高氮渗滤液缺氧/厌氧UASB-SBR工艺低温深度脱氮

在低温条件下,采用缺氧/厌氧UASB-SBR组合工艺处理实际垃圾填埋场渗滤液.结果表明,该工艺可实现有机物和氮的同步、深度去除.在进水COD平均为11950.2mg/L,NH4+-N为982.7mg/L的条件下,出水分别为390.1mg/L和2.9mg/L,去除率分别为96.7%和99.7%.同时,缺氧UASB1反应器的最大COD负荷达到13kg/(m3×d),最大COD去除速率为12.39 kg/(m3×d),具有高效缺氧反硝化和高效厌氧降解有机物反应的双重功效, 在SBR反应器的缺氧段和缺氧UASB,反应器内获得了99%以上的反硝化率.对于冬季水温分别为14.9,14.1,13.5,11.05℃的低温条件下,SBR反应器实现了完全硝化和反硝化,出水TN分别为4.1,5.7,14.1,16.5mg/L,达到了深度脱氮的目的.此外,在上述温度范围内,温度对反硝化速率(rN)的影响大于对硝化速率 (rDN)的影响, rN/rDN比值相对恒定.     

高锰酸钾预氧化并复合高岭土与聚合氯化铝(PAC)絮凝去除水中颤藻

采用高锰酸钾预氧化复合高岭士与聚合氯化铝(PAC)混凝,对去除水中颤藻进行了研究.通过正交试验得出了在试验水质条件下,颤藻去除最佳条件为:高锰酸钾投加量为0.5mg·l~(-1),预氧化时间为15min,PAc投加量为2.5mg·l~(-1),粒径为160目的高岭土投加量为50mg·l~(-1).在此条件下,高锰酸钾可氧化颤藻失活但并没有破坏藻细胞壁,防止了藻毒素的释放.预氧化产生的水合二氧化锰作为凝结核促进了絮体的形成,并使之更加密实、易沉降,且沉降后藻絮体不再上浮,提高了处理后的水质.     

磁黄铁矿和石灰石改性硫磺发泡材料的脱氮除磷性能研究

基于硫磺自养反硝化(SAD)脱氮效率高、除磷效率低及磁黄铁矿自养反硝化(PAD)除磷效率高、脱氮效率低的特点,利用微细粒磁黄铁矿和石灰石与硫磺熔混、发泡得到磁黄铁矿与石灰石改性硫磺发泡材料(PLMSFM).通过批次试验探究磁黄铁矿和发泡剂配比对PLMSFM脱氮除磷的影响,优化得出硫磺∶石灰石∶磁黄铁矿∶碳酸氢钠的质量比...     

Recovery of solid fuel from municipal solid waste by hydrothermal treatment using subcritical water

Hydrothermal treatments using subcritical water (HTSW) such as that at 234 °C and 3 MPa (LT condition) and 295 °C and 8 MPa (HT condition) were investigated to recover solid fuel from municipal solid waste (MSW). Printing paper, dog food (DF), wooden chopsticks, and mixed plastic film and sheets of polyethylene, polypropylene, and polystyrene were prepared as model MSW components, in which polyvinylchloride (PVC) powder and sodium chloride were used to simulate Cl sources.While more than 75% of carbon in paper, DF, and wood was recovered as char under both LT and HT conditions, plastics did not degrade under either LT or HT conditions. The heating value (HV) of obtained char was 13,886-27,544 kJ/kg and was comparable to that of brown coal and lignite. Higher formation of fixed carbon and greater oxygen dissociation during HTSW were thought to improve the HV of char.Cl atoms added as PVC powder and sodium chloride to raw material remained in char after HTSW. However, most Cl originating from PVC was found to converse into soluble Cl compounds during HTSW under the HT condition and could be removed by washing.From these results, the merit of HTSW as a method of recovering solid fuel from MSW is considered to produce char with minimal carbon loss without a drying process prior to HTSW. In addition, Cl originating from PVC decomposes into soluble Cl compound under the HT condition. The combination of HTSW under the HT condition and char washing might improve the quality of char as alternative fuel.     

