复介电常数在水土污染监测中的应用研究

采用短路同轴线法测量了淀粉聚乙烯醇共混体样品,在含水率、离子浓度不同时的复介电常数,研究了频率、离子浓度、含水率与相对复介电常数的关系。结果表明,淀粉PVA复介电常数的实部对含水率很敏感,虚部在500~700MHz频段随含盐量升高呈对数增加,这为利用测量相对复介电常数进行水土系统离子污染监测,提供了可能和实验依据。     

ACCU采样和PIXE技术用于PM10污染溯源的研究

使用美国RP公司生产的多通道自动采样系统(ACCU)在上海吴淞工业区进行冬季3个月8个不同风向的PM10采样；使用质子激发X荧光发射方法(PIXE)测定颗粒物中18个无机元素浓度．结果发现，8个风向的质量浓度分布取决于不同方位的大气质量状况．将大气颗粒物中的元素浓度作为环境污染指纹，8个方位的无机元素浓度分布与采样点周围的居民住宅、道路交通和工矿企业的排放密切相关，表明该方法能准确地确定排放源的范围和污染来源．研究结果表明，ACCU采样系统和PIXE分析技术的优化组合可为大气污染溯源、治理和改善环境空气质量提供一种快速和准确可靠的新方法．     

几种不同浓缩技术回收水中病毒的效果

实验表明,即使病毒剂量低到一个感染性病毒也可使人感染,并可在人群间造成传播。因此,水环境的病毒污染深为人们关切。 水中的致病性病毒主要来自人和动物的排泄物及医院废水。目前已从各种水体中检测出120多种危及人类健康的肠道病毒和其它病毒。 世界卫生组织要求,用最灵敏的方法试验,在100—1000L饮用水中应不含病毒。因此,病毒的浓缩技术是监测水中病毒的前提。 现在国内外使用的浓缩技术方法很多,但都不甚理想。我们用几种不同的方法回收自来水和污水厂出水中实验性污染的病毒,以便选择具有快速、简便、适用性广泛、浓缩水样体积大和回收病毒效率高的技术。     

南京市城区气溶胶粒度分布特征

以九段串级式撞击采样器对南京市气溶胶进行采样测定。经统计分析发现，气溶胶呈双峰分布，粒度分布规律明显，峰值粒径在0.37μm-0.65μm和4．3μm-5.6μm之间，气溶胶浓度季节变化显著，秋季＞夏秋，秋季颗粒物中细粒子质量百分比较夏季的多，两季质量中位位直径分别为6．5μm,4,4μm，说明与季节变化密切相关。     

关于锅炉大气污染物排放标准的思考

多年来锅炉大气污染物排放标准,一直沿用以锅炉排放污染物的浓度来评价的方法.由于锅炉燃烧的方式,锅炉运行、维护等方面的管理上存在很大的差异,目前低温连续供热的理念地提出,都给锅炉排放污染物的评价带来新的考验.本文主要探讨,锅炉大气污染物的评价指标以污染物排放量还是以浓度为标准,更能体现锅炉运行的实际状况,更准确地反映污染源源强.     

厌氧条件下活性黑(KBR)染料脱色的批量投料研究

在厌氧条件下，进行了微生物降解染料活性黑（ＫＢＲ）的试验研究。试验中研究了氯离子浓度、染料浓度、生物量、特别是投加易降解物对染料降解的影响，并且对厌氧降解该染料的过程进行了分析，着重探讨了易降解物葡萄糖投加量对该染料脱色降解的作用     

两种方法监测近岸大气NOX浓度的比较

分别用常规法和离子色谱法对近岸海域大气ＮＯＸ 进行同步监测，并对两方法间的相关性和测定结果的换算进行了研究。结果表明： 两者呈极显著的正相关，相关系数达０－８３５（ｎ＝ ９） ，其测定结果是可换算的。为此，建立了采用离子色谱法测定气溶胶ＮＯ－３ 浓度预测近岸大气ＮＯＸ 浓度的方法。     

