兰州市南山季节性土壤微生物特征及影响因素

为了探究不同季节和不同植被类型对土壤微生物分布的影响,以兰州市南山不同海拔的两种植被类型为研究对象,采用稀释涂布平板法测定了土壤微生物的季节动态变化特征.结果表明：研究区内细菌数量占微生物总数的96.22%~99.80%,远高于真菌和放线菌数量.土壤微生物类群随季节变化呈现明显差异,其总数整体表现为夏季最高,为89.22×10⁶cfu/g soil,分别是春、秋、冬季的12.02、3.28、2.74倍,其中夏季细菌数量最高,真菌与放线菌数量均在春季达到最大值.人工林样地土壤微生物数量略低于荒坡,环境因子中土壤含水量和有机碳含量高于荒坡.随着海拔的升高,pH值逐渐上升,土壤温度、有机碳与全氮含量逐渐下降,土壤微生物总数则呈现先减少后增加的趋势.相关分析表明,不同季节各微生物类群与环境因子的相关系数各有不同,春季放线菌与有机碳,秋季真菌与有机碳、全氮均呈极显著正相关（P<0.01）.冗余分析表明,环境因子中有机碳与第一物种轴的相关系数最高,为0.520,说明土壤有机碳含量是影响土壤微生物类群分布的主导因素.     

Seasonal variation and size distribution of biogenic secondary organic aerosols at urban and continental background sites of China

Size-resolved biogenic secondary organic aerosols(BSOA) derived from isoprene and monoterpene photooxidation in Qinghai Lake, Tibetan Plateau(a continental background site) and five cities of China were measured using gas chromatography/mass spectrometry(GC/MS). Concentrations of the determined BSOA are higher in the cities than in the background and are also higher in summer than in winter. Moreover, strong positive correlations(R2= 0.44–0.90) between BSOA and sulfate were found at the six sites,suggesting that anthropogenic pollution(i.e., sulfate) could enhance SOA formation,because sulfate provides a surface favorable for acid-catalyzed formation of BSOA. Size distribution measurements showed that most of the determined SOA tracers are enriched in the fine mode( 3.3 μm) except for cis-pinic and cis-pinonic acids, both presented a comparable mass in the fine and coarse( 3.3 μm) modes, respectively. Mass ratio of oxidation products derived from isoprene to those from monoterpene in the five urban regions during summer are much less than those in Qinghai Lake region. In addition, in the five urban regions relative abundances of monoterpene oxidation products to SOA are much higher than those of isoprene. Such phenomena suggest that BSOA derived from monoterpenes are more abundant than those from isoprene in Chinese urban areas.     

大型空间环境模拟器真空系统配置技术研究

分别对国内外大型空间环境模拟器的真空系统配置进行了介绍,并对真空系统各个子系统的配置与技术特点进行了分析,重点针对大型空间环境模拟器真空系统中所需的真空抽气策略进行了研究,为后续超大型环境试验设备的研制和试验测试提供了参考。     

提升汇流环湿热环境适应性方法研究

目的提高汇流环在湿热环境下的适应能力。方法实物解剖,观察汇流环绝缘材料损坏情况、碳粉堆积情况,在不同温度、湿度下测试绝缘材料绝缘度、抗电强度,碳粉堆积和导电情况,比对不同绝缘材料性能,并找出最适合的绝缘材料,比对滚动汇流环、碳刷组件、刷丝组件,找到解决碳粉堆积的方法。结果汇流环受湿热影响会从接缝处和电缆连接处进入湿气,温度、湿度的上升会使得原绝缘材料性能下降,长时间使用汇流环,碳粉会在汇流环内堆积并受到湿热的影响而导电,局部密封汇流环可以减少湿气进入。PPO材料性能优异,可以替换原绝缘材料从而减少湿热的影响,使用刷丝组件替代碳刷可以避免碳粉的产生。结论综合运用局部密封、绝缘材料改进、碳刷组件改进三种措施,可以有效提高汇流环在湿热环境下的适应能力。     

一种模拟动力学边界条件的环境振动试验方法研究

目的提高环境振动试验的可靠性。方法以某典型钛合金蜂窝夹芯壁板试验件为例,提出一种模拟试验件动力学边界条件的试验方法,在试验件周围引入弹性连接件,再通过刚性转接工装与振动台台面连接,以试验件在试验安装状态下的共振频率及振型节线位置为优化目标,以弹性连接件的外形尺寸及厚度为优化变量,对弹性连接件进行优化设计,从而模拟试验件真实的动力学边界条件。结果弹性连接件的优化设计使得试验件在试验安装状态下前两阶共振频率与试验要求相差小于8%,而且振型节线位置与试验要求基本重合,达到了模拟试验件真实动力学边界条件的设计目标。结论对于壁板类试验件,在传统刚性夹具的基础上引入弹性连接件的试验方法,可以较好地模拟试验件真实动力学边界条件,提高环境振动试验的可靠性,并且这种方法对试验费用及试验周期影响较小,具有良好的工程应用前景。     

