耦合厌氧氨氧化反应的高氮负荷型双室MFC性能研究

实验针对厌氧氨氧化反应在双室型MFC阳极和阴极2种形式的耦合,将厌氧氨氧化菌分别接种于a、b-双室型MFC的阳、阴极,并探究其产电、脱氮性能及脱氮机理.结果表明,2种类型的MFC均可在NH+4-N、NO-2-N浓度分别为400 mg·L-1和528 mg·L-1的高氮浓度模拟配水条件下稳定启动.与开路状态下的线性关系曲线不同,2类MFC在闭路状态下氨氮、亚硝态氮浓度均呈单指数关系衰减曲线,脱氮效率显著提高,周期内氨氮、亚硝态氮去除率均分别达到99%和85%以上.另外a、b-MFC平均容积氮去除负荷分别为0.417 kg·m-3·d-1和0.516 kg·m-3·d-1.在外阻1500Ω条件下,a-MFC最高输出电压48.0 m V,b-MFC最高输出电压可达到502.2 m V,b-MFC稳定输电周期约2170 min.     

黄土高原磷湿沉降特征及其对坝系流域磷输出影响-以羊圈沟为例

对黄土高原坝系流域磷(P)的湿沉降过程进行动态监测,分析了降雨-径流过程中各形态磷的输出变化,探讨了黄土高原坝系流域磷湿输出分异特征及其对水体的影响.结果表明:2015年湿季(7、8月)共11场降雨,产生的磷湿沉降负荷为30.8 kg,磷湿沉降通量为0.16kg·hm~(-2),干季(9月)共3场降雨,产生的磷湿沉降负荷为20.51 kg,磷湿沉降通量为0.11 kg·hm~(-2),干湿季磷湿沉降负荷呈现出明显差异性;选取3场降雨过程(降雨量从小到大)进行动态分析发现,流域磷湿沉降负荷分别为3.33、7.51和6.35 kg,相应的本地区磷湿沉降通量依次为0.02、0.04、0.03 kg·hm~(-2),3场降雨总磷(TP)的输出负荷为1.5×10-3kg,溶解性总磷(DTP)的输出负荷为1.24×10~(-3)kg,PO_4~(3-)-P的输出负荷为7×10-4kg,表明该地区磷湿沉降以可溶性磷为主.根据单因子评价方法中的标准指数法,发现流域水质不能满足Ⅴ类水质标准,应对流域水体加强管理.     

纳米TiO2添加剂对DMDF发动机大负荷燃烧及PM排放影响的试验研究

在一台电控增压中冷四缸柴油机的进气道上加装一套电控喷射装置,使其运行柴油/甲醇双燃料(DMDF)模式.研究了甲醇中Ti O_2添加剂的添加量及同一添加剂添加量在不同甲醇分散系喷射量时对发动机大负荷工况的燃烧和颗粒物(PM)排放的影响.结果表明,在甲醇中添加适量(30和100 mg·kg~(-1))的纳米Ti O_2能够使爆发压力升高,对燃烧有一定的促进作用,但添加过量(100 mg·kg~(-1))会对燃烧产生不利影响.加入纳米Ti O_2后,干炭烟烟度排放和积聚态颗粒数明显降低,在添加剂添加量为1000 mg·kg~(-1)时,最大降幅分别达到26.8%和29.4%,而核态颗粒物排放变化不大.在相同添加剂添加量下,增加甲醇分散系替代率R_m会使放热始点后移,放热更加集中,爆发压力增大,干炭烟烟度和颗粒物排放均大幅度降低.在添加剂添加量为100 mg·kg~(-1)时,与R_m=10%相比,R_m=40%时爆发压力增加0.94 MPa,放热率峰值增加53.5%,烟度、核态颗粒数、积聚态颗粒数和颗粒物总数的降幅分别达66.9%、42.3%、67.0%和58.0%.     

