Heavy metals in the habitat and throughout the food chain of the Neotropical otter, Lontra longicaudis, in protected Mexican wetlands

Top predators like the Neotropical otter, Lontra longicaudis annectens, are usually considered good bioindicators of habitat quality. In this study, we evaluated heavy metal contamination (Hg_tot, Pb, Cd) in the riverine habitat, prey (crustaceans and fish), and otter feces in two Ramsar wetlands with contrasting upstream contamination discharges: Río Blanco and Río Caño Grande in Veracruz, Mexico, during the dry, the wet, and the nortes seasons. Most comparisons revealed no differences between sites while seasonal differences were repeatedly detected for all of the compartments. Higher concentrations of Pb during the dry season and of Cd during the wet season in otter feces mirrored differences detected in the most seasonally consumed prey. Compared with fecal methylmercury values reported for the European otter (0.25–0.75 mg kg^?1) in unprotected areas, the Hg_tot levels that we measured were lower (0.02–0.17 mg kg^?1). However, Pb (117.87 mg kg^?1) and Cd (9.14 mg kg^?1) concentrations were higher (Pb, 38.15 mg kg^?1 and Cd, 4.72 mg kg^?1) in the two Ramsar wetlands. Protected areas may shelter species, but those with water-linked diets may suffer the effect of chemicals used upstream.     

Utility of cefixime as a complexing reagent for the determination of Ni(II) in synthetic mixture and water samples

A simple, sensitive, and accurate UV spectrophotometric method has been developed for the determination of nickel in synthetic mixture and water samples. The method is based on the complexation reaction of nickel ion with cefixime, thus leading to the formation of Ni–cefixime complex in ethanol-distilled water medium at room temperature. The complex showed the maximum absorption wavelength at 332 nm. Beer’s law is obeyed in the working concentration range of 0.447–4.019 μg?mL^?1 with apparent molar absorptivity of 7.314?×?10³?L?mol^?1?cm^?1 and Sandell’s sensitivity of 0.008 μg/cm²/0.001 absorbance unit. The limits of detection and quantitation for the proposed method are 0.016 and 0.054 μg?mL^?1, respectively. The factors such as cefixime concentration and solvent affecting the complexation reaction were carefully studied and optimized. The method is validated as per the International Conference on Harmonisation guideline. The method is successfully applied to the determination of Ni(II) in synthetic mixture and wadi water samples collected from Al Rustaq. The same water samples are also analyzed by atomic absorption spectrophotometry. Both methods determined the amount of Ni(II) in water sample and found to be approximately the same.     

Treatment of wastewater containing arsenic using Rhazya stricta as a new adsorbent

The effective removal of heavy metals from aqueous wastes is among the most important issues for many industrialized countries. Removal of arsenic (As) from aqueous solutions was studied using Rhazia stricta biomass. The batch experiments are carried out to investigate the effect of the significant process parameters such as pH, contact time, solute concentration and adsorbent dose. The optimum pH required for maximum adsorption was found to be 5. The equilibrium data for the adsorption of As(V) on R. stricta are tested with various adsorption isotherm models such as Langmuir, Freundlich, Tempkin and Generalized equation. Results indicate the following order to fit the isotherm: Langmuir (1 and 2)?>?Tempkin?>?Generalized form?>?Freundlich. A comparison of two kinetic models showed that our data fitted well to the Elovich model.     

Ecological footprint analysis applied to a sub-national area: the case of the Province of Siena (Italy)

This work is part of a larger project, which aims at investigating the environmental sustainability of the Province of Siena and of its communes, by means of different indicators and methods of analysis. The research presented in this article uses ecological footprint and biocapacity as indicators to monitor the environmental conditions of the area of Siena, thus complementing previous studies carried out using Emergy, greenhouse gases balance and other methods. The calculations have been performed in such a way as to enable a disaggregation of the final results according to the classical categories of ecologically productive land and of consumption, but also according to citizen's and public administration's areas of influence. This information allows us to investigate in detail the socio-economic aspects of environmental resource use. Among the notable results, the Siena territory is characterized by a nearly breakeven total ecological balance, a result contrasting with the national average and most of the other Italian provinces. Furthermore, the analysis has been carried out at different spatial scales (province, districts and communes), highlighting an inhomogeneous territorial structure consisting of subareas in ecological deficit compensated by zones in ecological surplus.     

