Seed yeast cultivation for salad oil manufacturing wastewater treatment

The mixture of five yeast strains obtained from soil could remove about 85% TOC of oil-rich wastewater in batch test.While the highest MLSS was obtained at an N:C of 1:5,the oil removal decreased with the increase of N:C during yeast sludge cultivation.Ammonium chloride was the best nitrogen source for yeast cultivation from the viewpoint of yeast growth and oil utilizxation.An ammonia concentration of over 1300 mg/L led to mass death of yeast at a pH of 5.The ammonia concentration should be controlled at a level of 1000 mg/L or lower.     

复配絮凝剂的筛选及其在炼油污泥中的应用

通过试验筛选出对炼油污泥处理效果好的复配絮凝剂。试验和现场应用结果表明：使用有机高分子絮凝剂(PAM)分别和无机高分子絮凝剂(PAC)复配处理炼油污泥比单独使用任何一种絮凝剂的处理效果更好，复配絮凝剂具有适应性广、投加量少、浮渣少等优点，处理后的污水可以达到排放标准。     

用呼吸仪监测取代酚类化合物对活性污泥的抑制

应用呼吸仪测定活性污泥中微生物的活性。研究了九种取代酚对微生物活性的影响,发现抑制效应与有机物的正辛醇-水分配系数、最低未占轨道能级有着相关联系,并发现取代酚对活性污泥硝化细菌比起异养细菌有着更强的抑制。生物膜比活性污泥具有更好的耐抑制能力,驯化对抗抑制有明显的效果,增大污泥浓度在一定程度上可以减轻毒害。     

循环式活性污泥法处理污水工艺研究

循环式活性污泥法是通过厌氧装置培养优化的活性污泥,然后在曝气池中进行同步的硝化反硝化过程,从而达到脱氮除磷的效果。     

Toxic metals in sewage sludge-amended soils: has promotion of beneficial use discounted the risks?

Land application of contaminated waste products has been defended as beneficial use by some scientists and regulators, based on the premise that the behavior of any toxins accumulated in soils from this practice is reasonably well understood and will not have detrimental agronomic or environmental impacts into the foreseeable future. In this review, I use the case of toxic metals in sewage sludges applied to agricultural land to illustrate that metal behavior in soils and plant uptake is difficult to generalize because it is strongly dependent on the nature of the metal, sludge, soil properties and crop. Nevertheless, permitted agricultural loadings of toxic metals from sewage sludges are typically regulated using the sole criterion of total metal loading or concentrations in soils. Several critical generalizing assumptions about the behavior of sludge-borne metals in soil-crop systems, built into the US EPA risk assessment for metals, have tended to underestimate risks and are shown not to be well justified by published research. It is argued that, in the absence of a basic understanding of metal behavior in each specific situation, a more precautionary approach to toxic metal additions to soils is warranted.     

氯化钠抑制下乙酸厌氧降解的动力学模型

作者利用五个实验室规模的完全混合反应器进行较长时间的半连续培养,研究在氯化钠抑制下乙酸盐的厌氧降解。结果表明,在不同条件下运行的反应器内,存在优势菌群的显著差异,因此在不同条件下运行的反应器对抑制有不同的响应。作者引入抑制因子的概念,建立了在氯化钠抑制下乙酸厌氧降解的动力学模型。同时指出反应器运行条件与菌群组成的联系以及菌群组成的差别对反应器运行状况的影响,在废水生物处理的动力学模型研究中应给予足够的重视。     

机械强化污泥回流式一体化活性污泥法的运行机理研究

活性污泥通过机械搅拌强化污泥内循环回流,提高了污泥的活性,并且使污泥浓度可达到4.5kg/m3,用该机械强化污泥回流式一体化活性污泥法处理小区生活污水,当水力停留时间为3h,溶解氧为2.2mg/L,机械搅拌速度为250r/min时,CODcr、氨氮去除率均可达到83% 以上,出水达到国家污水排放一级标准.该一体化活性污泥法简单易行,运行成本低,投资小,操作维护方便,是生活小区生活污水适宜的处理工艺技术.     

A／O-化学除磷工艺中DMBR动态膜成膜条件研究

根据动态膜原理，将0．1mm孔径无纺布为膜材的动态膜反应器（Dynamic Membrane BioReactor，DMBR）应用于A／O-化学除磷工艺之中，在动态膜反应器内完成泥水分离。试验测试了曝气强度、初始膜通量和污泥浓度对动态膜成膜的影响。结果表明，曝气强度和初始膜通量是影响成膜的关键性参数。当曝气强度≥60m^3／m^2·h或初始膜通量≥70L／m^2·h，2h内均不能形成截留性能良好的动态膜。在VSS／SS较低的污泥系统中，适宜的成膜条件为：曝气强度≤40m^3／m^2·h；初始膜通量≤40L/m^2·h。     

膜生物反应器处理印染废水技术研究

采用小试规模(148L/d)的厌氧-好氧膜生物反应器处理印染废水.当水力停留时间为14小时,进水COD、色度分别为208.54～2592.00mg/l、32～256倍,通过水解酸化-体式膜生物反应器试验,系统对COD、色度的去除率分别达到了80%～90%、87.5%.出水水质浓度或指标分别为21.80～363.20mg/l、8倍,具有良好的处理效果.厌氧-好氧膜生物反应器工艺处理印染废水技术可行、操作简单、易于管理、可为工业规模应用提供技术参考.     

膜生物反应器膜污染的水力学控制实验研究

叙述了膜污染是影响膜-生物反应器处理技术推广应用的关键因素，采用水动力学方法是控制膜污染的有效方法。在不同污泥浓度条件下。对不同曝气强度下膜污染的发展速率及其形成机理进行了试验研究，研究结果表明：对应于不同污泥浓度均存在一个经济曝气强度，其大小随污泥浓度升高呈线性增加，膜生物反应器在经济曝气强度条件下运行可控制膜污染的发展；并从理论上推导出一个临界污泥浓度，其值为5．15g／L。对应于临界污泥浓度，并且污泥絮体在膜面可形成比较稳定的动态膜，膜过滤压差上升的速率最慢，膜生物反应器在此临界污泥浓度条件下运行膜污染发展最为缓慢。