A/O工艺N_2O的产生与释放的影响因素

采用A/O工艺,在连续运行条件下,以DO、SRT和硝化液回流比(R)为影响因素,对A/O生物脱氮工艺处理模拟城市生活污水过程中N2O的释放进行了研究。实验结果表明,SRT对A/O工艺N2O释放的影响最大,其次是DO,R的影响最小。N2O转化率随着SRT的升高而降低,当SRT从10 d升高到20 d时,总N2O平均转化率从0.319%下降到0.002%。总N2O转化率随着好氧池DO的升高先降低后有所升高,当DO分别为0.6 mg O2/L、1.2 mg O2/L、2.5 mg O2/L时,反应器的总N2O平均转化率分别为0.306%、0.007%和0.013%。R对N2O释放的影响差异不明显,总N2O平均转化率在300%时最低,为0.007%。N2O释放量最低的工艺运行条件组合是SRT为20 d、DO为1.2 mg O2/L、R为300%。     

Formation of PCDD/Fs from oxidation of 2-monochlorophenol over an Fe2O3/silica surface

The role of iron in surface-mediated formation of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) from 2-chlorophenol (2-MCP) was investigated over the temperature range of 200-550 °C under oxidative conditions. In order to compare and contrast with previous work on copper and ferric oxide-mediated pyrolysis of 2-MCP, identical reaction conditions were maintained (50 ppm 2-MCP, model fly-ash particles containing 5% Fe₂O₃ on silica). Observed products included dibenzo-p-dioxin (DD), 1-monochlorodibenzo-p-dioxin (1-MCDD), dibenzofuran (DF), 4,6-dichlorodibenzofuran (4,6-DCDF), 2,4- and 2,6-dichlorophenol, 2,4,6-trichlorophenol, quinone, catechol, chloro-o-quinone, chlorocatechol and polychlorinated benzenes. Yields of DD and 1-MCDD were 2 and 5 times higher than under pyolysis conditions, respectively. Although 4,6-DCDF was the major PCDD/F product formed with a yield that was 2.5× greater than under pyrolysis, the yield of non-chlorinated DF, which was the dominant PCDD/F product under pyrolysis, decreased by a factor of 3. Furthermore, the ∼2× higher yield of PCDDs under oxidative conditions resulted in a PCDD to PCDF ratio of 0.75 compared to a relatively low ratio of 0.39 previously observed under pyrolytic conditions.     

废水中环氧丙烷降解菌株的培育及降解效果研究

本文通过对污泥的驯化筛选得到4株降解环氧丙烷废水的优势茵A、B、C、D，并对降解效果最好的一个菌株A进行研究，得到其最佳降解条件是温度为30℃、pH为5、废水浓度为20％、反应时间为9h，其COD去除率可达到63．24％左右。     

Toxicity of nanoparticulate and bulk ZnO, Al2O3 and TiO2 to the nematode Caenorhabditis elegans

Limited information is available on the environmental behavior and associated potential risk of manufactured oxide nanoparticles (NPs). In this research, toxicity of nanoparticulate and bulk ZnO, Al₂O₃ and TiO₂ were examined to the nematode Caenorhabditis elegans with Escherichia coli as a food source. Parallel experiments with dissolved metal ions from NPs were also conducted. The 24-h median lethal concentration (LC₅₀) and sublethal endpoints were assessed. Both NPs and their bulk counterparts were toxic, inhibiting growth and especially the reproductive capability of the nematode. The 24-h LC₅₀ for ZnO NPs (2.3 mg L⁻¹) and bulk ZnO was not significantly different, but significantly different between Al₂O₃ NPs (82 mg L⁻¹) and bulk Al₂O₃ (153 mg L⁻¹), and between TiO₂ NPs (80 mg L⁻¹) and bulk TiO₂ (136 mg L⁻¹). Oxide solubility influenced the toxicity of ZnO and Al₂O₃ NPs, but nanoparticle-dependent toxicity was indeed observed for the investigated NPs.     