A Comparative Study On the Levels of Trace Metals in Some Mediterranean and Red Sea Fishes

Samples of Mugil cephalus, Liza ramada, Siganus luridus, Siganus rivulatus, Epinephelus alexandrinus, Epinephelus areolatus, Epinephelus fasciatus, Epinephelus chlorostigma, Cephalopholis argus and Cephalopholis sonnerati were collected from the Mediterranean and Red Seas and their muscle and bone analyzed by AAS for some trace metals (Cr, Mn, Fe, Co, Ni, Cu, Zn, Cd, Pb). the results showed that these metals accumulate in the bones to a greater extent than in the muscle. the highest accumulated element is cobalt (4.7-20.8 times), while the lowest is lead (1.1-2.5 times). the accumulation is more pronounced in Red Sea species than in Mediterranean species. the elevated levels of lead in Mugil cephalus (2.6-3.0 mg kg^-1) and Epinephelus alexandrinus (3.0-3.9 mg kg^-1) were attributed to the intake in food in the polluted environment of Alexandria coastal water. the relationship between body size and concentration of trace metals using a standard linear regression technique gives a significant positive correlation for cobalt, manganese, iron and lead in the muscle, as well as for lead in the bones of Mugil species from the Red Sea, while the Mediterranean species showed little correlation.

There is a tendency for increased concentrations of the essential metals manganese, iron and copper with increasing trophic level of the fish, while the opposite is true for the toxic metals chromium and lead. Our results indicate that there is no risk from toxic metal concentrations in muscle of fish from the Mediterranean and Red Seas consumed by man even in contaminated areas.     

Poly(3-hydroxybutyrate-co-3-hydroxyhexanoate)/Organomodified Montmorillonite Nanocomposites for Potential Food Packaging Applications

Poly(3-hydroxybutyrate-co-3-hydroxyhexanoate) (PHBHHx) is a versatile, biobased and biodegradable copolymer from the family of polyhydroxyalkanoates. This study aims to further ameliorate its properties in order to enhance its applicability for food packaging purposes through preparation of organomodified montmorillonite clay (OMMT) nanocomposites. Nanocomposites based on pure PHBHHx as well as commercial PHBHHx granulate, after a previous dry-mixing with OMMT in concentrations of 1, 3, 5 and 10 wt%, were prepared using melt blending and compression molding. Investigation of the samples showed well dispersed nanofiller and highly intercalated nanocomposites, resulting in a continuous decrease in gas permeability, lowering O₂, CO₂ and water vapor permeability with about 5–7 % and approximately 40 % at OMMT concentration of 1 and 10 wt%, respectively. Besides gas permeability, other properties were affected as well. Thermal stability of the samples increased gradually up to 5 wt% nanofiller, but was reduced at 10 wt%. In order to investigate the effects of OMMT and molecular weights on PHBHHx crystallization, nanocomposites were also produced by solvent-casting and compared to those obtained by melt-blending. Crystallization was retarded, because of severe lowering of molecular weight due to processing-induced chain scission, catalyzed by OMMT moisture. However, this reduction was counteracted for a large part by using commercial PHBHHx granulate, which has shown better crystallization properties. The samples were rendered increasingly more brittle, displaying higher Young’s modulus and severely reduced elongation at break. From this study it appeared that, upon viewing all affected properties as a whole, the sample based on commercial PHBHHx and containing 3 wt% OMMT shows most promise for possible applications, however further research must be performed in order to exploit their fullest potential.     