Comparison among model estimates of critical loads of acidic deposition using different sources and scales of input data

The critical load (CL) of acidic atmospheric deposition represents the load of acidity deposited from the atmosphere to the earth’s surface at which harmful acidification effects on sensitive biological receptors are thought to occur. In this study, the CL for forest soils was estimated for 27 watersheds throughout the United States using a steady-state mass balance approach based on both national and site-specific data and using different approaches for estimating base cation weathering. Results suggested that the scale and source of input data can have large effects on the calculated CL and that the most important parameter in the steady-state model used to estimate CL is base cation weathering. These results suggest that the data and approach used to estimate weathering must be robust if the calculated CL is to be useful for its intended purpose.     

Self-inhibition can limit biologically enhanced TCE dissolution from a TCE DNAPL

Biodegradation of trichloroethene (TCE) near a Dense Non Aqueous Phase Liquid (DNAPL) can enhance the dissolution rate of the DNAPL by increasing the concentration gradient at the DNAPL-water interface. Two-dimensional flow-through sand boxes containing a TCE DNAPL and inoculated with a TCE dechlorinating consortium were set up to measure this bio-enhanced dissolution under anaerobic conditions. The total mass of TCE and daughter products in the effluent of the biotic boxes was 3-6 fold larger than in the effluent of the abiotic box. However, the mass of daughter products only accounted for 19-55% of the total mass of chlorinated compounds in the effluent, suggesting that bio-enhanced dissolution factors were maximally 1.3-2.2. The enhanced dissolution most likely primarily resulted from variable DNAPL distribution rather than biodegradation. Specific dechlorination rates previously determined in a stirred liquid medium were used in a reactive transport model to identify the rate limiting factors. The model adequately simulated the overall TCE degradation when predicted resident microbial numbers approached observed values and indicated an enhancement factor for TCE dissolution of 1.01. The model shows that dechlorination of TCE in the 2D box was limited due to the short residence time and the self-inhibition of the TCE degradation. A parameter sensitivity analysis predicts that the bio-enhanced dissolution factor for this TCE source zone can only exceed a value of 2 if the TCE self-inhibition is drastically reduced (when a TCE tolerant dehalogenating community is present) or if the DNAPL is located in a low-permeable layer with a small Darcy velocity.     

湘江株洲段丰水期镉污染负荷总量测算及分配

以2010年8月湘江干流株洲段代表性断面水质与底泥监测资料以及其他资料为基础,采用WASP7模型模拟该江段丰水期镉浓度,并进行镉污染负荷测算与分配。研究结果表明,WASP7模型较好地重现了镉浓度的变化规律,8月份该河段上游镉入流量2 446.33 kg,下游出流量3 076.44 kg,区间增量630.12 kg,其中点源负荷量241.67 kg,占38.4%,面源负荷量304.49 kg,占48.3%,内源负荷量为83.96 kg,占13.3%。     

Incorporating Uncertainty Into the Ranking of SPARROW Model Nutrient Yields From Mississippi/Atchafalaya River Basin Watersheds1

