Numerical study on premixing characteristics and explosion process of starch in a vertical pipe under turbulent flow

Fire and explosion accidents are frequently caused by combustible dust, which has led to increased interest in this area of research. Although scholars have performed some research in this field, they often ignored interesting phenomena in their experiments. In this paper, we established a 2D numerical method to thoroughly investigate the particle motion and distribution before ignition. The optimal time for the corn starch dust cloud to ignite was determined in a semi-closed tube, and the characteristics of the flame propagation and temperature field were investigated after ignition inside and outside the tube. From the simulation, certain unexpected phenomena that occurred in the experiment were explained, and some suggestions were proposed for future experiments. The results from the simulation showed that 60–70 ms was the best time for the dust cloud to ignite. The local high-temperature flame clusters were caused by the agglomeration of high-temperature particles, and there were no flames near the wall of the tube due to particles gathering and attaching to the wall. Vortices formed around the nozzle, where the particle concentration was low and the flame spread slowly. During the explosion venting, particles flew out of the tube before the flame. The venting flame exhibited a “mushroom cloud” shape due to interactions with the vortex, and the flame maintained this shape as it was driven upward by the vortex.     

Large eddy simulation and experimental study of the effect of wire mesh on flame behaviours of methane/air explosions in a semi-confined pipe

Preventing the propagation of flames in a pipeline is an effective measure for avoiding gas explosion accidents and reducing losses. To evaluate the effect of wire mesh, acting as a porous media, experimental and simulation studies are conducted to determine the influence of the wire mesh on the dynamics of premixed methane/air flame propagation in a semi-closed pipe. Four different kinds of wire mesh with different numbers of layers are chosen in the experiments and simulation, and the mechanism of wire mesh quenching of the flame is investigated. The experimental and simulation results are consistent. Flames are quenched when 4 layers of 40-mesh or 3 layers of 60-mesh wire mesh are used; however, once the flame propagates through the wire mesh, the risk of methane combustion may increase. The wire mesh becomes the key factor causing flame folds and acceleration, and the greater the number of layers or the larger the mesh size is, the more obvious the folds after the flame passes through the wire mesh. Moreover, the combination of heat absorption and disruption of the continuous flame surface by the mesh causes flame quenching. Wire mesh can effectively attenuate the flame temperature during premixed flame propagation in a pipe, and the attenuated maximum rate reaches approximately 79% in the case of adding 3 layers of 60-mesh wire mesh.     

金属丝网对甲烷/空气预混火焰管道内传播的影响

为研究管道内金属丝网对甲烷/空气预混火焰传播的影响，通过实验和三维数值模拟研究安装金属丝网的管道内火焰传播特性以及流场、温度场的变化。结果表明:40目4层的金属丝网可以使火焰淬熄，30目4层的金属丝网无法淬熄，但可以使火焰停滞3 ms；大涡模型可以很好地对管道内火焰淬熄现象进行模拟；当火焰穿过30目4层金属丝网时，速度增大，在Kelvin Helmholtz不稳定和Rayleigh Taylor不稳定的耦合作用下形成湍流；金属丝网的目数会影响热量在丝网层中的扩散，当金属丝网为30目4层时，火焰热量扩散快，而当金属丝网为40目4层时，火焰热量扩散慢且温度大幅度衰减，衰减率达到83%。     

基于分布型电力系统的 PSO 优化设计

优化了传统粒子群算法，运用了混沌算法对粒子做初始化，优化了传统粒子群算法的收敛特性，并在算法的优化过程中，增加了混沌干扰元素对整体最优化极值做混沌干扰，将符合杂交几率的优化粒子做杂交处理，提高了粒子群的种类，增强了粒子群算法的搜寻水平。并通过IEEE33节点的分布型电力系统做无功优化仿真验证，通过比较，验证了优化算法的优越性与准确性。     

以氢气为主要成分的其他可燃气体对低浓度甲烷爆炸特性的影响

为研究矿井火区中一氧化碳(CO)、氢气(H_2)、乙烯(C_2H_4)和乙烷(C_2H_6)等其他可燃气体对甲烷(CH_4)爆炸特性的影响,利用可视球形气体爆炸系统开展了多元可燃气体爆炸压力特性试验,观察并分析了峰值爆炸压力、最大爆炸压力上升速率及其相应时间。通过高速摄影系统拍摄了视窗范围内爆炸火焰传播图像,基于边缘检测方法确定了火焰前锋位置,继而得到最大火焰传播速度。分析了以氢气为主要成分的其他可燃气体对低浓度CH_4-空气混合物压力特性和火焰传播行为的影响。结果表明,多元可燃气体的存在增加了低浓度CH_4-空气混合物的爆炸危险性。随混合气体体积分数增加,低浓度CH_4-空气混合物的峰值爆炸压力、最大爆炸压力上升速率和最大火焰传播速度非线性增加;此外,到达峰值爆炸压力、最大爆炸压力上升速率的时间显著缩短。     

