我国典型铅锌选矿企业尾矿产生及综合利用分析

通过对我国6家典型铅锌选矿企业铅锌尾矿产生情况的调研及现场采样测试分析,掌握典型企业铅锌尾矿的产生、理化性质及综合利用情况,推算出不同品位铅锌原矿吨产品铅锌尾矿的产生系数,并结合我国铅锌选矿行业及铅锌尾矿综合利用现状,提出适合我国国情的对策建议。     

ZnOOH/O3催化臭氧化体系去除水中痕量对氯硝基苯

以实验室制备的羟基化锌（ZnOOH）为催化剂,考察了其催化臭氧化去除水中痕量对氯硝基苯（ppCNB能力.本实验条件下,蒸馏水中反应20　min时,催化臭氧化比单独臭氧化对pCNB的去除率提高了51 .3个百分点;催化过程遵循自由基反应机理,催化剂表面结合的羟基基团有利于催化反应;pCNB的去除效果随催化剂投量的增加而更佳,催化剂重复使用3次后,催化效果基本没有变化,水中的重碳酸盐以及缓冲溶液中的磷酸盐可以明显降低催化活性,中性条件下,催化作用最佳.     

电沉积法处理电解锌漂洗废水的动力学研究

采用电沉积法处理电解锌漂洗工艺废水,以回收废水中的重金属资源。在不同实验条件下对电沉积反应过程中电沉积反应速率及其影响因素进行了研究,结果表明,电沉积回收重金属锌符合准一级动力学规律,当V=6 V时,速率常数k=0.0214。最佳实验条件为:槽电压V=6 V、电解时间为45~60 min、pH为2.5~3.5,反应过程中应充分搅拌。利用电沉积法处理电解锌漂洗废水,将重金属Zn2+还原为单质锌,处理废水的同时实现重金属资源的回收,在工业中有较好的应用前景。     

陕西老厂铅锌矿床成矿流体特征及其地质意义

陕西老厂铅锌矿床是一个与海相火山岩有关的块状硫化物矿床。老厂铅锌矿床石英流体包裹体的均一温度为93.3~396.5℃,平均值为235.9℃;盐度为0.4~22.5wt%NaCl,平均值为9.9wt%NaCl。原生流体包裹体均一温度测定结果表明其具有近似正态分布的特点;石英流体包裹体的盐度表明,其不成正态分布,且盐度较低。老厂矿床δDV-SMOW‰和δ18 OH2O‰的组成关系反映了其成矿流体为混合热液来源。     

石灰干化污泥稳定后土壤中Pb、Cd和Zn浸出行为的研究

以人工制备Zn、Pb、Cd污染土壤为研究对象,采用城市污水处理石灰干化污泥作为稳定剂,对污染土壤进行稳定化处理,并采用TCLP、SPLP、去离子水浸提和优化的BCR连续提取法对稳定化效果进行分析和评价.结果表明,单独使用石灰干化污泥,TCLP浸出浓度随着干化污泥质量分数的增加而显著减少,干化污泥的质量分数为40%时,稳定化率最大为Zn-99.54%、Pb-99.60%、Cd-99.85%.SPLP和去离子水浸出评价稳定效果时,Pb和Zn在加入质量分数10%和20%的干化污泥时浸出明显降低,但在加入30%和40%时由于在强碱条件Pb和Zn会再溶出,导致稳定效果变差.为了恢复植物生长功能,经过FeSO4和H3PO4调节pH后,石灰干化污泥稳定过的土壤pH有效降低,同时FeSO4和H3PO4有利于促进Pb和Zn的稳定效果.经稳定化后,土壤中的重金属可交换态降低,限制了土壤重金属的迁移.该研究结果表明石灰干化污泥可以再利用,应用于重金属污染土壤的稳定化修复中,并能改善稳定后土壤适宜植物生长的理化性质.     

速生树种竹柳对复合污染土壤中镉和锌的吸收、积累与生理响应特性

为探讨竹柳在重金属复合污染(镉、锌)土壤中生长的生理变化及重金属在植株内的转移情况,以竹柳(Salix sp.)三号及竹柳五号为试验材料,以重金属复合污染的水稻土为供试土壤,通过盆栽试验研究了重金属对竹柳生理指标、重金属吸收与积累量、富集系数(BCF)和转运系数(TF)的影响.结果表明:竹柳各器官重金属含量和转移情况不同,其中,叶片中Cd、Zn含量最高,分别达61.4和1940 mg·kg~(-1);竹柳三号对Zn的转运能力大于竹柳五号,而竹柳五号的净光合速率更高;生长100 d后,重金属在竹柳叶片中的积累量和转移系数均高于其他部位,竹柳吸收的重金属主要分布在叶片中,可通过集中处理叶片达到去除土壤中重金属污染的目的.     

