CO2浓度升高对半干旱区春小麦光合作用及水分生理生态特性的影响

大气CO₂浓度升高已成为世界范围内重要环境问题。为了解大气CO₂浓度升高对春小麦光合作用及水分生理生态特性的影响,在典型半干旱区定西利用开顶式气室(OTC)试验平台,以春小麦“定西24号”为供试品种,开展了CO₂浓度增加模拟试验。试验设对照(390μmol·mol^?1)、480μmol·mol^?1和570μmol·mol^?1等3个CO₂浓度(摩尔分数)梯度。结果表明:在对照和增加CO₂浓度条件下,春小麦叶片净光合速率和蒸腾速率日变化均呈“双峰型”分布,出现明显的“午休”现象;胞间CO₂浓度的日变化表现为斜“V”字型曲线;叶水势日变化呈现反抛物线曲线走向,在中午后出现水势曲线拐点。在不同生育时期内,净光合速率、气孔导度和胞间CO₂浓度均表现为开花期最大,乳熟期最小。而蒸腾速率表现为开花期最大,拔节期最小,叶片水平水分利用效率表现为孕穗期最大,乳熟期最小。随着CO₂浓度升高,春小麦叶片净光合速率、胞间CO₂浓度、水分利用效率和水势提高,气孔导度和蒸腾速率降低。与对照大气CO₂浓度相比,在480μmol·mol^?1浓度和570μmol·mol^?1浓度下,整个生育期净光合速率平均分别提高了14.68%和28.20%,气孔导度平均降低了15.29%和24.83%,胞间CO₂浓度平均提高了10.38%和26.15%,蒸腾速率平均减小了6.63%和12.41%,WUE平均增加了22.9%和46.9%。随着CO₂浓度升高,蒸腾失水减少,叶片水势不断增加,从而增强了春小麦对干旱胁迫的抵御能力。研究结果为我国半干旱区春小麦对全球气候变化下的敏感性及适应性提供理论参考。     

农药混配制剂环境风险评估现状与展望

本文综述了欧洲和美国农药混配制剂的环境风险评估方法。详细介绍了欧洲食品安全局(EFSA)评估体系中的2种方法,即,基础的"整体测试法"和近年来提倡的"基于组分的方法"。"基于组分的方法"的特点是以浓度加和模型(CA模型)作为默认假设进行初级评估,以独立作用模型(IA模型)等作为高级评估手段的农药混配制剂环境风险评估方法。此外,本文还介绍了模型偏差率(MDR)、毒性相似度及毒力单元(TU)等概念以及混配制剂风险评估流程。本文的目的旨在为建立我国农药混配制剂的环境风险评估方法体系提供参考。     

2种再生水深度处理工艺对有毒有机污染物去除效果的评价研究

采用固相萃取(SPE)技术和气相色谱/质谱联用(GC/MS)的方法对2个再生水厂的进水和不同深度处理工艺出水中的有毒有机污染物进行了定性和定量分析,讨论了这2种不同再生水深度处理工艺对有毒有机污染物的去除效果.结果表明,厌氧/缺氧/好氧(A2/O)+连续微滤技术(CMF)+加氯消毒处理工艺和水解酸化+膜生物反应器(MB...     

厌氧膨胀床处理低浓度污水的污泥颗粒和生物活性变化

污泥的聚集形态和活性，是影响厌氧反应器处理效率的关键因素。通过对厌氧膨胀床反应器（anaerobicex—pandedblanketreactor，AEBR）处理低浓度城镇污水在启动和稳定运行期的污泥活性研究，AEBR在启动运行期内，接种颗粒污泥为适应低浓度基质条件，污泥粒径经历从大变小，再重新颗粒化粒径变大的过程。在运行期第103天，粒径小于1000μm污泥的体积比达到44．7％，平均粒径为952μm，到运行期第173天，粒径小于1000μm污泥的体积比降为28％，平均粒径达1179μm，污泥重新颗粒化完成。颗粒污泥适应新的环境后，单位重量污泥的最大比产甲烷活性（specificmetha．nogensisactivity，SMA）值和胞外聚合物含量增加，分别达到112mLCH4／（gVSS·d）和215mg／gVSS。在处理实际城镇污水的AEBR反应器内，辅酶F420含量可以有效指示污泥样品的产甲烷活性，AEBR反应器不同高度位置的污泥活性不一样，反应器底部污泥活性低于中上部区域污泥的活性。     

电渗析在丙烯酸丁酯废水预处理中的应用

采用电渗析法预处理丙烯酸丁酯生产废水,可将废水中的有机酸盐浓缩回收,同时大大降低废水的污染物浓度.重点研究了淡水浓水初始体积比的影响,同时考察了电渗析过程中水的迁移.实验确定了淡水浓水的最佳初始体积比为5∶1,此时对COD为61 650 mg/L的废水,COD去除率可达99.5%,脱盐率在99.5%以上,同时可将废水的...     

