贫燃条件下汽车尾气中NOx催化净化研究进展

汽车尾气排放的NOx(主要是NO)是城市大气的主要污染源之一。本综述了近l0年来贫燃条件下NOx催化转化为N2的催化剂研究进展。这些方法包括HC-SCR、NO直接催化分解、NOx吸附-还原等。讨论了不同催化剂的性能影响因素。新的负载材料MFI、MCM-41、SAPO-34的应用增强了催化剂的性能。双功能催化剂由于两种活性位的协同作用表现出较高的活性和选择性。新的纳米结构概念催化剂NOx吸附还原中发现有广泛应用。介绍了上述催化脱除NOx的各种机理并指出了今后研究的方向。     

枣庄矿区自营铁路安全现状分析及对策

按枣庄矿区十年发展规划,未来十年矿区煤炭产量将达到1800万t,矿区自营铁路煤炭外运将突破1000万t.为实现枣矿集团大集团战略目标,本文从矿区自营铁路运营现状及影响安全运输能力提高的瓶颈进行调研分析,并以此为依据提出提高矿区铁路安全运输能力的对策.     

不同CDPF贵金属负载量对柴油公交车VOCs组分排放影响

基于重型底盘测功机,利用质子转移反应质谱(PTR-MS)研究了柴油公交车在中国典型城市公交车循环(CCBC)下,不同CDPF贵金属负载量对尾气中挥发性有机物(VOCs)组分排放特性的影响.结果表明,柴油公交车VOCs主要组分为含氧有机物(OVOCs)、芳香烃和烯烃等,且OVOCs占比达50%以上;在贵金属成分、配比相同时,VOCs减排率随CDPF贵金属负载量增加而增加:贵金属负载量为15 g·ft~(-3)(A型后处理装置)、25 g·ft~(-3)(B型)和35 g·ft~(-3)(C型)时,VOCs总量的减排率依次为36.2%、40.1%和41.4%.C型后处理装置对烷烃全循环减排率高达70.2%,且对OVOCs的催化有微弱优势;对于不饱和烃类,3种不同贵金属负载量的后处理装置均有一定催化效果,但无明显差异;A型对含氮有机物减排率可达50.5%,但减排率随贵金属负载量增加而降低.采用DOC+CDPF后能较好地降低公交车VOCs排放量进而降低臭氧生成潜势(OFP).同时考虑不同方案减排效果与成本因素,当加权系数分别为0.8和0.2时,B型为最优方案.     

氯代挥发性有机物CVOCs催化氧化的研究进展

氯代挥发性有机物(CVOCs)因其性质稳定、反应性差且毒性高,成为目前大气污染物净化技术中的难点。催化氧化法是去除CVOCs最有效的方法之一。对CVOCs催化氧化的研究进行综述,列举实例介绍了各类催化剂对常见CVOCs的催化研究现状,对催化性能、催化剂失活、反应机理等方面进行了详细分析,总结出积碳和氯中毒是催化剂失活的两大主要因素,而载体性质、活性组分分散度、水等对催化性能产生很大影响。最后,展望了未来催化剂的研究重点。     

TiO2–PANI/Cork composite: A new floating photocatalyst for the treatment of organic pollutants under sunlight irradiation

A novel photocatalyst based on TiO_2–PANI composite supported on small pieces of cork has been reported. It was prepared by simple impregnation method of the polyaniline(PANI)–modified TiO_2 on cork. The TiO_2–PANI/Cork catalyst shows the unique feature of floating on the water surface. The as-synthesized catalyst was characterized by X-ray diffraction(XRD),scanning electron micrograph(SEM), transmission electron microscopy(TEM), thermogravimetric analysis(TGA), Fourier transform infrared spectroscopy(FT-IR), UV–vis diffuse reflectance spectra(UV–vis DRS) and the Brunauer–Emmett–Teller(BET) surface area analysis. Characterization suggested the formation of anatase highly dispersed on the cork surface. The prepared floating photocatalyst showed high efficiency for the degradation of methyl orange dye and other organic pollutants under solar irradiation and constrained conditions, i.e., no-stirring and no-oxygenation. The TiO_2–PANI/Cork floating photocatalyst can be reused for at least four consecutive times without significant decrease of the degradation efficiency.     

