络合-超滤耦合工艺去除水中镍离子的研究

以聚丙烯酸钠(PAANa)和聚乙烯亚胺(PEI)作为络合剂,将其与镍离子络合后的溶液转移至超滤杯中,在0.1 MPa压力下通过聚醚砜超滤膜进行分离,研究pH值和络合剂/Ni2+装载质量比(L)对Ni2+去除率的影响,并根据朗缪尔等温模型拟合络合反应平衡常数.同时研究超滤时间对膜通量和Ni2+去除率的影响.结果表明,选用PAANa为络合剂,在pH值为8、L=5时,Ni2+的去除率达到最大值99.5%.PEI为络合剂时,Ni2+去除率在pH值为7、L为5时达到最大值93.0%.不同pH值条件下拟合得到的络合平衡常数表明,pH为7时最有利于络合反应.另外,单个络合剂单体所能结合的Ni2+个数随着pH值的升高而增大.研究结果还表明,在长达12 h的超滤时间内,PAANa为络合剂时,膜通量的衰减<10%;PEI为络合剂时,膜通量基本保持不变;Ni2+的去除率都基本保持恒定.因此,在合适条件下,络合-超滤耦合工艺能有效去除水中的镍离子.     

FCR多级接触氧化系统处理乳品工业废水的研究

为提高乳品工业废水生物处理的去污脱氮能力,以新型螺旋状纤维填料作为载体,采用多级氧化槽内不同种类微生物形成的食物链系统（food chain reactor）,详细考察了不同水力停留时间COD、TN、NH^＋₄-N、TP等的去除率及其去除机理,并对污泥减量化效果进行了初步探讨.结果表明,当进水COD为842～1 843 　mg/L、TN为36.3～92.2 　mg/L、NH^＋₄-N为30.1～52.1 　mg/L,HRT=6　h时,系统COD的平均去除率达到93.3%;TN和NH⁺₄-N的去除效果显著,其平均去除率分别达到73.3%和80.7%,出水COD、TN、NH⁺₄-N平均值分别为79.4　mg/L、9.6 　mg/L、6.1　mg/L,均低于《污水综合排放标准》（GB 8978-2002）的一级标准.该系统不仅具有较高的去污脱氮效果,而且产生的剩余污泥量极少,其污泥产率的平均值为7.7%.该系统运行费用低,操作管理方便,长期运行稳定,可应用于城市污水、中高浓度有机废水（如餐厅污水、食品工业废水）等的处理.     

水热法制备BiVO4及其可见光催化降解糖蜜酒精废水

以Bi(NO3)3•5H2O为铋源,NH4VO3为钒源,采用简单的水热法制备了BiVO4 光催化剂,并用X-射线衍射(XRD)、扫描电子显微镜(SEM)、红外光谱(IR)和紫外-可见光漫反射光谱(UV-vis)对产品进行了结构表征。同时,在BiVO4光催化降解糖蜜酒精废水反应中考察了催化剂用量、通氧量、溶液pH值、双氧水用量及光照强度对糖蜜酒精废水脱色率的影响。实验结果表明,水热产品属于单斜晶系BiVO4,其带隙能为2.398 eV,并具有良好的可见光催化活性。当降解经30倍稀释的糖蜜酒精废水,BiVO4添加量为3.0 g•L−1 ,通氧量为120 L•h-1,助氧化剂H2O2添加量为9 %,不改变废水pH值,在400W镝灯离液面11cm照射反应180 min的条件下,糖蜜酒精废水的脱色率为88.60 %,COD去除率为25.84%,而添加5g•L−1的FeSO4•7H2O后其脱色率和COD去除率分别提高到90.90 %和91.26%。单斜晶型BiVO4晶体的可见光催化糖蜜酒精废水过程符合一级动力学反应。     

Evaluation of reusing alum sludge for the coagulation of industrial wastewater containing mixed anionic surfactants

A coagulation-flocculation process is typically employed to treat the industrial wastewater generated by the consumer products industry manufacturing detergents, soaps, and others. The expenditure of chemicals including coagulants and chemicals for pH adjustment is costly for treating this wastewater. The objective of this study was to evaluate the feasibility of reusing the aluminum sulfate (alum) sludge as a coagulant or as a coagulation aid so that the fresh alum dosage can be minimized or the removal e ciency can be enhanced. The experiments were conducted in a jar-test apparatus simulating the coagulation-flocculation process for simultaneous removals of organic matters, anionic surfactants, suspended solids, and turbidity. At the optimum initial pH value of 10 and the fresh alum concentration of 400 mg/L, the total suspended solids (TSS), total chemical oxygen demand (TCOD), total anionic surfactants, and turbidity removal e ciencies were 71.5%, 76.4%, 95.4%, and 98.2%, respectively. The addition of alum sludge as a coagulant alone without any fresh alum addition could significantly remove the turbidity, TCOD, and anionic surfactants. The TSS was left in the supernatants after the settling period, but would subsequently be removed by adding the fresh alum. The TSS, TCOD, and turbidity removal e ciencies were also enhanced when both the alum sludge and the fresh alum were employed. The TCOD removal e ciency over 80% has been accomplished, which has never fulfilled by using the fresh alum alone. It is concluded that the alum sludge could be reused for the treatment of industrial wastewater generated by the consumer products industry.     

