Kinetics and pathways for the debromination of polybrominated diphenyl ethers by bimetallic and nanoscale zerovalent iron: effects of particle properties and catalyst

Polybrominated diphenyl ethers (PBDEs) are recognized as a new class of widely-distributed and persistent contaminants for which effective treatment and remediation technologies are needed. In this study, two kinds of commercially available nanoscale Fe⁰ slurries (Nanofer N25 and N25S), a freeze-dried laboratory-synthesized Fe⁰ nanoparticle (nZVI), and their palladized forms were used to investigate the effect of particle properties and catalyst on PBDE debromination kinetics and pathways. Nanofers and their palladized forms were found to debrominate PBDEs effectively. The laboratory-synthesized Fe⁰ nanoparticles also debrominated PBDEs, but were slower due to deactivation by the freeze-drying and stabilization processes in the laboratory synthesis. An organic modifier, polyacrylic acid (PAA), bound on N25S slowed PBDE debromination by a factor of three to four compared to N25. The activity of palladized nZVI (nZVI/Pd) was optimized at 0.3 Pd/Fe wt% in our system. N25 could debrominate selected environmentally-abundant PBDEs, including BDE 209, 183, 153, 99, and 47, to end products di-BDEs, mono-BDEs and diphenyl ether (DE) in one week, while nZVI/Pd (0.3 Pd/Fe wt%) mainly resulted in DE as a final product. Step-wise major PBDE debromination pathways by unamended and palladized Fe⁰ are described and compared. Surface precursor complex formation is an important limiting factor for palladized Fe⁰ reduction as demonstrated by PBDE pathways where steric hindrance and rapid sequential debromination of adjacent bromines play an important role.     

基于层次分析法的未确知测度理论泥石流危险性评价

将未确知测度理论与层次分析方法相结合用于评价泥石流危险性。根据泥石流危险性的影响因素和等级划分标准，选取泥石流规模、泥石流发生频率、流域面积、主沟长度、最大相对高差、流域切割密度、主沟床弯曲系数、泥砂补给长度比、24小时最大降雨量、人口密度等10个指标作为泥石流危险评价因子，利用未确知测度理论建立泥石流危险性评价指标的未确知测度函数，通过层次分析方法确定各评价指标的权重，依据置信度识别准则对泥石流危险性进行评价，并结合实例进行了对比分析。研究结果表明，基于层次分析方法的未确知测度理论的评价方法评价过程合理、置信度高、结果可靠，为泥石流危险性评价提供了一种新的方法     

曝气生物流化床处理高氨氮粪便污水

应用好氧曝气生物流化床反应器处理动车集便器粪便污水,研究反应器同步硝化反硝化脱氮及去除COD效能,以及DO对处理效能的影响,通过镜检观察反应器内微生物特性,探究反应器同步硝化反硝化脱氮机理。结果表明,反应器维持DO在2.5 mg/L左右时,对粪便污水中氨氮、TN和COD的去除率分别达99.8%、84.1%和95.5%,在好氧曝气生物流化床反应器中,实现同步硝化反硝化脱氮并去除有机物。分析认为,反硝化脱氮主要发生在生物膜内的厌氧微环境,反硝化反应主要由厌氧反硝化菌完成,曝气生物流化床反应器同步硝化反硝化脱氮机理主要从微环境理论解释。     

Eichhornia crassipes capability to remove naphthalene from wastewater in the absence of bacteria

The aim of the current study was to investigate the potential of an aquatic plant, the water hyacinth (Eichhornia crassipes) devoid rhizospheric bacteria, to reduce naphthalene (a polyaromatic hydrocarbon) present in wastewater and wetlands.The capability of sterile water hyacinth plants to remove naphthalene from water and wastewater was studied in batch systems. Water hyacinths enhance the removal of pollutants through their consumption as nutrients and also through microbial activity of their rhizospheric bacteria.Experimental kinetics of naphthalene removal by water hyacinth coupled with natural rhizospheric bacteria was 100% after 9 d. Plants, decoupled of rhizospheric bacteria, reduced naphthalene concentration up to 45% during 7 d. Additionally, naphthalene uptake by water hyacinth revealed a biphasic behavior: a rapid first phase completed after 2.5 h, and a second, considerably slower rate, phase (2.5-225 h). In conclusion, water hyacinth devoid rhizospheric bacteria reduced significantly naphthalene concentration in water, revealing a considerable plant contribution in the biodegradation process of this pollutant.     

