炼油污水的深度处理

对炼油污水深度处理常用技术——过滤、膜分离、化学氧化技术进行了详细的论述，并结合中试试验，对动态砂滤系统、PAN膜处理系统和高级氧化系统处理炼油厂二级排放水的适用性进行了论证。     

油田固体废弃物回注技术的可行性试验

胜利油田临盘采油厂临南油田水质改性后固体废弃物急剧增加、处理难度大,高渗储层回注的处理办法在夏52-414井开展现场试验取得成功.对其他油田的污泥处理具有参考借鉴价值.     

稠油污水生化性处理技术研究

为了探讨稠油污水能否使用生物法处理,以生活污水和农药厂生化池原菌种经过诱导驯化,分别培养了可以在稠油污水中生长的好氧菌种革兰氏阴性菌G-1和厌氧菌种革兰氏阴性菌G-2.以G-2和G-1对稠油污水进行顺序处理,可使其BOD5/CODCr达到0.26;采用SBR法对新疆稠油污水放大处理试验的结果：COD降至150 mg/L以下,各项指标达到GB8978-1998二级排放标准.     

采油厂HSE监督检查管理系统创建实践研究

本文根据采油厂生产过程风险特点,以生产单元为对象,通过建立全员参与的HSE监督检查体系,实现对采油厂HSE监督检查标准的统一规范,利用开发的HSE监督检查信息集成平台,创建完成采油厂HSE监督检查管理系统。在大庆油田第五采油厂的应用实践显示,其能为采油厂带来巨大的风险管理效益,是全面落实直线与属地HSE责任的有效载体。对于采油厂有效实施HSE监督检查具有重大意义,是HSE管理制度的一种创新。     

Material flow analysis of lubricating oil use in California

Petroleum lubricating oils, used throughout the economy, are distinct among petroleum products in their capacity to be recovered and recycled at the end of their useful life. Used lubricating oil is regulated at the state and federal level because of concerns about environmental impacts arising from improper disposal, although rates of recovery are not known. We present a material flow analysis of lubricants through California's economy in the years 2007–2012. We introduce a novel technique for computing aggregate waste generation from a collection of hazardous waste manifest records, and apply it in order to determine a recovery rate for used oil and to estimate the quantity of oil managed informally in the state. The records also offer a detailed view of the fate of used oils after they are recovered. We find that around 62% of lubricants are recoverable at end of life, of which 70–80% is being recovered. This rate shows a slight downward trend. If the trend is accurate, measures should be taken to improve the performance of the used oil management system. Policy opportunities exist to reduce the quantity of oil managed informally through improving access to responsible used oil management methods. These include increasing the collection of used oil from industrial sources as well as “do it yourself” oil changes, expanding in-state reprocessing capacity, and promoting increased out-of-state reprocessing of used oil. Our methods introduce new possibilities to make use of direct observation in material flow analysis, potentially improving data availability and quality and increasing the relevance of material flow methods in policy applications.     

超高强度钻杆低温断裂性能及裂纹扩展特征研究

超高强度钻杆在冬季低温环境下容易发生脆性断裂事故,为了从断裂力学角度揭示其冷脆现象的本质,采用ZBC2302-D型示波冲击试验机,获得了不同温度下超高强度钢在冲击断裂过程中的力-位移曲线,并对比分析了冲击功、起裂功和裂纹扩展功之间的变化关系。采用国家标准GB 4161—2007中的计算公式,计算了冲击试样的裂纹扩展量Δa和阻抗应力强度因子K_R;同时,引入K_R阻力曲线,得到超高强度钻杆在不同温度下的剩余强度图。结果表明,当冲击试样开始出现裂纹时,随温度降低,钻杆的初始起裂应力有所增加,出现硬化现象。当钻杆出现一定长度的裂纹时,随温度降低,阻抗应力强度因子越来越小,而且降低速度越来越快,剩余强度也表现出相同的变化趋势。随温度降低,材料抵抗裂纹扩展的能力逐渐下降,表明钻杆在低温下更容易断裂。     

