ClO2氧化法预处理联苯胺类染料中间体废水

采用ClO₂氧化法预处理联苯胺类染料中间体生产废水，探讨了影响COD和联苯胺去除率的主要因素，并采用GC/MS技术对ClO₂氧化前后废水中的有机组分进行了分析。实验确定了较佳的工艺参数：ClO₂加入量为45~55 mg/L，ClO₂与联苯胺的化学计量比控制在（3.0~3.5）∶1，反应时间为 30~35 min。在此条件下，ClO₂氧化后出水中联苯胺去除率达到80%以上，联苯胺类污染物含量得到有效降低，废水BOD₅/COD由原水的0.18提高到0.40。该方法能提高废水的可生化性，是一种较好的生化预处理技术。     

Photocatalytic degradation of disperse blue 1 using UV/TiO2/H2O2 process

The photocatalytic degradation of a dye derivative, C.I. disperse blue 1 (1), has been investigated under UV light irradiation in the presence of TiO2 and H2O2 under a variety of conditions. The degradation was studied by monitoring the change in substrate concentration employing UV spectroscopic technique as a function of irradiation time. The degradation was studied under different conditions such as different types of TiO2, reaction pH, catalyst and substrate concentration containing hydrogen peroxide (H2O2), besides molecular oxygen in the presence of TiO2. The degradation of dye was also investigated under sunlight and the efficiency of degradation was compared with that of the artificial light source. The degradation rates were found to be strongly influenced by all the above parameters. The photocatalyst Degussa P25 was found to be more efficient for the degradation of the dye.     

三种偶氮染料降解历程在紫外-可见光谱上的表现

本文对基本结构相似的三种偶氮染料橙黄Ⅱ、活性艳红Ｘ－３Ｂ和活性黑Ｋ－ＢＲ水溶液在铁粉还原－光氧化两步法处理中的紫外－可见光谱图作对比分析，依据其结构与特征吸收的关系，初步推测还原铁粉－光氧化法降解染料的历程。     

蒽醌染料中间体溴氨酸降解酶的特性

从污染地分离筛选出的菌株BX26对蒽醌染料中间体溴氨酸有显著的降解脱色作用，降解过程受降解酶的控制，试验结果表明，降解酶为溴氨酸诱导的胞外酶，该酶在温度高于50℃处理后失活，盐度对该酶失活有影响，盐度高于1%会显著降低该酶活力，酶对溴氨酸的催化脱色要有氧参加，氮气气氛中酶活受抑制。     

Loofa egyptiaca as a novel adsorbent for removal of direct blue dye from aqueous solution

In this paper, Loofa egyptiaca (LE), an agricultural plant cultivated in Egypt, was used to prepare low-cost activated carbon (LE_C1 and LE_C2) adsorbents. The adsorbents (LE, LE_C1 and LE_C2) were evaluated for their ability to remove direct blue 106 dye from aqueous solutions. Batch mode experiments were conducted using various parameters such as pH, contact time, dye concentration and adsorbent concentration. The surface chemistry of LE, LE_C1 and LE_C2 was analyzed by scanning electron microscopy (SEM). The experimental data were examined using Langmuir, Freundlich, Temkin and Harkins–Jura isotherms. The results showed that the adsorption of direct blue 106 was maximal at the lowest value of pH (pH = 2). Removal efficiency was increased with an increase in dye concentration and a decrease in amount of adsorbent. Maximum adsorption capacity was found to be 57.14, 63.3 and 73.53 mg/g for LE, LE_C1 and LE_C2 respectively. Kinetics were also investigated using pseudo-first-order, pseudo-second-order and intra-particle diffusion models. The experimental data fitted very well with the pseudo-first-order and pseudo-second-order kinetic models. The results indicate that LE, LE_C1 and LE_C2 could be employed as adsorbents for the removal of direct blue dye from aqueous solutions.     

Aureobasidium pullulans UVMU3-1产耐热性胞外漆酶活性物质培养基优化及其对染料脱色作用

对出芽短梗霉无色素突变株Aureobasidium pullulans UVMU3-1产耐热性胞外漆酶活性物质培养基进行优化,并研究其分子量大小、热稳定性及对三苯甲烷类染料孔雀石绿和结晶紫的脱色作用.结果表明:蔗糖、NaNO_3为UVMU3-1产耐热性胞外漆酶活性物质的最佳碳源和氮源,产酶优化培养基配方为:蔗糖66.5 g·L~(-1),NaNO_338.4 g·L~(-1),NaCl 1.08 g·L~(-1),酵母浸粉0.2 g·L~(-1),KH_2PO_41 g·L~(-1),pH=6.0.影响UVMU3-1产耐热性胞外漆酶活性物质的因素依次为:起始pH蔗糖NaClNaNO_3,培养7 d时产生最大酶活(94.81 U·L~(-1)),比对照提高3.85倍.其分子量小于1000 D,具有良好的热稳定性,煮沸30 min后高温酶活仍残留72.50%.粗酶液(7.5 U·L~(-1))与三苯甲烷类代表性染料孔雀石绿和结晶紫75℃反应5 min后,脱色率分别为76.3%、77.5%,反应35 min后脱色率分别达到96.3%、95.3%.     

