Unregulated emissions from diesel engine with particulate filter using Fe-based fuel borne catalyst

The alteration and formation of toxic compounds and potential changes in the toxicity of emissions when using after-treatment technologies have gained wide attention. Volatile organic compound（VOC）, carbonyl compound and particle-phase polycyclic aromatic hydrocarbon（PAH） emissions were tested at European Steady State Cycle（ESC） to study unregulated emissions from a diesel engine with a fuel-borne catalyst and diesel particulate filter（FBC–DPF）. An Fe-based fuel-borne catalyst was used for this study. According to the results, brake specific emissions of total VOCs without and with DPF were 4.7 and4.9 mg/kWh, respectively, showing a 4.3% increase. Benzene and n-undecane emissions increased and toluene emission decreased, while other individual VOC emissions basically had no change. When retrofitted with the FBC–DPF, total carbonyl compound emission decreased 15.7%, from 25.8 to 21.8 mg/kWh. The two highest carbonyls, formaldehyde and acetaldehyde, were reduced from 20.0 and 3.7 to 16.5 and 3.3 mg/kWh respectively. The specific reactivity（SR） with DPF was reduced from 6.68 to 6.64 mg/kWh. Total particle-phase PAH emissions decreased 66.4% with DPF compared to that without DPF. However, the Benzo[a]pyrene equivalent（BaPeq） with DPF had increased from 0.016 to 0.030 mg/kWh.Fluoranthene and Pyrene had the greatest decrease, 91.1% and 88.4% respectively. The increase of two- and three-ring PAHs with DPF indicates that the fuel-borne catalyst caused some gas-phase PAHs to adsorb on particles. The results of this study expand the knowledge of the effects of using a particulate filter and a Fe-based fuel-borne catalyst on diesel engine unregulated emissions.     

Mo-modified Pd/Al2O3 catalysts for benzene catalytic combustion

Mo-modified Pd/Al2O3catalysts were prepared by an impregnation method and tested for the catalytic combustion of benzene. The catalysts were characterized by N2 isothermal adsorption, X-ray diffraction（XRD）, X-ray photoelectron spectroscopy（XPS）, temperatureprogrammed desorption of NH3（NH3-TPD）, H2temperature-programmed reduction（H2-TPR）, and high-angle annular dark-field scanning transmission electron microscopy（HAADF-STEM）. The results showed that the addition of Mo effectively improved the activity and stability of the Pd/Al2O3catalyst by increasing the dispersion of Pd active components, changing the partial oxidation state of palladium and increasing the oxygen species concentration on the surface of catalyst. In the case of the Pd-Mo/Al2O3catalyst,benzene conversion of 90% was obtained at temperatures as low as 190°C, which was 45°C lower than that for similar performance with the Pd/Al2O3catalyst. Moreover, the 1.0% Pd-5% Mo/Al2O3catalyst was more active than the 2.0% Pd/Al2O3catalyst. It was concluded that Pd and Mo have a synergistic effect in benzene catalytic combustion.     

石化企业苯类物质非密闭操作过程的职业暴露分析

采用职业卫生学调查和职业暴露风险评估方法,对选定的苯类物质非密闭操作过程较集中的芳烃装置进行职业暴露分析和评估,为石化企业苯类物质的健康风险控制提供依据。     

顶空毛细柱气相色谱法测定水中七种苯系物研究

选用Elite-FFAP色谱柱,利用顶空-毛细柱气相色谱技术对水中的苯、甲苯、乙苯、对二甲苯、间二甲苯、邻二甲苯、苯乙烯七种挥发性苯系物进行同时测定,并对样品的平衡温度、保温时间、程序升温的条件控制、水中含盐量等影响因素进行了探讨,优化了检测条件,使七种挥发性苯系物得到不错的分离。样品平衡温度控制在70℃,样品平衡时间19 min,进样口温度180℃,检测器温度230℃,10 mL水样中加入4 g NaCl的条件下,分离效果最佳。     

环境空气中苯系物污染物的快速定量研究

本文采用便携式GC/MS仪器对大气中痕量苯系物污染物的快速定量分析进行研究。对比实验结果表明,全扫描和选择离子扫描两种扫描方式下苯系物测定结果的相对标准偏差分别在5.1%²8.4%和13%28.4%和13%¹9%之间,回收率范围分别为46%19%之间,回收率范围分别为46%¹86%和60%186%和60%¹10%,方法检出限范围分别为2.504110%,方法检出限范围分别为2.504¹0.63 ug/m3和0.49410.63 ug/m3和0.494².399 ug/m3。总体而言,选择离子扫描方式在测定结果的精密度与准确度上均优于全扫描方式。     

