水稻中硅元素的分布及存在状态

利用UV-Vis分光光度计、X线分析显微镜及扫描电子显微镜(Scanning electron microscope,SEM)对水稻不同器官中硅元素的含量、分布及存在状态进行观察和分析,研究水稻中硅酸的化学性质,为水稻硅元素的综合利用提供科学依据.结果表明:水稻以可溶性原硅酸的形式吸收土壤中的硅酸,同样以可溶性原硅酸的形式输送到各器官中.不同的生长期,水稻导管液内的可溶性原硅酸的含量不同,成熟期最高可达到912 mg/L(以SiO2表示).通过比较导管汁液和土壤溶液的硅酸浓度可知,水稻选择性地吸收和浓缩硅酸,最高浓缩率可达85倍.X线分析显微镜观察发现,硅酸普遍存在于水稻各器官中,越是坚硬的部位硅酸分布得越多.SEM图像表明,沉积在水稻各器官中的硅胶体具有一定的形状且不溶于强酸.对水稻干燥组分中硅酸含量的分析结果表明,稻壳中硅酸含量最高,达到13.3%,是生产硅单质及碳化硅材料的最有效的资源之一.     

Adsorption behaviors of activated carbons for the exhaust from spray painting booths in vehicle surface coating

Adsorption performance of activated carbon adsorbers in the downstream duct of vehicle spray painting booths has been studied to understand whether fine paint particles in the off-gas would deteriorate the adsorption capacity of volatile organic compounds (VOCs) on activated carbons. Three forms of activated carbons were selected and their properties were determined using nitrogen adsorption analysis, the measurement of pH value and total ash content, energy dispersion spectrometer, field-emission scanning electron microscopy, and thermogravimetric analysis. Results show that the adsorption capacity of activated carbon strongly depends upon its available specific surface area. When the total uptake on activated carbon approaches saturation, the vapors adsorbed would commence to get displaced by the paint particles gradually as time elapses and finally the uptake of vapors and paint particles reach equilibrium. Microporous carbons, in particular, were much more susceptible to paint particles. A Langmuir-type model for the uptake on activated carbons was suggested, which successfully described the adsorption behaviors of the off-gas released from vehicle spray painting booth.     

Heavy Metals in Moss and Bark From Urban Area of Florence: A New Cleaness Procedure for Removing Superficial Particulate Matter

Abstract

Hypnum cupressiforme epiphytic moss and tree bark (elm and holm oak) samples have been collected in three sites of the city of Florence in the period 1995–1998. Lead, zinc, copper, and cadmium were determined by differential pulse anodic stripping voltammetry (DPASV) in about 200 samples collected at different heights above ground. A new clean-up procedure by nitrogen jet has been followed and its efficiency has been also verified by electron microscopy (SEM and ESEM techniques). Lead median contents in moss and bark samples fall within the ranges of 0.052–0.86 and 0.20–1.30 μmoles g^?1 (dry weight), resulting values for moss and bark are proportional to the vehicular traffic density. the increasing use of lead-free gasoline has not been followed by a decrease of lead moss concentration.     

复杂形态井巷工程三维激光扫描与MIDAS-FLAC3D耦合建模稳定性分析研究

受井巷工程空间形态的复杂性及探测技术的局限性影响,部分人员无法进入的复杂形态井巷工程的实际空间形态往往很难准确获得,复杂井巷工程的数值分析往往很难进行建模或建立模型与实际误差较大,而在此基础上进行的稳定性分析结果可靠性往往较差。采用三维激光扫描技术对复杂形态井巷工程进行三维激光点云扫描,基于点云数据运用MIDAS软件建立精确形态的复杂井巷工程模型,通过耦合技术建立最终可以在FLAC3D中进行运算并且与实际形态相一致的数值模型。最后以某矿山主溜井为工程实例,利用三维激光精确扫描技术获取该井巷工程的实际空间形态,在此基础上进行MIDAS与FLAC3D耦合方法的建模分析,对该复杂井巷工程的稳定状况进行了稳定性分析。     