Long-term depletion of calcium and other nutrients in eastern US forests

Both harvest removal and leaching losses can deplete nutrient capital in forests, but their combined long-term effects have not been assessed previously. We estimated changes in total soil and biomass N, Ca, K, Mg, and P over 120 years from published data for a spruce-fir site in Maine, two northern hardwood sites in New Hampshire, central hardwood sites in Connecticut and Tennessee, and a loblolly pine site in Tennessee. For N, atmospheric inputs counterbalance the outputs, and there is little long-term change on most sites. For K, Mg, and P, the total pool may decrease by 2%–10% in 120 years depending on site and harvest intensity. For Ca, net leaching loss is 4–16 kg/ha/yr in mature forests, and whole-tree harvest removes 200–1100 kg/ha. Such leaching loss and harvest removal could reduce total soil and biomass Ca by 20%–60% in only 120 years. We estimated unmeasured Ca inputs from rock breakdown, root-zone deepening, and dry deposition; these should not be expected to make up the Ca deficit. Acid precipitation may be the cause of current high leaching of Ca. Although Ca deficiency does not generally occur now in acid forest soils, it seems likely if anthropogenic leaching and intensive harvest removal continue.     

Poly(ethylene oxide)-coated granular starch-poly(hydroxybutyrate-co-hydroxyvalerate) composite materials

Granular cornstarch was coated with several biodegradable polymers in an effort to improve the mechanical properties of starch-poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) composites. Only samples containing poly(ethylene oxide) (PEO)-coated granular starch showed a large improvement in tensile properties over uncoated starch. For example, a 50/50 blend of PEO-coated starch and PHBV had a tensile strength of 19 MPa and an ultimate elongation of 23%, compared to 10 MPa and 11% for a similar blend containing uncoated starch. PEO may act as an adhesive between the starch and the PHBV and/or increase the toughness and resistance to crack growth of PHBV around the starch granules.Paper presented at the Bio/Environmentally Degradable Polymer Society—Third National Meeting, June 6–8, 1994, Boston, Massachusetts.Names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product and the use of the name by the USDA implies no approval of the product to the exclusion of others that may also be suitable.     

尿中氚水和总氚的对比分析测定研究

用蒸馏液闪法测量尿中氚水浓度 ,用氧化蒸馏液闪法测量尿中总氚 (氚水和有机氚 )浓度。同时测量了 1999年核设施退役时接触氚人员的高于本底水平的尿中氚水和总氚浓度 72个样品。比较氚水和有机氚浓度 ,得到有机氚浓度占氚水浓度的平均值为 (5 4± 3 7) % ,其值与理论值和动物实验值基本相符     

Investigation the effect of adding graphene oxide into diesel/higher alcohols blends on a diesel engine performance

ABSTRACT

This article aims to study the influence of the addition of graphene oxide nanoparticles (GO) to diesel/higher alcohols blends on the combustion, emission, and exergy parameters of a CI engine under various engine loads. The higher alcohols mainly n-butanol, n-heptanol, and n-octanol are blended with diesel at a volume fraction of 50%. Then, the 25 and 50 mg/L concentrations of GO are dispersed into diesel/higher alcohols blends using an ultrasonicator. The GO structures are examined using TEM, TGA, XRD and FTIR. The findings show that there is a reduction in p_max. and HRR when adding higher alcohols with diesel fuel. Regarding engine emission, there is a significant improvement in emissions formation with adding higher alcohols. The addition of GO into diesel/higher alcohols blends improves the brake thermal efficiency by 15%. Moreover, the p_max. and HRR are both enhanced by 4%. The CO, UHC and smoke formation are reduced considerably by 40%, 50 and 20%, respectively, while NO_x level is increased by 30% with adding GO. Finally, adding high percentages of n-butanol, n-heptanol, and n-octanol with diesel fuel with the presence of GO has the potential to achieve ultra-low CO, UHC, and smoke formation meanwhile keeping high thermal efficiency level.     

池州市碳酸钙资源开发现状和发展措施

介绍了国内外碳酸钙行业生产、应用技术发展现状和池州市碳酸钙资源开发现状，找出了池州市碳酸钙资源开发中存在的问题和解决措施，提出了池州市碳酸钙工业发展需要实施的各种措施。     

Ethoxylated Soybean Polyols for Polyurethanes

Soybean polyols prepared by ring opening reactions of epoxidized soybean oil with hydrogen active compounds (water, alcohols, organic or inorganic acids, thiols, hydrogen etc.) have a low reactivity in the reaction with isocyanates because the hydroxyl groups are secondary. This paper presents a simple and convenient method to increase the reactivity of soybean polyols with secondary hydroxyl groups by ethoxylation reactions with the preservation of triglyceride ester bonds. The method uses mild reaction conditions: low alkoxylation temperature of 35–45 °C, low pressure of 0.1–0.2 MPa (15–30 p.s.i.) and a superacid as catalyst (HBF₄). The new soybean polyols have a higher reactivity toward isocyanates in polyurethane formation due to the high percentage of primary hydroxyl groups. The primary hydroxyl content was determined by the second order kinetics of polyol reaction with phenyl isocyanate.