兼性厌氧苯胺降解菌株AN29.经过形态、生理生化特征试验和16S rDNA序列分析结果,鉴定菌株AN29为假单胞菌(Pseudomonas sp.),其特性为:降解苯胺的最适温度为37℃,降解苯胺合适的起始pH值为6.5～8.0,可以利用苯胺的最高浓度为4 000mg/L,合适起始浓度为500～2 000mg/L.     

Removal of organic matter and nitrogen from distillery wastewater by a combination of methane fermentation and denitrification/nitrification processes

Introduction D istillery w astew ater m ainly includes spent w ash, w hich is one of the m ost com plex, troublesom e industrial organic effluents. This kind of w astew ater has previously been treated aerobically after dilution w ith other w ash w aters.…     

生物沸石球强化吸附氨氮废水的动力学研究

用一种具有多孔结构特征的沸石球作为载体固定化硝化细菌强化吸附氨氮废水。结果表明,沸石球能快速固定化硝化细菌,吸附动力学表明150 min对氨氮吸附容量达到2.816 mg/g,而且还有继续增加的趋势。假二级动力学方程和Elovich模型的精确拟合说明,生物沸石球对氨氮的吸附过程可能是非均相扩散起作用及以化学吸附反应为主的复杂转化过程。扩散拟合结果表明,氨氮在生物沸石球的吸附是以液膜扩散和颗粒内扩散为吸附速率的控制步骤,活性的硝化细菌对氨氮的硝化使氨氮在微孔的吸附得到了强化。     

INTEGRATING LANDSCAPE ASSESSMENT AND HYDROLOGIC MODELING FOR LAND COVER CHANGE ANALYSIS1

ABSTRACT: Significant land cover changes have occurred in the watersheds that contribute runoff to the upper San Pedro River in Sonora, Mexico, and southeast Arizona. These changes, observed using a series of remotely sensed images taken in the 1970s, 1980s, and 1990s, have been implicated in the alteration of the basin hydrologic response. The Cannonsville subwatershed, located in the Catskill/Delaware watershed complex that delivers water to New York City, provides a contrast in land cover change. In this region, the Cannonsville watershed condition has improved over a comparable time period. A landscape assessment tool using a geographic information system (GIS) has been developed that automates the parameterization of the Soil and Water Assessment Tool (SWAT) and KINEmatic Runoff and EROSion (KINEROS) hydrologic models. The Automated Geospatial Watershed Assessment (AGWA) tool was used to prepare parameter input files for the Upper San Pedro Basin, a subwatershed within the San Pedro undergoing significant changes, and the Cannonsville watershed using historical land cover data. Runoff and sediment yield were simulated using these models. In the Cannonsville watershed, land cover change had a beneficial impact on modeled watershed response due to the transition from agriculture to forest land cover. Simulation results for the San Pedro indicate that increasing urban and agricultural areas and the simultaneous invasion of woody plants and decline of grasslands resulted in increased annual and event runoff volumes, flashier flood response, and decreased water quality due to sediment loading. These results demonstrate the usefulness of integrating remote sensing and distributed hydrologic models through the use of GIS for assessing watershed condition and the relative impacts of land cover transitions on hydrologic response.     

SEWAGE DISCHARGES FROM SHIPS TRANSITING COASTAL SALT WATERS1

ABSTRACT: A number of aspects of the discharging of non-oily wastewaters by transiting ships are treated in this overview paper. In the introduction, options to discharging (the use of holding tank, on board treatment) and the impact of changing regulations are discussed. Assessment of the effects of sewage discharges on coastal waters required that data, at first not available, be generated. An account is given of the characterization of Navy shipboard wastewaters and of experiments involving sewage discharges at sea, measurements of water quality before, during and after an amphibious operation, and fore and aft of transitting Navy ships. A better understanding of sewage dilution after discharge led to the verification of a method for controlled discharging of sewage (and other wastewaters). This method permits limiting the coliform bacteria count in the ship's wake to values below acceptable limits. The final sections contain information on long range effects of ships’sewage discharges, obtained in studies by the U.S. Navy and others, as well as public health considerations.     

新型低温CuO/AC脱硫剂制备——煅烧温度对脱硫活性的影响

首次将炭载型ＣｕＯ／ＡＣ用于烟气脱硫,在最经济的烟气脱硫温度窗口（１２０～２５０℃）显示出高的脱硫活性．考查了煅烧温度和煅烧后脱硫剂的预氧化对脱硫活性的影响,并对脱硫剂进行了ＴＰＤ和ＥＸＡＦＳ表征．结果表明：经２５０℃煅烧的ＣｕＯ／ＡＣ脱硫剂具有最高的脱硫活性．２００℃煅烧,前驱体Ｃｕ（ＮＯ₃）₂未完全分解;高于２５０℃煅烧,活性组分ＣｕＯ被载体Ｃ部分还原为金属Ｃｕ 微晶,从而发生烧结、聚集,以上均导致脱硫剂活性的下降．尽管不同温度煅烧的ＣｕＯ／ＡＣ表现出大的脱硫活性差异,但吸硫后均生成同一反应产物ＣｕＳＯ₄．２５０℃煅烧的ＣｕＯ／ＡＣ脱硫剂Ｃｕ 以ＣｕＯ和Ｃｕ₂Ｏ形态存在,其中的Ｃｕ₂Ｏ在２００℃很容易氧化成ＣｕＯ