Effect of catalyzed diesel particulate filter and its catalyst loading on emission characteristics of a non-road diesel engine

In this study, the effects of a diesel oxidation catalyst (DOC) coupled with a catalyzed diesel particulate filter (CDPF) with different catalyst loadings on the power, fuel consumption, gaseous and particulate emissions from a non-road diesel engine were investigated. Results showed that the after-treatment had a negligible effect on the power and fuel consumption. The reduction effect of the DOC on the CO and hydrocarbon (HC) increased with the engine load. Further reductions occurred coupling with the CDPF. Increasing the catalyst loading resulted in a more significant reduction in the HC emissions than CO emissions. The DOC could increase the NO₂ proportion to 37.9%, and more NO₂ was produced when coupled with the CDPF below 250°C; above 250°C, more NO₂ was consumed. The after-treatment could reduce more than 99% of the particle number (PN) and 98% of the particle mass (PM). Further reductions in the PN and PM occurred with a higher CDPF catalyst loading. The DOC had a better reduction effect on the nucleation particles than the accumulation ones, but the trend reversed with the CDPF. The DOC shifted the particle size distribution (PSD) to larger particles with an accumulation particle proportion increasing from 13% to 20%, and the geometric mean diameter (GMD) increased from 18.2 to 26.0 nm. The trend reversed with the CDPF and the accumulation particle proportion declined to less than 10%. A lower catalyst loading on the CDPF led to a higher proportion of nucleation particles and a smaller GMD.     

4—氯苯甲酸钠的光催化氧化降解及其影响因素

本试验采用P－25TiO2，光催化剂，对4－氯苯甲酸钠的光催化氧化降解及污染物初始浓度，催化剂投加量和入射光强等因素的影响进行了研究，研究发现污染物初始降解速率与其初始浓度的关系遵循Langmuir-Hinshelwood模式，其中半饱和浓度常数Ks不仅是催化剂和污染物种类的函数，而且也是入射光强的函数，催化剂投加量存在一限值，当低于此限值时，污染物降解速率由于催化剂浓度的不足受到影响而下降，当高于此限值时，污染物降解速率受催化剂投加量的影响变小，在本试验4－CBA－Na浓度为0.15-0.6mmol／L时该催化剂限值浓度大约为0.4g/L，在入射光强为1-7mW/cm^2和催化剂浓度为0.4g／L下，污染物降解速率与光强成0.67次幂关系，经估算其量子效率为6．3％。     

An assessment of how distance and diesel oxidation catalyst will impact thermal decomposition behaviors of particles

Decomposition mass loss and pyrolysis products analyses of particles sampled at various locations along the tailpipe of a Euro-IV diesel engine were performed using a thermogravimetry in conjunction with Fourier transformation infrared spectrometry-mass spectrum. Diesel particles were collected at the same location with and without diesel oxidation catalyst (DOC) mounted on the test engine separately. The three poles in thermal gravity-differential thermal gravity images suggested that the decomposition process of diesel particles could be divided into three stages which correspond to the decompositions of lower boiling substances, higher boiling substances and soot respectively. It is noticed that no matter whether DOC was mounted or not, the further the particles were sampled away from the engine block, the lower the peak temperatures and the heavier the mass losses within the first two stages, which indicated that the soluble organic fraction in the particle samples increased and therefore lowering the activation energy of thermal decomposition. Hydroxyl, ammonia, C_xH_y fragments, benzene, toluene, and phenol were found to be the primary products of particle decomposition, which didn't change with the location of particle sample point. The employment of DOC increased the activation energy for particle oxidation and resulted in a higher peak temperature and lower mass loss within the first-stage. Moreover, the CO stretching bands of aldehyde and ketone at 1771 cm^?1 was only detected without a DOC, while the NO₂ peak at 1634 cm^?1 was solely noticed with the presence of DOC. Compared to the first-stage pyrolysis products, more polycyclic aromatic hydrocarbons and less C_xH_y fragments were seen in the second-stage.