New insights in analysing parasitoid attracting synomones: early volatile emission and use of stir bar sorptive extraction

Summary. It is well known that feeding by Pieris brassicae caterpillars on cabbage leaves triggers the release of volatiles that attract natural antagonists such as the parasitoid Cotesia glomerata. The temporal dynamics in the emissions of parasitoid attracting volatiles has never been elucidated in this system. In a time course experiment, caterpillar infested leaves attracted the parasitoid within one hour after infestation. At such an early stage of infestation, as much as fifty percent of the parasitoids flew towards the infested plant in a wind tunnel bioassay, while only five percent flew towards the non-infested control plant. Three hours after infestation and later, the response to the volatiles from the infested plant reached its maximum and then continued at a constantly high level for the remaining 14 hours of the experiment. Chemical analyses of volatiles collected from infested leaves at short time intervals during the first 24 hours identified a total of ten compounds, comprising green leaf volatiles, terpenoids, and a nitrile. Significant increase of emission within the first 5 hours following initial herbivory was detected for (Z)-3-hexen-1-ol, (Z)-3-hexen-1-yl acetate, cineole and benzylcyanide. Subsequently, a coupled bioassay-chemical analysis procedure was developed allowing for testing and analyzing the same sample for future identification of the bioactive compounds. This was achieved by using stir bar sorptive extraction for the analysis of solvent extracts of caterpillar-damaged leaves.     

The arbuscular mycorrhizal fungus Glomus mosseae induces growth and metal accumulation changes in Cannabis sativa L

The effect of arbuscular mycorrhiza on heavy metal uptake and translocation was investigated in Cannabis sativa. Hemp was grown in the presence and absence of 100 microg g-1 Cd and Ni and 300 microg g-1 Cr(VI), and inoculated or not with the arbuscular mycorrhizal fungus Glomus mosseae. In our experimental condition, hemp growth was reduced in inoculated plants and the reduction was related to the degree of mycorrhization. The percentage of mycorrhizal colonisation was 42% and 9% in plants grown in non-contaminated and contaminated soil, suggesting a significant negative effect of high metal concentrations on plant infection by G. mosseae. Soil pH, metal bioavailability and plant metal uptake were not influenced by mycorrhization. The organ metal concentrations were not statistically different between inoculated and non-inoculated plants, apart from Ni which concentration was significantly higher in stem and leaf of inoculated plants grown in contaminated soil. The distribution of absorbed metals inside plant was related to the soil heavy metal concentrations: in plant grown in non-contaminated soil the greater part of absorbed Cr and Ni was found in shoots and no significant difference was determined between inoculated and non-inoculated plants. On the contrary, plants grown in artificially contaminated soil accumulated most metal in root organ. In this soil, mycorrhization significantly enhanced the translocation of all the three metals from root to shoot. The possibility to increase metal accumulation in shoot is very interesting for phytoextraction purpose, since most high producing biomass plants, such as non-mycorrhized hemp, retain most heavy metals in roots, limiting their application.     

Combined effect of fire and water scarcity on vegetation patterns in arid lands

In many arid zones around the word, the vegetation spontaneously forms regular patterns to optimize the use of the scarce water resources. The patterns act as early warning signal that fragile ecosystems may suddenly undergo irreversible shifts, thus, interpreting the structural shape of vegetation patterns is crucial to deciphering the ecosystem history and its expected further development. The sudden and irreversible shift of delicate ecosystems as a consequence of minor variation of the climatic forcing has been studied extensively in the past. The attitude of the ecosystem to recover after a catastrophic event, such as fire, did not receive as much attention so far. Here we modelled fire, as a sudden shift of the ecosystem state variables and functionality and evaluated post-fire scenarios under the hypothesis that two major feedbacks shaped the vegetation patterns: a positive feedback between preferential infiltration and plant growth, and a second feedback between infiltration and vegetation burning. A simple model solving a set of partial differential equations for soil moisture, plant biomass, surface water and dead biomass balance predicted significantly diverse post-fire vegetation patterns depending on the fire severity and on the degree of soil water repellency induced by the vegetation burning.     

Chitosan for direct bioflocculation of wastewater

Environmental Chemistry Letters - Coagulation/flocculation is a major phenomenon occurring during industrial and municipal water treatment to remove suspended particles. Common coagulants are metal...