氮氟掺杂二氧化钛(N,F-TiO2)的制备及可见光催化活性的研究

以氨水为氮源,氢氟酸为氟源,采用溶胶-凝胶法制备了氮氟掺杂二氧化钛(N,F-TiO2)光催化剂,并通过X-射线衍射(XRD)和扫描电镜(SEM)技术对其晶型和形态进行表征.最后以酸性红B为模型污染物,探讨了N和F加入量、焙烧温度、焙烧时间、照射时间、催化剂用量、溶液初始浓度和照射功率等因素对N,F-TiO2可见光催化活性的影响.结果表明,制备的N,F-TiO2以锐钛型为主,N和F的掺杂对TiO2的晶相没有明显改变,但可以扩大TiO2的可见光响应范围.当N和F的加入量均为2.0%,且在500℃下焙烧40 min时,得到的N,F-TiO2的可见光催化活性明显高于单N或单F掺杂的TiO2(N-TiO2或F-TiO2).对于50 mL浓度为10.0 mg·L-1的酸性红B溶液,当催化剂加入量为1.5 g·L-1,128W光照3.0 h,溶液pH=5.6时,去除率为85.40%.适当延长光照时间至4.0 h,降解率几乎可达100%.另外,研究还证明了N,F-TiO2催化可见光降解过程中有.OH自由基生成.     

水环境中典型纳米颗粒对菲的吸附特征

以典型三环多环芳烃菲为代表,选取11种典型纳米颗粒对水中不同浓度的菲进行吸附实验,探究水体中的纳米颗粒对菲的吸附特征.结果表明,Freundlich模型对所有样品的拟合结果最好.logKFr值显示,有机膨润土及3种炭黑对菲的吸附作用最强,且远远大于其他纳米颗粒.有机膨润土对菲的吸附表现为线性吸附(n=1.08),而3种炭黑均表现出显著的非线性特征(n＜0.5),且非线性特征随吸附能力的增强而增强,其他几种纳米颗粒均表现出非线性吸附特征(n＜0.9).水中所有的纳米颗粒在与菲作用的过程中,吸附的强弱与颗粒表面电位、粒径及比表面积均无显著相关性,即对于所有纳米颗粒来说,这几种性质并不是决定吸附作用的最主要因素,而吸附剂的化学组成及结构特性可能是引起吸附作用差异的主要原因.     

二氧化钛复合型催化剂制备及其微波辅助催化氧化甲苯性能

实验采用溶胶凝胶法和传统浸渍法制备了TiO2-分子筛复合载体及复合载体负载过渡金属与稀土元素催化剂,通过微波辅助催化氧化甲苯的性能实验考察其催化活性.结果表明,复合TiO2明显提高了载体结构的稳定性与耐温性,并使过渡金属铜(Cu)、锰(Mn)和稀土元素铈(Ce)等活性组分在催化剂表面的分散更均匀;在复合载体吸附、吸波性能与多相活性组分催化的共同作用下,Cu-Mn-Ce/TiO2-分子筛催化剂微波辅助催化氧化甲苯的完全燃烧温度仅为175℃,此时甲苯去除率可达99％;15 h的连续性实验表明,TiO2复合型催化剂具有良好的催化活性与稳定性.由催化剂表征分析结果可知,活性组分颗粒的均匀分布与铜、锰氧化物及铜锰尖晶石固溶物等活性相的存在促进了甲苯的催化氧化,锐钛矿型TiO2较高的电子迁移速率与催化剂孔径的增大均有助于甲苯的氧化降解.     

有序介孔碳载金/L-赖氨酸/纳米金修饰电极的制备及其对邻苯二酚、对苯二酚的检测响应研究

通过化学还原的方法合成有序介孔碳负载纳米金粒子,并构筑有序介孔碳载金/L-赖氨酸/纳米金复合膜修饰玻碳电极;利用扫描电镜观察介孔碳和介孔碳复合膜的微观结构,并用循环伏安法、电化学阻抗谱表征自组装电极的过程.在此基础上用差分脉冲伏安法研究对苯二酚和邻苯二酚混合物在该电极上的电催化氧化,研制了一种基于有序介孔碳载金/L-赖氨酸/纳米金复合膜修饰电极分别检测对苯二酚和邻苯二酚的传感器.在最优的实验条件下,该传感器在对苯二酚和邻苯二酚浓度为1×10-6～8×10-4mol·L-1的范围内具有良好的线性关系,检出限分别为3×10-7mol·L-1、7×10-7mol·L-1.     

乙醇处理对树脂基纳米水合氧化铁结构及其除砷性能的影响

通过考察乙醇处理对树脂基纳米水合氧化铁(D201-HFO)结构及其除砷性能的影响,评价乙醇处理在复合材料制备中的必要性.结果表明,乙醇处理后负载水合氧化铁(HFO)在D201树脂内的分散性增加,材料对砷的饱和吸附量提高约20%,且复合材料的比表面积、孔容、孔径分别增加了52%、65%、28%;但乙醇处理对复合材料的机械强度和负载HFO的晶型无影响,在pH值、离子竞争对该材料除砷性能的影响趋势方面也无明显作用,对复合材料固定床除砷性能及再生方面也无明显作用.总体而言,乙醇处理对D201-HFO复合材料实际除砷性能影响不大,从技术经济性考虑可以省略.     

