Experimental and theoretical studies on NO selective catalytic oxidation over α-MnO2

Based on the experimental and theoretical methods, the NO selective catalytic oxidation process was proposed. The experimental results indicated that lattice oxygen was the active site for NO oxide over the $\mathrm{\alpha }$-MnO₂(110) surface. In the theoretical study, DFT (density functional theory) and periodic slab modeling were performed on an $\mathrm{\alpha }$-MnO₂(110) surface, and two possible NO oxidation mechanisms over the surface were proposed. The non-defect $\mathrm{\alpha }$-MnO₂(110) surface showed the highest stability, and the surface O_s (the second layer oxygen atoms) position was the most active and stable site. O₂ molecule enhanced the joint adsorption process of two NO molecules. The reaction process, including O₂ dissociation and O=N-O-O-N=O formation, was calculated to carry out the NO catalytic oxidation mechanism over $\mathrm{\alpha }$-MnO₂(110). The results showed that NO oxidation over the $\mathrm{\alpha }$-MnO₂(110) surface exhibited the greatest possibility following the route of O=N-O-O-N=O formation. Meanwhile, the formation of O=N-O-O-N=O was the rate-determining step.     

TA15钛合金与铝合金和结构钢接触腐蚀大气暴露试验研究

讨论了TA15钛合金与铝合金和结构钢接触后,在海南万宁大气试验站大气暴露的试验结果。3年的大气暴露试验显示,在海洋性大气环境下,2B06铝合金、16CrSiN i钢和30CrMnSiA钢无论与TA15钛合金接触与否,腐蚀都很严重,力学性能明显下降;对2B06铝合金进行阳极氧化,对16CrSiN i钢和30CrMnSiA钢进行氯化铵镀镉,可在一定程度上减缓腐蚀,但经过一定时间大气暴露,无论与TA15钛合金接触与否,都产生了严重腐蚀,力学性能明显下降;对2B06铝合金进行阳极氧化,对16CrSiN i钢和30CrMnSiA钢进行氯化铵镀镉,再喷涂1号航空底漆进行防护,可有效防止接触腐蚀。     

利用粉煤灰制备高纯超细氧化铝粉体的研究

利用粉煤灰为原料制备高纯超细氧化铝粉体。给出了采用硅酸二钙晶相转变自粉化、高效分散剂———碳化法从粉煤灰中制备氧化铝方法的工艺路线 ,确定了从粉煤灰制备高纯超细氧化铝粉体的最佳工艺条件 ,为粉煤灰的高价值利用开辟了一条新途径     

催化技术在污染物治理应用的研究进展

对近年来催化技术在污染物治理应用的研究进展进行了综述,指出了现在研究中存在的主要问题,并对其前景进行了展望。     

稀土材料氢氧化铈吸附水中亚砷酸与砷酸阴离子的特性效果

以开发新型高效除砷吸附材料为目的 ,在室温 (2 5℃ ) ,初始浓度 0 .0 5～ 2 5 0mg/L ,pH4～ 11条件下 ,对稀土材料氢氧化铈 (HCO)进行了吸附除砷的性能评价 .实验结果表明 ,在实验条件下 ,HCO对亚砷酸和砷酸阴离子都显示了良好的吸附效果 ,其吸附等温线能很好地用Langmuir方程进行描述 .对于低浓度 (0 0 5～ 10mg/L)的砷溶液 ,HCO在所选 pH条件下对亚砷酸和砷酸阴离子的吸附率可达 10 0 % .对于高浓度的砷溶液 ,偏酸性 (pH 4 )条件有利于砷酸阴离子 ,而中性 /微碱性 (pH 7,8)条件最有利于亚砷酸阴离子的吸附 .HCO对 2种形态的砷阴离子的吸附效应在较宽 pH范围内同溶液的离子强度基本无关 ,常见阴离子 (Cl-,NO-3 ,SO2 -4)的存在对砷的吸附也未显示出干扰效应 .从实验结果推测 ,HCO吸附亚砷酸和砷酸阴离子的主要反应机理应属于专性吸附     

利用XPS研究复合氧化物催化剂在汽车尾气净化中硫中毒及抗硫中毒机理

运用ＸＰＳ分析方法研究一系列复合氧化物催化剂中毒前后硫在其表面的各种形态及催化剂活性组分中毒前后的组成，价态，化学机理及其变化。结果表明，ＳＯ２在催化剂活性中心进行化学吸附，然后一部分ＳＯ２与活性组分生成相应的亚硫酸盐和硫酸盐，从而使催化剂失活。     

