超声波/零价铁协同体系作用机理探讨

在超声波/零价铁协同体系中,探讨了OH.的产生途径及其影响因素,并分析了Fe0表面形态变化。结果表明:在超声波/零价铁体系中,羟基自由基的产生途径主要有四种:声空化导致水分子热解、Fenton反应、超声波与类Fenton反应的复合效应、铁粉颗粒效应;pH值过低或过高都不利于羟基自由基产生;当铁粉投加量为2.0g/L时最有利于羟基自由基产生;超声波通过冲刷、碎裂、清洗、气蚀和熔合等多种效应,活化和增强铁粉的表面性能。     

萘降解菌MQ合成靛蓝的研究

利用萘降解菌(丛毛单胞菌)MQ完整细胞对吲哚进行转化合成靛蓝,结果表明菌株MQ具有较好的靛蓝合成能力,靛蓝产量在4h左右即达到稳定.薄层色谱和高效液相色谱分析结果表明,合成的蓝色产物为靛蓝.考察了反应温度及摇床转速对靛蓝合成的影响,结果表明最适温度和转速分别为25℃和150r·min-1.随后,采用表面响应法确定了菌株MQ合成靛蓝的最优条件:菌株接种量OD6602.16,吲哚浓度200.55mg·L-1,pH=6.91.在最优条件下,菌株MQ合成靛蓝的产量为53.05mg·L-1,比初始条件下的产量提高了179%.     

络合-超滤耦合工艺去除水中镍离子的研究

以聚丙烯酸钠(PAANa)和聚乙烯亚胺(PEI)作为络合剂,将其与镍离子络合后的溶液转移至超滤杯中,在0.1 MPa压力下通过聚醚砜超滤膜进行分离,研究pH值和络合剂/Ni2+装载质量比(L)对Ni2+去除率的影响,并根据朗缪尔等温模型拟合络合反应平衡常数.同时研究超滤时间对膜通量和Ni2+去除率的影响.结果表明,选用PAANa为络合剂,在pH值为8、L=5时,Ni2+的去除率达到最大值99.5%.PEI为络合剂时,Ni2+去除率在pH值为7、L为5时达到最大值93.0%.不同pH值条件下拟合得到的络合平衡常数表明,pH为7时最有利于络合反应.另外,单个络合剂单体所能结合的Ni2+个数随着pH值的升高而增大.研究结果还表明,在长达12 h的超滤时间内,PAANa为络合剂时,膜通量的衰减<10%;PEI为络合剂时,膜通量基本保持不变;Ni2+的去除率都基本保持恒定.因此,在合适条件下,络合-超滤耦合工艺能有效去除水中的镍离子.     

非离子表面活性剂对污泥调理脱水效果的影响

现有污泥脱水技术仅使污泥含水率降到80%左右,难以满足日益严格的污泥处置要求.以污泥比阻（SRF）、脱水率为考察指标,比较了两大类非离子型表面活性剂（辛基酚聚氧乙烯醚OPEO型和烷基糖苷APG）对剩余污泥的脱水效果,并对原泥及调理后污泥进行了显微观察.结果表明,非离子表面活性剂可使污泥絮体粒径变小,不规则程度降低,改善了污泥的脱水性能,而且烷基糖苷APG脱水效果优于OPEO型.APG投加量为0.05%干固体时,污泥比阻即可降低到原泥的42%,脱水率可达到93%.以烷基糖苷APG为调理剂进行板框脱水实验,结果表明,当APG投加量为0.05%干固体时,脱水泥饼含水率比原泥脱水泥饼含水率低约10%,脱水率可达到97%.本研究为APG应用于污泥脱水,改善污泥脱水性能提供一些参考.     

FeⅡ(EDTA)络合协同RDB去除NO废气效能及过程分析

为进一步提高一氧化氮(NO)的去除效率,在新型生物转鼓反应器(rotating drum biofilter,RDB)中,以FeⅡ(EDTA)络合协同RDB生物转鼓的耦合技术强化难水溶性NO的气液传质速率,提高生物还原效能为目标进行了研究.结果表明,适量FeⅡ(EDTA)被添加到RDB底部营养液后,能迅速吸收气相中的NO并生成FeⅡ(EDTA)-NO络合物,进而可通过反硝化实现同步脱氮和络合剂再生.在转速0.5 r.min-1、空床停留时间(EBRT)57.7 s、温度30℃、pH 7～8的实验条件下,RDB的净化效能随络合剂的投加而显著改善;FeⅡ(EDTA)质量浓度从0增至500 mg.L-1后,NO去除率从61.1%提高到97.6%,去除负荷从16.2 g.(m3.h)-1上升到26.7 g.(m3.h)-1.分析了FeⅡ(EDTA)络合协同净化NO的反应过程,建立了NO净化效率与FeⅡ(EDTA)添加浓度的关联方程,可较好地拟合实验数据.     

