海洋环境低水位加速腐蚀研究进展

以海洋环境中一个非常重要的局部腐蚀形式——低水位加速腐蚀(ALWC)为对象,自其检测、发生原因、防护三个方面就国内外的文献报告进行综述分析。在检测方面,首先介绍了常用的宏观观察这一被动形式,并突出其特征,然后介绍了利用海水中可溶性无机氮含量作为ALWC发生概率预测这一主动形式,分析其优势与不足。在发生原因方面,在对将ALWC认定为一种典型的微生物腐蚀(MIC)形式的认知过程进行介绍之后,重点分析了微生物对ALWC作用机制不清晰的原因,并建议在后续研究中突出动态演变过程,结合高通量测序等分子生物学技术,确定在不同的阶段影响ALWC的关键微生物,且进一步在大气-海水体系下研究典型菌株及其协同作用的影响,提出微生物对ALWC的作用机制。在防护方面,根据新建和已建钢结构设施分别对传统和针对ALWC所具有的MIC与局部腐蚀特性的新型高效防护方法进行了介绍,并分析了防护方法的优缺点。     

硫酸盐还原菌对EH40焊接钢海水腐蚀的影响

目的研究无菌和SRB体系中EH40钢焊接接头的母材区、热影响区和焊缝区腐蚀差异。方法利用金相显微镜观察、失重法、电化学测试、扫描电镜和X射线光电子能谱仪等分析手段。结果焊缝区微观组织由块状铁素体(BLF)和魏氏组织(W)组成;热影响区可再分为粗晶区(CGHAZ)和细晶区(FGHAZ)两个区;母材区主要由BLF、AF和少量珠光体组成。在无菌对照体系中,焊缝区腐蚀速率为0.0026 mm/a,混合区次之,为0.0023 mm/a,母材区最小,为0.0019 mm/a。含SRB体系中,各区的腐蚀速率为:焊缝区(0.0037 mm/a)混合区(0.0034 mm/a)母材区(0.0030 mm/a)。热影响区腐蚀产物形貌粗大,点蚀孔也较大。结论焊缝区比母材区容易腐蚀,由此易造成小阳极大阴极加速腐蚀,热影响区容易发生点蚀。SRB能促进三个区域试样腐蚀加速。     

储罐用钢在3.5%NaCl溶液中的腐蚀行为研究

目的对比研究三种油气储罐在水压试验时的腐蚀行为特征。方法选用9Ni钢、Q235碳钢、304L不锈钢储罐用材料以及3.5%NaCl模拟海水溶液,采用开路电位、电化学阻抗谱、动电位极化曲线测试方法研究三种储罐用钢在模拟海水中的电化学腐蚀特征,同时结合浸泡质量损失试验和微观腐蚀形貌进行分析。结果 9Ni钢、Q235碳钢、304L不锈钢稳定后的开路电位(vs.SCE)分别为-0.55、-0.64、-0.10m V,Rt值分别为2 792、1 765、125 100,平均腐蚀深度分别为0.070 6、0.160 3、0.002 5 mm/a。微观腐蚀形貌显示,9Ni钢和Q235碳钢表面发生明显的腐蚀,而304L不锈钢只发生轻微的点蚀。结论在3.5%NaCl模拟海水溶液中,304L不锈钢最耐腐蚀,Q235碳钢最易腐蚀,9Ni钢居于两者之间。因此在9Ni钢和Q235碳钢储罐海水试压过程中需要采取临时保护。     

铍青铜弹簧片应力腐蚀断裂研究

目的研究传感器微动开关弹簧片应力腐蚀的机理,找到断裂原因。方法对弹簧片进行断口形貌观察、能谱成分分析,并进行产品模拟腐蚀实验。结果传感器内部意外进入雨水,在工作温度下形成湿热环境,开关盒中的游离氨在此环境下释放出来,在开关盒内部形成潮湿氨气氛,铍青铜弹簧片工作时凹面一侧承受静拉应力作用,从而在潮湿氨和拉应力共同作用下发生应力腐蚀开裂。结论通过采用无氨酚醛塑料制备开关盒,弹簧片的应力腐蚀得到了有效预防。     

铝合金的实验室盐雾试验腐蚀行为图像特征提取

目的提取铝合金材料在盐雾箱试验中可以表征腐蚀程度的表面形貌图像特征量。方法首先,对采集于表面化学清洗过的试样原始图像进行图像增强等预处理,突出腐蚀部位;其次,基于数字图像处理的分形和小波分解方法提取出分形维数和小波能量特征值。结果与以质量损失量为基础的腐蚀深度特征值进行相关性对比,基于图像分析的特征提取法的准确度和精度比较高。结论该方法可以应用于对试样的腐蚀程度进行定性和定量分析,判断并预测试样的腐蚀速度。     

The importance of temperature in assessing iron pipe corrosion in water distribution systems

Temperature is expected to play a significant role in the corrosion of iron pipes in drinking water distribution systems. Temperature impacts many parameters that are critical to pipe corrosion including biological activity, physical properties of the solution, thermodynamic and physical properties of corrosion scale, and chemical rates. Moreover, variations in temperature and temperature gradients may give rise to new corrosion phenomena worthy of consideration by water treatment personnel.     