光催化降解有机磷农药废水的可行性

在ＴｉＯ２粉末的存在下，研究光催化降解有机磷农药废水的可行性。结果表明，ＣＯＤｃｒ６５０ｍｇ／Ｌ，有机磷１９．８ｍｇ／Ｌ的有机磷农药废水在３７５Ｗ中压汞灯照射４ｈ，ＣＯＤ去除率为９０％，有机磷将完全转化为无机磷。同时还研究了光催化剂ＴｉＯ２的用量，反应液初始ｐＨ值，空气流量，外加Ｆｅ３＋浓度等多种因素对光降解的影响；并利用太阳聚光做了室外实验     

Promotional effect of cobalt doping on catalytic performance of cryptomelane-type manganese oxide in toluene oxidation

The cryptomelane-type manganese oxide (OMS-2)-supported Co (xCo/OMS-2; x = 5, 10, and 15 wt.%) catalysts were prepared via a pre-incorporation route. The as-prepared materials were used as catalysts for catalytic oxidation of toluene (2000 ppmV). Physical and chemical properties of the catalysts were measured using the X-ray diffraction (XRD), Fourier transform infrared spectroscopic (FT-IR), scanning electron microscopic (SEM), X-ray photoelectron spectroscopy (XPS), and hydrogen temperature-programmed reduction (H₂-TPR) techniques. Among all of the catalysts, 10Co/OMS-2 performed the best, with the T_90%, specific reaction rate at 245°C, and turnover frequency at 245°C (TOF_Co) being 245°C, 1.23 × 10⁻³ mol_toluene/(g_cat·sec), and 11.58 × 10⁻³ sec⁻¹ for toluene oxidation at a space velocity of 60,000 mL/(g·hr), respectively. The excellent catalytic performance of 10Co/OMS-2 were due to more oxygen vacancies, enhanced redox ability and oxygen mobility, and strong synergistic effect between Co species and OMS-2 support. Moreover, in the presence of poisoning gases CO₂, SO₂ or NH₃, the activity of 10Co/OMS-2 decreased for the carbonate, sulfate and ammonia species covered the active sites and oxygen vacancies, respectively. After the activation treatment, the catalytic activity was partly recovered. The good low-temperature reducibility of 10Co/OMS-2 could also facilitate the redox process accompanied by the consecutive electron transfer between the adsorbed O₂ and the cobalt or manganese ions. In the oxidation process of toluene, the benzoic and aldehydic intermediates were first generated, which were further oxidized to the benzoate intermediate that were eventually converted into H₂O and CO₂.     

多孔氧化铝层制备的研究

采用预腐蚀与交流腐蚀相结合的方法．研究了多孔氧化铝层的制备工艺．探讨了制备工艺中各步骤的作用以及影响因素。利用扫描电镜，研究了多孔氧化铝层制备工艺对铝箔微观形貌的影响。研究表明．交流腐蚀工艺对铝箔表面微观形貌的改变作用最明显。一次后处理后铝箔表面蚀孔变密．氧化膜的结构更加疏松细腻。二次后处理，调整和热处理等步骤对铝箔表面的微观形貌影响不大。     

Greenhouse impacts of anthropogenic CH4 and N2O emissions in Finland

The Finnish anthropogenic CH₄ emissions in 1990 are estimated to be about 250 Gg, with an uncertainty range extending from 160 to 440 Gg. The most important sources are landfills and animal husbandry. The N₂O emissions, which come mainly from agriculture and the nitric acid industry are about 20 Gg in 1990 (uncertainty range 10–30 Gg). The development of the emissions to the year 2010 is reviewed in two scenarios: the base and the reduction scenarios.According to the base scenario, the Finnish CH₄ emissions will decrease in the near future. Emissions from landfills, energy production, and transportation will decrease because of already decided and partly realized volume and technical changes in these sectors. The average reduction potential of 50%, as assumed in the reduction scenario, is considered achievable.N₂O emissions, on the other hand, are expected to increase as emissions from energy production and transportation will grow due to an increasing use of fluidized bed boilers and catalytic converters in cars. The average reduction potential of 50%, as assumed in the reduction scenario, is optimistic.Anthropogenic CH₄ and N₂O emissions presently cause about 30% of the direct radiative forcing due to Finnish anthropogenic greenhouse gas emissions. This share would be even larger if the indirect impacts of CH₄ were included. The contribution of CH₄ can be controlled due to its relatively short atmospheric lifetime and due to the existing emission reduction potential. Nitrous oxide has a long atmospheric lifetime and its emission control possiblities are limited consequently, the greenhouse impact of N₂O seems to be increasing even if the emissions were limited somehow.