第三产业风机、冷却塔噪声污染防治浅谈

随着社会的发展，尤其是第三产业的不断兴起，其噪声污染问题日益突出。本文从对噪声扰民案件入手、分析，发现风机和冷却塔噪声污染最为严重。针对主要污染源，从技术方面提出了解决噪声污染的方法，为环境管理，治理提供科学依据。     

排放系数法估算污染物排放总量

掌握污染物总量动态变化情况，采用排放系统法进行估算是有效的方法。利用１９９５年上海乡镇工业污染调查数据对排放系数进行验证，说明应如何选用排放系数。     

Ecoprofit-Styria-prepare Thirteen pollution prevention case studies in the Styrian industry

The paper focuses upon the organization of a federal state-funded pollution prevention project in the Styrian industry. The project includes 13 companies from the textile, pulp and paper, machine building, wood working and printed circuit board manufacturing industries, covering most of the sectors and sizes in the Styrian industry. It started in January 1994 and will last for one year. It will demonstrate the possibilities of pollution prevention and the need for further research work. This project will make use of the methods and tools that were refined in the Austrian Prepare project. As a first step, a systematic balance of all the inputs and outputs of a company is made, after which the weak points and inefficiencies of material and energy use are identified and the options for improvements, both economical and ecological, are defined. Consequently, modifications in products and production lead to a situation with less waste and emissions. The preliminary lessons from these projects are presented: as a rule, the utilities (consumption of process materials and water, cleaning, energy, preparatory and finishing steps) are treated as black boxes and usually represent a considerable optimization potential. In these areas especially there is usually a lack of information and coordination as well as a need for a systematic and comprehensive approach. Leadership in the company and creative consultants are needed for starting lasting successful pollution prevention projects.     

湖州市北污水处理厂污泥处理运行管理

重点介绍湖州市北污水处理厂采用带式压滤机进行污泥脱水处理的应用情况及运行管理,并进行了小结。     

Improvement of the antifouling characteristics in a bioreactor of polypropylene microporous membrane by the adsorption of Tween 20

Surface modification by physical adsorption of Tween 20 was accomplished on polypropylene microporous membranes (PPMMs). Attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR) and scanning electron microscope (SEM) were used to characterize the chemical and morphological changes on the membrane surfaces. Water contact angles and relative pure water fluxes were measured. The data showed that the hydrophilic performance for the modified membranes increased with the increase in the adsorption amount of Tween 20 onto the surface or into the pores of polypropylene microporous membranes. To test the antifouling property of the membranes by the adsorption of Tween 20 in a membrane bioreactor (MBR), filtration for active sludge was performed using synthetic wastewater. With the help of the data of water fluxes and the FE-SEM photos of the modified PPMMs before or after operating in a MBR for about 12 d, the PPMMs with monolayer adsorption of Tween 20 showed higher remained flux and stronger antifouling ability than unmodified membrane and other modification membranes studied.     

两段接触氧化法处理生活污水的工程实例

本污水厂设计规模 70 0 0m3 d ,进水CODCr3 0 0mg L ,BOD515 0mg L ,SS 2 0 0mg L ,采用两段接触氧化法处理工艺 ,运行结果表明 ,出水水质达到GB8978 1996污水综合排放标准中的二级标准     

去除生活废水及污泥中病毒的研究

从生活废水中病毒的处理着手，通过实验测定病毒蚀斑形成数量(PFU)，说明了生活废水中病毒数量的非恒定性和病毒易与污泥吸附的特性，以及常规废水处理方法对它们杀灭效率的不一致性，并分析了废水处理过程中几种杀灭病毒的方法，以及它们的不同效率和杀灭病毒的原理，探讨城市污水处理中病毒去除的几种方法。     

ASM1中废水和污泥组分浓度的测定方法研究

对呼吸计量法应用于校准ASM1作了简明的阐述。在呼吸速率与模型组分关系的基础上,介绍了ASM1中废水与污泥各组分浓度的测定方法,并指出模型组分细化的意义。     

铜镍电镀污泥的资源化与无害化处理试验研究

提出了铜镍电镀污泥的资源化与无害化处理的工艺流程 ,并用试验考察了各工序的技术经济指标。试验结果表明 ,铜粉品位大于 90 % ,铜的回收率大于 95 % ,硫酸镍质量达到工业一级 ,镍回收率大于 80 % ,浸出渣和净化渣经固化处理后可作普通建筑材料使用 ,工艺过程产生的废水可以达标排放     

骆马湖的氮磷平衡及实施截污工程对水质改善效果的研究

骆马湖“九五”期间的氮磷平衡分析结果表明：氮磷在骆马湖湖体中的滞留量分别为1188.89t/a和193.36t/a。根据骆马湖的水质要求，在骆马湖截污工程完成后，没有新的污染进入水体的前提下，对骆马湖水体通过自然净化恢复到要求状态所需的时间进行了详细的数学推导和科学论证，结果表明，在不考虑底泥营养物质的情况下，只需0.19年左右的时间就能恢复，如果考虑底泥的影响。也只需0.59年左右的时间就能恢复，因此得出结论：对骆马湖实施截污是加速骆马湖水体改善的最佳途径。