纵向通风隧道内火灾温度场分布规律研究

以狮子洋水下特长隧道为工程背景,利用CFD数值模拟软件FDS 4.01,建立隧道实体物理模型,进行火灾数值模拟分析。研究了列车火灾热释放功率为15 MW、不同坡度、不同纵向通风风速下,该类隧道内拱顶附近和2 m高处温度场的纵向分布规律,以及各工况下拱顶的最高温度,并分析其对隧道结构防火和人员疏散救援的影响。结果表明:随隧道坡度的增大,在同一通风速率下的烟气回流长度逐渐减小,但随着风速的加大,坡度对烟气回流的影响逐渐减弱;随着通风风速的增大,火区附近的温度下降,而沿程温度上升,纵向通风速率越大,拱顶温度越低。     

Numerical simulation of an array of fences in Saemangeum reclaimed land

This paper discusses about the quantitative effect of windbreak fences on wind velocity in the reclaimed land at Saemangeum in South Korea. Windbreak fences were constructed in the reclaimed land to reduce the wind velocity to prevent the generation and diffusion of dust. However, up to this time, no in-depth studies were conducted to quantitatively measure the effect of the windbreak fences on wind velocity thus an optimum windbreak structure is not yet determined. Using CFD simulations, the effects of fence porosity, fence height, and the distance between the adjacent fences were investigated. A wind tunnel experiment was initially conducted and data gathered were used to develop the CFD models. From the experiments and CFD simulations, the overall percentage difference of the measured velocities was 7.20% which is generally acceptable to establishing the reliability of the CFD models. The reduction effect on wind velocity was measured in between the adjacent fences up to a height of 0.6 m from the ground surface. In terms of porosity ( = 0, 0.2, 0.4, 0.6), 0.2 was found to be the optimum value. Conversely, the effect of fence height (0.6, 0.8 and 1.0 m) showed no significant difference; therefore, 0.6 m height is recommended. In addition, the reduction effect of distance between the adjacent fences (2, 4 and 6 m) on wind velocity having a 0.2 porosity has decreased to about 75% regardless of the distance. In the case of the reclaimed land in Saemangeum, a decrease of 75% can prevent the generation and diffusion of dusts. However, the source of dusts is very large. Therefore, constructing an array of windbreak with 6 m distance between them is deemed necessary.     

隧洞施工通风系统事故树分析

在采矿、铁路、公路及水利水电工程中，常常采用长距离隧洞或隧道来穿越高山。而隧洞的施工以其施工技术复杂、难度大、风险高，经常成为控制工程工期的主要环节，隧洞施工中的通风换气系统，关系到施工能否顺利进行和施工作业人员的人身安全，根据隧洞施工通风系统的运行特点，采用安全系统分析中的事故树（FTA）方法，对隧洞施工中通风系统的安全性进行定性分析，找出影响通风安全的主要因素，并提出了通风安全管理对策，可以保证施工作业的顺利进行和人身安全，提高整个施工作业的安全度。     

南山铁矿风场及扩散规律风洞模拟研究

以风洞模拟方式研究中性层结条件下南山铁矿凹山采场地域边界层风场特征,并以示踪气体扩散摸拟方法给出该地域大气扩散参数的实验结果。     

盾构隧道的开挖模拟及地震反应数值分析

由于盾构隧道掘进的特殊施工工艺,使开挖模拟的数值计算存在着诸多难以量化的因素。采用应力释放法模拟盾构隧道的开挖,在衬砌和土体之间设置等代层单元模拟盾构施工的影响,求得竣工期的应力场和位移场。在静力计算基础上运用动力有限元时程分析法,采用粘性人工边界条件,分析了隧道衬砌在地震过程中的最大响应。其结果和规律可为一般的盾构隧道地震反应分析提供借鉴。     

公路隧道火灾事故调研与对策分析

通过调研国内外近60年来,有代表性的33起公路隧道火灾事故,对公路隧道火灾事故起因、特点及危害进行了详细分析,结合国外公路隧道火灾安全措施以及防火安全评估经验,提出几点降低公路隧道火灾事故风险,减少事故危害的对策与建议。以期为公路隧道规划、设计以及建设运营等工作提供有益的参考。     

隧道火灾拱顶附近烟气最高温度的研究

为了研究顶部开口的城市隧道在采用自然通风模式下的火灾特性,在已建成的隧道中设计并实施了全尺寸火灾试验,得到了隧道火灾自然通风模式下的拱顶附近烟气最高温度纵向变化数据。通过实验数据与理论预测结果对比的方法验证了H.Kurioka等人建立的隧道火羽流模型及其计算公式的可靠性,为市政公路隧道建设提供了科学依据,为隧道火灾的研究及其消防工作提供理论指导和有益借鉴。     

集中排烟公路隧道入口段火灾下诱导风速研究

为研究集中排烟模式下公路隧道入口段发生火灾时的合理诱导风速,以某公路隧道为背景,运用火灾动力学模拟软件FDS对隧道人口段火灾时不同坡度、不同诱导风速的16组火灾工况进行模拟研究,通过对各工况下隧道内的温度场分布及烟气控制效果模拟结果的分析,得到了各工况下的合理诱导风速,研究结果可为公路隧道集中排烟系统关键设计参数提供参考.     

隧道排污量估算与治污效果预测

通过隧道排污量和排污效果的简单分析，指出了其排污治理过程中应注意的有关事项，如进 行人口控制，改善居民的生活方式，提高环境保护意识和治理技术等，所述分析方法可供其它类似 工程参考。     

Physical Modeling of Emissions from Naturally Ventilated Underground Parking Garages

The dispersion of pollutants from naturally ventilated underground parking garages has been studied in a boundary layer wind tunnel. Two idealized model setups have been analysed, one was simulating pollutant dispersion around an isolated rectangular building and one was representing dispersion in a finite array of idealized building blocks. Flow and dispersion close to modelled ground level emission sources was measured. The results illustrate the complexity of the flow around buildings and provide insight in pollutant transport from ground level sources located directly on building surfaces. As a result, areas critical with respect to high pollutant concentrations could be visualized. Particularly, the results show high concentration gradients on the surface of the buildings equipped with modelled emission sources. Inside the boundary layers on the building walls, a significant amount of pollutants is transported to upwind locations on the surface of the building. The paper documents the potential of physical modelling to be used for the simulation and measurement of dispersion close to emission sources and within complex building arrangements.