Abstract: Excessive loads of nutrients transported by tributary rivers have been linked to hypoxia in the Gulf of Mexico. Management efforts to reduce the hypoxic zone in the Gulf of Mexico and improve the water quality of rivers and streams could benefit from targeting nutrient reductions toward watersheds with the highest nutrient yields delivered to sensitive downstream waters. One challenge is that most conventional watershed modeling approaches (e.g., mechanistic models) used in these management decisions do not consider uncertainties in the predictions of nutrient yields and their downstream delivery. The increasing use of parameter estimation procedures to statistically estimate model coefficients, however, allows uncertainties in these predictions to be reliably estimated. Here, we use a robust bootstrapping procedure applied to the results of a previous application of the hybrid statistical/mechanistic watershed model SPARROW (Spatially Referenced Regression On Watershed attributes) to develop a statistically reliable method for identifying “high priority” areas for management, based on a probabilistic ranking of delivered nutrient yields from watersheds throughout a basin. The method is designed to be used by managers to prioritize watersheds where additional stream monitoring and evaluations of nutrient‐reduction strategies could be undertaken. Our ranking procedure incorporates information on the confidence intervals of model predictions and the corresponding watershed rankings of the delivered nutrient yields. From this quantified uncertainty, we estimate the probability that individual watersheds are among a collection of watersheds that have the highest delivered nutrient yields. We illustrate the application of the procedure to 818 eight‐digit Hydrologic Unit Code watersheds in the Mississippi/Atchafalaya River basin by identifying 150 watersheds having the highest delivered nutrient yields to the Gulf of Mexico. Highest delivered yields were from watersheds in the Central Mississippi, Ohio, and Lower Mississippi River basins. With 90% confidence, only a few watersheds can be reliably placed into the highest 150 category; however, many more watersheds can be removed from consideration as not belonging to the highest 150 category. Results from this ranking procedure provide robust information on watershed nutrient yields that can benefit management efforts to reduce nutrient loadings to downstream coastal waters, such as the Gulf of Mexico, or to local receiving streams and reservoirs.     

对水泥企业生产环境负荷之浅析

基于生命周期理论，采用CNI环境影响评价方法对我国水泥生产的环境负荷进行了定量分析。结果表明：水泥生产的环境影响主要体现在温室效应、不可再生能源消耗和不可再生资源消耗，其环境负荷分别占对应环境影响类型世界总负荷的2.76％，2.34％和1.39％，2006年我国水泥生产的环境负荷约占世界总负荷的1.28％，其中，立窑生产工艺、湿法回转窑生产工艺和新型干法生产工艺的环境负荷分别为0.84％，0.12％和0.32％。通过行业结构调整，用新型干法生产工艺取代其他落后的生产工艺，可使我国水泥生产的环境负荷降至世界总负荷的1％左右。     

三峡库区香溪河流域非点源营养盐输出变化的试验研究

综合三峡库区香溪河流域土地利用结构和水系特点，在三大支流出口处设置常规水质监测断面，于干流响滩处设置水文控制断面，通过断面水质水量监测，利用数字滤波法解析径流多源和污染多源，研究上游来流点源和非点源营养盐输出负荷变化。结果表明：受农业非点源污染影响，TN是高岚河（0788 mg/L）＞古夫河（0712 mg/L）＞南阳河（0567 mg/L）；南阳河受磷矿企业点源输入的影响，TP是南阳河（0323 mg/L）＞高岚河（0074 mg/L）＞古夫河（0053 mg/L）；断面流量与降雨量的相关系数〖WTBX〗R〖WTBZ〗2=0720 2；TN和TP非点源年负荷输出分别占总量的61%和40%的， 20100607次降雨径流监测分析发现此次降雨汇流期间营养盐TN和TP输出的非点源贡献率分别达752%和709%；营养盐负荷主要受径流量影响，TN和TP输出负荷与流量的相关系数分别是0963 6和0978 9     

冲击负荷对厌氧序批式反应器的影响及其恢复重建过程

研究了在厌氧条件下以葡萄糖为基质的厌氧序批式反应器(ASBR)中冲击负荷对基质吸收和储存的影响及其恢复重建过程.结果表明,正常状态下,反应器在进水COD为5 000.0 mg/L,出水COD为188.6 mg/L,当进水负荷提高至正常状态2倍后,反应器中COD大量累积,其中51.13％为挥发性有机酸(VFA),48.87％则被转化为糖原储存在细胞体内,出水COD最高为2 368.9 mg/L,污泥糖原储存量最高为273.55 mg/g(以挥发性固体计),是正常状态的4.2倍.在冲击负荷条件下,反应器的产甲烷能力恢复较快,胞内糖原储存恢复较慢,出水COD和胞内糖原分别经过20、41 d后恢复冲击负荷前水平.