A method for the determination of rhodamine b and brilliant sulfaflavine on cotton string collectors and in a spray tank solution mixture

Abstract

A fluorescent method for the determination of rhodamine B (RhB) and brilliant sulfaflavine (BSF) dual tracers on cotton string collectors and in spray tank solutions was developed for the evaluation of the effects of adjuvants on the atmospheric drift of agricultural sprays. Both tracers on collectors were extracted with deionized water simultaneously and measured directly with a Fluorescent Specrometer by switching the maximum excitation and emission wavelengths. The linear ranges of the RhB and BSF standard curves were 0–50 and 0–10 ppb respectively. Recoveries of tracers on cotton strings ranged from 92.9% ± 1.1% to 95.1% ± 1.0% for RhB and 91.9% ± 2.8% to 103% ± 0.6% for BSF when spiked levels ranged from 0.25 to 2.5 μg per collector. The detection limit of the instrument was approximately 0.1 ppb for both tracers. The detection limits of the analytical method were approximately 0.1 ppb for RhB and 0.3 ppb for BSF when the background levels of cotton strings were subtracted. The presence of one tracer in the solution did not significantly interfere with the detection of the other tracer in the same solution. The presence of adjuvants added to the spray tank solutions did not interfere with the detection of both tracers when the adjuvants were applied at the manufacturer's maximum recommendation rates.     

雾化介质阻挡放电联合电晕放电对染料溶液脱色研究

实验将介质阻挡放电与电晕放电组合在一个反应器内,以靛蓝二磺酸钠溶液为实验废水,将高压电极上通入50Hz交流高压电,在常压空气中形成介质阻挡放电-电晕放电系统,放电产生的低温等离子体及其活性基团作用于染料分子。考察了电源电压、电极间距、处理时间对染料溶液脱色率和能量效率水平的影响,确定反应器工作状态为介质阻挡放电系统电极间距30mm、电晕放电系统电极间距25mm、电源电压20kV。     

壳聚糖/纳米CdS复合颗粒可见光光催化降解猩红B动力学研究

采用仿生矿化法制备了壳聚糖/纳米CdS复合颗粒光催化剂,并用于可见光光催化降解猩红B染料模拟废水,研究了猩红B初始浓度、pH、催化剂投加量和催化剂重复使用次数等因素对猩红B光催化降解的影响.X射线衍射(XRD)分析表明,壳聚糖能有效负载CdS纳米微晶.采用Langmuir-Hinshelwood模型描述壳聚糖/纳米CdS复合颗粒可见光光催化降解猩红B反应动力学行为,在猩红B初始质量浓度较低(≤20 mg/L)时,光催化降解过程符合假一级动力学方程.降低猩红B初始浓度和溶液pH都可显著增大光催化降解速率常数;催化剂投加量小于0.7 g/L时,光催化降解速率随其增加而增大,但催化剂投加量过大会使光催化降解速率减小;催化剂重复使用第5次时,猩红B光催化降解速率常数仍为第1次使用时的63.4%.     

Fenton试剂氧化法处理染料结晶废母液

采用Fenton试剂氧化法处理分散橙、分散紫和分散蓝3种染料结晶废母液。研究了H₂O₂加入量、n（H₂O₂）#x02236;n（Fe²⁺）和废母液pH对COD去除率或TOC去除率的影响。对TOC去除反应分段进行了动力学方程拟合，并探讨了反应机理。实验得到的分散橙、分散紫和分散蓝的废母液处理工艺条件：H₂O₂加入量分别为264.4，352.9，441.2mmol/L；n（H₂O₂）#x02236;n（Fe²⁺）分别为20，10，20；废母液pH=3。3种废母液在0~20min和20~120min两个阶段的反应与二级动力学拟合方程的相关性最好。3种废母液经Fenton试剂氧化处理后，部分有机物降解为小分子有机酸，部分有机物完全矿化。