Some happy,others sad: exploring environmental justice in solid waste management in Kinshasa,The Democratic Republic of Congo

This paper explores the concept of environmental justice (EJ) in solid waste management (SWM) in Kinshasa, the Democratic Republic of Congo (DRC). It evaluates the extent to which EJ occurs in SWM and discusses the factors accounting for this state of affairs. The paper examines the relevant theoretical framework(s) and mechanisms that would facilitate the attainment of EJ in Kinshasa. It is argued that solid waste (SW) often ends up in the poorest and least powerful communities in the cities of the DRC. A qualitative research methodology, which includes exhaustive critical review of the literature, system analysis, reflections from best practices through case studies and discussion with stakeholders, was used for this study. Findings revealed that SWM in Kinshasa is a duty entrusted to publicly-funded municipal authorities. There are evidences of a clear divide between the rich and poor neighbourhoods in the manner SW is managed. This is an inequality that has only recently begun to be recognised as injustice practices in SWM. It is argued that a politico-cultural mechanism on remedying SWM inequities could enable changes that will address EJ in Kinshasa. Such a solution will go directly against the prevailing notion “some happy, others sad”.     

金属冶炼进口物料的固体废物鉴别方法

建立了金属冶炼进口物料的固体废物鉴别方法,并利用该方法对海关查扣的3种金属冶炼进口物料进行了固体废物鉴别。鉴别结果显示:物料1、2和3的自然属性分别为砷含量超标铜精矿、锰阳极泥、回转窑氧化锌,产生来源分别为有害物质超标的产品、污染控制设施产生的物质、有意识加工的目标产物;物料1和2属于我国禁止进口的固体废物,物料3不属于固体废物。本文建立的固体废物鉴别方法可行,可为金属冶炼进口物料的固体废物鉴别和监管提供参考。     

Nitrogen evolution during the co-combustion of hydrothermally treated municipal solid waste and coal in a bubbling fluidized bed

Nitrogen evolution was studied during the co-combustion of hydrothermally treated municipal solid wastes (HT MSW) and coal in a bubbling fluidized bed (BFB). HT MSW blending ratios as 10%, 20% and 30% (wt.%) were selected and tested at 700, 800, 900 °C. Emissions of NO and N₂O from blends were measured and compared with the results of mono-combustion trials. Moreover, concentrations of precursors like NH₃ and HCN were also quantified. The results are summarized as follows: NO emissions were predominant in all the cases, which rose with increasing temperature. The blending of HT MSW contributed to the NO reduction. N₂O emissions decreased with temperature rising and the blending of HT MSW also presented positive effects. At 30% HT MSW addition, both NO and N₂O emissions showed the lowest values (391.85 ppm and 55.33 ppm, respectively at 900 °C). For the precursors, more HCN was detected than NH₃ and both played important roles on the gas side nitrogen evolution.     

Alternative management structures for municipal waste collection services: The influence of economic and political factors

Identifying and characterising the factors that determine why a local authority opts for a particular way of managing its waste collection service is an important issue, warranting research interest in the field of municipal solid waste (MSW) management. This paper presents empirical evidence spanning a broad time horizon (2002–2010) showing that economic and political factors impact in different ways on the provision of waste management services. We examine five alternatives in this area, including public and private service delivery formulas and, within each field, individual and joint options. Our findings highlight the importance of the service cost and that of the various indicators of fiscal stress as determinant factors of management decisions regarding the provision of MSW management services.     

CFD simulation of MSW combustion and SNCR in a commercial incinerator

A CFD scheme was presented for modeling municipal solid waste (MSW) combustion in a moving-grate incinerator, including the in-bed burning of solid wastes, the out-of-bed burnout of gaseous volatiles, and the selective non-catalytic reduction (SNCR) process between urea (CO(NH₂)₂) and NO_x. The in-bed calculations provided 2-D profiles of the gas–solid temperatures and the gas species concentrations along the bed length, which were then used as inlet conditions for the out-of-bed computations. The over-bed simulations provided the profiles of incident radiation heat flux on the top of bed. A 3-dimensional benchmark simulation was conducted with a 750 t/day commercial incinerator using the present coupling scheme incorporating with a reduced SNCR reduction mechanism. Numerical tests were performed to investigate the effects of operating parameters such as injection position, injection speed and the normalized stoichiometric ratio (NSR) on the SNCR performance. The simulation results showed that the distributions of gas velocity, temperature and NO_x concentration were highly non-uniform, which made the injection position one of the most sensitive operating parameters influencing the SNCR performance of moving grate incinerators. The simulation results also showed that multi-layer injections were needed to meet the EU2000 standard, and a NSR 1.5 was suggested as a compromise of a satisfactory NO_x reduction and reasonable NH₃ slip rates. This work provided useful guides to the design and operation of SNCR process in moving-grate incinerators.     