免烧粉煤灰陶粒作为BAF填料处理城市污水

以电厂粉煤灰为主要试验原料,辅以外加药剂(水泥、石灰、石膏、水玻璃),经混合、成球、陈化和养护等工序,制得免烧粉煤灰陶粒,并将其作为曝气生物滤池(BAF)工艺的载体填料处理城市污水.待挂膜启动成功后,考察了水力停留时间( HRT)、COD负荷、氨氮负荷对COD和氨氮去除效果的影响.实验结果表明:在温度为18～21℃、气...     

絮凝-SBR-Fenton氧化处理酶制剂废水的研究

以某酶制品厂的废水为研究对象,确定了絮凝-SBR-Fenton高级氧化的试验方法.结果表明,在絮凝阶段,当聚合氯化铝(PAC)投加量为0.6g/L,搅拌6 min,絮凝70min的条件下,预处理的出水CODCr效果最好,去除率为44.6%;再经过SBR工艺处理,停留时间为14 h时,CODCr去除率达到了89.2%;之后再进行Fenton高级氧化,氧化的最佳条件是:ρ(FeSO4·7H2O)为3 g/L,ρ(H2O2)为0.8g/L,反应时间2 h.最终出水达到了GB 8978-1996<污水综合排放标准>中二级排放标准.     

物化法处理生活垃圾渗滤液新进展

概述了物化法处理垃圾渗滤液的研究现状和最新进展,并展望了物化法处理垃圾渗滤液的研究方向。     

活性炭纤维固定化菌对微囊藻毒素MC-LR的去除研究

研究了藻蓝蛋白提取过程中微囊藻毒素MC-LR的释放分布规律,并用活性炭纤维对一株微囊藻毒素降解菌株进行了固定化,考察了不同活性炭纤维预处理方法、活性炭纤维用量、pH值、温度以及MC-LR浓度对固定化藻毒素降解菌去除MC-LR的影响.结果表明,藻蓝蛋白提取过程中MC-LR主要分布在超滤滤液中,占MC-LR总含量的81.2%.固定化藻毒素降解菌去除MC-LR的效率明显高于非固定化藻毒素降解菌.藻毒素降解菌用(1+9)盐酸预处理后的活性炭纤维固定化,其去除效果最佳.MC-LR去除的最适条件为:活性炭纤维用量为10g/L,温度为35℃,pH值为8.0.固定化藻毒素降解菌对pH值,温度具有一定的耐受性,能够在pH5~pH9、10℃~35℃范围内有效地去除MC-LR.     

Reaction mechanism and metal ion transformation in photocatalytic ozonation of phenol and oxalic acid with Ag+/TiO2

Photocatalytic ozonation of phenol and oxalic acid （OA） was conducted with a Ag^＋/TiO2 catalyst and different pathways were found for the degradation of different compounds. Ag^＋ greatly promoted the photocatalytic degradation of contaminants due to its role as an electron scavenger. It also accelerated the removal rate of OA in ozonation and the simultaneous process for its complex reaction with oxalate. Phenol could be degraded both in direct ozonation and photolysis, but the TOC removal rates were much higher in the simultaneous processes due to the oxidation of hydroxyl radicals resulting from synergetic effects. The sequence of photo-illumination and ozone exposure in the combined process showed quite different effects in phenol degradation and TOC removal. The synergetic effects in different combined processes were found to be highly related to the properties of the target pollutants. The color change of the solution and TEM result confirmed that Ag＋ was easily reduced and deposited on the surface of Tit2 under photo-illumination, and dissolved again into solution in the presence of ozone. This simple cycle of enrichment and distribution of Ag^＋ can greatly benefit the design of advanced oxidation processes, in which the sequences of ozone and photo-illumination can be varied according to the needs for catalyst recycling and the different properties of pollutants.     

制备工艺对La改性湿式氧化催化剂活性和稳定性的影响

采用CWAO(催化湿式空气氧化)法处理甲基橙模拟印染废水,以过量浸渍法制备催化剂,以水样COD Cr去除率和脱色率表征催化剂的活性,以催化剂使用后处理出水中溶出的金属离子质量浓度表征催化剂的稳定性.结果表明,多组分催化剂的金属组分构成为Cu、Fe、La,m(Cu)∶m(Fe)∶m(La)为1∶1∶2,35℃下动态共浸渍8 h,450℃下焙烧3 h,由此制备得到Cu-Fe-La/FSC催化剂.应用该催化剂,以CWAO法处理模拟印染废水,废水COD Cr去除率和脱色率可分别达到79.1%和98.9%,催化剂的活性较高;使用该催化剂处理后的废水中Cu、Fe、La、Al的溶出量(以ρ计)分别为6.1、2.4、2.2、3.2 mg/L,说明金属元素的溶出量较低,催化剂的稳定性较高.