Effect of barium sulfate modification on the SO2 tolerance of V2O5 /TiO2 catalyst for NH3-SCR reaction

Sulfur poisoning of V_2O_5/BaSO_4–TiO_2(VBT),V_2O_5/WO_3–TiO_2(VWT) and V_2O_5/BaSO_4–WO_3–TiO_2(VBWT) catalysts was performed in wet air at 350℃ for 3 hr,and activities for the selective catalytic reduction of NO_x with NH_3 were evaluated for 200–500℃.The VBT catalyst showed higher NO_x conversions after sulfur poisoning than the other two catalysts.The introduction of barium sulfate contributed to strong acid sites for the as-received catalyst,and eliminated the redox cycle of active vanadium oxide to some extent,which resulted in a certain loss of activity.Readily decomposable sulfate species formed on VBT-S instead of inactive sulfates on VWT-S.These decomposable sulfates increased the number of strong acid sites significantly.Some sulfate species escaped during catalyst preparation and barium sulfate was reproduced during sulfur poisoning,which protects vanadia from sulfur oxide attachment to a great extent.Consequently,the VBT catalyst exhibited the best resistance to sulfur poisoning.     

石墨烯复合材料在水处理中的应用研究

新型碳材料石墨烯,因其比表面积大,物理、化学特性优异,通常作为吸附剂或复合材料载体,用于难降解有机废水处理.载体石墨烯改性后,可优化复合材料性能,包括溶解性和可控性.基于复合材料制备,选取典型污染物废水,如染料废水、苯酚废水、农药废水,从吸附处理和催化降解两方面展开,简要介绍石墨烯复合材料的应用研究及作用效果,显示出复合材料可有效提高污染物降解效率,回用效果好.此外,石墨烯复合材料在回用及实际应用方面仍有待进一步研究.     

Fe-MnOx-CeO2/ZrO2低温催化还原NO性能研究

以纳米ZrO2为载体,用浸渍法制备出Fe-MnOx-CeO2/ZrO2催化剂,考察了活性组分配比和助剂负载量对催化剂低温NH3选择性催化还原NO活性的影响,并对催化剂进行了XRD、SEM、EDS和BET表征;探讨了温度、H2O和SO2对Fe-MnOx-CeO2/ZrO2催化剂低温下NH3选择性催化还原NO的影响,结果表明,无SO2和H2O条件下,8%Fe-10%MnOx-CeO2/ZrO2催化剂具有良好的催化活性和稳定性.120℃时,催化剂的脱硝效率为85.23%,当温度升至180℃时,脱硝效率可达到92.0%.SO2和H2O共存条件下,催化剂易失活,采用傅立叶变换红外光谱对各反应阶段的催化剂进行了表征,对其失活机制进行深入研究,结果表明,催化剂失活的主要原因是催化剂表面硫酸铵盐的沉积和催化剂本身活性成分的硫酸盐化.     

H2S匀圆杂选择性催化氧化工艺及催化剂研究现状

论述了石油流化催化裂化烟气中H2S气体的选择性催化氧化处理工艺和工艺中所使用的各种类型选择性氧化催化剂.目前已发展并投入使用的选择性氧化工艺主要有:Superclaus工艺、Euroclaus工艺、Clinsulf-Do工艺、BSR/Hi-Activity工艺、Selectox工艺和Modop工艺等,各工艺具有不同的特点和应用范围.H2S选择氧化催化剂主要包括以下几种体系:碳体系、SiC载体体系、分子筛体系、氧化物体系和柱撑黏土体系等.其中碳体系和氧化物体系的研究开展的较早较多,关于分子筛体系的研究近期有所减少,SiC是研究人员认为非常有潜力的一个载体体系,其相关体系研究也一直在进行之中,柱撑黏土体系还处于初步研究阶段,离实际应用尚有距离.     

Application of red mud as a basic catalyst for biodiesel production

Red mud was investigated in triglyceride transesterification with a view to determine its viability as a basic catalyst for use in biodiesel synthesis.The effect of calcination temperature on the structure and activity of red mud catalysts was investigated.It was found that highly active catalyst was obtained by simply drying red mud at 200°C.Utilization of red mud as a catalyst for biodiesel production not only provides a cost-effective and environmentally friendly way of recycling this solid red mud waste,significantly reducing its environmental effects,but also reduces the price of biodiesel to make biodiesel competitive with petroleum diesel.