离子液体对废旧印刷线路板中铜、锌、铅的浸出规律

以离子液体1-丁基磺酸-3-甲基咪唑三氟甲烷磺酸盐([BSO_3HMIm]OTf)为浸出剂,初步研究了WPCBs浸铜过程中锌和铅浸出率的影响因素。实验结果表明:铜、锌的浸出率随着WPCBs粒径的减小、H_2O_2溶液加入量的增大而增大,铜的浸出率随浸出温度的升高先增大后减小,锌的浸出率受浸出温度影响不大;铅的浸出率受5种因素影响不大,且总体处于较低水平。在WPCBs粒径为0.100~0.250 mm、离子液体加入量为60.0%(φ)、H_2O_2溶液加入量为7.5%(φ)、固液比为1∶15、浸出温度为50℃的条件下,铜、锌、铅的浸出率分别为99.84%,93.25%,22.46%。     

聚硅酸锌铝的制备及其性能研究

以硅酸钠、硫酸锌、硫酸铝为原料，通过共聚法制备了无机高分子絮凝剂聚硅酸锌铝（PSZAS），研究了Na₂SiO₃的摩尔浓度、活化时间、Al/Si、Zn/Si 配比及絮凝剂的投加量对絮凝效果的影响，用X-射线衍射（XRD）和电子扫描电镜（SEM）对该絮凝剂的结构及形貌进行了表征。结果表明：当硅酸钠的浓度为0.4 mol/L，硅酸活化时间为2 h，Si∶Al∶Zn=1∶1∶1.5，絮凝剂投加量为20 mL/L废水时，絮凝剂的电中和能力和吸附架桥能力最强，絮凝剂对含H-酸染料模拟废水的絮凝效果最好。     

Accumulation and mobility of zinc in soil amended with different levels of pig-manure compost

Applying manure compost not only results in zinc accumulation in the soil but also causes an increase in zinc mobility and enhances zinc leaching. In this study, the physical and chemical characteristics of zinc, zinc profiles, and zinc balance were investigated to characterise the fate of zinc in fields where the quality and amount of pig manure compost applied have been known for 13 years. Moreover, we determined zinc fractionation in both 0.1 mol L^?1HCl-soluble (mobile) and -insoluble (immobile) fractions. Adsorption of zinc in the soil was enhanced with increasing total carbon content following the application of pig manure compost. The 159.6 mg ha^?1 year^?1manure applied plot (triplicate) exceeded the Japanese regulatory level after only 6 years of applying pig manure compost, whereas the 53.2 mg ha^?1 year^?1 manure applied plot (standard) reached the regulatory level after 13 years. The zinc loads in the plots were 17.0 and 5.6 kg ha^?1 year^?1, respectively. However, 5.9 % and 17.2 % of the zinc loaded in the standard and the triplicate pig manure compost applied plots, respectively, were estimated to be lost from the plough layer. Based on the vertical distribution of mobile and immobile zinc content, a higher rate of applied manure compost caused an increase in the mobile zinc fraction to a depth of 40 cm. Although the adsorption capacity of zinc was enhanced following the application of pig manure compost, a greater amount of mobile zinc could move downward through the manure amended soil than through non manure-amended soil.     

Ionic dye adsorption by zinc oxide nanoparticles

The adsorption behaviour of Basic Red 12, Acid Orange 7 and Acid Blue 1 on zinc oxide nanoparticles (ZNP) has been investigated to understand the physicochemical process involved and to explore the possible use of nanoparticles in the treatment and management of textile waste matter. The dye removal capacity of ZNP towards Basic Red 12, Acid Orange 7 and Acid Blue 1 was found to be 15.64, 6.78 and 6.38 mg g^?1, respectively. The adsorption process was pH dependent and optimum pH values of 9.0, 2.0 and 4.0 were obtained for Basic Red 12, Acid Orange 7 and Acid Blue 1, respectively. Equilibrium was established after 1.0 h for all dyes. Langmuir, Freundlich and Temkin isotherm models were applied to the system. The adsorbent ZNP was characterised using scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), Brunauer–Emmett–Teller (BET) and Fourier transform infrared (FTIR) techniques. SEM analysis revealed the noticeable nanoporous morphology of the material. The results of FTIR spectroscopy showed that the process is driven by an electrostatic complexation mechanism. XRD studies revealed the nanocrystalline structure of ZNP. BET surface area measurement suggested a high pore volume and large surface area for the adsorbent. The kinetic measurements suggested pseudo-second-order kinetic processes with high regression coefficients and smaller standard error of estimate values and lower residual sum of squares. The thermodynamic measurements suggested that all processes were exothermic and accompanied by negative values for Δ G⁰, Δ S⁰ and Δ H⁰.