不同含水率煤尘在瓦斯爆炸诱导下爆炸传播规律研究

为了探究不同含水率煤尘在瓦斯爆炸诱导下的爆炸传播规律,利用自行搭建的直管瓦斯爆炸诱导煤尘二次爆炸实验系统,从冲击波压力和火焰传播速度2个方面,研究了不同含水率沉积煤尘在瓦斯爆炸诱导下的爆炸传播规律和原因。研究结果表明:当煤尘含水率小于40%时,管道内沉积煤尘会在瓦斯爆炸诱导下产生二次爆炸,同时沉积煤尘总量一定时,沉积煤尘二次爆炸产生的冲击波超压峰值和火焰传播速度随着煤尘含水率的增加先增大后减小;当沉积煤尘含水率为20% 时,煤尘二次爆炸产生的冲击波超压峰值、火焰传播速度峰值达到最大值,分别为1.657 MPa和468.060 m/s;当沉积煤尘含水率大于40%时,沉积煤尘无法产生二次爆炸,此时爆炸产生的威力小于单一瓦斯爆炸,火焰传播速度衰减较无煤尘的瓦斯爆炸更快,沉积煤尘起到抑制瓦斯爆炸传播的作用。研究结果可以为防治煤尘二次爆炸提供理论依据。     

公路隧道火灾发生位置与人群疏散通道仿真研究

利用EXODUS建立隧道的仿真场景,确定疏散人群仿真参数,并将出口工效OPS作为评价疏散效率的指标,分析不同火灾发生位置对疏散时间的影响。采用K-means算法分别对火灾发生位置和人群疏散通道位置进行聚类,并建立基于两者影响下的出口工效模型,通过对该模型求偏导,得出隧道火灾发生位置和人群疏散通道选择之间的关系。研究结果表明:火灾发生位置越接近人行横通道,疏散时间波动越大,人行横通道和隧道入口的疏散时间随人群疏散区域分界线变化,当火灾发生距人行横通道20~110 m时,变化明显,当距140~350 m时,变化平稳;出口工效OPS总体呈现不稳定的阶梯状变化趋势;火灾发生位置和人群疏散通道的最优位置呈线性递减关系。研究结果可应用于隧道应急指挥中心管理人员制定有效疏散路径和采取诱导分流人群措施。     

开敞空间可燃气云爆炸冲击波超压及灾害动力响应研究评述

为了进一步梳理和分析开敞空间可燃云爆炸冲击波超压传播规律及灾害动力响应方面的各项研究成果,推进可燃气体爆炸安全防控,减少人员伤亡和经济损失。在分析现有研究的基础上,总结开敞空间可燃气云爆炸冲击波超压传播规律及灾害动力响应研究等方面存在的不足,提出开敞空间多元混合气体爆炸冲击波超压传播规律研究、多影响参数下可燃气云爆炸冲击波超压传播规律定量分析、基于可燃气云爆炸冲击波超压作用下的承载体动力响应等未来研究的关键技术问题。     

Law of variation for low density polyethylene dust explosion with different inert gases

To reveal the effects of different inert gases on explosion characteristics during low density polyethylene (LDPE) dust explosion and optimize the explosion-proof process, eight N₂ (CO₂)/air mixed inerting conditions were experimentally studied. Typical inerting conditions with 12 L cylindrical explosive tank were used to study the characteristics on the flame propagation. The thermogravimetric analysis with related theories were used to further explain the mechanism and quantities in low density polyethylene (LDPE) dust explosion with different inert gases. The results showed that the reduction of O₂ concentration could effectively delay the progress of flame growth process and weaken the effect of dust combustion reaction. The flame growth process of condition (N₂/air (18% O₂)) was 2.05 times slower than that of the non-inert condition. The explosion strength was obviously reduced, and the characteristic parameters such as explosion pressure and flame propagation speed were also affected by the decrease of O₂ concentration. For LDPE powder, the smaller the median diameter, the greater the explosion intensity and the lower the limiting oxygen content (LOC). The LOC with CO₂ was usually higher than that with N₂ and the effect of CO₂ was significantly better than N₂ in inerting.     

植物离体快繁中若干关键技术的预防措施

菌类污染，褐变现象和玻璃化现象，是植物离体快繁中的三大难题，现已严重影响植物离体培养与快繁体系的建立．本文较详细地论述了这三大难题出现的原因，进而提出预防及控制的措施。