萃取-催化氧化光度法测定生物体中H2O2含量研究

提出萃取-催化氧化光度法测定生物体中H2O2含量的新方法.用稀土催化H2O2产生羟基自由基以氧化二苯基碳酰二肼,生成红色二苯基碳酰腙,其最大吸收波长为563.0nm;当二苯基碳酰二肼浓度一定时,△A563与H2O2含量呈量效关系.在0～30μmol/L H2O2 含量范围内,该法能简单、快速、精确地测定生物样品中H2O2实际含量.     

Preparation of rare-earth metal complex oxide catalysts for catalytic wet air oxidation

Catalytic wet air oxidation (CWAO) is one of the most promising technologies for pollution abatement. Developing catalysts with high activity and stability is crucial for the application of the CWAO process. The Mn/Ce complex oxide catalysts for CWAO of high concentration phenol-containing wastewater were prepared by coprecipitation. The catalyst preparation conditions were optimized by using an orthogonal layout method and single-factor experimental analysis. The Mn/Ce serial catalysts were characterized by Brunauer-Emmett-Teller (BET) analysis and the metal cation leaching was measured by inductively coupled plasma torch-atomic emission spectrometry (ICP-AES). The results show that the catalysts have high catalytic activities even at a low temperature (80°C) and low oxygen partial pressure (0.5 MPa) in a batch reactor. The metallic ion leaching is comparatively low (Mn<6.577 mg/L and Ce<0.6910 mg/L, respectively) in the CWAO process. The phenol, COD_Cr, and TOC removal efficiencies in the solution exceed 98.5% using the optimal catalyst (named CSP). The new catalyst would have a promising application in CWAO treatment of high concentration organic wastewater. Translated from Techniques and Equipment for Environmental Pollution Control, 2005, 6(2): 40–44 [译自: 环境污染治理技术与设备]     

中国对流层二氧化硫光化学氧化过程的数值研究

利用一个三维非静力区域大气化学输送模式与中尺度气象模式MM5相连接构成一个数值模拟系统，模拟了中国地区对流层臭氧与其前体物的分布以及二氧化硫转化为硫酸盐的过程，模式扬地面源排放、大气输送和扩散、干沉积、气相化学反应和云雨过程。结果表明：日间，O3浓度主要由NOx和NMHC的源排放和光化学反应过程支配，大气辐射是光化学反应强弱的决定因子，其强度可使SO2、O3和SO4^2-的生成浓度呈现不同的日变化和季节变化，结果表明高浓度的O3对二氧化硫转化为硫酸盐的化学过程有很大的促进作用，然而，这种作用受NMHC浓度的影响很大，较高浓度的NMHC使O3浓度上升，但同时增加了对OH等自由基的消耗，使SO2的转化率降低。     

LPWCO method for the treatment of high concentrated organic wastewater

Based on wet air oxidation (WAO) and Fenton reagent, thispaper raises a new low pressure wet catalytic oxidation(LPWCO)which requires low pressure for the treatment of highlyconcentrated and refractory organic wastewater. Compared withgeneral wet air oxidation, the pressure of the treatment(0.1-0.6MPa) is only one of tens to percentage of latter(3.5-10MPa). Inaddition, its temperature is no more than 180℃.Compared withFenton reagent, while H2O2/COD(weight ratio) less than 1.2, theremoval of COD in the treatment is over twenty percents more thanFenton's even the value of COD is more than 14000mg/L. In thispaper, we study the effect factor of COD removal and the mechanismof this treatment. The existence of synergistic effect (catalytic oxidation and carbonization) for COD removal in H2SO4-Fenton reagent system under the condition of applied pressure and heating (0.1-0.6MPa, 104-165℃) was verified. The best condition of this disposal are as follows:H2O2/COD(weight ratio)=0.2-1.0, Fe2+ 0.6×10-3 mol, H2SO4 0.5mol, COD>1×104mg/L, the operating pressure is 0.1-0.6MPa and temperature is 104-165℃. This method suit to dispose the high-concentrated refractory wastewater, especially to the wastewater containing H2SO produced in the manufacture of pesticide, dyestuff and petrochemical works.