有机蒙脱石负载纳米铁去除溶液中四溴双酚A的研究

研究了改性蒙脱石负载纳米铁材料(NZVI-CMT)在甲醇-水体系中对四溴双酚A(TBBPA)的去除作用,并确定了反应温度、TBBPA初始浓度以及材料投加量等因素对去除效果的影响.结果表明,在25℃条件下,0.02 g NZVI-CMT对初始浓度为10 mg·L-1TBBPA溶液的去除率可达97.5%,而且NZVI-CMT对TBBPA的去除率明显高于两种单一材料即纳米零价铁(NZVI)及有机蒙脱石(CMT)的去除率(18.3%、67.3%),同时也大于两者之和(85.6%).利用NZVI-CMT对TBBPA进行重复去除实验时,前3次的去除率均可达到90%以上.通过检测降解产物并分析材料对TBBPA去除过程的特性,发现NZVI-CMT对TBBPA的去除以吸附为主,并伴有少量还原脱溴反应发生,而且较高的反应温度对降解反应有利.     

Effect of transition metal doping under reducing calcination atmosphere on photocatalytic property of TiO2 immobilized on SiO2 beads

TiO₂ immobilized on SiO₂ (TiO₂/SiO₂) have been prepared by sol-gel method and various ions of transition metals (Cr³⁺, Co²⁺, Ni²⁺, Cu²⁺, and Zn²⁺) were doped on the photocatalyst using wet impregnation method under reducing calcination atmosphere. The photocatalytic activity of metal doped TiO₂/SiO₂ towards phenol degradation under black light irradiation were investigated and compared with undoped TiO₂/SiO₂. The results showed that the photoresponse of Cu²⁺ and Zn²⁺ doped TiO₂/SiO₂ were larger than undoped TiO₂/SiO₂, indicating that the photogenerated carriers were separated more efficiently in Cu²⁺ and Zn²⁺ doped TiO₂/SiO₂. The reactivity was in the order of Cu²⁺ > Zn²⁺ > Ni²⁺ > Cr³⁺ > Co²⁺. The different photoreactivity was ascribed to combine effect of the different ionic radii and photocorrison tendency of the dopants. The sample was also characterized by surface analytical methods such as X-ray diffraction, scanning electron micrograph/electron dispersive X-ray analyzer and UV-Vis absorption spectrum.     

Photocatalytic activity of TiO2 containing anatase nanoparticles and rutile nanoflower structure consisting of nanorods

A series of TiO2 with different crystal phases and morphologies was synthesized via a facile hydrothermal process using titanium nbutoxide and concentrated hydrochloric acid as raw materials. The photocatalytic activity of the samples was evaluated by degradation of Methyl Orange in aqueous solution under UV-Visible light irradiation. On the basis of detailed analysis of the characterizing results of high-resolution transmission electron microscopy, X-ray powder diffraction measurements, X-ray photoelectron spectroscopy and Brunauer-Emmett-Teller measurement, it was concluded that the photo-activity of the catalyst is related directly to the 3D morphology and the crystal phase composition. An excellent catalyst should have both a futile 3D flower-like structure and anatase granulous particles. The 3D flower-like structure could enhance light harvesting, as well as the transfer of reactant molecules from bulk solution to the reactive sites on TiO2. In addition, the optimum anatase/rutile phase ratio was found to be 80：20, which is beneficial to the effective separation of the photogenerated electron-hole pairs.     

Enhanced photocatalytic activity of quantum-dot-sensitized one-dimensionally-ordered ZnO nanorod photocatalyst

An efficient photocatalyst was fabricated by assembling quantum dots （QDs） onto one-dimensionally-ordered ZnO nanorods, and the photocatalytic properties for Methyl Orange degradation were investigated by scanning electron microscopy, transmission electron microscopy, X-ray diffraction, UV-Vis-NIR absorption spectroscopy and photoluminescence. The results indicate that the catalyst with assembled QDs is more favorable for the degradation than the pristine ZnO nanorods. The QDs with core-shell structure lower the photocatalytic ability due to the higher carder transport barrier of the ZnS shell layer. Besides its degradation efficiency, the photocatalyst has several advantages given that the one-dimensionally-ordered ZnO nanorods have been grown directly on indium tin oxide substrates. The article provides a new method to design an effective and easily recyclable photocatalyst.     

多壁碳纳米管的制备与可见光催化性能

采用溶胶-凝胶法,制备了多壁碳纳米管(MWCNTs)/CdS/TiO2复合半导体光催化剂。通过扫描电镜(SEM)、X射线衍射(XRD)和紫外-可见吸收光谱(UV-vis)等分析方法对光催化剂进行了结构表征,并考察了在可见光照射条件下MWCNTs/CdS/TiO2对甲基橙(MO)降解的光催化性能。结果表明,MWCNTs/CdS/TiO2能有效降解甲基橙。低浓度MO降解效果比高浓度好,光催化剂投加量为1.2 g/L即可达到较好的催化效果,酸性条件有利于光催化,投加适宜浓度的H2O(2低于10 mmol/L)时会和催化剂产生协同效果,浓度过大,催化效果下降。阴离子对催化效果有抑制作用,其中PO43-的抑制作用最强。所制备的复合催化剂具有较好的实际应用价值。