平板显示器回收的新挑战

显示屏（监视器和电视机）经历了从阴极射线管到平板显示器技术的快速变化。截至目前为止,只有少量的平板显示器已记录在废物收集点。平板显示器的数量越来越多,在未来需要足够的用于回收的基础设施。本文旨在通过液晶显示屏幕的回收对经济影响的案例研究来提供数量、成分、回收利用技术和经验的基本数据。对于组件和材料也适用于其他类型的电子产品,如黑色金属和有色金属,印刷电路板或电缆,回收途径和技术是众所周知的和可用的。目前,液晶显示器（LCD）在欧洲不回收。处置时,例如,通过焚烧,有价值的材料,其成分是不再可用。例如：铟具有重要战略意义的应用,如,太阳能光伏作为一种稀缺资源。液晶显示器在欧洲具有回收基础设施,因此是有用的。     

某机载军用加固液晶显示器的振动试验

针对某型机载军用加固液晶显示器在随机振动试验条件下出现的故障,进行了故障定位和失效机理分析。根据分析结果对故障采取了相应的纠正措施(用硅橡胶减振器代替失效的异戊橡胶减振器),通过试验验证,证明该措施显著提高了该显示器的振动环境适应性。     

电催化氧化法处理阳离子染料废水的试验研究

以结晶紫作为阳离子染料,采用电催化氧化法对阳离子染料溶液进行了电解脱色处理试验,研究了电流密度、电解质种类、电解质浓度、pH值等对该溶液脱色率的影响,测定了电解时溶液中生成的余氯浓度和溶液的紫外-可见吸收光谱曲线,并对不同电解时间的溶液的吸光度进行了归一化计算。结果表明:随着电解时间的延长,水溶液中活性氯浓度不断上升,经一定时间后达到最大值;在电催化和活性氯的协同作用下,阳离子染料结晶紫分子中的大π共轭体系被破坏、苯环结构基本瓦解,溶液快速脱色;在电流密度为5.1mA/cm2、NaCl浓度为4g/L、pH值为9.41的条件下,初始浓度为100mg/L的结晶紫溶液经过20min的电解,其脱色率可高达98.31%。     

Resistance and biosorption mechanism of silver ions by Bacillus cereus biomass

Biosorption of silver ions onto Bacillus cereus biomass was investigated. Overall kinetic experiments were performed for the determination of the necessary contact time for the attainment of equilibrium. It was found that the overall biosorption process was best described by pseudo second-order kinetic model. The crystals detected by scanning electron microscope and X-ray photoelectron spectroscopy suggested the precipitation was a possible mechanism of biosorption. The molecular genetics of silver resistance of B. cereus biomass was also detected and illustrated by a whole cell sensor tool.     

TiO2载体对Mn-Ce/TiO2催化剂脱硝活性的影响

以TiO₂为载体,选取过渡金属元素Mn为活性组分,稀土金属元素Ce为活性助剂,采用分步共混法制备了Mn-Ce/TiO₂催化剂（活性组分负载量16%）,系统研究了TiO₂载体的晶型和晶粒尺寸对催化剂脱硝活性的影响。实验结果表明：分别以锐钛矿型和金红石型TiO₂为载体制备的催化剂,其低温脱硝活性相差不大,活性组分均以无定型态高度分散于载体中,以金红石型TiO₂为载体制备的催化剂中部分TiO₂转变为锐钛矿型;以不同晶粒尺寸TiO₂载体制备的催化剂的低温脱硝活性相差较大,比表面积较大、晶粒尺寸较小的TiO₂载体制备的催化剂,其脱硝活性低于晶粒尺寸较大的TiO₂载体制备的催化剂。     

ACF电极电解处理含NaCl结晶紫染料废水的研究

以吸附结晶紫达到饱和的活性炭纤维为阳极,在NaCl介质中对初始浓度为100 mg/L的结晶紫染料废水进行了电解脱色处理。实验考察了NaCl浓度、pH值和电流密度等对溶液脱色率的影响,测定了电解时溶液中生成的游离氯浓度及不同电解时间后溶液的紫外-可见吸收光谱曲线,并对不同电解时间后溶液的归一化吸光度比值进行了计算。结果发现,溶液中所产生的游离氯的浓度随电解时间的增加快速上升,20 min时就几乎达到了最大值;在活性氯的作用下,结晶紫分子中的大π共轭体系被破坏,溶液迅速脱色;电解液中所含的NaCl浓度、电解液的pH值和电流密度等都对脱色率有影响;在一定实验条件下,初始浓度为100 mg/L的结晶紫染料废水在电解60 min后脱色率可高达99.3%。     

Combining Measures of Dispersal to Identify Conservation Strategies in Fragmented Landscapes

