全文获取类型
收费全文 | 90篇 |
免费 | 7篇 |
国内免费 | 50篇 |
专业分类
安全科学 | 4篇 |
废物处理 | 20篇 |
环保管理 | 2篇 |
综合类 | 75篇 |
基础理论 | 23篇 |
污染及防治 | 19篇 |
评价与监测 | 4篇 |
出版年
2022年 | 2篇 |
2021年 | 5篇 |
2020年 | 6篇 |
2019年 | 4篇 |
2018年 | 3篇 |
2017年 | 4篇 |
2016年 | 4篇 |
2015年 | 10篇 |
2014年 | 5篇 |
2013年 | 9篇 |
2012年 | 5篇 |
2011年 | 3篇 |
2010年 | 3篇 |
2009年 | 11篇 |
2008年 | 6篇 |
2007年 | 11篇 |
2006年 | 10篇 |
2005年 | 11篇 |
2004年 | 6篇 |
2003年 | 1篇 |
2002年 | 6篇 |
2001年 | 1篇 |
2000年 | 4篇 |
1999年 | 4篇 |
1998年 | 3篇 |
1997年 | 1篇 |
1996年 | 1篇 |
1995年 | 1篇 |
1994年 | 2篇 |
1993年 | 2篇 |
1992年 | 1篇 |
1991年 | 2篇 |
排序方式: 共有147条查询结果,搜索用时 15 毫秒
61.
以强化生物除磷(EBPR)污泥为研究对象,考察了不同初始乙酸浓度条件下富磷污泥厌氧发酵过程中磷及相关指标的变化,并探讨释磷机制.结果表明:初始乙酸浓度对污泥最大释磷量影响不大,(73.1±2.2)%的污泥总磷量(TP)以磷酸盐的形式释放到液相中,其主要来自聚磷的分解.聚磷的分解途径包括:1)聚磷菌(PAOs)通过吸收乙酸贮存聚β-羟基烷酸酯(PHA)的厌氧生物释磷机制释放磷酸盐;2)PAOs的维持作用导致的聚磷直接分解过程.当初始乙酸浓度不充足时,生物释磷过程受限制,聚磷以相对较慢的速率直接分解;随着乙酸浓度的增大,生物释磷速率增快,同时随之增加的PHA含量能促进污泥的水解酸化.上清液中PO43--P和Mg2+浓度在达到最大值后出现了下降的现象,其可能形成鸟粪石等沉淀.根据试验数据,本文提出了从富磷污泥中回收磷的策略,即可在厌氧消化开始前向污泥中投加一定量碳源,并在发酵24h内分离上清液进行磷回收,这样不仅可以快速大量地从上清液中回收磷并减少沉淀引起的管道堵塞等问题,还可消除高浓度磷酸盐对厌氧消化的影响. 相似文献
62.
以对叔丁基杯[4]芳烃与溴乙酸乙酯为主要反应底物合成了对叔丁基杯[4]芳烃乙酸,然后将其负载在沸石上,红外光谱显示合成物具有杯[4]芳烃乙酸的特征结构,扫描电镜分析表明对叔丁基杯[4]芳烃乙酸成功负载于沸石之上,且分布均匀,分散性良好.通过静态吸附实验,结果表明在pH值 4,对叔丁基杯[4]芳烃乙酸/沸石的负载比0.025/1,吸附剂用量0.5g,铀初始质量浓度10mg/L,吸附时间30min时,沸石在负载了对叔丁基杯[4]芳烃乙酸后,对溶液中铀的吸附率从30%左右提高到93%.沸石和负载沸石吸附动力学行为均符合准二级动力学模型,但负载沸石对铀的吸附速率明显高于沸石.沸石和负载沸石吸附等温式都符合Langmuir吸附等温线,说明都为单分子层吸附;由此推导出的最大吸附量Qm从16.8919提高到32.5733mg/g,这主要是因为沸石负载了对叔丁基杯[4]芳烃乙酸增加了吸附点位.吸附铀前后的红外光谱表明,负载沸石对铀的去除主要依靠对叔丁基杯[4]芳烃乙酸与铀的强络合作用和Si—O和Al—O的吸附作用,两种作用的协同加快了吸附速率,增加了吸附容量. 相似文献
63.
乙酸钠为碳源时进水COD和总磷对生物除磷的影响 总被引:11,自引:4,他引:7
研究了乙酸钠为碳源时,乙酸盐和总磷浓度对循序间歇式生物除磷工艺运行效果的影响,以及含高浓度乙酸盐废水不能有效除磷的原因结果表明:COD<600mg·L-1时,随着COD/TP值的增大,总磷去除率提高,COD/TP<50时,磷的去除率提高显著,但当COD/TP>50时,磷的去除变化不大;进水乙酸盐浓度过高(COD>600mg·L-1)使除磷效率逐渐下降,COD>1000 mg·L-1会使生物除磷系统完全崩溃;研究发现除磷效率的下降是由于过多的乙酸盐从厌氧段进入了好氧段,引起丝状菌的增殖、污泥膨胀,导致聚磷菌被洗出. 相似文献
64.