基于磁场理论的矿岩加载损伤破坏表征研究

充填体与围岩的相互力学作用,除了接触带表壁附近可以通过贴置电阻应变片的方式进行应变值测量外,接触面及接触带附近的损伤破坏情况不易监测。基于此,应用磁场理论,将磁粉加入到配比试样中,充磁之后进行加载试验。通过特斯拉计测量试样表壁在加载过程中的磁感应强度变化,建立由表及里的损伤破坏联系规律。试验结果表明:加了磁粉的配比试样,在加载过程中各监测点处的磁感应强度值变化明显,特别是在内部裂纹扩展至临空面处的磁感应强度几乎减小至0.2 mT以下;而试样在加载过程中,各监测点的磁感应强度值随着压密破坏而变化;在未破坏时,不同区域有较一致的随试样内部压密相应磁感应强度增大的变化规律,而在试样加载破坏后,不同监测点磁感应强度变化起伏较大。     

生物矿化针铁矿吸附废水中铬的实验研究

在静态条件下,利用生物矿化针铁矿对含铬模拟废水进行吸附实验研究.结果表明,生物矿化针铁矿对质量浓度在5 mg/L以下的含Cr2O72-,Cr3+模拟废水均具有较好的去除效果,平均去除率达94%,出水达到"污水综合排放标准"(GB 8978-1996);其吸附符合Langmuir与Freundlich模型.      

回用生活污水的电化学消毒试验研究

对北京某中水站回用于杂用水的生活污水进行电化学消毒试验。试验结果表明 ,生活污水经生物接触氧化、活性炭吸附后 ,流经电化学消毒器停留 2 0s、耗电 0 .30kWh/m3 、消毒器出水放置 1h后 ,总大肠菌群数 <3个 /L ,满足生活杂用水的卫生学指标。当余氯浓度及接触时间相等的条件下 ,电化学消毒法的杀菌效果好于加氯消毒。E .coli细胞经电化学消毒和加氯消毒处理后 ,扫描电镜观察的结果表明 :2种方法作用后的细胞在形态上的变化是不相同的 ,说明电化学消毒的消毒机制不仅仅取决于电解产氯的作用 ,还有其他的杀菌作用     

立式储罐变形评估的三维激光扫描实验

针对常规储罐检测工作量大、效率低的问题,利用三维激光扫描仪对某储罐进行外部检测,获取高精度的储罐三维点云数据,通过建模形成一个拟合罐体,与理想罐体进行3D比较得到储罐变形的整体情况,该方法能够对储罐的变形评估做出准确判断,距离储罐底板0.3 m处有最大径向偏差51.63 mm,0.9 m处有最大倾斜度0.177°,基于三维激光扫描技术为储罐罐壁变形检测提供了一种可靠的新方法。     

Impacts of natural weathering on the transformation/neoformation processes in landfilled MSWI bottom ash: a geoenvironmental perspective

Natural weathering processes are significant mechanisms that noticeably affect the fundamental nature of incineration ash residues. To provide a greater understanding of these processes, a MSWI (mono)landfill site in the north east of the US was selected as the target for systematic investigation of the natural weathering of bottom ash residues. Samples of various ages were collected from locations A (1 yr), B (10 yrs), C (13-14 yrs) and D (20 yrs) of the landfill in 2009. We investigated the phase transformation of the collected bottom ash particles, neoformation processes as well as the behavior and distribution of certain heavy metals (Cu, Pb, Zn, Ni, and Cr) in the neoformed phases using optical microscopy, SEM-EDX, and bulk examinations. Key findings: at the preliminary stage, the waste metallic particles (Al, Fe, and Cu) and unstable minerals such as lime, portlandite, ettringite and hydrocalumite convert to oxide and hydroxide (hydrate) phases, calcite, alumina gel and gypsum. At the intermediate stage, the decomposition of melt products including magnetite spinels and metallic inclusions is triggered due to the partial dissolution of the melt glass. At the longer time horizon it is possible to track the breakdown of the glass phase, the extensive formation of calcite and anhydrite, Al-hydrates and more stable Fe-hydrates all through the older ash deposits. Among the dominant secondary phases, we propose the following order based on their direct metal uptake capacity: Fe-hydrates>Al-hydrates>calcite. Calcite was found to be the least effective phase for the direct sorption of heavy metals. Based on overall findings, a model is proposed that demonstrates the general trend of ash weathering in the landfill.