Abstract: Understanding the way in which habitat fragmentation disrupts animal dispersal is key to identifying effective and efficient conservation strategies. To differentiate the potential effectiveness of 2 frequently used strategies for increasing the connectivity of populations in fragmented landscapes—corridors and stepping stones—we combined 3 complimentary methods: behavioral studies at habitat edges, mark‐recapture, and genetic analyses. Each of these methods addresses different steps in the dispersal process that a single intensive study could not address. We applied the 3 methods to the case study of Atrytonopsis new species 1, a rare butterfly endemic to a partially urbanized stretch of barrier islands in North Carolina (U.S.A.). Results of behavioral analyses showed the butterfly flew into urban and forested areas, but not over open beach; mark‐recapture showed that the butterfly dispersed successfully through short stretches of urban areas (<500 m); and genetic studies showed that longer stretches of forest (>5 km) were a dispersal barrier, but shorter stretches of urban areas (≤5 km) were not. Although results from all 3 methods indicated natural features in the landscape, not urbanization, were barriers to dispersal, when we combined the results we could determine where barriers might arise: forests restricted dispersal for the butterfly only when there were long stretches with no habitat. Therefore, urban areas have the potential to become a dispersal barrier if their extent increases, a finding that may have gone unnoticed if we had used a single approach. Protection of stepping stones should be sufficient to maintain connectivity for Atrytonopsis new species 1 at current levels of urbanization. Our research highlights how the use of complementary approaches for studying animal dispersal in fragmented landscapes can help identify conservation strategies.     

钠盐量影响下DD6单晶高温合金的高温热腐蚀规律研究

目的 开展镍基单晶高温合金DD6在950 ℃下的热盐腐蚀试验(95%Na2SO4+5%NaCl)，探明涂盐量和涂盐方式(周期涂盐和单次涂盐)对DD6高温热腐蚀的影响规律和机理。方法 结合扫描电子显微镜、X射线能量色散谱、X射线衍射等设备，对不同涂盐量及涂盐方式下DD6的表面及横截面形貌进行观察分析，分析不同涂盐量和涂盐方式下DD6的高温热腐蚀机理。结果 DD6在950 ℃下主要发生碱性熔融热腐蚀，同时伴随氧化、硫化和氯化等过程。高温热腐蚀使得DD6合金表面生成的保护性氧化膜被熔融态的腐蚀介质破坏，导致O、S、Cl等外部元素通过氧化膜的缺陷进入DD6基体中，在合金的亚表面发生内氧化、内硫化以及内氯化反应，横截面上出现明显的腐蚀层，其主要由氧化物以及硫化物组成。随着热腐蚀的进行，DD6表面物质发生了剥蚀，沉积盐量的增加导致剥蚀现象越加严重，合金内部致密的组织结构也被破坏，横截面上出现了大量孔洞、裂纹等缺陷。在相同涂盐量下，周期涂盐法使得DD6的腐蚀程度高于单次涂盐法。结论 DD6高温热腐蚀行为与涂盐量及涂盐方式密切相关，相同涂盐方式下，涂盐量越大，DD6热腐蚀更加严重。涂盐量一定时，周期涂盐法使得DD6的热腐蚀剧烈程度大于单次涂盐法，且DD6在上述热腐蚀条件下均发生剥蚀破坏。     

液晶显示器液晶处理与铟回收技术

在实验室条件下,对液晶显示器回收的各个重要环节作了初步的探索,提出了一整套回收工艺.其中包括利用丙酮常温浸取去除偏光片、分离玻璃基板、溶解液晶,还包括利用硫酸溶液和二氧化锰联合浸取玻璃基板,铟的浸取率达89%.得到的铟的酸液经过萃取、置换和电解,可以得到铟的产品,为液晶显示器的资源化和无害化提供实验数据和技术支持.     

不同晶型纳米TiO_2在斑马鱼体内的富集与清除

为探讨纳米材料的慢性生物效应以及材料结构对生物富集的影响,开展了A-TiO2(锐钛型纳米TiO2)和R-TiO2(金红石型纳米TiO2)在斑马鱼(Danio rerio)体内的长期富集和清除试验.采用半静态暴露试验,试验周期为46 d(暴露阶段28 d,清除阶段18 d),每种晶型设置2个处理组(ρ分别为4.0和10.0 mg/L),测定各时间点斑马鱼体内不同晶型纳米TiO2含量(以w计);以暴露阶段的BAF(生物富集系数)以及清除阶段的排出速率常数、总量清除率为终点,比较斑马鱼对2种晶型纳米TiO2的富集、清除的异同.结果表明:在暴露阶段,A-TiO2在斑马鱼体内的富集量显著高于R-TiO2,10.0 mg/L处理组斑马鱼体内富集量均显著高于4.0 mg/L处理组;4.0和10.0 mg/L的A-TiO2处理组的BAF分别为76.7和105.4 L/kg,略高于R-TiO2(41.6和36.1 L/kg),二者在斑马鱼体内均不具有生物蓄积性.在清除阶段,斑马鱼体内的2种晶型的纳米TiO2均可被排出,清除阶段的清除率为88.0%~100%;斑马鱼体内2种晶型纳米TiO2富集量的下降均符合一阶指数衰减方程,排出速率常数在0.26~1.01 d-1之间.