Inverse modeling of Asian Rn flux using surface air Rn concentration

When used with an atmospheric transport model, the ²²²Rn flux distribution estimated in our previous study using soil transport theory caused underestimation of atmospheric ²²²Rn concentrations as compared with measurements in East Asia. In this study, we applied a Bayesian synthesis inverse method to produce revised estimates of the annual ²²²Rn flux density in Asia by using atmospheric ²²²Rn concentrations measured at seven sites in East Asia. The Bayesian synthesis inverse method requires a prior estimate of the flux distribution and its uncertainties. The atmospheric transport model MM5/HIRAT and our previous estimate of the ²²²Rn flux distribution as the prior value were used to generate new flux estimates for the eastern half of the Eurasian continent dividing into 10 regions.The ²²²Rn flux densities estimated using the Bayesian inversion technique were generally higher than the prior flux densities. The area-weighted average ²²²Rn flux density for Asia was estimated to be 33.0 mBq m⁻² s⁻¹, which is substantially higher than the prior value (16.7 mBq m⁻² s⁻¹). The estimated ²²²Rn flux densities decrease with increasing latitude as follows: Southeast Asia (36.7 mBq m⁻² s⁻¹); East Asia (28.6 mBq m⁻² s⁻¹) including China, Korean Peninsula and Japan; and Siberia (14.1 mBq m⁻² s⁻¹). Increase of the newly estimated fluxes in Southeast Asia, China, Japan, and the southern part of Eastern Siberia from the prior ones contributed most significantly to improved agreement of the model-calculated concentrations with the atmospheric measurements. The sensitivity analysis of prior flux errors and effects of locally exhaled ²²²Rn showed that the estimated fluxes in Northern and Central China, Korea, Japan, and the southern part of Eastern Siberia were robust, but that in Central Asia had a large uncertainty.     

牡蛎壳生物滤池处理含盐污水中的硝化特性

采用牡蛎壳为曝气生物滤池填料,以含NaCl的生活污水为处理对象,在SBR操作条件下,系统考察进水NaCl浓度、曝气时间及进水pH值等对硝化性能的影响。结果表明,进水NaCl浓度为10~15 g/L时,平均氨氮去除率可稳定在97%以上;较高浓度NaCl对亚硝酸化菌活性影响较弱,对硝酸化菌活性影响较强,特别是在日曝气时间少于12 h时,其出水中亚硝氮的含率大于50%;当进水pH值在6~9变化时,反应器内pH值可稳定在6.5~7.5,硝化性能良好,表明牡蛎壳填料可为硝化反应提供碱度。     

UV/Fenton技术处理某工厂高浓度乳化油废水

研究了UV/Fenton技术对高浓度金属清洗乳化油废水的处理效果,考察了亚铁与双氧水浓度、pH、反应时间和搅拌对COD去除效果的影响。实验结果表明,UV/Fenton技术对高浓度乳化油废水(COD平均浓度为35 000 mg/L)具有较高的去除效果,最佳工艺条件为:亚铁与双氧水浓度分别为2 400 mg/L和6 000 mg/L,pH为3,经过2 h反应,COD可降低至1 050 mg/L,去除率为97%。搅拌会降低COD的去除率。研究表明,UV/Fenton技术对高浓度乳化油废水具有很好的降解效果,且药品消耗较低,为目前此类高浓度有机废水的处理提供了技术参考。     

MBR在橡胶废水处理中的应用

橡胶废水具有含盐量高、色度高、有机污染成分含量高且难于生化降解等特点。膜生物反应器(MBR)技术的核心是生化处理加微滤膜过滤,通过将MBR技术应用于橡胶废水处理的实践表明,该技术对COD、氨氮、磷酸盐的平均去除率都达到了85%以上,再辅之以药剂处理后,降低了色度和难降解有机物含量,出水水质完全符合排放标准的要求,是一种解决橡胶污水处理难题的有效途径。     

Effects of low concentration biodiesel blend application on modern passenger cars. Part 1: Feedstock impact on regulated pollutants, fuel consumption and particle emissions

Five biodiesels from different feedstocks (rapeseed, soy, sunflower, palm, and used fried oils) blended with diesel at 10% vol. ratio (B10), were tested on a Euro 3 common-rail passenger car. Limited effects (−2% to +4%) were observed on CO₂ emissions. CO and HC emissions increased between 10% and 25% on average, except at high speed - high power where emissions were too low to draw conclusions. NOx emissions increased by up to 20% for two out of the five blends, decreased by up to 15% for two other blends, and remained unchanged for one blend. Particulate matter (PM) was reduced for all blends by up to 25% and the reductions were positively correlated with the extent of biodiesel saturation. PM reductions are associated with consistent reductions in non-volatile particle number. A variable behaviour in particle number is observed when volatile particles are also accounted.