煤矸石中铅、铬、镉的溶出性能

以滕南煤田某煤矿风化煤矸石为研究对象,应用主成分分析法分析了煤矸石粒径对Pb,Cr,Cd溶出浓度的影响,应用回归分析法分析了浸溶时间与Pb,Cr,Cd溶出浓度的关系特征。实验结果表明：模拟湿地浸溶条件下,煤矸石中Pb,Cd,Cr溶出浓度均超出或接近Ⅲ类水体水质标准,对水环境存在污染风险;煤矸石粒径对Pb,Cd,Cr溶出浓度存在影响,粒径越小则Pb、Cr、Cd溶出浓度越大,粒径小于8.0 cm的煤矸石浸溶贡献较大。建立了表征Pb,Cr,Cd溶出浓度与浸溶时间对数（以10为底）关系的一元三次多项式回归方程,经检验均具有显著性。     

SAMPLING FRAME FOR IMPROVING PEBBLE COUNT ACCURACY IN COARSE GRAVEL‐BED STREAMS1

ABSTRACT: Improved sampling techniques are needed to increase the accuracy of pebble‐count particle‐size distributions used for stream studies in gravel‐bed streams. However, pebble counts are prone to operator errors introduced through subjective particle selection, serial correlation, and inaccurate particle‐size measurements. Errors in particle‐size measurements can be minimized by using a gravel template. Operator influence on particle selection can be minimized by using a sampling frame, 60 by 60 cm, in which sampling points are identified by the cross points of thin elastic bands. Serial correlation can be minimized by adjusting the spacing between the cross points and setting it equal to the dominant large particle size (=D₉₅). In a field test in a cobble‐bed stream, the sampling frame developed in this study produced slightly coarser size distributions, particularly in the cobble range, than the traditional heel‐to‐toe walk that selects particles with a blind touch at the tip of the boot. The sampling frame produced more similar sampling results between two operators than heel‐to‐toe walks. The difference between the two sampling methods is attributed to an unbiased selection of fine and coarse particles when using the sampling frame.     

低C/N比污水生物脱氮所需外加碳源量的确定

利用中试规模实验装置,探讨了现有活性污泥工艺改造成间歇曝气生物脱氮工艺的实践中,碳氮比(C/N)对废水生物脱氮效率、脱氮反应速度的影响,分析了脱氮容量,确定了所需外加碳源量.      

城区大气颗粒物中有机氯农药的含量与分布

采用FA-3型气溶胶粒度分布采样器采样,对北京和天津2个样点夏季大气中不同粒径颗粒物上有机氯农药残留量进行分析.在所有分级样品中均检测出δ-HCH,p,p'-DDD和p,p'-DDT,其他有机氯农药只在部分样品中被检出.北京样中HCHs(α-HCH+β-HCH+γ-HCH+δ-HCH)含量为0.240ng/m3,DDTs(p,p'-DDT+p,p'-DDD+p,p'-DDE)含量为0.962ng/m3,天津样品中HCHs含量为0.581 ng/m3,DDTs含量为1.874ng/m3.天津样中有机氯农药残留明显高于北京样.大气颗粒物上的有机氯农药粒径分布特征为:北京样中HCHs和DDTs含量随粒径均呈单峰分布,而天津样中HCHs呈三峰态分布,DDTs呈较弱的单峰态分布.HCHs和DDTs两类化合物的质量中值直径和分散度分别在2.1～2.5μm和3.1～3.7μm范围内.      

DS-Ⅰ催化剂脱硫脱氮技术的实验研究

以纯ＳＯ２及燃煤电厂烟气作实验气,利用积分法固定床ＣＦＢ方式进行了ＤＳ－Ⅰ型催化剂与活性炭催化性能的对比试验,对不同还进行了不同烟气温度、ＳＯ２浓度、湿度、烟气流速等工艺参数对ＤＳ-Ⅰ型催化剂催化性能的影响试验。对不同催化剂进行优化组合,可在除尘器后直接脱硫、脱氮,其脱硫率达８６％、脱氮率达６８％。催化剂经再生,可反复使用。     

新型低温Fe/AC脱硫剂的研究

将活性焦担载氧化铁制得Fe/AC脱硫剂用于烟气脱硫,在最经济的烟气脱硫温度窗口(120℃～250℃)显示出高的脱硫活性.考察操作条件对其脱硫活性的影响,并借助EXAFS和TPD表征技术对其内在原因进行探讨.Fe/AC脱硫剂在排烟温度下用于脱硫,其活性明显优于活性焦和纯Fe₂O₃,且载体炭无氧化烧损.Fe/AC吸硫后形成2种含硫物质:H₂SO₄和Fe₂(SO₄)₃,H₂O和O₂的存在可增加Fe/AC对SO₂的吸附硫容.由高比表面活性焦制得的Fe/AC有更高的脱硫活性,这源于活性组分Fe₂O₃在其上良好的分散性.Fe/AC用于脱硫应在适宜空速[(800L/(kg·h)]下操作.