基于ImageJ评价泥炭岩心存储对色相与彩度的影响

利用ImageJ软件对2008年在红原泥炭地开展钻探时的泥炭岩心照片和2009年分样时的岩心照片进行表面色彩分析.对比分析发现,存储以前和存储以后泥炭岩心的表面色彩发生改变,表现在样品存储后基于RGB色彩体系的三元色值和灰度值均有降低(变暗),且各色值变化幅度降低.就各色值在剖面上的变化特征而言,样品存储前和存储后的变...     

外力作用下管道内表面缺陷处裂纹扩展研究

为提高油气管道安全风险评估的准确性,以含内表面缺陷管道为研究对象,利用ABAQUS软件线弹性及弹塑性分析不同尺寸缺陷对裂纹萌生特征的影响;采用扩展有限元法,建立管道3点弯曲模型与全尺寸静载物理试验,并非线性拟合裂纹扩展尺寸,研究内表面缺陷处裂纹扩展情况。研究结果表明:内表面缺陷中心处极易萌生裂纹,随着缺陷尺寸的增大,裂纹萌生所需外力在缺陷相对长度为0.08、相对深度为0.4时的增长趋势变化较大,且缺陷深度对裂纹萌生的影响更大;对比数值模拟与全尺寸物理试验,发现在小于70 mm位移载荷或147.25 kN外力下裂纹尺寸快速扩展,之后呈变缓的趋势;非线性拟合裂纹尺寸,得到较为准确的裂纹扩展尺寸的预测结果。     

添加剂和湿法除尘主要参数对炭黑去除效率的影响

选取十六烷基三甲基溴化胺(CTAB)、十二烷基苯磺酸钠(SDBS)、月桂醇聚氧乙烯(9)醚(AEO-9)和壬基酚聚氧乙烯醚(OP-10)4种表面活性剂配制成吸收液,采用伞形罩洗涤器对燃煤窑炉黑烟进行湿法除尘净化实验,探讨添加剂种类、入口含尘浓度(Cin)、入口风速(u)和液气比(L/G)参数的不同对炭黑(BC)去除效率(η)的影响,结合压降(ΔP,Pa)的变化提出高效脱黑的可行方案.结果表明,在实验条件同为Cin=2g·m-3、u=12m·s-1和L/G=0.2L·m-3条件下,4种吸收液脱黑效果差别不大,AEO-9吸收液具有略明显的优势,炭黑去除效率可达到99.5%(0.06mmol·L-1,AEO-9);在u=12m·s-1和L/G=0.2L·m-3条件下,Cin=5g·m-3时更利于洗涤器对黑烟的净化,AEO-9吸收液的炭黑去除效率近乎100%,ΔP变化不大;入口风速的变化对炭黑去除效率和压降的影响比较明显,当Cin和L/G分别为2g·m-3、0.2L·m-3时,最佳入口风速为12～14m·s-1,炭黑去除效率保持在99%以上;最佳操作液气比可控制在0.2～0.4L·m-3.     

Particle properties in granular activated carbon filter during drinking water treatment

The elemental composition and bacteria attached in particles were investigated during granular activated carbon (GAC) filtration.The experimental results showed that trapped influent particles could form new,larger particles on GAC surface.The sloughing of individuals off GAC surface caused an increase in effluent particles in the size range from 5 to 25 μm.The selectivity for element removal in GAC filters caused an increasing proportion of metallic elements in the effluent particles.The distribution of molar ratio indicated a complicated composition for large particles,involving organic and inorganic substances.The organic proportion accounted for 40% of total carbon attached to the particles.Compared with dissolved carbon,there was potential for the formation of trihalomethanes by organic carbon attached to particles,especially for those with size larger than 10 μm.The pure carbon energy spectrum was found only in the GAC effluent and the size distribution of carbon fines was mainly above 10 μm.The larger carbon fines provided more space for bacterial colonization and stronger protection for attached bacteria against disinfection.The residual attached bacteria after chorine disinfection was increased to 10 2-10 3 CFU/mL within 24 hours at 25°C.     

Characteristics of contaminants in water and sediment of a constructed wetland treating piggery wastewater e uent

Constructed wetland (CW) is the preferred means of controlling water quality because of its natural treatment mechanisms and function as a secondary or tertiary treatment unit. CW is increasingly applied in Korea for secondary e uent of livestock wastewater treatment. This study was conducted to recognize the characteristics of contaminants in the accumulated sediment at the bottom soil layer and to reduce the phosphorus release from sediments of the free water surface CW for the treatment of secondary piggery wastewater e uent from a livestock wastewater treatment facility. The results revealed that the dominant phosphorus existence types at near the inlet of the CW were non-apatite phosphorus (59%) and residual phosphorus (32%) suggesting that most of the particles of the influent are made up of inorganic materials and dead cells. Sediment accumulation is important when determining the long-term maintenance requirements over the lifetime of CW. Continuous monitoring will be performed for a further assessment of the CW system and design.