全自动淋洗-智能蒸馏联合技术检测土壤中阳离子交换量 总被引:3,自引:0,他引:3
针对土壤中阳离子交换量检测国标方法的不足,介绍了一种全自动淋洗法结合自动智能一体化蒸馏的联合技术。通过对实际样品和6种土壤标样的比较实验,表明,淋洗时间设置为20 min、乙醇洗涤次数设置为4次、蒸馏液质量设置为130 g较佳,在该条件下,土壤标样及实际样品的相对标准偏差(0.87%~1.07%)远小于行业标准方法的标准偏差(3.87%~5.18%),方法准确度也均在保证值范围内。该方法自动化程度高、可操作性强且检测结果的准确度、精密度及重现性都符合标准规定,可满足大批量土壤样品分析要求。 相似文献
65.
Jin Zhang Qiang Yang Xiaofei Song Hui Qiao Junhao Zhang 《International Journal of Green Energy》2017,14(12):1011-1019
Electrospun cellulose acetate (CA) nanofibrous mats incorporated with capric acid was studied to fabricate form-stable phase change materials (PCMs) for storing/retrieving thermal energy. Electrospun CA nanofibrous mats with different porous structures and specific surface areas were firstly prepared through regulating the volume ratio of mixture solvent of acetone/dichloromethane (DCM). Effects of different volume ratio of mixture solvent and mat thickness on the morphological structure, specific surface area, and absorption capacity of CA nanofibrous mats were systematically investigated. The results indicated that CA nanofibrous mats were highly porous on the surface; hence, they were capable of absorbing a large amount of capric acid. The maximum absorption capacity of CA mats via electrospinning with volume ratio of acetone/DCM being 5/5 was ~95.8 wt%, due to its higher specific surface area of ~17.1 m2/g. The specific surface area and capric acid absorption capacity of CA nanofibrous mats increased with the increases of mat thickness. As the thickness of nanofibrous mats increased from 10 to 85 μm, the corresponding specific surface area and capric acid absorption capacity of mats increased respectively from 7.2 to 29.0 m2/g and 92.1 to 98.5%. Morphological structures, as well as the properties of thermal energy storage and thermal insulation of the fabricated form-stable PCMs, were studied by scanning electron microscopy, differential scanning calorimetry, and measurement of freezing times, respectively. The results indicated that the resulting form-stable PCMs could well maintain their phase transition characteristics and demonstrated great thermal energy storage capability and temperature regulation ability. 相似文献
66.
通过在不同的时间段,测定存放于铝箔复合膜集气袋和玻璃注射器的丙酮,醋酸乙酯,苯,异丙醇标准气的浓度,气体浓度与贮存时间的关系,本次试验结果表明,丙酮,醋酸乙酯,苯,异丙醇在铝箔气袋中的稳定性明显优于在玻璃注射器中,应尽可能在8-24h内测定。 相似文献
67.
Summary. Male obliquebanded leafrollers, Choristoneura rosaceana (Harris), were induced to respond to a pheromone source tainted with a behavioural antagonist, Z9-tetradecenyl acetate, when a source releasing the antagonist was placed 10 cm upwind of the tainted source in a wind tunnel.
However, placement of the antagonist upwind of an attractive pheromone source did not interrupt pheromone-mediated responses.
Placement of a source releasing Z9-tetradecenyl acetate, a minor pheromone component of the sympatric species, the threelined leafroller, Pandemis limitata (Robinson), upwind of a calling P. limitata female, reduced conspecific male pheromone-mediated response but resulted in upwind flight by male C. rosaceana and contact with heterospecific females. Male P. limitata locked on and flew upwind to but did not contact heterospecific females when a source releasing Z9-tetradecenyl acetate was positioned upwind of a calling C. rosaceana female. In the field, adaptation or habituation to Z9-tetradecenyl acetate caused by atmospheric treatment with this compound apparently resulted in reciprocal heterospecific
pheromone responses. More C. rosaceana males were captured in traps baited with their pheromone and the behavioural antagonist in small field plots treated atmospherically
with Z9-tetradecenyl acetate than in nontreated control plots. Fewer male P. limitata were captured in traps baited with their own pheromone, or with C. rosaceana pheromone tainted with Z9-tetradecenyl acetate in plots treated atmospherically with Z9-tetradecenyl acetate than in nontreated control plots. We argue that Z9-tetradecenyl acetate is an important synomone which assists in partitioning the sexual chemical communication channels of
C. rosaceana and P. limitata.
Received 9 February 1999; accepted 22 March 1999. 相似文献
68.
废水同步生物处理与生物燃料电池发电研究 总被引:27,自引:10,他引:17
利用厌氧活性污泥作为接种体成功地启动了空气阴极生物燃料电池(ACMFC),110h的接种产生了0.24V的电压;以乙酸钠和葡萄糖作底物分别产生了0.38V和0.41V电压(外电阻1 000Ω),最大功率密度分别达到146.56 mW/m2和192.04mW/m2,表明有机废水可以用来发电;同时,乙酸钠和葡萄糖的去除率分别为99%和87%,表明燃料电池可以处理废水.二者的电子回收率均在10%左右,主要是由于阴极对氧气分子的透过作用引起的微生物好氧呼吸导致电子损失. 相似文献
69.
70.