复合生物膜-活性污泥反应器同步脱氮除磷

通过实验研究比较了复合生物膜-活性污泥反应器(HY)和传统活性污泥反应器(AS)的脱氮除磷效果。结果表明,在水力停留时间(HRT)16 h、污泥龄12～15 d、水温19～21℃、pH 6.3～7.8的条件下,复合生物反应器比活性污泥反应器运行更稳定,未发生污泥膨胀。在相同运行条件下,复合生物反应器对COD、TN和TP的去除率分别为95%、91%和98%,而活性污泥反应器对COD、TN和TP的去除率分别为85%、84%和90%。稳定工况下复合生物反应器的比硝化、比反硝化速率,比吸磷、比释磷速率均高于活性污泥反应器,且微生物相更加丰富。通过建立16S rDNA克隆文库发现生物膜和活性污泥的微生物群落结构均具有高度多样性,但生物膜微生物的微生物相比活性污泥更复杂。     

晚期垃圾渗滤液的部分亚硝化

利用实验室小试SBR在(33±1)℃的条件下,通过动态调控溶氧浓度(DO)(2～7 mg/L)和水力停留时间(2～5 d),经过130 d的运行成功启动了晚期垃圾渗滤液(NH4+-N含量1 227～2 133 mg/L)的部分亚硝化,使出水NO2--N∶NH4+-N稳定维持在1∶1左右,为后续的厌氧氨氧化工艺创造了进水条件。利用实时荧光定量PCR研究启动过程中的特异微生物氨氧化细菌的含量变化表明,氨氧化细菌的含量与NO2--N的生成速率和出水NO2--N稳定性有着显著相关性。     

UASB-SBR-絮凝工艺处理地沟油制生物柴油废水

采用UASB-SBR-絮凝工艺处理地沟油制生物柴油废水，考察了各个阶段的废水处理效果。实验结果表明：UASB稳定运行阶段进水COD约为15000mg/L时，COD去除率约为87%，出水COD在2500mg/L以下，出水挥发性脂肪酸（VFA）浓度为4~6mmol/L，最佳容积负荷为15.0kg/（m3·d）；采用SBR处理UASB出水，当容积负荷为1.5kg/（m3·d）时，出水COD在200mg/L以下，COD去除率在83%以上，ρ（NH₃-N）在5mg/L以下，TP约为25mg/L。向SBR出水中加入质量分数为5%的聚合氯化铝进行化学除磷，加入量为5mL/L，处理后废水TP为4~6mg/L。处理后废水的COD，ρ（NH₃-N），TP均达到CJ343-2010《污水排入城市下水道水质标准》的A类要求。     

不同填料载体生物膜对微囊藻毒素的去除效果

利用自行设计的生物膜培养装置,通过对4种不同填料载体进行连续曝气循环培养生物膜,对湖水中的溶解态微囊藻毒素(MCs)的去除作用进行了研究。结果表明,填料载体上生物膜从形成到稳定大约需要3周;生物膜形成后对MCs的去除效率由高到低的顺序是:颗粒活性炭柱>多密孔球型滤料柱>塑料悬浮填料柱>陶瓷滤球柱。在实验水质条件下,当水力停留时间(HRT)=5 h,进水MCs浓度为21.5～47.25μg/L时,颗粒活性炭、多密孔球型滤料柱对MCs的去除率最高可达100%,塑料悬浮填料柱对MC-LR和MC-RR的去除率分别为70%和88%。当HRT=2.5 h时,塑料悬浮填料柱对MC-RR的去除率为MC-LR的2倍。生物膜对MCs的降解效果随温度(5～20℃)和溶解氧的升高而增加。塑料悬浮填料作为合适的生物膜挂膜填料载体对水源水的生物预处理具有良好的应用前景。     

污泥转移SBR工艺处理低浓度生活污水

污泥转移SBR工艺是一种通过内部污泥回流实现污泥在不同SBR隔室间转移,从而增加污泥利用效率,提高系统除污效能的新工艺。以设计规模为240 m3/d、处理低浓度生活污水的工艺系统为对象,研究了新工艺在不同泥转移量(污泥回流比)下的除污性能,并与系统以传统SBR方式运行的情况进行了对比。结果表明,新工艺可以有效提高SBR反应器的容积利用率;采用30%的污泥回流比进行污泥转移,新工艺的处理能力比传统SBR工艺提高近1/2,除磷效率从46%提升至85%。出水各项水质指标均能达到国家排放标准的要求。     

氮掺杂TiO2可见光光催化剂的制备及性能

以尿素和钛酸丁酯为原料,通过溶胶-凝胶法低温下制备了高可见光催化活性的氮掺杂TiO2(NDT)光催化剂,采用XRD、TEM、BET和UV-Vis DRS等测试手段对其进行了表征,并在自制光催化反应器中降解甲基橙评价了样品的光催化活性。结果表明,当氮与钛的摩尔比为0.5∶1时,350℃焙烧的样品(NDT350)具有最佳的可见光光谱吸收和光催化活性,该催化剂为锐钛矿晶相,平均粒径为21 nm,比表面积为89.13 m2/g。可见光辐照下,NDT350降解甲基橙的表观反应速率常数为1.381×10-2min-1,是商业P25催化剂的16.85倍。NDT350优良的可见光催化活性与其大的比表面积和强烈的可见光光谱吸收有关。