试析气相色谱法测定环境空气中苯系物的要点

随着我国城市化进程的不断加快,我国的环境污染问题越来越严峻。苯系物作为空气污染物中的重要一种,其对人体的健康有着非常大的危害。本文从气相色谱法测定环境空气中苯系物浓度的原理及方法出发,对影响测定结果的因素进行了分析。     

蚯蚓细胞色素P450酶系对土壤中芘或苯并[a]芘的响应

以赤子爱胜蚓(Eisenia fetida)为受试生物,通过人工污染草甸棕壤微宇宙试验方法,研究了暴露于不同环境浓度芘或苯并[a]芘(添加量分别为0.12、0.24、0.48、0.96 mg·kg~(-1))污染的土壤中14 d后,蚯蚓体内细胞色素P450(CYPs)酶系,如CYPs总量、CYP1A1及CYP2C9活性的变化.结果显示,芘或苯并[a]芘暴露导致蚯蚓CYPs总量、CYP1A1及CYP2C9活性的变化不同.其中,CYPs总量与CYP1A1活性对芘的响应趋势相似:试验3 d后,0.96 mg·kg~(-1)芘导致二者都显著高于对照水平;14 d后,都显著低于对照水平;CYP1A1活性对芘的响应更为敏感.CYPs总量与CYP2C9活性对苯并[a]芘的响应趋势相似:暴露初期,苯并[a]芘最高暴露剂量(0.96 mg·kg~(-1))导致二者都显著低于对照水平;试验结束后,苯并[a]芘最低暴露剂量(0.12 mg·kg~(-1))导致二者都显著高于对照水平,最高剂量暴露导致二者都显著低于对照水平,CYP2C9活性对苯并[a]芘的响应更为敏感.因此,推断CYPs亚酶对污染物的响应具有选择性且亚酶的响应敏感度高于CYPs总量.将CYPs总量与CYP1A1活性结合,或与CYP2C9活性结合分别诊断土壤芘污染或并[a]芘污染,较为准确有效.     

对苯二甲酸生产废水回用实验研究

采用高级氧化工艺对对苯二甲酸生产废水进行处理，系统考察了氧化剂投加量、废水pH等对处理效果的影响，得出了最佳工艺条件。经过处理的PTA废水，水质达到了车间用水的要求。本方法具有处理效果好、操作简单和环境友好等优点。     

污泥含炭吸附剂对挥发性有机废气吸附实验研究

研究了污泥含炭吸附剂对挥发性有机污染物的吸附特性。结果表明,污泥含炭吸附剂对苯系物的吸附为典型的物理吸附,其吸附甲苯等温线的类型系优惠型吸附等温线,表明具有良好的吸附能力;在吸附反应温度为20℃,气体流量为500 mL/m in(停留时间为0.424 s),甲苯浓度为2 700 mg/m3时,甲苯的饱和吸附容量为150.0 mg/g;同时,研究表明污泥含炭吸附剂对苯系物的饱和吸附容量和吸附强弱次序为二甲苯甲苯苯。结果表明污泥含炭吸附剂适合对中低浓度有机废气的吸附净化。     

改性TiO_2光催化降解三苯甲烷类污染物

以硫酸钛为原料采用水热法制备了掺Fe3＋TiO2晶体粉末,采用X射线衍射仪（XRD）对样品的结构进行了表征。在可见光条件下,用溴酚蓝、甲基绿、甲基蓝、孔雀石绿、甲基紫和碱性品红等6种典型三苯甲烷类化合物为目标降解物,研究了以自制的掺Fe3＋TiO2晶体粉末对它们的催化降解作用。实验结果表明,制备的掺Fe3＋TiO2晶体属于锐钛矿型。6种化合物的光催化降解反应遵循拟一级动力学规律,且可用Langmuir-Hinshelwood（L-H）动力学模型描述,其表观反应速度常数（k）的大小顺序为：溴酚蓝〈甲基绿〈甲基蓝〈孔雀石绿〈甲基紫〈碱性品红,大小变化次序与其半衰期t1/2成反比,并从分子结构上对它们的降解规律进行定性解释。