兰州地区大气臭氧时空变化及影响因素研究

本文采用OMI臭氧遥感数据,结合甲醛垂直柱浓度、气象数据以及经济数据,分析了2005~2015年兰州地区臭氧柱浓度时空变化格局,并探索了影响臭氧的新气象因子,总结达到臭氧污染的日照、气压等气象条件,确定影响臭氧柱浓度的主要人为源并确定其限域。结果表明:1)2005~2015年夏季柱浓度值最高,冬季、秋季次之,春季最低;夏季波动幅度最大,其余三季波动幅度较小且平稳。2)11年中,臭氧柱浓度具有较大的波动。2005年至2010年快速增长到最高值331.997 DU。2010年之后,臭氧柱浓度缓慢下降,2014年起有回升趋势。3)OMI遥感数据具有较高的可靠性,并根据AQI的线性关系划分了臭氧柱浓度的污染等级。结果指示了11年大气臭氧空间变化,2005~2009年5年间研究区全区空气质量一直处于良,2010年全区轻度污染,后两年污染逐渐减弱,2013~2015年全区恢复至良。4)根据兰州发展的趋势以及周边城市的关系,划分了兰州经济圈及功能区,并结合臭氧柱浓度空间分布图得出臭氧污染与经济特征的密切关系。5)正弦模型拟合后臭氧柱浓度变化趋势呈不明显的周期性,说明臭氧的人为来源贡献较大。6)创新探索影响臭氧污染的新气象因子(日照、气压等参数),并确定其重要人为源限域。     

环境升温过程对常温固化环氧树脂热力学性能的影响

目的提高常温固化环氧树脂体系的高温使用性能。方法采用常温固化剂T31、中温固化剂IPDA以及高温固化剂DDM作为混合固化剂,对E-44型和AG-80型混合环氧树脂体系进行常温固化反应,并分析环境升温过程对固化物热力学性能的影响。通过DMA分析、热变形测量、固化度测试,分别评价室温固化环氧树脂在环境升温过程前后的玻璃化转变温度、热变形量及体系内部的固化反应程度变化,并通过吸水率测试和弯曲强度测试对玻璃纤维布增强常温固化环氧树脂基复合材料的耐湿热性能以及高温条件下的力学性能进行分析。结果环氧树脂常温固化物的tg为85.21℃,经1.5℃/min的平均升温速率加热至90℃之后,该环境升温过程使固化物的固化度增大至92%以上,tg增长为132.06℃的同时热变形温度增大。其复合材料耐湿热性能提高,且100℃时弯曲强度的保持率为65%,对于加热至120℃的环境升温过程,固化物的固化度接近96%,tg增长为144.45℃的同时热变形温度进一步提高,其复合材料耐湿热性能改善程度更加明显,且130℃时弯曲强度保持率仍接近60%。结论常温、中温、高温混合固化剂的合理复配有助于环氧树脂体系在环境升温变化的诱导条件下发生梯度式固化反应,使体系内部的交联固化程度迅速升至较高水平,可以有效提高其玻璃化转变温度,显著改善常温固化环氧树脂体系在高温条件下的热力学性能。     

机载战术导弹挂飞环境地面振动试验方案研究

研究总结了某型机载战术导弹服役过程中所经受的振动激励主要来源,同时研究分析不同激励方式对战术导弹吊耳载荷响应效果的影响,确定该型机载战术导弹振动载荷加载方案。采用理论计算与有限元建模计算分析的方法,分析比较不同激励方式对导弹吊耳载荷响应效果的影响。总结确定了该型机载战术导弹振动载荷的主要来源,通过理论算例和有限元建模计算的方法分别计算了不同激励方式下导弹吊耳的载荷响应,并最终确定了振动载荷加载激励方式。     

Monitoring Air Quality in Mountains: Designing an Effective Network

A quantitatively robust yet parsimonious air-quality monitoring network in mountainous regions requires special attention to relevant spatial and temporal scales of measurement and inference. The design of monitoring networks should focus on the objectives required by public agencies, namely: 1) determine if some threshold has been exceeded (e.g., for regulatory purposes), and 2) identify spatial patterns and temporal trends (e.g., to protect natural resources). A short-term, multi-scale assessment to quantify spatial variability in air quality is a valuable asset in designing a network, in conjunction with an evaluation of existing data and simulation-model output. A recent assessment in Washington state (USA) quantified spatial variability in tropospheric ozone distribution ranging from a single watershed to the western third of the state. Spatial and temporal coherence in ozone exposure modified by predictable elevational relationships ( 1.3 ppbv ozone per 100 m elevation gain) extends from urban areas to the crest of the Cascade Range. This suggests that a sparse network of permanent analyzers is sufficient at all spatial scales, with the option of periodic intensive measurements to validate network design. It is imperative that agencies cooperate in the design of monitoring networks in mountainous regions to optimize data collection and financial efficiencies.     

Cumulative impact assessment in environmental planning: A coastal wetland watershed example

Several theoretical, analytical, and institutional difficulties have impeded the development and application of the assessment of cumulative environmental impacts. Watershed development on coastal wetlands offers an ideal context for evaluating the land disturbance target approach to cumulative impact assessment. A model land use planning system involving a time series approach was developed for Elkhorn Slough in California. The approach included four major components: evaluation of erosion susceptibility, measurement of land disturbance, establishment of a land disturbance target, and a comparison of existing and target land disturbance values. Further research is needed to test the transferability of the approach in a wide range of coastal watersheds and to verify the applicability of the methods to other cumulative impact problems.