Valorisation of used cooking oil sludge by codigestion with swine manure

The addition of lipid wastes to the digestion of swine manure was studied as a means of increasing biogas production. Lipid waste was obtained from a biodiesel plant where used cooking oil is the feedstock. Digestion of this co-substrate was proposed as a way of valorising residual streams from the process of biodiesel production and to integrate the digestion process into the biorefinery concept.Batch digestion tests were performed at different co-digesting proportions obtaining as a result an increase in biogas production with the increase in the amount of co-substrate added to the mixture. Semi-continuous digestion was studied at a 7% (w/w) mass fraction of total solids. Co-digestion was successful at a hydraulic retention time (HRT) of 50 d but a decrease to 30 d resulted in a decrease in specific gas production and accumulation of volatile and long chain fatty acids. The CH₄ yield obtained was 326 ± 46 l/kg VS_feed at an HRT of 50 d, while this value was reduced to 274 ± 43 l/kg VS_feed when evaluated at an HRT of 30 d. However these values were higher than the one obtained under batch conditions (266 ± 40 l/kg VS_feed), thus indicating the need of acclimation to the co-substrate. Despite of operating at low organic loading rate (OLR), measurements from respirometry assays of digestate samples (at an HRT of 50 d) suggested that the effluent could not be directly applied to the soil as fertiliser and might have a negative effect over soil or crops.     

变电站污水处理现状与展望

变电站一般位于城市郊区或乡村环境等市政设施尚不完善的区域,无法接入市政污水管网,许多变电站粗放式的污水处理方式无法满足环保要求.随着变电站智能化水平的提高,站内工作人员越来越少,传统的污水处理方式无法适应新形势下变电站内污水处理要求.因此,针对变电站粗放式的污水管理方式及新条件下传统污水处理方式等不满足环保要求的问题,根据站址外环境创新变电站污水处理方式成为关键.通过对变电站既有污水处理方式的研究,结合变电站智能化的发展进程,进行总结,可为变电站污水处理设计或水环境管理提供参考.     

野外环境生长的薰衣草精油抑菌作用测定方法比较研究

采用滤纸片法和混合法对野外环境生长的薰衣草精油的抑菌作用进行了研究,并对两种试验方法进行了比较,测定了最小抑菌浓度(MIC)与最小杀菌浓度(MBC),以期充分发挥薰衣草精油的抑菌作用.滤纸片法结果表明:薰衣草精油对多数实验菌都有抑菌作用,对枯草杆菌则未表现出抑制作用;混合法实验显示:薰衣草精油对实验菌均有抑菌作用,精油浓度与抑菌作用成线性相关,抑菌作用较滤纸片法效果更好.在使用时,可用于表面喷涂、熏蒸,还可将精油作为安全的食品添加剂,提高食品的保鲜效果,保证其品质.     

绿色木霉改性玉米秸秆溢油吸附剂的制备及其性能研究

利用绿色木霉对玉米秸秆进行固态发酵,通过单因素改性实验(改性时间、固液比和改性温度)制备溢油吸附剂TCS(Trichoderma viride modified corn stalk),并模拟溢油环境测定TCS的吸油量.研究表明,25℃下,改性6 d、固液比1∶4时,制得的TCS吸油量最大,达到13.84 g.g-1,相对原材料RCS(Raw corn stalk,吸油量为6.58 g.g-1)提高了110.33%.对RCS和TCS进行扫描电子显微镜(SEM)分析显示制得的TCS表面变得更加粗糙;傅里叶红外光谱分析(FT-IR)表明玉米秸秆纤维素组分被部分降解;X射线衍射分析(XRD)得到改性后的材料结晶度降低;纤维素、半纤维素和木质素等组分测定进一步表明生物改性降低了玉米秸秆中纤维素及半纤维素的含量,这些均说明改性后材料吸油量增加的原因.吸附动力学及保油性能测试表明,TCS具有快速的吸油速率,80 r.min-1条件下振荡1 h后即达到吸附平衡;且在吸附饱和后滴淌10 min仍能保持最初吸油量的74.87%,具有良好的保油性能.