拜耳法赤泥粒径分级预处理的研究

赤泥是从铝土矿中提取氧化铝的过程中产生的工业废渣.分析了拜耳法赤泥的粒径分布,以及主要化学组成和矿物组成在不同粒径赤泥中的变化规律.在此基础上,提出先将赤泥粒径分级预处理,然后根据粗细粒径赤泥的差异分别进行回收利用的思路.研究结果表明,赤泥中粒径大于0.075 mm的粗颗粒以铁、硅、钙为主,实践证明可以通过磁选或重选工...     

Determination of specific gravity of municipal solid waste

This investigation was conducted to evaluate experimental determination of specific gravity (G_s) of municipal solid waste (MSW). Water pycnometry, typically used for testing soils was adapted for testing MSW using a large flask with 2000 mL capacity and specimens with 100–350 g masses. Tests were conducted on manufactured waste samples prepared using US waste constituent components; fresh wastes obtained prior and subsequent to compaction at an MSW landfill; and wastes obtained from various depths at the same landfill. Factors that influence specific gravity were investigated including waste particle size, compaction, and combined decomposition and stress history. The measured average specific gravities were 1.377 and 1.530 for as-prepared/uncompacted and compacted manufactured wastes, respectively; 1.072 and 1.258 for uncompacted and compacted fresh wastes, respectively; and 2.201 for old wastes. The average organic content and degree of decomposition were 77.2% and 0%, respectively for fresh wastes and 22.8% and 88.3%, respectively for old wastes. The G_s increased with decreasing particle size, compaction, and increasing waste age. For fresh wastes, reductions in particle size and compaction caused occluded intraparticle pores to be exposed and waste particles to be deformed resulting in increases in specific gravity. For old wastes, the high G_s resulted from loss of biodegradable components that have low G_s as well as potential access to previously occluded pores and deformation of particles due to both degradation processes and applied mechanical stresses. The G_s was correlated to the degree of decomposition with a linear relationship. Unlike soils, the G_s for MSW was not unique, but varied in a landfill environment due both to physical/mechanical processes and biochemical processes. Specific gravity testing is recommended to be conducted not only using representative waste composition, but also using representative compaction, stress, and degradation states.     

释氧材料修复地下水石油烃污染研究进展

石油烃对土壤和地下水的污染不断被重视,释氧材料作为一种强化生物修复技术正日益受到关注。文章介绍了释氧材料的发展史,阐述修复场地条件、地下水化学环境和材料释氧速率控制对修复效果的影响,并对该技术的发展进行了展望。     

季节性城市生活垃圾成分分析及厌氧消化特性研究

城市生活垃圾的成分及特性随着季节和人类在不同季节的生活习惯而变化，针对我国北方城市研究了一年中不同季节的城市生活垃圾成分特点，对影响厌氧发酵过程的相关成分如总有机碳（TOC）、总氮（TN）、蛋白质、脂肪和还原糖等进行了测定分析。通过厌氧消化实验，测得不同季节城市生活垃圾pH值、日产气量、沼气甲烷含量、甲烷累积量、挥发性脂肪酸（VFAs）和氧化还原电位（ORP）等参数的变化规律，分析相应变化的影响因素。结果表明，二、三季度的含水率分别为64．81％和67．50％，高于一、四季度，一季度发酵原料中蛋白质和脂肪含量分别为12．56％和8．86％，明显高于其他3个季度。一季度甲烷累积量最高，达到17616mL，单位发酵原料的产气量为204．8mL／g，也是4个季度中最高的，说明蛋白质、脂肪等有机成分含量对厌氧发酵过程及结果影响比较明显。为进一步的城市生活垃圾厌氧消化制取生物燃气的工艺条件提供依据。     

高含固污泥厌氧消化中Fe/S及pH对原位抑硫效率影响及其交互作用

以城市污水处理厂高含固污泥为对象,分别进行了连续厌氧消化抑硫试验和消化污泥Fe(Ⅲ)投加抑硫试验,探讨不同Fe/S(摩尔比)对污泥厌氧消化中溶解态硫化物去除效率的影响以及Fe(Ⅲ)与pH的交互作用.结果表明,热水解污泥厌氧消化采用原位抑硫技术,在Fe/S(摩尔比)为7.75时沼气中H_2S含量可由170.4×10~(-6)降至14.09×10~(-6),无需进行后续处理;当pH为7.00~7.50、Fe/S为1~11时,pH为原位抑硫主要显著影响因子,提高消化池pH有利于降低Fe(Ⅲ)投加量;高含固污泥厌氧消化沼气满足H_2S利用标准时,所需最低Fe/S为7.0;当消化池pH低于7.30时,将无法通过调节Fe/S实现H_2S浓度达标排放.